A student makes an aqueous solution of sodium hydroxide. Which statement correctly identifies the two ions present in the solute of this mixture?

The sodium ion is negative, and the hydroxide ion is positive.

The sodium ion is positive, and the hydroxide ion is positive.

The sodium ion is positive, and the hydroxide ion is negative.

The sodium ion is neutral, and the hydroxide ion is neutral

Answer:

Im pretty sure the answer is A. An electron moves from the FIFTH energy level down to the SECOND energy level.

Explanation:

Answer:

In order for the powder to dissolve, each powder molecule must separate from the other powder molecules and be surrounded by water molecules. This shift in arrangement either absorbs or releases energy depending on the situation. It is due to the exchange of energy that the temperature of the solution fluctuates.

Explanation:

:)

Explanation:

Lift the kitten's tail. The opening just under the tail is the anus. Below the anus is the genital opening which is round in males and is a vertical slit in females. In kittens of similar size, the distance between the anus and the genital opening is greater in the male than the female.

TW: use of inapropate words*

Answer:

not enough information to tell

Explanation:

One way you can tell this difference is the distance between the cat's genitals (organs seen on the outside of the body) and the anus.  A male will have a much greater distance between the genitals and anus than females, 1/2 inch apart on a male kitten and over 1 inch apart on a male adult cat.  However, if the two are almost adjacent on a kitten or less than 1/2 inch apart on an adult, it’s a female.

The concentration of the diprotic acid equals 3.4 M

We'll begin by writing the balanced equation for the reaction.

H₂X + 2NaOH —> Na₂X + 2H₂O

From the balanced equation above,

From the question given above, the following data were obtained:

MaVa / MbVb = nA/nB

(Ma × 25) / (1.95 × 87.42) = 1/2

(Ma × 25) / 170.469 = 1/2

Cross multiply

Ma × 25 × 2 = 170.469

Ma × 50 = 170.469

Divide both side by 50

Ma = 170.469 / 50

Ma = 3.4 M

Therefore, the concentration of the acid, H₂X is 3.4 M

Learn more about titration:

https://brainly.com/question/25624144

The number of moles of a solute per liter of solution is measured using the unit of concentration known as molarity.

Thus, The approach for resolving molarity issues is quite straightforward. This describes an easy way to figure out how molarity of a solution.

Remembering the units of molarity (M): moles per liter, is the key to calculating molarity. Calculate how many moles of the solute are dissolved in a solution's liter volume to determine its molarity.

The molarity of a solution made by combining 23.7 grams of KMnO4 with 750 mL's worth of water. You must first determine the amount of moles of the solute because this example lacks the liters or moles required to determine molarity.

Thus, The number of moles of a solute per liter of solution is measured using the unit of concentration known as molarity.

Learn more about Molarity, refer to the link:

https://brainly.com/question/31545539

#SPJ1

Answer:

I think the person is not move

Explanation:

b/c the net force is zero............. 100 w + 100 E

............... 100+(-100 = 0

Answer:

490.83 oK

Explanation:

First of all, we better agree on the meaning of the word adiabatically. It means without the loss or gain of heat. So nothing is given up to or taken from the environment.

This also assumes that no change has occurred in the pressure.

T1 = 310 oK

T2 = ?

V1 = 12 L

V2 = 19 L

T1/V1 = T2/V2

310 / 12 = x/19            Multiply both sides by 19

310*19 / 12 = T2         Multiply 310 * 19 on the left.

5890 / 12   = T2         Divide by 12

490.83 = T2

Answer:

The answer is energy. Please give me Brainliest!

Explanation:

Raising the concentrations of reactants makes the reaction happen at a faster rate. For a chemical reaction to occur, there must be a certain number of molecules with energies equal to or greater than the activation energy.

Answer:

about 4 or 4.8

Explanation:

A. The abundance of the 2nd isotope is 48.119%

B. The mass of the 2nd isotope is 108.905 amu

Let the 1st isotope be A

Let the 2nd isotope be B

A. Determination of the abundance of the 2nd isotope

Abundance of isotope A = 51.881%.

Abundance of B = 100 – A

Abundance of B = 100 – 51.881

B. Determination of the mass of the 2nd isotope

Atomic mass of silver = 107.868 amu.

Mass of 1st isotope (A) = 106.906 amu

Abundance of isotope A (A%) = 51.881%.

Abundance of isotope B (B%) = 48.119%

[tex]atomic \: mass = \frac{mass \: of \:A \times \:A\%}{100} + \frac{mass \: of \:B \times \:B\%}{100} \\ \\ 107.868 = \frac{106.906\times \ \: 51.881}{100} + \frac{mass \: of \:B \times \:48.119}{100} \\ \\ 107.868 = \: 55.464 + 0.48119 \times mass \: of \:B \\ \\ collect \: like \: terms \\ \\ 0.48119 \times mass \: of \:B = 107.868 - 55.464 \\ \\ divide \: both \: side \: by \: 0.48119 \\ \\ mass \: of \:B = \frac{107.868 - 55.464 }{0.48119} \\ \\ mass \: of \:B =108.905 \: amu \\ \\ [/tex]

Therefore, the mass of the 2nd isotope is 108.905 amu

Learn more: https://brainly.com/question/7955048

Answer:

A) HF (Hydrofluoric acid)

Explanation:

dw I gotchu. So first off there are three types of intermolecular forces of attraction: 1) London-Dispersion, 2) Dipole-Dipole, 3) Hydrogen-Bonding Attraction Forces. That is also ranked in increasing strength, with Hydrogen-Bonding Attraction Forces being the strongest. Every molecule has London-Dispersion forces present and all the diatomic molecules listed have dipole moments of a certain debye (or Coloumb-meter) value. Both are irrelevant here so dw about that. Lets look at the strongest attraction: the hydrogen-bonding one. Now, don't get confused bc all of these acids are bonded to H bc hydrogen-bonding attraction forces only occur when H is bonded to N, O, or F. So Process of Elimination, hydrofluoric acid (HF) has the strongest intermolecular forces of attraction.

Note: If you don't know what inter/intra molecular forces of attraction are, ill give u a quick summary. Intermolecular refers to electrostatic attractions between molecules while intramolecular refers to the actual bonds, single, double, or triple, binding the atoms together. Well there you have it, have a great day. :)

Answer:

yes is the anser

Explanation:

i donyt know how to be wrong

The correctly balanced equation among the options is 2HgO → 2Hg + O2.

Balancing a chemical equation means ensuring that the number of atoms of each element on both sides of the equation are the same in accordance to the law of conservation of mass.

To balance a chemical equation, we make use of coefficients, which are numbers placed in front of the element or compound in the reaction.

According to this question, the following equation: 2HgO → 2Hg + O2, is correctly balanced because the number of atoms of Hg (2) and O (2) are the same on both sides.

Learn more about balancing chemical equations at: https://brainly.com/question/8062886

Answer:

Electron configuration can be carried out in two steps which can be:

Sublevel notation

Shell notations.

In the sublevel notation, the sequence of filling electrons into the orbitals of the sublevels are guided by some principles:

the maximum number of electrons in the orbital of sublevels are two for s-sublevel, six for p-sublevel, ten for d-sublevel and fourteen for f-sublevel. This indicates that the maximum number of electrons in an orbital is two.

Aufbau's prinicple states that sublevel with lower energies are filled up before those with higher energies.

Pauli exclusion principle states that no two electrons in an atom can have the same set of the four quantum numbers.

Hund's rule states that electrons go into degenerate orbitals singly first before pairing occurs.

Using the shell notation, numbers are used to denote the sum of electrons in all orbitals each energy level.

For an atom of Be:

Sublevel notation for the 4 electrons 1s²2s²

Shell notation 2,2

Other representation is using the electron dot structure.

Answer:

High trainability allows the owner to train the dog to handle certain things--some dog can be trained as police dogs and can be taught various jobs, so high trainability is very important

When a dog is Viscous, the dog will keep people away from your house, they will be able to keep danger away and because they are viscous they will be able to handle danger.

Loud bark- A loud bark from a dog can help alert other people when there is a intruder, it makes alot of noise so they can attract attention easily.

Quiet Bark- Ideal for pet owners who do not like noise, they bark quietly so they are not a bother to work or anyone doing something.

Answer:

1. Ionic bonds result from transfer of electrons, but covalent bonds are formed by sharing.

2. Ions are arranged in a three-dimensional array (like crystals). Covalently bonded substances exist as discrete molecular units.

3. Ionic compounds often dissociate into ions in solution, but covalently bonded molecules retain their molecular identity in solution.

Hope this helps :)

Answer:

The group that tests the variable.

Explanation:

The group that tests the variable is a control group.

Answer:

C when testing the group put the varible in control

Answer:

1) H - hydrogen - 1.100797

2) HE - helium - 4.00260

3) LI - lithum -6.941

Explanation:

On the periodic table the mass of carbon is reported as 12.01 amu. This is the average atomic mass of carbon. No single carbon atom has a mass of 12.01 amu, but in a handful of C atoms the average mass of the carbon atoms is 12.01 amu.

Answer:

The bond between Phosphorus and Chlorine in PCl3 is covalent as chlorine needs one electron and phosphorus has metallic character and easily donate electron

Answer:

CoBr2,CoBr2·6H2O,CoBr2·2H2O

Explanation:

The statement describing nucleic acid has been that nucleic acid provides the blueprint for the formation of proteins.

Nucleic acid has been the genomic material in the body that performs the function of storage of information. DNA and RNA are nucleic acids.

The proteins are the biomolecules that are composed of amino acid units bound by the polypeptide bond. The information for the correct sequence of binding of protein has resulted from the mRNA codes.

The correct sequence and folding results in the operational protein, that has been able to perform varying functions. The codes for the binding of protein have resulted from the blueprint consisting of nucleic acid.

Thus, nucleic acid performs the function of acting as a blueprint for the formation of proteins.

For more information about proteins, refer to the link:

https://brainly.com/question/2193769

Some molecules in a substance have a high kinetic energy hence they are able to convert into vapor. These molecules exert pressure on the liquid surface.

We know that the molecules that compose matter are in constant random motion. The kinetic energy of all the molecules in the liquid are not the same. The molecules at the surface of the liquid posses more kinetic energy than the molecules below.

Some molecules of a substance have high enough kinetic energy to vaporize. These molecules exert  pressure on the substance.

Learn more: https://brainly.com/question/25273232

Answer:

Some molecules of a substance have high enough kinetic energy to vaporize. These molecules exert pressure on the substance.

Explanation:

Answer:

i think

they are used to male the animal grow

Once the animal eats the food, the atoms in food are  used to make the animal grow.

An atom is defined as the smallest unit of matter which forms an element. Every form of matter whether solid,liquid , gas consists of atoms . Each atom has a nucleus which is composed of protons and neutrons and shells in which the electrons revolve.

The protons are positively charged and neutrons are neutral and hence the nucleus is positively charged. The electrons which revolve around the nucleus are negatively charged and hence the atom as a whole is neutral and stable due to presence of oppositely charged particles.

Atoms of the same element are similar as they have number of sub- atomic particles which on combination do not alter the chemical properties of the substances.

Learn more about atom,here:

https://brainly.com/question/13654549

#SPJ2

Answer:

Answer: 10.4

Explanation:

ph is just as follows:

[tex]pH = -log[H_{3}O^{+}][/tex]

So plugging in our concentration we get:

[tex]-log(4.45*10^{-11})=10.35163999...[/tex]

Then rounding to one decimal place takes us to pH = 10.4

Answer:

Kinetic Molecular Theory states that gas particles are in constant motion and exhibit perfectly elastic collisions. Kinetic Molecular Theory can be used to explain both Charles' and Boyle's Laws. The average kinetic energy of a collection of gas particles is directly proportional to absolute temperature only.

Explanation:

hope this helps! goodluck & enjoy the rest of ur day or night.

Answer: Certain physical constants (e.g., melting point, boiling point, density, refractivity, solubility) can be found in the literature for many compounds, whereas others (e.g., specific rotation) are characteristic of different groups of compounds and are known for almost all of them.

Explanation:

Answer:

We know the initial volume of the potassium nitrate solution is 1.0 mL and the initial concentration is 2.0 M, we also know that an unknown volume of water was added to the solution, which diluted our concentration down to a final value of 0.008 M. We are trying to find the final volume.

Here we can use this formula since the initial and final solutions are proportional. Before that let's define our variables.

[tex]M_1 = 2.0 M\\V_1 = \frac{1.0 mL}{1000} = 0.001 L\\M_2 = 0.008 M\\V_2 = \ ?[/tex]

[tex]M_{1}V_{1} =M_2 V_2\\[/tex]

[tex](2.0)(0.001) = (0.008)V_2\\\\\frac{(2.0)(0.001)}{0.008} = V_2\\\\V_2 = 0.25 L \ or \ (0.25 \ * \ 1000) = 250 \ mL[/tex]

Therefore you would have 0.25 L or 250 mL of your final solution.