Heat that flows by conduction is the transfer of thermal energy between substances in contact. What must occur for this to happen? TA B Block A has a higher temperature than block B heat flow The two blocks are the same temperature and heat flow stops Heatis transferred from the wamer block to the cooler block 2012 Encyclopædia Batannlea, Inc. B B heat flow ​

Answer:

2.5 meter per second

Explanation:

momentum = mass multiplied by velocity

please mark me brainliest

Answer:

C) the wave is interfered with

Answer:

A line that is drawn vertically down the earth but is not parallel to the prime Meridian.

Explanation:

A line that is drawn vertically down the earth but is NOT parallel to the Prime Meridian, best describes the meridian of longitude.

Prime Meridian is an imaginary line which divides the earth into eastern and western hemispheres

Meridian of longitude is an imaginary semicircle that runs from north to south direction and joins the two poles. All meridians are of the same length and meet at the poles.

Hence, option 3 is the answer.

To learn more about Prime Meridian and meridian of longitude here

https://brainly.com/question/20020992

#SPJ2

Answer:

There are 5.69*10²⁴ molecules in 9.45 moles.

Explanation:

The mole is defined as the amount of matter that particles have, that is, atoms and elementary entities.

Avogadro's Number or Avogadro's Constant is called the number of particles that make up a substance (usually atoms or molecules) and that can be found in the amount of one mole of said substance. Its value is 6.023*10²³ particles per mole and represents a quantity without an associated physical dimension. Avogadro's number applies to any substance.

Then the following rule of three can be applied: if 1 mole contains 6.023 * 10²³ molecules, 9.45 moles, how many molecules will it have?

[tex]amount of molecules=\frac{9.45 moles*6.023*10^{23}molecules }{1 mole}[/tex]

Solving:

amount of molecules= 5.69*10²⁴⁴ molecules

There are 5.69*10²⁴ molecules in 9.45 moles.

Answer:

Average atomic mass of uranium = 237.97 amu

Explanation:

Given data:

Abundance of U-234 = 0.01%

Abundance of U-235 = 0.71%

Abundance of U-238 = 99.28%

Average atomic mass of uranium = ?

Solution:

Average atomic mass  = (abundance of 1st isotope × its atomic mass) +(abundance of 2nd isotope × its atomic mass) + (abundance of 3rd isotope × its atomic mass)  / 100

Average atomic mass  = (234×0.01)+(235×0.71)+(238+99.28) /100

Average atomic mass =  2.34 + 166.85+23628.64 / 100

Average atomic mass = 23797.83 / 100

Average atomic mass = 237.97 amu.

Answer:

Ring is made up off copper.

Explanation:

Given data:

Mass of ring = 89.2 g

Volume of water = 10 mL

Volume of water + ring = 20 mL

Ring is made up of = ?

Solution:

Volume of ring = (Volume of water + ring) - Volume of water

Volume of ring = 20 mL - 10 mL

Volume of ring = 10 mL

Density:

Density = mass/volume     ( 1 mL = 1 cm³)

d = 89.2 g/  10cm³

d = 8.92 g/cm³

Thus, ring is made up off copper.

Answer:

3.193 mol

Explanation:

The reaction is

[tex]N_2+3H_2\rightarrow 2NH_3[/tex]

We use the stoichiometry in order to find the moles of nitrogen required.

[tex]9.58\ \text{mol of }NH_3\times \dfrac{1\ \text{mol of }N_2}{2\ \text{mol of }NH_3}[/tex]

[tex]=3.193\ \text{mol of }N_1[/tex]

The amount of nitrogen required is 3.193 mol to produce 9.58 mol of ammonia.

Answer:

30 grams

Explanation:

I got 40 wrong so I picked 30

Answer:

30 grams

Explanation:

I did the ck12

Answer:

viruses can kill you vaccines can save your life.

Explanation:

Answer:

The effect of leaky vaccines on how disease spreads is explained by the “imperfect-vaccine hypothesis”. It holds that, without vaccination, a very virulent virus can get into a population and kill infected hosts (people or animals) very quickly – before they have a chance to spread it. This means that the virus will die out very quickly too, as all potential hosts will be dead or immune to it.

Explanation:

Answer:

99.3%

Explanation:

The percent by mass of the solute can be expressed as:

And for this problem:

So to calculate the percent by mass first we need to calculate the mass of water, to do so we use its density (1 g/L):

Density water = mass water / volume

Now we have all the data required to calculate the % mass:

Answer: 14.3

Explanation:

Answer: Hydrogen, Nitrogen, Flourine, Oxygen, Iodine, Chlorine and Bromine

Explanation:

Answer:

Carbon dioxide or co^2

Explanation:

Answer:

3.37 × 10²³ molecules

Explanation:

Given data:

Mass of C₆H₁₂O₆ = 100 g

Number of molecules = ?

Solution:

Number of moles of C₆H₁₂O₆:

Number of moles = mass/molar mass

Number of moles = 100 g/ 180.16 g/mol

Number of moles = 0.56 mol

Number of molecules:

1 mole contain 6.022 × 10²³ molecules

0.56 mol × 6.022 × 10²³ molecules /1 mol

3.37 × 10²³ molecules

Answer:

Light and heat

ur welcomeeeeeeee

Answer:

Light and Heat

Give the other guy brainiest

Explanation:

Thx for the point though

Answer:

the answer should be c.

Explanation:

Answer:

In CH4 bond angle is 109.5 but it is slightly less than 109.5 in SF2 both compounds have same hybridization SP3 but bond angle of SF2 is less due to presence of two lone pairs

Explanation:

Answer:

12 number of moles of carbon dioxide are used.

Explanation:

Given data:

Number of moles of oxygen produced = 12 mol

Number of moles of CO₂ used = ?

Solution:

Chemical equation:

6CO₂ + 6H₂O      →     C₆H₁₂O₆ + 6O₂

Now we will compare the moles of oxygen with carbon dioxide.

                     O₂            :          CO₂

                      6             :             6

                    12              :             12

Thus, 12 number of moles of carbon dioxide are used.

Answer:

Nonmetals are further to the right on the periodic table, and have high ionization energies and high electron affinities, so they gain electrons relatively easily, and lose them with difficulty.

Explanation:

They also have a larger number of valence electrons, and are already close to having a complete octet of eight electrons.

Periodic table is divided as metals, non metals, noble gases and semiconductors. Among these nonmetals tend to have high electron affinities because of small size and high effective nuclear charge.

Non metals are the element that have property to gain electron. When any element gain electron then element attain negative charge and that element is called anion.

As we go from left to right in periodic table, the size of element decreases as number of electrons keep on adding electrons in the same shell . As the number of electrons increases, the number of proton in the nucleus also increases. Due to this, the hold of nucleus on the outermost proton increases and the size decreases. Due to this, the ionization energy increases and hence the power to gain electron increases.

Therefore, nonmetals tend to have high electron affinities because of small size and high effective nuclear charge.

To learn more about non metals, here:

https://brainly.com/question/28650063

#SPJ2

Answer: When an atom becomes a positive ion it pulls it's electrons closer, decreasing it's radius moreover, when it becomes a negative ion, it pulls it's electrons closer and decreases the radius

I hope this helps :)

Answer:

covalent bond

Explanation:

hope this helps :D

Mass of water needed : 96.3 g

A mole is a number of particles(atoms, molecules, ions)  in a substance

This refers to the atomic total of the 12 gr C-12  which is equal to 6.02.10²³, so 1 mole = 6.02.10²³ particles  

Can be formulated :

N = n x No

N = number of particles

n = mol

No = 6.02.10²³ = Avogadro's number

moles H₂O=

[tex]\tt moles=\dfrac{N}{No}\\\\moles=\dfrac{3.22\times 10^{24}}{6.02\times 10^{23}}\\\\moles=5.35[/tex]

mass H₂O(MW=18 g/mol) :

[tex]\tt mass=moles\times MW\\\\mass=5.35\times 18\\\\mass=96.3~g[/tex]

Answer:

Wouldn't rust because zinc will lose electrons more readily than iron and will therefore oxidize first.

Explanation:

This process whereby rusting of steel is prevented by coating the steel with a layer of zinc is known as galvanization.

Now, in this process, the steel object will be coated in a thin layer of zinc. This coating will prevent oxygen and water from reaching the underneath metal since the zinc will also act as a sacrificial metal.

Now, Zinc is used because it has a lower reduction potential than iron and thus it will get easily more oxidized than iron. Which means the zinc will lose electrons more readily than iron.

Also, since zinc has a lower reduction potential, it is therefore the more active metal. Thus, even if the zinc coating is scratched and the steel is exposed to moist air, the zinc will still get to oxidize before the iron.

Answer:

A. Temperature or Pressure

Explanation:

Answer:

The right response will be "No".

Explanation: