Answer:
unbalanced and contact
Explanation:
The two terms that bests describes the net force acting on the sled is an unbalanced and contact force.
Force is a pull or push on a body. We have two main types of forces. Contact forces acts on a body and they must be in touch with it. An example is frictional force.
Non - contact forces acts based on force field and they are not in contact with the body. An example is gravitational force.
Since the sled is sliding down the road, it is changing velocity and so, unbalanced forces are acting on it.Therefore, the force on the wagon is an unbalanced and contact force.
Please select the word from the list that best fits the definition
Wave that has vibration in a direction that is perpendicular to the motion creating it
transverse wave
longitudinal wave
mechanical wave
Answer:
Transverse wave
Explanation:
A supply plane drops a package to the ground for stranded campers below. After falling for 8.14 seconds, the package will have a downward velocity of 80.79 m/s. How high was the plane when it dropped the package?
Answer:
333 m
Explanation:
The following data were obtained from the question:
Initial velocity (u) = 0 m/s.
Time (t) = 8.14 s.
Final velocity (v) = 80.79 m/s.
Acceleration due to gravity (g) = 9.8 m/s²
Height (h) =?
v² = u² + 2gh
80.79² = 0 + (2 × 9.8 × h)
6527.0241 = 0 + 19.6h
6527.0241 = 19.6h
Divide both side by 19.6
h = 6527.0241 / 19.6
h = 333 m
Thus, the plane was at a height of 333 m when the package was dropped.
D. Ampere
A screw of length 5 cm enters totally into a wooden block after 25 turns. What is the pitch of the
screw?
A. 0.1 cm
B. 0.2 cm
C. 0.4 cm
D. 0.5 cm
Answer:
0.5
Explanation:
u must simplyfiy
a car travels 200km in 3.0 hours. Determine the average velocity of the car
Answer:
66.67 km/hrExplanation:
The average velocity of the car can be found by using the formula
[tex]a = \frac{d}{t } \\ [/tex]
d is the distance
t is the time taken
From the question we have
[tex]a = \frac{200}{3} \\ = 66.66666...[/tex]
We have the final answer as
66.67 km/hrHope this helps you
Write two forms of mechanical energy
A phase diagram assumes______
is kept constant.
Odensity
O volume
O temperature
O pressure
When a person strikes and lights a match, potential energy in the match is transformed into which types of energy?
electrical and thermal
thermal and radiant
radiant and nuclear
nuclear and kinetic
hurry brainliest ill give 49 points
Answer:
Radiant and thermal
Explanation:
Electrical and thermal don't make sense because you are not using electricity to light the match. Radiant and nuclear is not right because you are not using nuclear energy to light the match. Nuclear and kinetic isn't right because you are using kinetic and you are not using nuclear energy.
Answer:
answer is B. thermal and radiant
Explanation:
just got it right on edge
Who might be suffering from dissociative fugue?
Answer:
More common in adults.
Explanation:
Identify the type of motion that occurs when a body moves around its own center of mass.
circular
revolution
rotation
resolution
Answer:
circular
Explanation:
What do we know about the relative strength of the electric field around each object?
Answer:
A charged object in an electric field experiences a force due to the field. The electric field strength, E, at a point in the field is defined as the force per unit charge on a positive test charge placed at that point.
Explanation:
Find the displacement of the object moving at v= -2 m/s for t=5s
Answer:
d = - 10 [m]
Explanation:
We must remember that speed is defined as the relationship between the displacement in a given time. In this way, we can propose the following equation.
[tex]v = d/t[/tex]
where:
v = velocity = 2 [m/s]
d = displacement [m]
t = time = 5 [s]
Now replacing:
[tex]d=-5*2\\d=-10[m][/tex]
Any one their to help
A popular ride at an amusment park lifts
customers up to a height of 50 m and then
drops them threw a displacement of 50 m
before slowing them to a stop. How fast
are the customers going at the 50 m
mark?
Answer:
five dollars
Explanation:
im thick lol
Particles in which state of matter are the most likely to interact with each other to cause a chemical reaction?
why are incandescent lights fo inefficient?
Answer:
Explanation:
Incandescent bulbs are extremely inefficient because 90% of the energy is wasted as heat, with only 10% being converted to visible light. This gives incandescent bulbs a luminous efficiency rating of around 2%. Ultimately, incandescent bulbs perform better as heaters than as light sources.
hand pushes on table with force of 35 N forward. whats the reaction force
Answer:
i think it is newtons third law of motion but i'm not sure sorry.i just really need point i don't know the answer.
Explanation:
A 20 kg mass is hanging on one side of a pulley and a 5 kg mass is hanging on the other. Determine the acceleration of each mass.
Answer:
i believe it's 7
Explanation:
41. What effects the efficiency of a pulley?
a. the type of rope or cable
b. the way the wheel turns
c. the length of the rope
d. how big the wheel is
e. only a and be
f. all of the above
Answer:
e. only a and b
What is the density of an object with a mass of 20 grams and a volume of 5 cm?
Answer:
4
Explanation:
Divide mass(m) by volume(v), you get density(D)
m/v=D
20/5=4
1. Four identical elephants are at different heights. If your physics teacher
asked you which of the following elephants has the greatest amount of
potential energy, what will be your answer? And why?
Helpppp:(((((
Question 1 of 25
A bookcase has a mass of 37 kg. What is the weight of the bookcase?
Help please
answers
81.6 pounds rounded or just 81.571 if it needs to be exact
a 50.0kg skydiver experience a 740newton air resistance force determine her acceleration please help asap
Answer:
a = - 5 [m/s²].
Explanation:
To solve this problem we must use Newton's second law, which tells us that the sum of forces on a body is equal to the product of mass by acceleration.
∑F = m*a
where:
F = resultant force [N] (units of Newtons)
m = mass = 50 [kg]
a = acceleration = 9.81 [m/s²]
For this particular problem, the only forces acting are the force of gravity acting down with negative sign, while the force of air opposes the fall, in this way it is positive.
[tex]f_{air}-F_{grav}=-m*a[/tex]
As the movement is pointing down the acceleration will be taken as negative.
[tex]740-(50*9.81)=-50*a\\740-490.5 = -50*a\\249.5 = -50*a\\a = - 5 [m/s^{2} ][/tex]
We should note that in this case, the acceleration has a negative sign, this means that the force of the air makes the skydiver move upwards
Plz di all plz i will give brainest and thanks to best answer do it right
Answer:
B
hdhdududydysgd
hdhdgdtdtdt
gsgdgdggd
Explanation:
I TIHNK IS THE ANSWER
Answer:
C
Explanation:
Wave length is - - - - >
Bsjejwakknsbsbehebebbdbdbs
A fireboat is to fight fires at coastal areas by drawing seawater with a density of 1030 kg/m3 through a 10-cm-diameter pipe at a rate of 0.04 m3/s and discharging it through a hose nozzle with an exit diameter of 5 cm. The total irreversible head loss of the system is 3 m, and the position of the nozzle is 3 m above sea level. For a pump efficiency of 70 percent, determine the required shaft power input to the pump and the water discharge velocity.
Answer:
50.93 m/s
199.5 kW
Explanation:
From the question, the nozzle exit diameter = 5 cm, Radius= diameter/2= 5cm/2= 2.5cm. we can convert it to metre for unit consistency= (2.5×0.01)=
0.025m
We can calculate the The cross sectional area of the nozzle as
A= πr^2
A= π ×0.025^2
= 1.9635 ×10^- ³ m²
From the question, the water is moving through the pipe at a rate of 0.1 m /s , then for the water to move through it at a seconds, it must move at
(0.1 / 1.9635 ×10^- ³ m²)
= 50.93 m/s
During the Operation of the pump, the Dynamic energy of the water= potential energy provided there is no loss during the Operation
mgh = 1/2mv²
We can make "h" subject of the formula, which is the height of required head of water
h = (1/2mv²)/mg
h= v² / 2g
h = 50.93² / (2 ×9.81)
h = 132.21m
From the question;
The total irreversible head loss of the system = 3 m,
the given position of nozzle = 3 m
the total head the pump needed=(The total irreversible head loss of the system + the position of the nozzle + required head of water )
=(3 + 3 + 132.21m)
=138.21m
mass of water pumped in a seconds can be calculated since we know that mass is a product of volume and density
Volume= 0.1m³
Density of sea water=1030 kg/m
(0.1 m^3× 1030)
= 103kg
We can calculate the Potential enegry, which is = mgh
= (103 ×9.81 × 138.21)
= 139651.5 Watts
= 139.65kW
To determine required shaft power input to the pump and the water discharge velocity
Energy= efficiency × power
But we are given efficiency of 70 percent, then
139651.5 Watts = 0.7P
=199502.18 Watts
P=199.5 kW
Therefore, the required shaft power input to the pump and the water discharge velocity is 199.5 kW
12. How many grams of beryllium are needed to produce 36.0 g of hydrogen? (Assume an excess of water.)
Be(s) + 2H, O() → Be(OH)2 (aq) +H,(g)
a
4.00 g
b. 36.0 g
c. 162 g
d 324 g
Answer:
Answer is: 162 g of beryllium.
Chemical reaction: Be + 2H₂O → Be(OH)₂ + H₂.
m(H₂) = 36,0 g.
m(Be) = ?
n(H₂) = m(H₂) ÷ M(H₂)
n(H₂) = 36,0 g ÷ 2 g/mol = 18 mol.
from reaction: n(Be) : n(H₂) = 1 : 1.
n(Be) = n(H₂) = 18 mol.
m(Be) = n(Be) · M(Be).
n(Be) = 18 mol · 9 g/mol = 162 g.
Answer:
Answer is: 162 g of beryllium.
Chemical reaction: Be + 2H₂O → Be(OH)₂ + H₂.
m(H₂) = 36,0 g.
m(Be) = ?
n(H₂) = m(H₂) ÷ M(H₂)
n(H₂) = 36,0 g ÷ 2 g/mol = 18 mol.
from reaction: n(Be) : n(H₂) = 1 : 1.
n(Be) = n(H₂) = 18 mol.
m(Be) = n(Be) · M(Be).
n(Be) = 18 mol · 9 g/mol = 162 g.
These the flow of electrons (the current) and where some of the electrons' energy gets converted into heat. (Lessons 5.01-5.03) electric currents Insulators Resistors Conductors
Answer: The answer is resistors
Explanation: I just took the unit test and it was correct
This image shows flashlight beams reflecting off a mirror from
different angles. Based on the angles of reflection, choose all pairs of
light rays that correctly match incoming light beams with their
reflected light beams,
Question 2. Based on the image and the angles of reflection shown witch statement is true.
A) When a light ray strikes a mirror, it randomly scattered.
B) light is absorbed by mirrors and reflected directly upwards.
C) light travels in a straight line until lit strikes an object
D) light is reflected back to its source when it strikes an object
Hey I'm working on this test right now, did you ever get the answers?
Keith has been using a software application for a year on his home computer. A new version of the application was recently released. Keith’s license has a term of two years and entitles Keith to upgrade his application to a new version within the term. What type of license does the application have?
Answer:
d license with maintenance .
Explanation:
just took this test. :)
A 35kg cannonball sits at rest on a flat level surface. What is the normal force exerted on the cannon ball. Use -9.8 m/s2 for acceleration due to gravity.
A. -343N
B. 44.8N
C. 25.2N
D. 343N
Answer:
a) N = 343 [N]
Explanation:
We must remember Newton's third law, which tells us that the force acting on a body is equal to the normal reaction force of equal magnitude but acting in the opposite direction.
[tex]N=m*g[/tex]
where:
m = mass = 35 [kg]
g = gravity acceleration = 9.81 [m/s²]
[tex]N = 35*9.8\\N= 343 [N][/tex]
In interactions of action-reaction pairs involving Earth and everyday objects, the effect on Earth's motion is often negligible because
Answer:
...The earth has a great mass. Since mass and inertia are directly proportional to each other, the larger the mass of the object, the more inertia that it has. Inertia is the objects resistance to a change in motion.
Explanation:
What two things does force depend on
Answer:
When dealing with the force of gravity between two objects, there are only two things that are important – mass, and distance or (acceleration)
Explanation: