M = 2 . 8 . 2
Valence Electron of M = 2
M ==> M⁺² + 2 e⁻
a. M⁺² + OH⁻ ==> M(OH)₂
b. M⁺² + PO₄⁻³ ==> M₃(PO₄)₂
Which helps regulate the temperature range of the Earth's atmosphere? Water or Land
Answer:
The oceans atmosphere. AKA Water.
Explanation:
The oceans and the atmosphere are the two large reservoirs of water in the Earth's hydrologic cycle. The two systems are complexly linked to one another and are responsible for Earth's weather and climate. The oceans help to regulate temperature in the lower part of the atmosphere.
Earth's atmosphere get warm up by the temperature absorbed by the gases in the atmosphere. However it can balanced water in earth such as ocean currents and cooling.
What is ocean currents?Ocean currents are formed from the pressure difference in ocean level and thus in day time there will be winds from ocean to land which cools the earth's surface.
Surface of the earth warms up by absorption of heat energy from sun. This warming will be higher if there are more greenhouse gases such as carbon dioxide, methane oxides of nitrogen, Sulphur etc.
Greenhouse gases intensely absorbs the temperature from radiation and thus increase the temperature of earth's surface. These gases are mainly evolved to the atmosphere by industries and factories.
Other factor which affects the temperature of earth surface include wind, ocean level etc. The level of ocean and ocean currents helps to regulate the temperature of the surface and make it cool.
To find more about ocean currents, refer the link below:
https://brainly.com/question/20823678
#SPJ2
"Henry mixed salt and water together in a cup until he observed a clear solution. He measured the mass of the solution. Then he placed the cup outside for several sunny days during the summer. After a week, he observed that only solid salt remained in the cup and the mass had decreased. Henry concluded that a physical and chemical change occurred in this investigation."
Which statements correctly defend or dispute his conclusion?
A.)He is correct. Dissolving salt in water is a physical change, but evaporating the water is a chemical change. Formation of a solid is evidence that a chemical change occurred.
B.)He is correct. Evaporation is a physical change, but dissolving salt in water is a chemical change. The change in mass is evidence that a chemical change occurred.
C.)He is incorrect. Dissolving salt in water and evaporation of the water are both physical changes. The reappearance of salt is evidence that the change was reversible by a physical change, so it could not be a chemical change.
D.)He is incorrect. Dissolving salt in water and evaporation of the water are both chemical changes. The reappearance of salt is evidence that the change was reversible by a chemical change, so it could not be a physical change.
Answer:
C.)He is incorrect. Dissolving salt in water and evaporation of the water are both physical changes. The reappearance of salt is evidence that the change was reversible by a physical change, so it could not be a chemical change.
Explanation:
From the analogy of the problem presented, we can see that Henry is grossly incorrect. His conclusion from the process of the experiment he carried out is completely wrong.
Physical changes are changes that alters the physical properties of matter particularly the form and state.
Chemical changes leads to the formation of a new kind of matter.
We can see that since the salt was obtained back after evaporation, no change has occurred to it.
Therefore, evaporation in itself is a physical change process.
Answer:
c on ed
Explanation:
What characteristic of an element’s atoms always determines the element’s identity?
Answer:
Number of protons
Explanation:
There are three sub atomic particles. These are;
- Protons
- Electrons
- Neutrons
Among these three particles, only one determines the identity of the element. This is the Protons. The number of protons which is also called the atomic number determines the identity of an element. For instance, atom with one proton is Hydrogen and n other element can have atomic number of one.
Tikiya is conducting experiments on samples of pure copper (Cu). While collecting data, Tikiya records both physical and chemical properties of the metal. Which of the following is dependent on the amount of copper particles in the sample? A. Electrical conductivity B. Thermal conductivity C. Mass D. Density
Answer: Mass
Explanation: I had the same question hope its right for you
Which of the following statements regarding bond energies is FALSE?
Answer:where are the statements
Explanation:
There are 4 different types of sublevels: s,p,d,f true or false
I think it is true because level 4 has 4 sublevels which is s, p, d and f.
The sun’s core is made of solid rock. True or false
Answer:
False
Explanation:
Heres what its made of:
The core is made of hot, dense plasma (ions and electrons), at a pressure estimated at 265 billion bar (3.84 trillion psi or 26.5 petapascals (PPa)) at the center. Due to fusion, the composition of the solar plasma drops from 68–70% hydrogen by mass at the outer core, to 34% hydrogen at the core/Sun center.
Determine the final temperature of sample with a specific heat of 1.1 J/g°C and a mass of 385 g if it starts out at a temperature of 19.5°C and 885 J of energy are added to it.
Answer:
T2 =21.52°C
Explanation:
Given data:
Specific heat capacity of sample = 1.1 J/g.°C
Mass of sample = 385 g
Initial temperature = 19.5°C
Heat absorbed = 885 J
Solution:
Formula:
Q = m.c. ΔT
Q = amount of heat absorbed or released
m = mass of given substance
c = specific heat capacity of substance
ΔT = change in temperature
ΔT = Final temperature - initial temperature
885J = 385 g× 1.1 J/g.°C×(T2 - 19.5°C )
885 J = 423.5 J/°C× (T2 - 19.5°C )
885 J / 423.5 J/°C = (T2 - 19.5°C )
2.02°C = (T2 - 19.5°C )
T2 = 2.02°C + 19.5°C
T2 =21.52°C
____ power is generated from the heat released when uranium atoms split in a process known as fission.
I think this is gonna be 2050 for memers
Answer:
HOLY WOAH
Explanation:
YES
what is the magnitude of earthquake took place in manila?
A.5.2
B.5.3
C.5.4
D.5.5
Answer:
i believe its 5.2
Explanation:
Large areas on the leaves of some plants lack chlorophyll and are therefore not green in color. How does this most likely affect photosynthesis?
Not enough sunlight is captured in these areas of the leaves.
Carbon dioxide cannot enter these areas of the leaves.
Too much glucose builds up in these areas of the leaves.
Oxygen cannot be released in these areas of the leaves
Answer:
Not enough sunlight is captured in these areas of the leaves.
Explanation:
Photosynthesis is the process whereby green plants manufacture their food using carbon dioxide and water in the presence of sunlight.
The sunlight is the energy source which drives this chemical change or reaction.
Therefore, to capture the sunlight, the green pigment called chlorophyll is needed. Without this sunlight, photosynthesis will not take place. Photosynthesis is a light dependent reaction. Without light, the process is greatly hamperedcan someone help answer this? thanks!
if surface tension relies on intermolecular forces, how could you make surface tension decrease?
(think about how and where molecules bind to each other)
Answer:
We could make the surface tension to decrease by removing and causing a disruption to the intermolecular forces(hydrogen bonds).
Explanation:
To explain this answer, we will consider an experiment whereby a paper clip is made to rest at the top surface of water inside a container/beaker.
First of all, the intermolecular forces present in water are also known as hydrogen bonds.
It's relationship with surface tension is that when there is high surface tension in the water, this high tension will allow the paper clip to rest on top of the hydrogen bonds present at the top surface in between the water molecules.
However, the surface tension will decrease when we remove or cause a disruption to the intermolecular forces (hydrogen bonds).
Please help me 30 pointsss dont guess please be sure
Answer:
Acid
Explanation:
;)
if an ion has 13 protons and 10 electrons what is the charge on the ion?
Answer:Al3+ indicates an ion of aluminum having a charge of + 3. I.e., since an aluminum atom normally has 13 protons and 13 electrons, this ion has 10 electrons (-10 charge) and 13 protons (+ 13 charge) giving it a charge of + 3 (-10 + 13 = +3).
Explanation:
The ion will have a charge of +3
The components of an atom and their charges are:
protons which have a positive charge electrons which have a negative charge neutrons which have no chargeThe charge of an ion will therefore depend on the number of electrons and protons as they cancel each other out.
The number of excess protons in this ion will be:
= Number of protons - number of electrons
= 13 - 10
= 3
Protons have a positive charge so there will be a charge of +3 as there are 3 excess protons.
In conclusion, this ion will have a charge of +3.
Find out more at https://brainly.com/question/21373859.
I really am bad at chemistry
Answer:
A, 4,3,3,4
B, 3,2,2,3
C, 2,6,2,3
D, 1,2,1, 1
A solution of baking soda has a pH of 9. Baking soda
(blank)
Answer: is a base
Explanation:
25.00 g of the compound is composed of 6.77 g of tin and 18.23 g of bromine. What is the percent by mass of tin in the compound? Show work.
The percent by mass of Tin : = 27.08%
Further explanationGiven
25.00 g of the compound
6.77 g of Tin
18.23 g of Bromine
Required
The percent by mass of Tin
Solution
Proust stated the Comparative Law that compounds are formed from elements with the same Mass Comparison, so that compounds have a fixed composition of elements
%mass X = (mass X/mass sample) x 100%
So %mass of Tin :
= (6.77 g : 25 g) x 100%
= 27.08%
OMG PLS ANSWER IM USING SO MANY P OINTS I SWEAR I NEED
Answer:
1)They have different densities.
2) The molecules are packed differently
Explanation:
Oil and Water have different densities The first reason that water and oil don’t mix is because their molecules are packed differently. The molecules of water are packed very densely. (Would be good to show water molecules packed densely) In one glass of water, there are more molecules than the number of known stars in the universe!
Answer:
diff densities
Explanation:
Water has a molar mass of 18.0 g/mol. How many particles of water do you drink if you drink 64 oz., or 1893 grams, of water in a day?
Answer:
[tex] \frac{1839}{18} = 102.16[/tex]
Take 102.16 and multiply by avogadros #
and you get 6.33 × 10^25 otherwise A
Answer:
Answer is A
Explanation:
I just took this.
What group on the periodic table is more reactive 5 or 6 and why?
Answer:
heheeheheh
Explanation:
Earths rocks change from one type to another over time die to various earth processes A- igneous rock B- cementation C- metamorphic rock D- rock cycle
Answer:
The rock cycle describes the processes through which the three main rock types (igneous metamorphic, and sedimentary) transform from one type into another.
3. All the deer in Horry County represent which of the following?
species
biome
population
community
Answer:
community
Explanation:
Answer:
The correct answer is population. I took the test and got it right.
what is the molecular polarity of the following lewis structure
Why are some energy resources more expensive to use than others?
Energy stored in an object because of position or condition is called ___________ energy.
Answer:
Potential energy
True or false for these!!!! Please help
All of the devices below either use or produce electrical energy. Which one converts mechanical energy to electrical energy?
E.Battery
F.Electrical drill
G.Wind turbine
H.Electric guitar
Answer:
G wind turbine
Explanation:
they get mechanical energy fron the wind the turns into electrical energy
Answer:
G is correct
Explanation:
just saying
A rocket travels 4500 meters in 150 seconds. What is its average speed?
Answer:
Your average speed was 3.77 Miles per hour
Explanation:
Name the following parts:
A—-
B——
C——