Temperature is a measurement of :
1) total energy in a system
2) the average kinetic energy of a system
3) the average potential energy of a system
4) the ability to do work
Answer:
Temperature is a measure of the average kinetic energy of the particles in an object. When temperature increases, the motion of these particles also increases. (That should give you the answer if you read closely first sentence)
1. Explain where they bury remains at the Forensic Osteological Research Center and why
Answer:
In the middle of the forest.
Explanation:
They have to bury the remains in the middle of the forest at the Forensic Osteological Research Center in order to study the decomposition of the dead person. By studying the decomposition of dead person we can get a lot of information which can be used in the study of criminal cases and solving of crimes. The middle place in the forest is a perfect place to bury the remains due to presence of huge amount of microbes as well as insect that helps in the decomposition.
Two rocks one weighing 100m and the other weiging 200n are drpped from a 50-m cliff at the same time when both rocks are 10m from the ground and air friction is ignored which is the same
Answer:
Ignore all friction
Where is each conversion factor found?
Answer:
Explanation: A conversion factor is a number used to change one set of units to another, by multiplying or dividing. When a conversion is necessary, the appropriate conversion factor to an equal value must be used. For example, to convert inches to feet, the appropriate conversion value is 12 inches equal 1 foot.
What is the molarity of a solution made from dissolving 3.0 moles of Saline (NaCl) in 0.25 L of solution?
Answer: the answer is 12M
Explanation: 3.0mol/ 0.25L =12M
12M is the molarity of a solution made from dissolving 3.0 moles of Saline (NaCl) in 0.25 L of solution.
What is molarity?The amount of molecules of molecules divided by the quantity of liters in solution is the definition of molarity, a concentration unit in chemistry. It is crucial to comprehend how it is calculated as well as when to employ it in comparison to other units because it is among the most widely used concentration units.
A chemical solution's concentration is measured in molarity (M). It refers to the solute's moles per liter of solution. To be clear, this is not the same as the liters of solvents (a common mistake).
molarity = number of moles of solute/ volume of solution in litre
molarity =3.0mol/ 0.25L
=12M
Therefore, 12M is the molarity of a solution made from dissolving 3.0 moles of Saline (NaCl) in 0.25 L of solution.
To know more about molarity, here:
https://brainly.com/question/29884686
#SPJ2
When collecting temperature as a function of time for the reaction of KOH with HCL, which time is most significant
Answer:
At the completion of reaction.
Explanation:
The time when the reaction take places is the most significant time for measuring temperature of the solution because on this time the temperature will decrease or increase. Some reactions releases heat energy upon completion we called them exothermic reactions whereas some absorb heat energy from the surrounding, decreases the temperature which is known as endothermic reaction so measuring temperature at the completion of reaction is the correct time.
i need help with d and e
Answer:
D: False
E: Ethane
Explanation:
PLEASE HELP I WILL MARK YOU BRAINLIEST !!If you react 4.25 moles of FeCl2, how many moles of Cl2 did you also react?
PLEASE IM BEGGING FOR HELPPPPP
Answer:
2 FeCl2 + Cl2 -> 2 FeCl3
According to numbers in reaction
Amount of Cl2 is half of FeCl2
Explanation:
Select the most reactive metal from the options below
Iron
Copper
Zinc
Gold
Answer: Hello, This is my most favorite class so I know this is right.
The most Reactive metal source is Copper.
Explanation:
This is the most reactive because it contains Lithium supplement.
Your Welcome! Mark me as Brainliest! :)
Pls help will give brainlist
Answer:
D. 5
Explanation:
The coefficient will almost always be the whole number in front of the variable.
example
5(x)= 7
The coefficient would be 5.
How do I do nunber 8?
