Answer:
[tex]H=\frac{V^2}{R}[/tex]
Explanation:
Let H be heat produced per sec
Time, t=1 sec
Resistance of resistor=R ohm
We have to write down the expression for the heat produced per second in a resistor in terms of potential difference and resistance.
We know that
Heat, [tex]H=I^2 Rt=\frac{V^2}{R}t[/tex]
Substitute the value
Then, we get
Heat,[tex]H=\frac{V^2}{R}\times 1[/tex]
[tex]H=\frac{V^2}{R}[/tex]
This is required expression for the heat produced per second in a resistor in terms of potential difference and resistance.
The diagram below shows a wave. The feature of the wave are labeled A, B, C, and D. Which label identifies the wavelength?
According to the given diagram, the c identifies the wavelength of the curve. Hence, option C is correct.
What is wavelength?In order to characterize waveform signals that are transmitted across wires or into space, the term "wavelength" is used to refer to the separation between two identical positions (adjacent crests) in succeeding cycles. Typically, this length in wireless systems is measured in meters (m), centimeters (cm), or millimeters (mm) (mm). When describing the wavelength of infrared (IR), visible light (UV), and gamma radiation, units of 10-9 nanometers (nm) or angstroms (10-10 m) are more usually used.
The relationship between frequency and wavelength is inverse, with frequency being the number of wave cycles per second. A signal's wavelength shortens as its frequency rises, or we may say that the relationship between wavelength and refractive index is inverse.
To get more information about wavelength :
https://brainly.com/question/13533093
#SPJ2
2. a) A student obtained ice at 0°C from a refrigerator and placed it in a beaker on a
bench. After 4 minutes, the temperature rose to 4°C. State the changes that would be observed in the water in terms of;
(i) volume
(ii) mass
(iii) density
(b) Sketch a graph of density against temperature if the ice is warmed from 0°C to
8°C.
Answer:
2 4
Explanation:
because
The amount of matter in an object is mass or weight
Answer:
mass
Explanation:
Can someone help me answer this question what type of rock will form in this type of environment. Pls don’t guess and actually answer it
Answer:
Looks like A but I'm not sure.
Explanation:
dont take my word for it I might be wrong
Answer:
deforestación en el mundo es incontrolable
Weight is best described as
A) an object’s resistance to acceleration.
B) what causes an object to fall.
C) the downward force exerted on objects due to gravity.
D) a force solely dependent on an object’s mass.
Answer:
d
Explanation:
Answer:
d
Explanation
a force solely dependent on the object’s mass
What determines what we call the phases of the
moon?
Different fractions of the moon
Areas of the moon we cannot see
Days on the calendar
No answer text provided.
Anita rides a bicycle to market 60km from her house in 3.5 hours. What is Anita’s
speed?
Rewrite the following sentences choosing the right words given between the
| How many/much) (tiverivera) (ts/are) there in Lebanon?
How many/muen) (people/population) (live/lives) in the South
Answer:
How muen population lives in the South
Answer:
How many people live in the South
I'm not sure about the first one sorry
Consider the four masses. Describe the motion of the masses if you used THE SAME amount of force to move each one over THE
SAME time
A)
The greatest mass would not move at all.
B)
All four masses would move the same distance,
The lower the mass, the greater the distance the mass would move,
D)
The greater the mass, the greater the distance the mass would move,
Answer:
option c...................
If you were in charge of designing a wire to carry electricity across your city, state or province, which of
the following properties would be most important for your wire to have?
Should it be thick or thin, aluminum or nichrome, buried underground or installed out in the sun
Pleaseeee I need this done I beg Ill give brainiest and make sure its at least on paragraph if not then at least as many sentences as you can please
Answer:
Thin, aluminium and buried underground.
Explanation:
When it comes to electrification of a state or province, some characteristics of the wire to use must be considered. This would help to minimize and avoid power loss and wire burns.
i. The wire to use should be thin, and a quite number can be twisted one against the other so as to increase the surface area for heat dissipation.
ii. Aluminium wire is more preferable for this project. It has a high melting point, and reduces energy loss.
iii. Burying the wire underground through an insulator is the best choice, though expensive but would preserve the wire from external influence.
please help me guys please please please please please please please please please please please please please
Answer:
1.F = 256 N
2.a = 8 m/s/s
By looking at the given information, you know force, and an acceleration. Therefore you have enough information to use the first formula.
F = ma
256 N = m * 8 m/s/s
m = 256 N/8 m/s/s
m = 32 Kg
Example 4:
Find the index of refraction for diamond if the speed of light in diamond is 1.24 x 10m/s
Use the proper FORMAT
Answer:
Given speed of light in diamond =1.24*10m/s
speed of light (c) =3*10^8m/s
refractive index of diamond =3*10^8/1.24*10=2.41*10^7m/s
In music, the note G above middle C has a frequency of about 392 hertz. If the speed of sound in the air is 340 m/s, what is the approximate wavelength of this note?(1 point)
1.2 meters
8.7 meters
0.87 meters
0.0026 meters
Answer:
0.87 meters
Explanation:
How do we know when an object is in static or dynamic equilibrium?
Answer:
First Condition of Equilibrium
Explanation:
This means that both the net force and the net torque on the object must be zero. The condition Fnet=0 F net = 0 must be true for both static equilibrium, where the object's velocity is zero, and dynamic equilibrium, where the object is moving at a constant velocity.The sum of the forces on it in each direction is zero. The sum of the torques on it in each direction is zero. Its linear momentum is zero.what are the different benefit of walking?
Answer:
U can walk to the bathroom
Explanation:
The pressure due to the liquid on an object immersed in that liquid is 4500 Pa
The density of the liquid is 900 kg/m.
What is the depth of the object below the surface of the liquid ?
Answer:
The depth of the object below the surface of the liquid is 0.510 meters.
Explanation:
The hydrostatic pressure ([tex]P[/tex]), measured in pascals, experimented by the object is directly proportional to density of the fluid ([tex]\rho[/tex]), measured in kilograms per cubic meter, gravitational acceleration ([tex]g[/tex]), measured in meters per square second, and depth of the object ([tex]h[/tex]), measured in meters. That is:
[tex]P = \rho\cdot g \cdot h[/tex] (1)
If we know that [tex]P = 4500\,Pa[/tex], [tex]\rho = 900\,\frac{kg}{m^{3}}[/tex] and [tex]g = 9.807\,\frac{m}{s^{2}}[/tex], then the depth of the object is:
[tex]h = \frac{P}{\rho\cdot g}[/tex]
[tex]h = \frac{4500\,Pa}{\left(900\,\frac{kg}{m^{3}} \right)\cdot \left(9.807\,\frac{m}{s^{2}} \right)}[/tex]
[tex]h = 0.510\,m[/tex]
The depth of the object below the surface of the liquid is 0.510 meters.
The depth of the object below the liquid's surface will be
"0.510 m".
Pressure and DensityAccording to the question,
Object immersed, P = 4500 Pa
Density of liquid, ρ = 900 kg/m³
Acceleration due to gravity, g = 9.8 m/s²
We know the relation,
→ Hydrostatic pressure (P) = ρ.g.h
or,
Depth will be:
→ h = [tex]\frac{P}{\rho .g}[/tex]
By substituting the values,
= [tex]\frac{4500}{900\times 9.8}[/tex]
= [tex]\frac{4500}{8820}[/tex]
= 0.510 m
Thus the above answer is appropriate.
Find out more information about pressure here:
https://brainly.com/question/1831566
an object that is accelerating may be
It must be either speeding up, or slowing down, or turning. There are no other possibilities.
Does the mass of the objects you are charging influence the amount of electric force created in an electric field?
Explanation:
Both gravitational and electric forces decrease with the square of the distance between the objects, and both forces act along a line between them. In Coulomb's law, however, the magnitude and sign of the electric force are determined by the electric charge, rather than the mass, of an object.
If you are startled by a sudden loud noise, your (____)
activated.
nervous system is
A. autonomic
B. parasympathetic
C. somatic
D. sympathetic
Answer:
D. sympathetic
Explanation:
Need help please in physics
Answer:
the switching circuitry is opened the soft iron armature is replaced to tasty le macha the switching circuitry is closed explain what happens when the switch circuit is a wonder you know about the characteristics of open to close this which right take the example of an electric generator for an electric motor which rotates in half rotation and change the armature and just try it ok I am sorry
A block of lead has dimensions of 4.50 cm by 5.20 cm by 6.00 cm. The block weighs 1587 g. From this information, calculate the density of lead.
Answer:
11.3 g/cm^3
Explanation:
density = mass/volume
volume of rectangular prism = length * width * height
volume = (4.50 cm)(5.20 cm)(6.00 cm) = 140.4 cm^3
mass = 1587 g
density = (1587 g)/(140.4 cm^3)
density = 11.3 g/cm^3
Eiman connects eight 12Ω lamps in series. What is
the total resistance of the circuit?
please help
Answer:
Total resistance is 96 ohm
Explanation:
Rs = R1 +R2 + R3 + R4 + R5 +R6 + R7 + R8
where R1 is lamp 1
R2 is lamp 2 n so on
Rs = 12 + 12 +12 + 12 +12 + 12 + 12 + 12( as each lamp is of resistance 12)
Rs = 96 ohm
GOOD LUCK FOR THE FUTURE! :)
help me pls i really need it...
Answer:
directly proportional
Explanation:
.........,.............
Explain the benefits of understanding sound waves properties in real life.
Answer:
The vibrations from sound waves cause our ears to send signals to our brains to create sound. The speed of sound waves will determine the sound's pitch, or how high or low something sounds. Sound waves are important because they allow us to hear important messages and emergency signals to protect ourselves.
Explanation:
I hope this helps :)
A balloon of hydrogen is put into to pressure chamber. The initial pressure and volume of hydrogen is 1 atm and .5 cm3. The pressure of the chamber is increased to 2 atm. What is the new volume? Use the formula for Boyle's Law: P1V1 = P2V2
Answer:
2.5 cm³
Explanation:
Use Boyle's Law
1×5=2×V
5=2V
V=5/2=2.5 cm³
A protein-digesting enzyme when mixed with starch solution would
Answer:
It would produce fat..........
Plz help in this question.
Answer:
The area of the liquid surface does not affect the pressure.
Why isn't the story of Israel not fully accurate?
Answer:
wait what do you mean? And why is this in physics?
Is this about the iron dome or something biblical?
Explanation:
Answer:
the story of Israel is part of the Bible that's what what you're your lesson is
Explanation:
Which of the following shows a balanced nuclear reaction?
Answer:
No. 2
Explanation:
The balanced nuclear reaction is shown by the following: ²³⁷₉₃ Np[tex]\rightarrow[/tex]⁴ ₂He +²³³₉₅ Am nuclear fission reaction.
What are nuclear reactions?There are two types of nuclear reactions which are nuclear fusion and nuclear fission .They involve the combination and disintegration of the element's nucleus respectively.
In nuclear fission, the nucleus of the atom is bombarded with electrons of low energy which splits the nucleus in to two parts .Large amount of energy is released in the process.It is used in nuclear power reactors as it produces large amount of energy.
In nuclear fusion,on the other hand, is a reaction which occurs when two or more atoms combine to form a heavy nucleus.Large amount of energy is released in the process which is greater than that of the energy which is released in nuclear fission process.
Learn more about nuclear reactions,here:
https://brainly.com/question/12786977
#SPJ2
what are some activities you can do on a regular basis? Physical education
activities you can do on a regular basis for physical education?
If so
WalkingGardeningDancingBicyclingSwimmingYoga