Answer:
Ba(NO2)2
Explanation:
Anything that contains calcium comes from a strong acid. Nitrous oxide (NO2) is a weak acid, therefore the salt it makes is less acidic than the rest --> the highest pH :)
How many grams of Ag2S
are produced from 10.0
grams of AgI?
10
AgI + Nazs
Ag2S +NaI
Answer:
10.0 g of AgI will produce 5.28 g of Ag₂S
Explanation:
The balanced equation of the reaction is given below:
2AgI + Na₂S ----> Ag₂S + 2NaI
From the equation of reaction, 2 moles of AgI produces 1 mole of Ag₂S
The moles of a substance is related to its mass by a quantity known as molar mass which is defined as the mass of one mole of that substance.
Molar mass of AgI = (108 + 127) g = 235 g
Molar mass of Ag₂S = (108 × 2 + 32) g= 248 g
Mass of 2 moles of AgI = 2 × 235 g = 470 g
470 g of AgI produces 248 g of Ag₂S
10 g of AgI will produce 248 /470 × 10 g of Ag₂S = 5.28 g
Therefore, mass of Ag₂S produced = 5.28 g
Organisms that get energy by eating dead organisms are called *
scavengers
omnivores
herbivores
decomposers
Answer:
The Answer is A. Scavengers
Briefly describe each of the suns layers. I’ll give brainless
Answer: The inner layers are the Core, Radiative Zone and Convection Zone.
The outer layers are the Photosphere, the Chromosphere, the Transition Region and the Corona.
Nuclear fusion of hydrogen in the core of the Sun produces tremendous amounts of energy that radiate out from the Sun.
The corona is the outermost layer of the Sun, starting at about 1300 miles (2100 km) above the solar surface (the photosphere). The temperature in the corona is 500,000 K (900,000 degrees F, 500,000 degrees C) or more.
The chromosphere is a layer in the Sun between about 250 miles (400 km) and 1300 miles (2100 km) above the solar surface (the photosphere). The temperature in the chromosphere varies between about 4000 K at the bottom (the so-called temperature minimum) and 8000 K at the top (6700 and 14,000 degrees F, 3700 and 7700 degrees C), so in this layer (and higher layers) it actually gets hotter if you go further away from the Sun, unlike in the lower layers, where it gets hotter if you go closer to the center of the Sun.
The photosphere is the deepest layer of the Sun that we can observe directly. It reaches from the surface visible at the center of the solar disk to about 250 miles (400 km) above that. The temperature in the photosphere varies between about 6500 K at the bottom and 4000 K at the top (11,000 and 6700 degrees F, 6200 and 3700 degrees C)
(phew! There you go!)
Santee Cooper is stocking lakes Marion and Moultrie with 109,000 sterile grass carp. The grass carp, which eat hydrilla (Invasive species), are the most effective and least Intrusive means to control the weed. What type of control are they using?
A Invasive
B biological
C.chemical
D physical
Answer:
biological
Explanation:
i took the test and got it right
How much energy is released when 67.04g of phosphorous is reacted with 10.20g of chlorine? ___ P + ___ Cl2 ___ PCl3 ΔH = -574 kJ
Answer:
26.78 kJ
Explanation:
To solve the problem, we have to first write the stoichiometric coefficients in the chemical equation:
2P + 3Cl₂ → 2PCl₃
With these coefficients, we have the same number of atoms of each chemical element on both sides: 2 atoms of P, 6 atoms of Cl.
According to the equation, 2 moles of phosphorous (P) react with 3 moles of chlorine (Cl₂), and 574 kJ of energy are released. We have to figure out which is the limiting reactant. For this, we convert the mass into moles by using the molar mass(MM):
MM(P) = 30.9 g/mol
67.04 g P/(30.9 g/mol) = 2.17 mol P
MM(Cl₂) = 35.4 g/mol x 2 = 70.8 g/mol
10.20 g Cl₂/(70.8 g/mol) = 0.14 mol Cl₂
Now, we multiply the actual moles of P (the amount we have for the reaction) by the stoichiometric ratio given by the chemical equation (3 mol Cl₂/2 mol P):
2.17 mol P x (3 mol Cl₂/2 mol P) = 3.25 mol Cl₂
To completely react 67.04 g P, we need 3.25 mol of Cl₂, and we have only 0.14 moles of Cl₂, so the limiting reactant is Cl₂.
Now, we use the limiting reactant to calculate the energy released from the reaction. The energy released per mole of Cl₂ is:
ΔH/(3 mol Cl₂) = -574 kJ/3 mol Cl₂= 191.3 kJ/mol Cl₂
Finally, we multiply the energy released per mole of Cl₂ by the number of moles of Cl₂ we have:
0.14 mol Cl₂ x 191.3 kJ/mol Cl₂ = 26.78 kJ
Help!!!
Is KOH soluble or insoluble in water?
Insoluble
Soluble
Answer: yes, it's soluble in water.
What does it mean to be limiting or excess? (Limiting Reactant)
Answer:
Find the limiting reagent by calculating and comparing the amount of product each reactant will produce. Balance the chemical equation for the chemical reaction. The reactant that produces a lesser amount of product is the limiting reagent. The reactant that produces a larger amount of product is the excess reagent.
Explanation:
A wildfire destroys most of the plant life in a forest. What would most likely happen to the animals that lived in the forest?
Answer:
They would be pushed out and lose their homes
Explanation:
A wildfire destroys most of the plant life in a forest. Animals would be pushed out and lose their homes.
What is wildfire?An unplanned, uncontrolled, and unpredictable fire inside an area of flammable vegetation is known by several names, including wildfire, bushfire, bushfire, wildland fire, and rural fire. A wildfire may be more precisely referred to by the terms bushfire, desert fire, forest fire, hill fire, peatland fire, prairie fire, vegetable fire, or veld fire, depending on the kind of vegetation that is present.
Wildfires are separate from controlled and prescribed burning, which is a good human use of wildland fire, even though controlled burns have the potential to turn into wildfires. Wildfires likely started shortly after terrestrial plants first appeared, which occurred in the Silurian epoch 419 million years ago, according to fossil charcoal. A wildfire destroys most of the plant life in a forest. Animals would be pushed out and lose their homes.
Therefore, animals would be pushed out and lose their homes.
To know more about wildfire, here:
https://brainly.com/question/12110285
#SPJ3
I need help with the question below:
[tex]PCl_5 = PCl_3+Cl_2 \\ [/tex]
Where PCl5 and PCl3 are gasses
In the above equation , Predict the effect of change in :
I. Temperature
ii. Pressure
iii. Removal of Chlorine
Answer:
1: As the temperature rises, the equilibrium moves towards the products
2: The higher the pressure, the higher the equilibrium goes to the reactants
3: By removing chlorine, the equilibrium moves towards the products
In a closed system for the reaction: A (g) + 2B (g) → AB₂ (g) The rate of the reaction increases when there is
A) an increase in pressure
B) an increase in the reaction vessel
C) a decrease in the concentration of A
D) an increase in surface area of A
Answer: D
Explanation: an increase in surface area of A
PLEASE HELP ILL MARK BRAINLIEST
Answer:
1. true
2. existing matter
3. the materials simply turn into gases you cannot see
hope that helps! ☺
plz mark Brainliest!
1. identify a metal that matches each of the following descriptions. There may be more than one possible metal.
a Reacts slowly with cold water to form a hydroxide.
b Does not react with oxygen when heated.
c Reacts slowly with dilute acid.
d Reacts very vigorously in cold water to form hydroxide.
Answer:
I don't think there is any metal matches with this condition
Q4
Which of the following is an example of nonpoint source pollution?
A. industrial effluent
B. Agricultural runoff
C. illegal dumping of waste
D. Oil leaking from your car
Answer:
Option C.
Ilegal dumping of waste
Explanation:
This is because non point source of pollution refers to source of pollution that are many and not directly one which is illegal or does not meet the legal term. This type of pollution does not have a point source, it has many sources and this type of pollution is cause by rainfall or precipitation. Where when the rain fall, it wash away the waste through to water bodies, causing pollution and endangering water bodies.
How many grams of 5% barium hydroxide solution will be needed to react 2 moles of sulfur (IV) oxide?
Answer:
DONT PRESS THAT LINK IT IS VIRUS AND HACK
Explanation:
Help quickly pleaaas
Answer:
chymotrypsin, cleaves peptide bonds selectively on the carboxylterminal side of the large hydrophobic amino acids such as tryptophan, tyrosine, phenylalanine, and methionine
Under certain conditions butane reacts with oxygen to form butanone which can be easily hydrogenated to butanol. Butene is easily made from butanol by elimination of water.
Explanation:
These are for the first too
What is the difference between speed and acceleration?
Please help :)
Answer:
Speed is how fast you are going at the moment but acceleration is how fast you are building up speed to get to a set point
Explanation:
??? Ipc helppp pllzz
Please Help I need to finish this by the end of the day!
Answer:
C
Explanation:
If I am not mistaken, due to the conservation of mass, whatever mass is on the side of the reactants should be the same for the product side.
This means
218.76g+53.96g = 272.72g
272.72g-266.66g = 6.06g
So the answer should be C
type a question about gas starting with “what if”
Answer:
what if we didn't have gas
Explanation:
what chemical is 2:8:6 in electrons?
Magnesium hydroxide is added to a solution of hydrochloric acid. A reaction occurs and magnesium chloride and water are formed. Testing the _______ would show that a reaction has occurred.
Answer:Magnesium (Mg) is a - reactant
Hydrogen (H2) is a - product
magnesium chloride (MgCI2) is a - product
hydrochloric acid (HCI) is a - reactant
Explanation: It’s in my notes
Select the compound that is soluble in water?
Answer:
NaOH
Explanation:
NaOH is among the water soluble bases
Can someone plz help me with this one problem plz!!!
Answer:
I think it is C
Explanation:
I just do.
Consider this reaction: NH4+ + HPO42− → NH3 + H2PO4−
Which is the conjugate base?
NH4+
NH3
HPO42–
H2PO4–
The conjugate base is formed when an acid loses its hydrogen or proton. In the reaction between ammonium ion and hydrogen phosphate, HPO₄²⁻ is the conjugate base. Thus, option C is correct.
What is a conjugate base?Conjugate bases are formed when the substance accepts or absorbs the proton or the hydrogen ion from the acids in the solution. It can be said as a base with an added hydrogen ion to it.
The chemical reaction of the acids and the bases has been shown as,
NH₄⁺ + HPO₄²⁻ → NH₃⁺ + H₂PO₄⁻
From the reaction, it can be said that ammonia donated its proton, whereas HPO₄²⁻ accepted hydrogen ions from the acid.
Therefore, HPO₄²⁻ has been the conjugate base in the given chemical reaction.
Learn more about conjugate base here:
https://brainly.com/question/12883745
#SPJ5
the action force
According to Newton's third law of motion, a reaction force between two objects is
but in the opposite direction.
equal to
greater than
less than
Answer:
equal to - it's opposite but equal energy is the third law
How many moles of sulfuric acid (H2SO4) are present in 500.0 mL of 0.15 M H2SO4 solution?
Answer:
Number of moles = 0.075 mol
Explanation:
Volume = 500.0 mL = 0.5 (Converting to L by dividing by 1000)
Molarity = 0.15 M
Number of moles = ?
The relationship between the quantities is given as;
Molarity = Number of moles / Volume
Number of moles = Molarity * Volume
Number of moles = 0.15 * 0.5
Number of moles = 0.075 mol
Can i titrate a solution of unknown concentration with another solution of unknown concentration and still get a meaningful answer
Answer:
No, I don't think so at least
Explanation:
In chemistry, you do calculations to find the concentration of a solution with another solution of KNOWN concentration. Without concentrations of either solution, were would you get values from? Where would you start? :3
You can not titrate a solution of unknown concentration with another solution of unknown concentration and still get a meaningful answer.
Titration involves the standardization of unknown solution using a standard solution. By this definition, titration must involve a standard solution.
Since the two unknown solutions are not standardized, we can never get a meaningful answer because we can not be able to perform any calculation unless we have a standard solution.
Learn more: https://brainly.com/question/2728613
if common names does not exist how would be the world of organic compounds
Explanation:
I think the question is not complete
Radioactive decay occurs when the ____ decays
Answer:
nucleus i think
Explanation:
Someone help please! Extra points & brainlest!
Answer:
golgi apparatus
Explanation:
Answer:
vacuole
Explanation:
the answer is vacuole im pretty sure!