Answer:
DONT CLICK THAT LINK THAT IS HACK AND VIRUS
Explanation:
En una planta de energía, se produce CO2 gracias a la reacción de combustión del material orgánico con oxígeno para producir CO2, SO2, SO3, NO, NO2 y H2O que son los causantes del efecto invernadero, el SO2 reacciona con H2O para formar H2SO3, causante de la lluvia ácida. En condiciones de gas ideal el SO2 se encuentra a una temperatura de 100°C y 0,5 atm de presión, el volumen ocupado generalmente es de 25 L. 5. La ecuación para hallar el número de moles debe ser: a. Gases ideales: relación entre todas las variables que influyen sobre los gases b. Boyle: relación entre volumen y presión c. Charles: relación entre el volumen y la temperatura d. Gay Lussac: relación entre la presión y la temperatura
Answer:
a. Gases ideales: relación entre todas las variables que influyen sobre los gases
Explanation:
La ecuación del gas ideal da la relación entre las variables; presión, volumen, temperatura y número de moles.
Según la ecuación del gas ideal; PV = nRT
P = presión del gas
V = volumen del gas
n = Número de moles del gas
R = constante de gas
T = temperatura del gas
El número de moles de SO2 se obtiene de;
n = PV / RT
n = 0,5 * 25 / 0,082 * 373
n = 12,5 / 30,586
n = 0,41 moles
The number of protons is equal to
a the number of neutrons.
b the atomic mass.
c the number of electrons.
d the atomic number.
Answer:
c the number of electrons
:)
Why is water called.compound
Answer:
because it's composed of two elements, hydrogen and oxygen. water is technically a molecular compound tho, for it has two hydrogens.
4) What mass of hydrogen is formed when 2.00g of magnesium
Mg + H2SO4–>H2SO4
Answer: 0.16 g H2
Explanation:
Mg+ H2SO4= MgSO4 + H2
Atomic massof Mg is 24
Molecular mass of H2 is 2
So,
24g Mg produce 2 g H2
1g Mg produce (2÷24)= 0.083 g H2
2.00g Mg produce (0.083×2) g H2
= 0.16 g H2
0.16g of hydrogen is formed when 2.00g of magnesium.
The mass of hydrogen gas formed when 2.00g of magnesium is equal to 0.165 g.
What is the balanced chemical equation?The chemical equation of a reaction is said to be a balanced equation when the number of atoms of substances is equal on either side of the equation.
Evergy balanced chemical equation must follow the law of conservation of mass according to which the total mass of the substances present on the reactant side should be equal to the total mass of substances present on the product side.
Given, the balanced chemical equation of the reaction of Mg and sulfuric acid:
[tex]Mg + H_2SO_4 \longrightarrow MgSO_4 +H_2[/tex]
One mole of magnesium produces hydrogen gas = 1mol
Given the mass of magnesium = 2g
The number of moles of Mg = 2/24.3 = 0.082 mol
Then the number of moles of hydrogen gas formed = 0.082 mol
The mass of the hydrogen gas = 0.082 × 2 = 0.165 g
Learn more about the balanced chemical equation, here:
brainly.com/question/15052184
#SPJ2
What is the mass of water released by the heating? Show your work or explain your reasoning.
Answer:
Dividing the mass of the water lost by the original mass of hydrate used is equal to the fraction of water in the compound. Multiplying this fraction by 100 gives the percent water in the hydrate.
Explanation:
The amount of water throughout the compound has been determined by dividing the mass of water wasted mostly by original quantity of hydrate used. The above fraction can be multiplied by 100 to get the hydrate's water content in percentages.
What is mass ?The proportion of matter that makes up an object is quantified by its mass. The kilogram, or kg, would be the fundamental SI unit of mass.
What is hydrate?Any substance that contains water through the form of H2O molecules is referred to as a hydrate. This water content by weight can vary, but it is typically fixed. The most well-known hydrates seem to be crystalline solids which decompose once the attached water is removed.
Therefore , The amount of water throughout the compound has been determined by dividing the mass of water wasted mostly by original quantity of hydrate used. The above fraction can be multiplied by 100 to get the hydrate's water content in percentages.
To know more about mass and hydrate.
https://brainly.com/question/11202174
#SPJ3
If magnesium and nickel were used as electrodes to construct an electrochemical cell like the one shown at right, which metal would form the anode and which the cathode?
anode:
cathode:
Answer:
anode: magnesium
cathode: nickel
Explanation:
edg. 2021
Newtons law of motion
A Jeweler is making sapphire rings using 2 sapphires on every 1 ring. If the jeweler has 12 sapphires and 10 rings, what is the theoretical yield? (3 points)
O 5 sapphire rings
O 6 sapphire rings
O 10 sapphire rings
O 12 sapphire rings
3 (05 05 LC)
The theoretical yield is 6 sapphire rings.
What is Theoretical yield?This is the total product formed as a result of the complete conversion of
the reactants. In this scenario, the reactant is the 12 sapphires in which 2
of it is needed to produce one sapphire ring.
This however translates to the theoretical yield being 6 sapphire rings
which is gotten by:
2 sapphires = 1 ring
12 sapphires = x
Cross multiply
2x = 12
x= 12/2 = 6 sapphire rings.
Read more about Theoretical yield here https://brainly.com/question/25996347
Directions Identify the reactants and product in the following reaction.
4A1+302 → 2A1203
What does chemistry mean?
Answer:
The definition of chemistry is a branch of science that deals with the form and properties of matter and substances or the interaction between individuals.
How are beef and gas productions related to methane levels?
Plzzz answer quick
Answer:
Cows and other ruminant animals (like goats and sheep) emit methane, a potent greenhouse gas, as they digest grasses and plants. This process is called “enteric fermentation,” and it's the origin of cows' burps.
Explanation:
40 g of NaCl is added to 1500 g of water. What is the molality of the resulting
solution?
Molality = moles of solute/mass (in kg) of solvent
The solute here is NaCl, of which you have 40 g or 40/58.4428 = 0.6844 moles NaCl.
The solvent here is water, of which you have 1500 g or 1.500 kg H2O.
The molality of the resulting solution would thus be 0.6844 moles NaCl/1.500 kg H2O = 0.4562 mol/kg.
If you have to consider sig figs, then your final answer would have one sig fig (40 g has one sig fig). In that case, your final answer would be 0.5 mol/kg.
3Ba(C2H3O2)2 + 2K3PO4 ⟶ Ba3(PO4)2 + 6KC2H3O2
If 4.36 mol of potassium phosphate react, how many grams of barium phosphate are produced?
Hello Mistyann!
First you need to know amount of barium phosphate is
Half of potassium phosphate, also 2.18 mol.
Molar mass of Barium phosphate is 3·137.2 + 2·(30.97+4·16) g/mol
You can calculate it yourself dear.
Now mass is amount of substance · molar mass.
It has been an honour to teach you, dear,
God bless!
Why is there no answer
Answer:
i don't know
Explanation:
.
Characteristics of a Group of Elements
Do not conduct electricity
• Mostly gas, but brittle when solid
Has 7 valence electrons
.
Which of these elements is in this groun?
Answer:
Gas
Explanation:
I dunno but a lucky guess i guess
how many protons electrons and neutrons does the following isotopes contain 1H+
Answer:
The other name for this isotope is a proton. This is because it contains just a single proton.
Explanation:
H+
Protons = 1
Electrons = 1 - 1 = 0 (The + sign means it has lost a single electron)
Neutrons = 0
Which organ detects stimuli from the environment and is part of the nervous system?
Group of answer choices
A. eye
B. stomach
C. heart
D. lungs
It's the eye because it's the organ of sight
1. A wave has a frequency of 800 Hz and a wavelength of 2000 cm. What speed
is this wave traveling?
Answer:
V=f*(wavelength)
V= (800)(20m)
16000m/s
Explanation:
Can somebody just name all the metalloids, gases, and liquids that are on the periodic table. please this is due in a hour!!!
Answer:
There are six liquid elements present in the periodic table. They are bromine,mercury ,caesium,gallium,rubidium and francium.
The metalloids; boron (B), silicon (Si), germanium (Ge), arsenic (As), antimony (Sb), tellurium (Te), polonium (Po) and astatine (At) are the elements found along the step like line between metals and non-metals of the periodic table.
The gaseous element group; hydrogen (H), nitogen (N), oxygen (O), fluorine (F), chlorine (Cl) and noble gases helium (He), neon (Ne), argon (Ar), krypton (Kr), xenon (Xe), radon (Rn) are gases at standard temperature and pressure (STP).
Explanation: