Answer:
The iupac name of CH3-O-CH2-CH2-CH3 is Methoxybutane.
Balance this chemical equation
Ca(OH)2 + HCl ---> CaCl2 + H2O
Answer:
The balance equation of Ca(OH)2 + HCl ---> CaCl2 + H2O
is
Ca(OH)2(s) + 2HCl(aq) ---> CaCl2(aq) +2H2O (l) (balanced equation)
How many moles of Chromium(III) nitrate (Cr(NO3)3) are produced when Chromium reacts with 0.85 moles of Lead(IV) nitrate (Pb(NO3)4) to produce chromium(III) nitrate (Cr(NO3)3) and lead? 4 Cr + 3 Pb(NO3)4 → 4 Cr(NO3)3 + 3 Pb
Answer:
[tex]0.64molCr(NO_3)_3[/tex]
Explanation:
Hello there!
In this case, according to the given chemical equation, it turns out possible for us to realize there is a 4:3 mole ratio of chromium(III) nitrate to lead(IV) nitrate, and therefore, we can calculate the moles of the former by applying the shown below stoichiometry setup:
[tex]0.85molPb(NO_3)_4*\frac{3molCr(NO_3)_3}{4molPb(NO_3)_4} \\\\0.64molCr(NO_3)_3[/tex]
Regards!
The movement of water from an area of high concentration to one of low concentration through a semipermeable membrane is called ?
0.444 mol C2H5OH= how many molecules
Explanation:
hope it make sense to u :)
based on the graph below, which statement
Answer:
4. Atmospheric pressure decreases as altitude increases.
Explanation:
hope this helps and is right. p.s i really need brainliest :)
what is acid? Explain it
Answer:
An acid is a chemical that is posining or sometimes not
Explanation:
This is the best I could explain brainliest
Study the particle below carefully and answer
the questions that followed.
a)ldentify the particle.
b)Write the electronic configuration of the
particle.
c)State
i.Atomic number
ii.Mass number
iii.Proton number
iv.Electron number
d) Calculate the neutron number
e) State the valency
f)What is the valence electrons?
Answer:
b is the answer hope that helps
please mark all that apply!
Answer:
F G there you go the guy on top is right
Explanation:
F G
Which of the following is a correct statement about water? (3 points)
Hydrogen bonding causes water to be strongly cohesive.
Hydrogen bonding causes water to have a low surface tension.
Water is a universal solvent because polar and nonpolar solutes can dissolve in it.
Water is less dense as a liquid than as a solid because of changes in bond structure.
Answer:
A: Hydrogen bonding causes water to be strongly cohesive.
Explanation:
Water has a high surafce tension. Hence droplets of water
Water cannot dissolve non polar substances like oil; only polar
Water is actually less dense in solid form :)
Hydrogen bonding causes water to be strongly cohesive.
This sticking together of like substances is called cohesion. Depending on how attracted molecules of the same substance are to one another, the substance will be more or less cohesive. Hydrogen bonds cause water to be exceptionally attracted to each other. Therefore, water is very cohesive.
Cohesion
Cohesion, also called cohesive attraction or cohesive force, is the action or property of like molecules sticking together, being mutually attractive. It is an intrinsic property of a substance that is caused by the shape and structure of its molecules, which makes the distribution of surrounding electrons irregular when molecules get close to one another, creating an electrical attraction that can maintain a microscopic structure such as a water drop. In other words, cohesion allows for surface tension, creating a "solid-like" state upon which light-weight or low-density materials can be placed.
Learn more about Cohesion
https://brainly.com/question/18176896
#SPJ2
To determine the molar mass of an element, one must know the element's
a. number of isotopes.
b average atomic mass
c avogradro constant
d atomic number
Answer:
d
Explanation:
from you know the atomic number it should be easy to find
To determine the molar mass of an element, one must know the element's atomic number. Therefore, option D is correct.
What is the atomic number ?An element's atomic number (Z) is the number of protons in the nucleus of each atom of that element. This means that the number of protons is the feature that distinguishes each element from all others. Elements differ based on their atomic number.
Because the combined masses of protons and neutrons account for nearly all the mass of a given atom, the atomic mass of a single atom can be calculated by adding the total number of protons and neutrons of that particular isotope.
The atomic mass of any element on the periodic table can be used to calculate its molar mass.
Thus, option D is correct.
To learn more about an atomic number, follow the link;
https://brainly.com/question/16858932
#SPJ6
The reaction of an acid and a base will always produce what kind of salt?
A.
a combination of the cation from the acid and the anion from the base
B.
a combination of the cation from a strong base and the anion from a weak acid
C.
neutral salts from the cation of a strong base and the anion from a weak acid
D.
basic salts from the cation of a strong base and a strong acid
E.
depends on the strength of the acid and the base
Explanation:
E maybe i am not sure or C
The total mass of reactants and products is _______ during a chemical reaction
Answer: The total mass of reactants and products is the same during a chemical reaction.
Explanation:
the total mass of reactants is equal to the total mass of products.
What is the correct name for the chemical formula N408?
Answer:
molar mass (molar weight)
Explanation:
21.) This substance consists of two or more nonmetal elements in a fixed ratio.
a.) element
b.) mixture
c.) molecule
d.) compound
Answer:
Molecule
Explanation:
when two or more than two non-metal elements are combined then it form Molecule.
6 a 100 sample of Au - 198 Au 198 be? Decays to 3.125 g in 13.5 days, what would the half-life of au198 be?
Answer:
Half-life = 2.7 days
Explanation:
The radioactive decay of an isotope follows the equation:
Ln[A] = -kt + ln[A]₀
Where [A] could be taken as the amount of A after t time, k is decay constant, [A]₀ initial amount of A.
Replacing to solve k:
Ln[3.125g] = -k*13.5days + ln[100g]
-3.465736 = -k*13.5days
k = 0.2567days⁻¹
Half-life is:
half-life = ln2 / k
Half-life = 2.7 days
Polar bears are adapted to stay warm by growing thick fur. These organisms most likely live in a what
Answer:
They live in the open snow
Explanation:
How many grams of water are produced when 12.50 mol oxygen reacts with hydrogen?
Answer: According to reaction below, when one mol of oxygen reacts with two mol of hydrogen, two mol of water is produced. Thus, when 2.5 mol of oxygen reacted with hydrogen, 2 * 2.5 mol = 5 mol of water is produced. The molar mass of water is 18 g/mol.
Explanation:
Not My WORK! I got this info from another site. BUT I HOPE IT HELPS :)
you can test carbon dioxide gas with
Answer:
you can test carbon dioxide gas with calcium hydroxide
hope this is what you're looking for
stay safe and have a nice day
✌◕ ◡ ◕✌
4. There are 1.9 moles of Oxygen gas at a pressure of 3.50 atm, and the temperature is 65°C. What is the
volume of the gas? Remember that R = 0.0821 L x atm/Kx mol AND that you must convert °C to K.
Fill in the variables chart:
Answer:
15.06 L
Explanation:
Using the ideal gas law equation:
PV = nRT
Where;
P = pressure (atm)
V = volume (L)
n = number of moles (mol)
R = gas law constant (0.0821 Latm/molK)
T = temperature (K)
According to the information provided in this question,
P = 3.50 atm
n = 1.9 moles
V = ?
T = 65°C = 65 + 273 = 338K
Using PV = nRT
V = nRT/P
V = (1.9 × 0.0821 × 338) ÷ (3.5)
V = 52.725 ÷ 3.5
V = 15.06 L
Which equation correctly represents the dissociation of a strong acid in water?
Question 26 options:
CH3COOH ↔H++ CH3COO−
NaOH →Na++OH−
HCl →H+ +Cl−
NH3+ H2O↔ NH4++ OH−
The equation that correctly represents the dissociation of a strong acid in water is as follows: HCl → H+ + Cl−
What is acid dissociation?Acid dissociation is the process by which an acid breaks up into it's constituent ions in an aqueous solution.
Acids are known to contain hydrogen ions (H+), hence, dissociate into H+ and an anion.
A strong acid like HCl dissociates completely in an aqueous solution while a weak acid does not dissociate completely.
According to this question, hydrogen chloride (HCl) is said to dissociate into hydrogen ion (H+) and chloride (Cl-) according to the following expression:
HCl → H+ + Cl−
Learn more about acid dissociation at: https://brainly.com/question/4363472
#SPJ1
What is the pOH of a solution of pH 3 acid? (Kw= 1.0 x 10-14)
Answer:
pOH = 11
Explanation:
The pH is an unit of concentration widely used in chemistry to find the quality of a solution.
To solve this question we must, as first, find the [H+] using the pH:
[H+] = 10^-pH
[H+] = 10^-3
Now, using kw:
kw = 1.0x10-14 = [H+] [OH-]
1.0x10-14 = [10^-3] [OH-]
[OH-] = 1.0x10-11
pOH = -log [OH-]
pOH = 1190 grams of NaNO3 were added to solution at 10 degrees Celsius. What type of solution was formed?
Answer:
friend me on here and imma send you the link Explanation:
Tritium (hydrogen-3) has a half-life of 12.3 years. How old is a bottle of wine if the tritium content is determined to be 25% in new bottle of wine
Answer:
24.6 years
Explanation:
Applying,
A = (A')[tex]2^{a/n}[/tex]..................... Equation 1
Where A = Original Tritium content in the wine, A' = Tritium content in the wine after decay, a = age of the old bottle, n = half life of Tritium
From the question,
Let A = X, therefore, A' = 0.25X
Given: n = 12.3 years
Substitute these values into equation 1
X = 0.25X([tex]2^{a/n}[/tex])
1 = 0.25×([tex]2^{a/12.3}[/tex])
1/0.25 =
4 = [tex]2^{a/12.3}[/tex]
[tex]2^{a/12.3}[/tex] = 2²
Equation the base,
a/12.3 = 2
a = 12.3×2
a = 24.6 years
Which process is represented by the label a?
Answer:
Sediment to sedimentary rock (and vice versa) is Compactation and Cementation.
Explanation:
This happens via Lithification, which is the compacting of sediments under pressure.
How GM food are produced?
What is genetic modification (GM) of crops and how is it done? GM is a technology that involves inserting DNA into the genome of an organism. To produce a GM plant, new DNA is transferred into plant cells. Usually, the cells are then grown in tissue culture where they develop into plants.
Answer:
GM is a technology that involves inserting DNA into the genome of an organism. To produce a GM plant, new DNA is transferred into plant cells. Usually, the cells are then grown in tissue culture where they develop into plants. The seeds produced by these plants will inherit the new DNA.
Phenolphthalein meaning
Answer:
Phenolphthalein is a chemical compound with the formula C20H14O4 and is often written as "HIn" or "phph" in shorthand notation. Phenolphthalein is often used as an indicator in acid–base titrations. For this application, it turns colorless in acidic solutions and pink in basic solutions.
Answer:
Phenolphthalein is a chemical compound, a colorless crystalline solid, though pink in a alkaline solution, and is also used as an acid-base indicator.
Explanation:
Does the excess reactant get used up completely in a reaction??
Answer:
In a chemical reaction, reactants that are not used up when the reaction is finished are called excess reagents. The reagent that is completely used up or reacted is called the limiting reagent, because its quantity limits the amount of products formed.
Explanation:
Which of the following phase changes describes what is
happening in the following endothermic process?
H20 (1) + heat --> H2O (g)
O melting
o freezing
o boiling
O condensing
Answer:
I think the answer is boiling
3. Which model has properties most similar to chlorine?
Model A
Model B
Model C
Model D
Answer:
bnsjsbbakakaisbsbwnsjznss
Explanation:
cnsjzjsnsnsjs ssnsnsnzksmnznnzna
If a piece of pure gold jewelers weighs 11.81 grams, how many atoms is it made of?
Answer:30.573 Billion atoms are in one gram
Explanation: