Answer: a- 323 b- 15
Explanation:
Why does a DNA fingerprint require millions of copies of each DNA fragment
Answer:
Because it can identify a person.
A DNA fingerprint is a piece of DNA so distinct that it can prove a person's identity. These distinct areas can take on many different forms, but each form is unique to any one individual.
PCR allows the amplification of a single copy of DNA into millions of copies. However this technique requires that the DNA of interest already be of a known sequence in order to design primers that will specifically hybridize to the target DNA.
It is important as:
It's used as evidence in courts, to identify bodies, track down blood relatives, and to look for cures for disease.
Learn more:
brainly.com/question/13695548
What element is in group 4 and period 3
What are resistors? please help
Answer:Resistor Basics
Resistors are electronic components which have a specific, never-changing electrical resistance. The resistor's resistance limits the flow of electrons through a circuit.
They are passive components, meaning they only consume power (and can't generate it). Resistors are usually added to circuits where they complement active components like op-amps, microcontrollers, and other integrated circuits. Commonly resistors are used to limit current, divide voltages, and pull-up I/O lines.
Resistor units
The electrical resistance of a resistor is measured in ohms. The symbol for an ohm is the greek capital-omega: Ω. The (somewhat roundabout) definition of 1Ω is the resistance between two points where 1 volt (1V) of applied potential energy will push 1 ampere (1A) of current.
As SI units go, larger or smaller values of ohms can be matched with a prefix like kilo-, mega-, or giga-, to make large values easier to read. It's very common to see resistors in the kilohm (kΩ) and megaohm (MΩ) range (much less common to see miliohm (mΩ) resistors). For example, a 4,700Ω resistor is equivalent to a 4.7kΩ resistor, and a 5,600,000Ω resistor can be written as 5,600kΩ or (more commonly as) 5.6MΩ.
Schematic symbol
All resistors have two terminals, one connection on each end of the resistor. When modeled on a schematic, a resistor will show up as one of these two symbols:
Resistor schematic symbols
Two common resistor schematic symbols. R1 is an American-style 1kΩ resistor, and R2 is an international-style 47kΩ resistor.
The terminals of the resistor are each of the lines extending from the squiggle (or rectangle). Those are what connect to the rest of the circuit.
The resistor circuit symbols are usually enhanced with both a resistance value and a name. The value, displayed in ohms, is obviously critical for both evaluating and actually constructing the circuit. The name of the resistor is usually an R preceding a number. Each resistor in a circuit should have a unique name/number. For example, here's a few resistors in action on a 555 timer circuit:
Answer: resistor is
Explanation:
A resistor controls the flow of the electrical current within a circuit. Resistors are made from materials like copper or carbon, which make it difficult for the electrical charges to flow through a circuit. The most common type of resistor is a carbon resistor, which is a general purpose resistor, best suited for lower-powered circuits.
Analyzing models compare an atom’s structure to a ladder. Identify one way in which ladder is not a good model from the atom.
Answer:
Climbing a ladder assumes that you would touch/use each step only once. Electrons will take one layer that is empty first, and previous layers or "steps" will continue being filled with additional electrons only when every other layer is occupied by, at least, one electron.
Explanation:
A good analogy is what passengers in a bus do. Everyone tries to sit alone first and only when every pair of seats has a person already seated, people will use them as well, sitting next to each other.
**PLEASE SHOW YOUR WORK**Calculate how much energy would be necessary to convert 250.0 grams of ice at -30°C to steam at 145°C.
Assume that the only time that liquid water changes to gas is when it is boiling. Please help me
Answer:
Q= mc∆T(ice) + mLF(ice) + mc∆T(water) + mLV(water) + mc∆T(steam)
m=250 g = 0.25 kg = ¼ kg c(ice)= 2100 J/kg.K c(water)= 4200 J/kg.K LF(ice)= 333.7 kJ/kg LV(water)= 2256 kJ/kg c(steam)= 2080 J/kg.K
Explanation:
Q= ¼ × 2100 × (0°-(-30°)) + ¼ × 333700 + ¼ × 4200 × (100°-0°) + ¼ × 2256000 + ¼ × 2080 × (145°-100°)
Q= 15750 + 83425 + 105000 + 564000 + 23400
Q= 791575 J
Students report that the sky in their area has mostly cirrus clouds. What are most likely the weather conditions in the area?
rainy weather
dark, overcast (blocking the sunlight)
stormy weather
fair, pleasant weather
Students are investigating the relationship between pressure and temperature in gases. They have blown up a balloon with carbon dioxide from an air tank and connected the balloon to a pressure gauge. The balloon is then submerged in ice or water baths at various temperatures in order to observe the pressure level after several minutes. What is the flaw in the student’s investigation, and how can the students improve their investigation to correctly determine the relationship?
A.
The volume and density of the air in the balloon can change, therefore they need to use several different balloons at different volumes to account for how density and volume affects pressure.
B.
The volume of the balloon can change, therefore they need to use several different balloons at different volumes to account for how volume affects pressure.
C.
The volume and density of the air in the balloon can change, therefore they need to use a rigid container such as plastic or metal to hold the air.
D.
To keep the volume of the balloon from changing, so they can focus on temperature and pressure they need to use a container that does not expand like a balloon. A constainer made of plastic or metal to hold the air.
Answer:
The volume and density of the air in the balloon can change, therefore they need to use a rigid container such as plastic or metal to hold the air.
Explanation:
HELP PLEASE Which type of power generation can produce carbon dioxide? solar hydroelectric coal wind
Answer:
COAL
Explanation:
Answer:
Coal!
Explanation:
Hope this helps!
Solve this puzzle
R+R
2.
You take a gas at 3 atm and increase the temperature from 120 K to 240 K. What is the final pressure?
A
6 atm
B
Not enough information
C
3 atm
D
1.5 atm
Answer:
A. 6atm
Explanation:
Using pressure law equation:
P1/T1 = P2/T2
Where;
P1 = initial pressure (atm)
T1 = initial temperature (K)
P2 = final pressure (atm)
T2 = final temperature (K)
According to this question;
P1 = 3 atm
P2 = ?
T1 = 120K
T2 = 240K
Using P1/T1 = P2/T2
3/120 = P2/240
Cross multiply
240 × 3 = P2 × 120
720 = 120P2
P2 = 720/120
P2 = 6atm
How do we know if molecules have kinetic energy?
Gas in a balloon occupies 3.3 liters. What volume will it occupy if the pressure is changed from 100 kPa to 90.0 kPa, if the temperature is held constant?
Answer:
3.7 L
Explanation:
Initial volume (V₁) = 3.3 L
Initial pressure (P₁) = 100 KPa
Final pressure (P₂) = 90 KPa
Final volume (V₂) =?
The final volume of the gas can be obtained by using the Boyle's law equation as follow:
P₁V₁ = P₂V₂
100 × 3.3 = 90 × V₂
330 = 90 × V₂
Divide both side by 90
V₂ = 330 / 90
V₂ = 3.7 L
Thus, the final volume of the gas is 3.7 L
Am I doing this right?
What is [OH-] of a solution
with a pH of 4.0?
Answer in M
Which indicates how evidence of climate change supports the theory of continental drift?
1. coal fields in several continents
2. volcano formation
3. glacial evidence
4. folded mountains in Africa and South America
Answer:
glacial evidence found in South America
Answer: C. Glacial evidence
If a piece of paper with a mass of 1.3 grams is shredded into pieces and then it's weighed again so what would be the mass of the paper shreds?
Option 1: More than 1.3 grams
Option 2: stays the same (1.3 grams)
or
Option 3: Less than 1.3 grams
Answer:
option 2
Explanation:
what is the radius of a circle i
s
Help! Need it ASAP!
Is steam and vapour different? If they are then how are they different?
Answer:
Explanation:
Water vapor is when water molecules are present in the air, while steam is water heated to the point that it turns into gas. In simplified science, both are referred to as the gaseous state of water. Steam is usually white or translucent in nature, while water vapor can be clear or translucent.
Steam is simply, water vapor. Hence, the key difference between steam and vapor is that steam is the gaseous state of water whereas vapor is the gaseous state of any substance. Moreover, steam is typically invisible while the vapor of some substances is colorful.
What is the lanthanide with least mass, periodic table?
Answer:
Europium/Eu ( not really sure )
The lanthanide element with the least mass is Lutetium (Lu)
Lutetium (Lu) is a member of the lanthanide series, which is a group of 15 elements located in the f-block of the periodic table. The lanthanide series starts with the element Lanthanum (La) and ends with Lutetium (Lu). Lutetium is the heaviest and most dense element in the lanthanide series. Lutetium has an atomic number of 71, indicating that it has 71 protons in its nucleus. It has a relatively high atomic mass of approximately 174.97 atomic mass units (u) according to the periodic table.
Hence, lutetium is the lanthanide element with the least mass.
Learn more about lanthanide elements here:
https://brainly.com/question/28305751
#SPJ 6
In what way is heat transferred to the tubes? (Hint “touching’”)
Please help
I will give you Brainliest
Answer:
in heat transfer, as the fluid flows along the tube, the wall layers are heated or cooled. temp. variation occurs in the wall layers.
good luck :)
i hope this helps
have a great day !!
how should baking pizza be categorized
Answer: The baking of a pizza should be categorized as an endothermic process because the dough absorbs heat. An endothermic process is a method that absorbs energy from its surroundings which is habitually in the form of energy
Explanation:
Answer:
endothermic; the dough absorbs heat
Explanation:
EDG2020
The number of ions produced when a substance dissolves is always equal to the number of Adams in a chemical formula. What is incorrect about following statement?
How many copies of DNA do haploid cells have
Answer:
2 lol
Explanation:
In a chemical reaction between copper metal and silver nitrate, 12.7 g of copper(II) and 64.5 g of silver nitrate react, and 38.1 g of Silver is produced. 21) Predict the products and write the balanced equation and include the physical state of each. 22) What type of chemical reaction is this? 23) Which is the limiting reactant? You must include the work for this to receive full credit. 24) What mass of excess is used up, and what mass is left over? 25) Calculate the percent yield.
Answer:What should you do if you realize during research that your original theory is wrong
Explanation:
What kind of reaction is 2H202 → 2H20 + O2?
O A. Decomposition
O B. Single-replacement
C. Double-replacement
O D. Synthesis
Answer:
this reaction is so the answer should be A
1. The chemical formula of caffeine is C8H10N4O2. Determine the percent composition of the molecule.
Show work please
Answer:
we find the mass for each element in one mole by multiplying the number of atoms in one molecule with the atomic mass
mC=8Ac=8*12=96g
mH=10AH=10*1=10g
mN=4AN=4*14=56g
mO=2AO=2*16=32g
by adding the masses together we find the molar mass of the molecule
M=mC+nH+mN+mO=96+10+56+32=194g/mole
we apply the rule of threes to find the percentage of each element
194g..96gC..10gH...56gN....32gO
100g....a...........b...........c.............d
a=(100*96)/194=49.48%C
b=(100*10)/194=5.19%H
c=(100*56)/194=28.85%N
d=(100*32)/194=16.48%O
Explanation:
Which of the following describes wind direction?
Wind direction is reported by the direction from which it originates. For example, a north or northerly wind blows from the north to the south. Wind direction is usually reported in cardinal (or compass) direction, or in degrees.
Which particles make up most of the mass of an atom?
i think Neuterons i am right
Answer:
I do not know srry
Explanation:
marking brainliest please help
determine the velocity of a cart traveling at 135cm in 5.5s.
Answer: 0.245 m/s
Explanation:
So velocity = d/t or distance over time in this case m/s or meters per second. But BE CAREFUL you must remember to convert cm to m always so 135 cm= 1.35m and 1.35m/5.5s= 0.245m/s
the number of ___ in an atom tells you how many chemical bonds that atom can form