Answers
Answer:
The resultant moment is 477.84 N·m
Explanation:
We note that the resultant moment is given by the moment about a given point
The length of the sides of the formed triangles are;
l = sin(40°) × 4/sin(110°) ≈ 2.736
Taking the moment about the lower left hand corner of the figure, with the convention that clockwise moments are positive, we have;
The resultant moment, ∑m, is given as follow;
∑M = 250 N × 4 m + 400 N × cos(40°) × 4 m - 400 N × cos(40°) × 2 m + 400 N × sin(40°) × 2 m × tan(40°) - 600 N × cos(40°) × 2 m - 600 N× sin(40°) × 2 m × tan(40°) = 477.837084 N·m
Therefore, the resultant moment, ∑m ≈ 477.84 N·m clockwise.
Related Questions
It is usually most slippery ___ of rain fall
Answers
Answer:
A.) At the start
Explanation:
Roads are most slippery at the beginning of rain storms due to oil and dirt from traffic. By the end of a rain storm, the oil and dirt are more likely to have been washed off the roadway. Additionally, rain is not the only factor that can contribute to slippery roadways - and not even the most dangerous. Ice is even slipperier.
Please help ASAP!!
Which of these substances is the most flammable?
A) nitrogen
B) sulfur dioxide
C) butane
D) nitric oxide
E) silica
Answers
Answer:
Butane
Explanation:
Its very simple, this subtance is highly flammable, its a easily liquefied gas that vaporizes at room temperature.
What do you think of this schematic diagram?
Answers
Explanation:
A schematic diagram is a picture that represents the components of a process, device, or other object using abstract, often standardized symbols and lines. ... Schematic diagrams do not include details that are not necessary for comprehending the information that the diagram was intended to convey.
Determine the design stress for bolts in a cylinder cover where the load is fluctuating due to gas pressure. The maximum load on the bolt is 50 kN and the minimum is 30 kN. The load is unpredictable and factor of safety is 3. The surface of the bolt is hot rolled and the surface finish factor is 0.9. During a simple tension test and rotating beam test on ductile materials (40 C 8 steel annealed), the following results were obtained : Diameter of specimen = 12.5 mm; Yield strength = 240 MPa; Ultimate strength = 450 MPa; Endurance limit = 180 MPa
Answers
Sorry I'm new and need points ty