Answer:
Respiration is considered as exothermic reaction because energy is released in this process. Glucose combines with oxygen present in our cells to form carbon dioxide and water along with energy.
Explanation:
Good Luck!
Respiration is considered as an exothermic reaction because, in the respiration process, oxidation of glucose takes place which produces a large amount of heat energy stored in the form of ATP. This is shown in the following chemical equation C 6
बा
If OPPOSITE poles (N and S) of
a magnet are placed near
each other, what happens?
Type answer here
Answer:
They attract each other
Explanation:
A magnet has two poles;
North pole and south pole
When two opposite poles are placed close to each other, they attract each other. The short rule is opposite opes attract.
When two like poles are placed close to each other, they repel each other. The short rule is like poles repel.
Balance the equation by typing in the correct coefficients into the blank spaces in front of each formula. Type 1 if
the coefficient is 1, do not leave space blank
_EH + _ G2 → _EG + _HG2
Answer:
2 in front of every one
Explanation:
HOPE IT HELPS
Measurements show that unknown compound X has the following composition:
element mass %
carbon 74.8%
hydrogen 25.1%
Write the empirical chemical formula of X. please help
the empirical chemical formula of X is CH4
Explanation:Step 1: Imagine you have a sample of compound weighing exactly . Multiply the mass of this sample by the mass percents to find the mass of each element in the sample
Step 2: Divide the mass of each element by the element's molar mass to find the moles of each element in the sample. Remember to round your answers to the correct number of significant digits.
Step 3: Divide the moles of each element by the the smallest number of moles of any element to find the mole ratio of elements in the sample.
Step 4: Multiply the mole ratio by the smallest whole number that changes it into a whole number ratio to find the atom ratio of elements in the sample.
Note that the result of each multiplication must equal a whole number only within measurement uncertainty.
The measurement uncertainty in this calculation comes from the measurement uncertainty of the mass percents given in the question. The mass percents each have significant digits. That means each mass percent has some measurement uncertainty in the third significant digit, and only the first two significant digits can be considered completely reliable.
In Step 1 you multiplied each mass percent by something with zero uncertainty (the exactly you assumed your sample weighed), in Step 2 you divided by a measurement with more than significant digits (the molar mass of the elements), and in Step 3 you divided by a measurement with the same number of significant digits (the least number of moles of any element in the compound). None of these steps added to the measurement uncertainty of your calculation.
Therefore, the measurement uncertainty in the final result of all your calculations is determined by the measurement uncertainty in the original mass percents and will be in the third significant digit. That means the result of each of the final multiplication steps must equal a whole number only to within the first two significant digits.
The whole numbers in the last column of the table are and .
Question 1
Which of the following is a false
Answer:
1.A 2.C 3.B
4. d
Explanation:
5. What is characteristic of an opaque object.
The inflation of airbags is due to the breakdown of a single chemical substance into two separate substances.
Two molecules of sodium azide (NaN3) break down into sodium (Na) and nitrogen gas (N2) during the reaction.
How many sodium (Na) atoms are produced in the reaction?
1 Na atom
2 Na atoms
3 Na atoms
Answer:
The correct answer would be
B. 2 Na atoms
Explanation:
As seen in the picture below,
someone plz help me.
Answer:
The answer is 2.
Explanation:
It is the only one that has a chemical change.
Hope this helped you :)
If so pls give brainliest.
HELP ME PLEASEEEEE!!!!!!!!!!
Answer:
I dont know what the answer is
Explanation:
What results when equal but opposite charges are present in two regions of a polar molecule? A. dipole B. ionic bond C. Electron sea D. crystal lattice
Answer: A. dipole
Explanation:
Dipole can be defined as the separation of the equal and opposite charges present in the molecule via ionic bonding. The water molecule comprising of two molecules of hydrogen being positively charged and one molecule of oxygen being negatively charged are connected via ionic bonding thus water molecule is an example of dipole molecule. There is unequal distribution of the electrical density throughout the molecule.
The polar molecule results in a dipole when equal but opposite charges are present in two regions.
Dipole:
Dipole arises when a molecule have opposite and equal charge in the ends.
For example - water molecule
In water molecule Oxygen is negatively charged and hydrogen have low electronegativity, this difference in electronegativities arise dipole in molecule.
Therefore, the polar molecule results in a dipole when equal but opposite charges are present in two regions.
To know more about Dipole,
https://brainly.com/question/18382778
Please help me with dis
Answer:
c
Explanation:
Your car burns gasoline as you drive from home to school
Which of the following chemical reactions produces water via a
synthesis reaction?
a 2H2 + O2 + 2H2O
b NaOH + HCI - NaCl + H2O
C CuO + H2 - Cu + H2O
d H2CO3 → CO2 + H2O
Answer:
Should be A, but also I think there should be an arrow between O2 and 2H2O
Write the equilibrium expressions for each of the following equilibria:
a. 2 Ba + O2 ⇌ 2 BaO
b. 2 Mg + O2 ⇌ 2MgO
c. P4 + 5 O2 ⇌ P4O10
Answer:
a.
[tex]K=\frac{[BaO]^2}{[Ba]^2[O_2]}[/tex]
b.
[tex]K=\frac{[MgO]^2}{[Mg]^2[O_2]}[/tex]
c.
[tex]K=\frac{[P_4O_{10}]^2}{[P_4][O_2]^5}[/tex]
Explanation:
Hello!
In this case, since the equilibrium expression is set up by dividing the products over the reactants and powering to the stoichiometric coefficient, we can proceed as follows:
a. 2 Ba + O2 ⇌ 2 BaO.
[tex]K=\frac{[BaO]^2}{[Ba]^2[O_2]}[/tex]
b. 2 Mg + O2 ⇌ 2MgO
[tex]K=\frac{[MgO]^2}{[Mg]^2[O_2]}[/tex]
c. P4 + 5 O2 ⇌ P4O10
[tex]K=\frac{[P_4O_{10}]^2}{[P_4][O_2]^5}[/tex]
Best regards.
4 Hydrogen has three naturally occurring isotopes. H.1, H-2, and H-3 The atomie mass of Hydrogen is 1.097 Which isotope is most abundant in nature? Explain
Answer:
The number following the name of the element is the number of subatomic particles inside the nucleus of the atom. This means that it is the mass number of the isotope. The average atomic mass of the element is the sum of the products of the percentage abundance and mass number of the naturally occurring isotopes.
Since, the average atomic mass of the hydrogen is nearest to 1 then, the most abundant isotope should be hydrogen-1.
Calculate the number of moles of NaOH contained in 250. mL of a 0.05M solution.
Answer:
0.0125mol
Explanation:
Molarity (M) = number of moles (n) ÷ volume (V)
n = Molarity × Volume
According to this question, a 0.05M solution contains 250 mL of NaOH. The volume in litres is as follows:
1000mL = 1L
250mL = 250/1000
= 0.250L
n = 0.05 × 0.250
n = 0.0125
The number of moles of NaOH is 0.0125mol.
9. Good insulator should be
(a) Fire proof
(b) Chemically inert
(c) Odourless in use
(d) All of the above
Ar
Answer:
A fire proof
Explanation:
I hope this is help
Please help me, I am confused
Answer:
B
Explanation:
Ionic compound can conduct electricity
How many lone pairs does this molecule have?
Answer:
Just 1 i.e., Option B.
Because except for top of the molecule, all other sides are filled with a letter meaning there is one free space.
Answer:
B
Explanation:
H . + H . -----> H:H {":" represents a covalent bond, that is, a shared pair of electrons}
A Lewis structure is a convention used to represent the covalent bonding in a molecule. Dots or lines are used to represent
valence electrons (electrons available for bonding). The Lewis structure for the hydrogen molecule is as follows.
H:H or H-H
A bonding pair is an electron pair shared between two atoms.
A nonbonding pair (lone pair, unshared pair) is a pair of electrons that remains on one atom and is not shared.
OMG PLEASEEEE HELPPPPPPPPPPP!!!!!!!!!!!
Answer:
the second one
Explanation:
THE answers is b
Balance this equation. Pb(NO3)2(aq)+NaCl(aq) -> NaNO3(aq)+PbCl2(s)
Answer:
Pb(NO3)2(aq) + 2NaCl(aq) -> 2NaNO3(aq)+PbCl2(s)
Explanation:
Pb(NO3)2(aq)+NaCl(aq) -> NaNO3(aq)+PbCl2(s)
This is how it starts out.
Left:
2 NO3s1 Pb1 Na1 ClRight
1 Na1 NO31 Pb2 ClSo the place to start with this equation is to bring the Cls up to 2
Pb(NO3)2(aq)+2NaCl(aq) -> NaNO3(aq)+PbCl2(s)
But the Nas are now out of kilter.
Pb(NO3)2(aq)+ 2NaCl(aq) -> NaNO3(aq)+PbCl2(s)
Now the right has a problem. There's only 1 Na
Pb(NO3)2(aq) + 2 NaCl(aq) -> 2NaNO3(aq)+PbCl2(s)
Check it out. It looks like we are done.
Why the bond in water molecule os polar covalent bond, while than in chlorine molecule is pure covalent bond? Give reason?
Explanation:
The unequal sharing of electrons between the atoms and the unsymmetrical shape of the molecule means that a water molecule has two poles - a positive charge on the hydrogen pole (side) and a negative charge on the oxygen pole (side). We say that the water molecule is electrically polar.
What is the correct formula for sodium carbonate?
a. Na(CO3)2
b. Na,(CO3)2
C. Na2CO3
Naz(CO)2
e. NaCO3
d.
a
a
b
b
ΟΟΟΟΟ
С
С
d
d
е
e
Answer:
na2 co3
Explanation:
sodium carbonate formula
Answer:
your answer is C.
Explanation:
this is what it would be like
O
|
|
Na+ C Na+
/ \
/ \
O- O-
what is computer hardware in short?
Answer:
computer hardware is a collection of a physical part of a computer system
examples = CPU , monitor , mouse etc
Think of the of the body that we need in order to do things like walk, run etc. What systems are these? How do they work together so you can do these activities?
Answer:
I dont get this
Explanation:
If combining cation A with a +3 charge and anion X with a -3 charge, how would we write the compound?
O AX
O A3X3
O 3AX
Answer: it’s not A3X3
Explanation:
1. AX
For binary ionic compounds (ionic compounds that contain only two types of elements), the compounds are named by writing the name of the cation first followed by the name of the anion.If a cation A carries +3 charge and an anion X carries -3 charge, the compound so formed is AX. Since the charges gets cancelled out.For example: consider aluminum phosphate, aluminum carries +3 charge and phosphate carries -3 charge, the molecular formula for the compound will be AlPO₄.Learn more:
brainly.com/question/11164440
How do you find the scientific notation of a Avogadro's number??
Answer: ummmmmm hmmmmm
Explanation:
How did chemists make their proposed model of the sub atomic particles?
Answer:
Because they want to clarify or give solution to the particle that the other didn't know
Explanation:
Correct me if im wrong thanks
1)how is ice made?
2)what materials does it use?
3)how is it put together
Answer:
milk and sugar and vinillia it uses a machine and you stir until it forms
Explanation:
The three types of intermolecular forces have different strengths. Rank
them from weakest to strongest.
If today is Monday and it is a 1st Quarter moon, what phase will it
be on Thursday?
Answer:
Wanning gibouss 56%
Explanation: