A 2.0 L flask contains nitrogen and oxygen gases at 25°C. The total pressure is 0.91 atm and contains 0.050 mol of nitrogen. Calculate the partial pressure of oxygen and moles of oxygen present

Answer:

divide the mass of element in 1 mole of the compound by the compound's molar mass and multiply the answer by 100.

Explanation:

take the molar mass of hydrogen in the water molecule, divide by the total molar mass of water, and multiply by 100.

does it help?

Answer:

none

Explanation:

It is given that there are 3 cats.

Each of the cats die with different diseases. One of cats died due to heart failure, the second cats died because of brain tumor and the third cat died due to an experiment gone wrong.

So there are none of the cats left out. All the cats died due to different reasons.

aniapsmxuansyxineydo

Answer:

6

Explanation:

6.0mol ( 1 mol H2/ 1 mol Zn ) = 6.0 mol of H2

H2 is hydrogen gas (hydrogen in the air).

Answer:

Controls the movement of substances into and out of the cell.

Answer:

C.same as [H+]

Explanation:

Autoionization of water is expressed as H+ * OH-  = Kc

The value of Kc is 1*10^-14. Now simply plug thus in and the value of given H+ to solve

(1*10^-7) * OH- = 1*10^-14

OH- = 1*10^-7

Thus, in this scenario, the H+ and OH- ions have same concentration and solution is said to be neutral.

Answer:

I think it can dissolve 80.0 grams

Answer:

See Explanation

Explanation:

Renewable energy sources refers to those energy sources that can never be depleted. This means that they can be used severally without getting exhausted. Solar, biomass, wind and hydroelectric power are all renewable energy sources.

Hence, from the perspective described above, we can say that wind is a form of solar energy because wind is formed when the air is heated by the sun.

Hydroelectric power is driven by the water cycle. This water cycle somehow depends on the sun to run efficiently. So, hydroelectric power can also be considered to be a form of  solar energy.

Answer:

The force applied to the object is an external force, from outside the system. When it does positive work it increases the gravitational potential energy of the system. Because gravitational potential energy depends on relative position, we need a reference level at which to set the potential energy equal to 0.

If an object is on top of a hill or in a position raised above the ground, it must have gravitational potential energy.

In physics, potential energy is the energy held by an object because of its position relative to other objects, stresses within itself, its electric charge, or other factors

If an object is lifted, work is done against the force of gravity.

When work is done energy is transferred to the object and it gains gravitational potential energy.

If the object falls from that height, the same amount of work would have to be done by the force of gravity to bring it back to the Earth’s surface.

Due to the Principle of Conservation of Energy we can say that:

Gravitational potential energy at the top = kinetic energy at the bottom

To know more about Potential Energy

https://brainly.com/question/24284560

#SPJ2

Answer:

WATER

Explanation:

Water melting  point 0 c boiling 100c

Answer:

CATION

Explanation:

If an atom has an equal number of protons and electrons, its net charge is 0. If it gains an extra electron, it becomes negatively charged and is known as an anion. If it loses an electron, it becomes positively charged and is known as a cation.

Answer:

Extinct

Explanation:

Extinct volcanos are not expected to erupt, and have not erupted in a very long time.

Answer:

2.04 moles

Explanation:

Since the ratio of Na2O to NaOH is 1:2, you multiply the number of moles by 2, equaling 2.04 moles.

Reaction 1 → Al + Zn²⁺ ⟶ Al³⁺ + Zn

Reaction 2 → Al³⁺ + Li ⟶ Al + Li⁺

Reaction 1 :-

Substance Oxidised :- Al

Substance Reduced :- Zn²⁺

Oxidizing Agent :- Zn²⁺

Reducing Agent :- Al

Reaction 2 :-

Substance Oxidised :- Li

Substance Reduced :- Al³⁺

Oxidizing Agent :- Al³⁺

Reducing Agent :- Li

Reaction 1 :-

Al

Zn²⁺

Zn²⁺

Al

Reaction 2 :-

Li

Al³⁺

Al³⁺

Li

Answer:

Number 3 alkyne is the answer

Explanation:

Answer: The answer is Alkyne.

Answer:

Seattle is shielded from extreme weather by the Cascade and Olympic mountain regions to the east and west, respectively. Low pressure systems tend to come from the south while high pressure systems tend to come from the north.

Answer:

its actually experimental this time

Explanation:

sorry bout the last one i just wanna help:(

Answer:

The correct answer is - B. New Moon.

Explanation:

The change of moon disc from all black to all light to all dark again is called the lunar cycle. It takes almost 30 days (29.53059 to be precise). The time from all black to all light or all light to all black is almost 15 days. All black moon is termed as the new moon and all light is termed as the full moon.

As given that the full moon is shown happening on the eleventh of the month then what moon would be around 25 which is 14 days later that should be in waxing gibbous phase and almost new moon.

Thus, the correct answer is - B. new moon.

Answer: 6.45 Joules

Explanation: I just did it

P2 = 54.6 kPa

Explanation:

Given:

V1 = 10.0 L. V2 = 50.0 L

P1 = 273 kPa. P2 = ?

We can use Boyle's law to solve this problem.

P1V1 = P2V2

Solving for P2,

P2 = (V1/V2)P1

= (10.0 L/50.0 L)(273 kPa)

= 54.6 kPa

Answer:

The pOH is 2.603

Explanation:The formula for finding pOH by pH is simply subtracting the pH from 14 pOH=14-11.397pOH=2.603.

Answer: 1.535e42 (or 1.535x10^42) moles of CO2

Explanation: i know this is six days late, but all you have to do for this one is multiply 2.55e18 by the standard mole value, 6.02e23 and your calculator will give you 1.535e42 moles!

Answer:

7242.1g

Explanation:

The balanced equation for this reaction is as follows:

Mg + 2HCl → MgCl2 + H2

From the above equation, it can be observed that 2 moles of HCl is needed to produce 1 mole of H2.

Using the formula below, we convert the mass of H2 to moles;

Molar mass of H2 = 2.016g/mol

mole = 200/2.016

mole = 99.21mol of H2

Since 2 moles of HCl is needed to produce 1 mole of H2.

Then 99.21 moles of H2 will be produced by 99.21 × 2 = 198.4mol of HCl

Molar mass of HCl = 1 + 35.5

= 36.5g/mol

Mole = mass/molar mass

Mass = molar mass × mole

Mass = 36.5 × 198.4

Mass = 7242.1g

Answer:

amount of gas and pressure

Answer:

Explanation:

The new volume can be found by using the formula for Boyle's law which is

[tex]P_1V_1 = P_2V_2[/tex]

where

P1 is the initial pressure

P2 is the final pressure

V1 is the initial volume

V2 is the final volume

Since we're finding the new volume we have

[tex]V_2 = \frac{P_1V_1}{P_2} \\[/tex]

First convert 745 mmHg to atm

760 mmHg = 1 atm

745 mmHg = 745/760 = 0.98 atm

We have

[tex]V_2 = \frac{500 \times 0.98}{1.8} \\ = 272.222...[/tex]

We have the final answer as

Hope this helps you

Explanation:

It's (D), nuclear fission................

Answer:

weight of H₂O formed = 2.3 grams H₂O (2 sig. figs.)

Explanation:

Rxn:                  CH₄(g)         +      2O₂(g)          =>     CO₂(g)           +  2H₂O(g)

Given:                 1.16g                   4.16g                     3.52g                  ? (g)

Moles:         1.16g/16g·mol⁻¹    4.16g/32g·mol⁻¹    3.52g/44g·mol⁻¹

                     = 0.0725mol.        = 0.13mol.             = 0.08mol.    => ? (moles)

Limiting Reactant: Divide each mole value by related coefficient of balanced standard equation (that is, balanced with coefficients in lowest whole number ratios). The smaller value is the limiting reactant.

                    0.0725/1                   0.13/2                0.080/1

                    = 0.0725                 = 0.065              = 0.080

Limiting Reactant is O₂(g) => 0.065 is smaller value after dividing each mole value by related coefficient of balanced equation.

NOTE: When working problem, however, one must use the mole value calculated from given amount in grams. That is, in this case 0.13 mole O₂. The 'divide by related coefficient and check smaller value' is ONLY for identifying the limiting reactant. This trick works for ALL general chemistry problems.

Moles H₂O formed: Since the coefficient of the limiting reactant (O₂) equals the coefficient of water (H₂O), then the moles of water formed is 0.065 mole H₂O.

Weight (in grams) of H₂O formed:

Grams H₂O = moles H₂O  x  formula weight H₂O

                   = 0.13 mole H₂O  x  18 g H₂O/mole H₂O

                   = 2.34 g H₂O  (calculator answer)

                   = 2.3 g H₂O  (final answer should be rounded to  2 sig. figs.)                                                                                                                                        => form of final answer should be based on data in final computation having the least number of sig. figs.                                      

Review: Sequence of calculations

       =>  moles of limiting reactant / coefficient of same cpd. in std. equation               = unknown (X) / coefficient of same (unknown) cpd. in std. equation

       => cross multiply and solve for unknown (X)

       => L.R.(moles) / eqn. coef. of L.R. = X / eqn. coef. of X  

       => (L.R.(calc'd moles)(eqn. coef. of X) = (X)(eqn. coef. of L.R.)

       => X (in moles) = (L.R.(calc'd. moles)(eqn. coef. of X) / (eqn. coef. of L.R.)

        => grams = moles x formula wt.                                                                

        => volume (L) = moles x std. volume (= 22.4L/mole)                                  

        => #particles = moles x Avogadro's Number (= 6.02 x 10²³ parts/mole)