calculate the number of moles of al2o3 that are produced when 3.60 mol fe is produced in the following equation. 2Al+3FeO—> 3Fe+Al2O3

Answer: 0.245 m/s

Explanation:

So velocity = d/t or distance over time in this case m/s or meters per second. But BE CAREFUL you must remember to convert cm to m always so 135 cm= 1.35m and 1.35m/5.5s= 0.245m/s

Explanation:

In chemistry, thermodynamics, and many other related fields, phase transitions (or phase changes) are the physical processes of transition between the basic states of matter: solid, liquid, and gas, as well as plasma in rare cases.

Answer:

In chemistry, thermodynamics, and many other related fields, phase transitions are the physical processes of transition between the basic states of matter: solid, liquid, and gas, as well as plasma in rare cases. A phase of a thermodynamic system and the states of matter have uniform physical properties.

Explanation:

Answer:

Dry ice

Explanation:

Answer:

The lava doesn't melt through ice because the steam ice sits on top of a blanket of steam rather than on top of the ice itself. This means the friction between the lava and the ice is very low.

Explanation:

Answer:

in heat transfer, as the fluid flows along the tube, the wall layers are heated or cooled. temp. variation occurs in the wall layers.

good luck :)

i hope this helps

have a great day !!

Answer:

it is the second one. Lead

Wind direction is reported by the direction from which it originates. For example, a north or northerly wind blows from the north to the south. Wind direction is usually reported in cardinal (or compass) direction, or in degrees.

Answer:

this reaction is so the answer should be A

Answer:

A. 6atm

Explanation:

Using pressure law equation:

P1/T1 = P2/T2

Where;

P1 = initial pressure (atm)

T1 = initial temperature (K)

P2 = final pressure (atm)

T2 = final temperature (K)

According to this question;

P1 = 3 atm

P2 = ?

T1 = 120K

T2 = 240K

Using P1/T1 = P2/T2

3/120 = P2/240

Cross multiply

240 × 3 = P2 × 120

720 = 120P2

P2 = 720/120

P2 = 6atm

Show the bolded items and the boxes.

Letter A because the temperature of a substance A increases "Twice as much".

Answer:

See the answer below

Explanation:

The cell represents the basic unit of life and any living organism.

One example of specialized cells in the body are the sex cells.

The sex cells are primarily concerned with reproduction and perpetuation of life. The cells undergo meiosis to produce haploid gametes. Male and female gametes then fuse together during fertilization to give rise to diploid zygotes which eventually give rise to new organisms.

Answer:

I love it

Explanation:

☁️ Answer ☁️

annyeonghaseyo!

Your answer is:

When electrons are lost, a positively charged ion is formed. When electrons are gained, a negatively charged ion is formed. (I like the car)

Hope it helps.

Have a nice day noona/hyung!~ ￣▽￣❤️

Answer:

we find the mass for each element in one mole by multiplying the number of atoms in one molecule with the atomic mass

mC=8Ac=8*12=96g

mH=10AH=10*1=10g

mN=4AN=4*14=56g

mO=2AO=2*16=32g

by adding the masses together we find the molar mass of the molecule

M=mC+nH+mN+mO=96+10+56+32=194g/mole

we apply the rule of threes to find the percentage of each element

194g..96gC..10gH...56gN....32gO

100g....a...........b...........c.............d

a=(100*96)/194=49.48%C

b=(100*10)/194=5.19%H

c=(100*56)/194=28.85%N

d=(100*32)/194=16.48%O

Explanation:

Answer:Resistor Basics

Resistors are electronic components which have a specific, never-changing electrical resistance. The resistor's resistance limits the flow of electrons through a circuit.

They are passive components, meaning they only consume power (and can't generate it). Resistors are usually added to circuits where they complement active components like op-amps, microcontrollers, and other integrated circuits. Commonly resistors are used to limit current, divide voltages, and pull-up I/O lines.

Resistor units

The electrical resistance of a resistor is measured in ohms. The symbol for an ohm is the greek capital-omega: Ω. The (somewhat roundabout) definition of 1Ω is the resistance between two points where 1 volt (1V) of applied potential energy will push 1 ampere (1A) of current.

As SI units go, larger or smaller values of ohms can be matched with a prefix like kilo-, mega-, or giga-, to make large values easier to read. It's very common to see resistors in the kilohm (kΩ) and megaohm (MΩ) range (much less common to see miliohm (mΩ) resistors). For example, a 4,700Ω resistor is equivalent to a 4.7kΩ resistor, and a 5,600,000Ω resistor can be written as 5,600kΩ or (more commonly as) 5.6MΩ.

Schematic symbol

All resistors have two terminals, one connection on each end of the resistor. When modeled on a schematic, a resistor will show up as one of these two symbols:

Resistor schematic symbols

Two common resistor schematic symbols. R1 is an American-style 1kΩ resistor, and R2 is an international-style 47kΩ resistor.

The terminals of the resistor are each of the lines extending from the squiggle (or rectangle). Those are what connect to the rest of the circuit.

The resistor circuit symbols are usually enhanced with both a resistance value and a name. The value, displayed in ohms, is obviously critical for both evaluating and actually constructing the circuit. The name of the resistor is usually an R preceding a number. Each resistor in a circuit should have a unique name/number. For example, here's a few resistors in action on a 555 timer circuit:

Answer: resistor is

Explanation:

A resistor controls the flow of the electrical current within a circuit. Resistors are made from materials like copper or carbon, which make it difficult for the electrical charges to flow through a circuit. The most common type of resistor is a carbon resistor, which is a general purpose resistor, best suited for lower-powered circuits.

Answer:

you have to decide 865,000 with 1000 and the answer is 865

Answer:

10 watts

Explanation:

Power = Work / Time

Power = 330 J / 33 s

Power = 10 watts

Answer:What should you do if you realize during research that your original theory is wrong

Explanation:

Answer:

3.7 L

Explanation:

Initial volume (V₁) = 3.3 L

Initial pressure (P₁) = 100 KPa

Final pressure (P₂) = 90 KPa

Final volume (V₂) =?

The final volume of the gas can be obtained by using the Boyle's law equation as follow:

P₁V₁ = P₂V₂

100 × 3.3 = 90 × V₂

330 = 90 × V₂

Divide both side by 90

V₂ = 330 / 90

V₂ = 3.7 L

Thus, the final volume of the gas is 3.7 L

Answer: Cs because its further to the right on the table, meaning its more reactive.

Explanation:

Answer:

Cs

Explanation:

This element is the farthest right, and lowest meaning that its reactivity is very high.

1. valence electrons and electronegativity

2. Both reactivity and electronegativity decrease down a group.

3. Electronegativity decreases down a group and reactivity increases down a group.

4. The number of valence electrons increases from left to right.

5. Cs

{quizlet: captncrun}

Answer:

by wearing of rocks

Explanation:

earths gravity your welcome

Answer:

weathering of rocks is the answer to your question

Answer: C) 1.6

Explanation: I got it right