Answer:
d an acid - base reaction.
Explanation:
Answer:
single replacement
Explanation:Look it up and got it from quizlet it should be right.
A sample of methane gas, CH4, occupies 3.25 L at temperature of 19.0 o C. If the pressure is held constant, what will be the temperature be if the volume expands to 10.00 L?
Answer:
625.46 °C
Explanation:
We'll begin by converting 19 °C to Kelvin temperature. This can be obtained as follow:
T(K) = T(°C) + 273
T(°C) = 19 °C
T(K) = 19 °C + 273
T(K) = 292 K
Next, we shall determine the Final temperature. This can be obtained as follow:
Initial volume (V₁) = 3.25 L
Initial temperature (T₁) = 292 K
Final volume (V₂) = 10 L
Final temperature (T₂) =?
V₁/T₁ = V₂/T₂
3.25 / 292 = 10 / T₂
Cross multiply
3.25 × T₂ = 292 × 10
3.25 × T₂ = 2920
Divide both side by 3.25
T₂ = 2920 / 3.25
T₂ = 898.46 K
Finally, we shall convert 898.46 K to celsius temperature. This can be obtained as follow:
T(°C) = T(K) – 273
T(K) = 898.46 K
T(°C) = 898.46 – 273
T(°C) = 625.46 °C
Therefore the final temperature of the gas is 625.46 °C
19) Which one of the following statements describes a chemical property of hydrogen gas?
A) Hydrogen gas has a density of 0.00009 g/cm’ at STP.
B) Hydrogen gas burns in air.
C) Hydrogen gas has a boiling point of 20. K at standard pressure.
D) Hydrogen gas is colorless.
What number is pointing to the area where magma is less dense due to
heat?
Answer:
I think it's 2
Explanation:
The magma gets so hot, it floats up before cooling and sinking again
Question 15 (3 points)
How are cations and anions related to metals and nonmetals?
Answer:
uff mere dil ma ture kali chadiya ha uff tumi apne buni ha
Answer:
Cations (positively-charged ions) and anions (negatively-charged ions) are formed when a metal loses electrons, and a nonmetal gains those electrons. ... And all of them form an anion with a single negative charge.
6.
Ammonia (NH3) acts as a weak base in aqueous solution. What is the acid that reacts with this base
when ammonia is dissolved in water?
(A) NHA
(B) H2O
(C) Oxygen, which is always dissolved in water
(D) None of the above, there are no acids in pure water
Answer:
90% of people marry there 7th grade love. since u have read this, u will be told good news tonight. if u don't pass this on eight comments your worst week starts now this isn't fake. apparently if u copy and paste this on ten comments in the next ten minutes you will have the best day of your life tomorrow. you will either get kissed or asked out in the next 53 minutes someone will say i love you.!Explanation:
Ammonia acts as a weak base in aqueous solution. Water is the acid that reacts with this base when ammonia is dissolved in water.
What is a base?According to the Arrhenius concept, base is defined as a substance which yields hydroxyl ions on dissociation.These ions react with the hydrogen ions of acids to produce salt in an acid-base reaction.
Bases have a pH higher than seven as they yield hydroxyl ions on dissociation.They are soapy in touch and have a bitter taste.According to the Lowry-Bronsted concept, base is defined as a substance which accepts protons .Base react violently with acids to produce salts .Aqueous solutions of bases can be used to conduct electricity .They can also be used as indicators in acid-base titrations.
They are used in the manufacture of soaps,paper, bleaching powder.Calcium hydroxide ,a base is used to clean sulfur dioxide gas while magnesium hydroxide can be used as an antacid to cure acidity.
Learn more about base,here:
https://brainly.com/question/12445440
#SPJ6
Need help on this question asap please
Answer:
The correct answer is - 14.
Explanation:
In the given molecular formula of the aluminum sulphite which is Al2(SO3)3, this molecular formula there different type of elements are bonded together to form this compound each element has a specific number of atoms present. This compound has three elements that are aluminum, sulfur, and oxygen and the atoms are present are:
Al = 2 atoms represented by subscript
S = 3 atoms represented as whole subscripts of sulfite
O = 9 atoms 3 inside bracket and 3 outside of bracket that multiplies.
Thus, total number of atoms are 2+3+9 = 14
What causes a substance to be hydrophobic?
Choose the correct name for each acid. Click here
to access the common polyatomic ion sheet.
HNO2:
DONE
HI:
DONE
H3PO4 :
DONE
The correct name of HNO₂, HI and of H₃PO₄ is nitrous acid, hydroiodic acid and phosphoric acid respectively.
What are acids?Acids are those substances in which carboxylic acid (-COOH) is present and pH value of acids falls in the range of 0 to 6.9.
Name of the HNO₂ compound is nitrous acid, of HI is hydroiodic acid and of H₃PO₄ is phosphoric acid.
Hence name of the HNO₂, HI and of H₃PO₄ is nitrous acid, hydroiodic acid and phosphoric acid respectively.
To know more about acids, visit the below link:
https://brainly.com/question/24375075
#SPJ2
Answer: HNO2 nitrours acid
HI Hydroiodic acid
H3PO4 phosphoric acid
Explanation: edu
When one element replaces another element the reaction is known as a _ replacement reaction
Answer:
Single replacement reaction
Explanation:
A single replacement reaction, sometimes called a single displacement reaction, is a reaction in which one element is substituted for another element in a compound.
What is the name for As4010?
Answer: As4010 is the Molecular Formula of Arsenic oxide. its Molecular Weight is 459.68.
hope its help you
have a great day keep smiling be happy stay safe.
How could a scientist use a sedimentary rock to provide evidence that the right k cycle is a valid scientific model
Answer:
By closely observing the sedimentary rock and the presence of organic materials and mineral grains in sedimentary rocks
Explanation:
The rock cycle explains how the three types of rock are formed over time from each other.
To use a sedimentary rock to prove that the rock cycle is a valid scientific model is by, closely observing the sedimentary rock. when the sedimentary rock is closed observed the principle of superposition will be seen ( i.e. younger segments deposited on top ), the presence of organic materials and mineral grains that can be found in Igneous or Metamorphic rocks can also be seen and this shows that Sedimentary rocks pass through the rock cycle. hence this proves that the rock cycle is a valid scientific model overtime
Oleic acid's melting point is 14°C and it's boiling point is 360°С. What phase is this substance
at room temperature 25°C?*
A. Solid
B. Liquid
C. Gas
D. Impossible to tell
Two tons of water is pumped into a tank 15 ft. High in 5 minutes. Determine the power output of the pump. (Note: One ton is equal to 2,000 lb. And remember to convert the minutes to seconds.)
Answer:
200 lb•ft/s
Explanation:
From the question given above, the following data were obtained:
Force (F) = 2 tons
Time (t) = 5 mins
Height (h) = 15 ft
Power (P) =?
Next, we shall convert 2 tons to pound. This can be obtained as follow:
1 ton = 2000 lb
Therefore,
2 tons = 2 × 2000
2 tons = 4000 lb
Next, we shall convert 5 mins to seconds. This can be obtained as follow:
1 min = 60 s
Therefore,
5 mins = 5 × 60
5 mins = 300 s
Finally, we shall determine the power of the pump. This can be obtained as follow:
Force (F) = 4000 lb
Time (t) = 300 s
Height (h) = 15 ft
Power (P) =?
P = F × h / t
P = 4000 × 15 / 300
P = 60000 / 300
P = 200 lb•ft/s
Thus, the power of the pump is 200 lb•ft/s
Answer:
It's 200 ft-lb/sec
Explanation:
I did it before!
25.2 g of CuSO4 6H20 (mm: 267.72 g/mol) is dissolved in 28.0 mL of water, calculate the molarity.
Answer:
3.36 M
Explanation:
Step 1: Given data
Mass of CuSO₄.6H₂O (m): 25.2 gMolar mass of CuSO₄.6H₂O (M): 267.72 g/molVolume of solution (V): 28.0 mL (we will assume it is equal to the volume of water)Step 2: Calculate the moles (n) of CuSO₄.6H₂O (solute)
We will use the following expression.
n = m/M
n = 25.2 g / (267.72 g/mol) = 0.0941 mol
Step 3: Calculate the molarity
Molarity is equal to the moles of solute divided by the liters of solution.
M = 0.0941 mol/0.0280 L = 3.36 M
. Chalk is made of CaCO 3 . How many molecules are in 5 grams of chalk?
Answer:
20.02 grams of chalk.
Explanation:
How is a calorimeter used in this experiment different from the ones used to find the energy content of a snack
Answer:
Kindly check the explanation section.
Explanation:
PS: Note that enough information are not being provided and we do not know the experiment this question is all about. However, some information are provided below which is going to aid in solving when you get access to the main question.
The determination of the heat transferred from one substance to another is one of the important aspect in science. The method in which this heat is being measured is known as calorimetry and the instrument used in this technique is known as the calorimeter.
When the energy content of a snack is needed to be calculated, there is the need use a type of instrument known as bomb calorimeter.
Most of the calorimeters used by students are not so expensive like the used in the industries. Most of these calorimeters operates at a constant pressure while the Bomb Calorimeter operates at constant volume.
What is needed for our cells to get energy from our food?
Answer:
cellular respiration is needed for our cells to get energy from our food.
Explanation:
Through the process of cellular respiration, the energy in food is converted into energy that can be used by the body's cells. During cellular respiration, glucose and oxygen are converted into carbon dioxide and water, and the energy is transferred to ATP.
More bushes of potatoes will be produced if the soil is fertilized more WHAT IS THE INDEPENDENT VAIRABLE AND THE DEPENDENT VARIABLE
Answer:
The dependent variable is the bushes of potatoes while the soil is an independent variable.
Explanation:
An experiment can be defined as an investigation which typically involves the process of manipulating an independent variable (the cause) in order to be able to determine or measure the dependent variable (the effect).
This ultimately implies that, an experiment can be used by scientists to show or demonstrate how a condition causes or gives rise to another i.e cause and effect, influence, behavior, etc in a sample.
Cause and effect can be defined as the relationship between two things or events in which an occurrence one (cause) leads to the occurrence of another (effect).
In an experiment , the variable being manipulated by an experimenter is known as an independent variable while the dependent variable is the event expected to change when the independent variable is manipulated.
Hence, the dependent variable is the bushes of potatoes while the soil is an independent variable.
Definition of fluid friction
Answer:
Fluid friction describes the friction between layers of a viscous fluid that are moving relative to each other
Hope it helps
Please mark me as the brainliest
Thank you
Gold can be pounded out to make a foil only a few atoms thick because of
A. Metallic Bonds
B. Ionic Bonds
C. Valence Bonds
D. Covalent Bonds
Answer:
A. Metallic Bonds
Explanation:
Metallic bonding is a type of chemical bonding that arises from the electrostatic attractive force between conduction electrons and positively charged metal ions.
Where are organelle located
Answer:
organelle are located in da cytoplasm of eukaryotic and prokaryotic cells
Hope this helps!
The majority of Earth's energy comes from.
1) Deep ocean vents
2) Zone
3) Volcanoes
4) The sun
Question 1
Calculate the pressure in a 12 Liter tank containing 2.52 moles of argon gas at 5°C?
a 8.2 atm
b 2.4 atm
с 0.3 atm
d 5 atm
PLEASE HELP
Answer:
D
Explanation:
People should be more concerned about the global water budget than the local water budget.
True
Or false
How many atoms are in 25.0 moles of calcium (Ca)?
Answer:
1.8066e+24 is the answer
what is the pH when h+=0.045 M?
Answer:
pH≈1.35
Explanation:
-log(0.045)≈1.35
C + O2 + CO2
What type of reaction occurs when carbon dioxide is formed from carbon and oxygen?
Answer:
combustion reaction.Explanation:
It is a combination reaction as carbon combines with oxygen to form carbon dioxide. It is a combustion reaction as carbon is burnt in the presence of oxygen.
If you had 14.5 moles of gold, how many atoms would you expect to have?
Answer:
(14.5 mol) x (6.022 x 10^23 atoms/mol) = 8.73 × 10^24 atoms
Explanation:
pls mark brainliest
When converting from grams to the must be used as a conversion factor
what is the advantage of rusting
Answer:
Provide more strength
Explanation:
Rust is metal that has been oxidised . Oxides are usually more fragile and porous than their crystals metal equivalents. Some oxides, such as Aluminum oxide, are useful because they have a thin, strong shell that protects the metal from further corrosion.