Answers
Explanation:
Function of circuit
The circuit is a "full adder". Its S output is the least-significant bit of the binary sum of the inputs A, B, C. Its C output is the most-significant bit of that 2-bit binary sum. The "S" and "C" refer to "sum" and "carry", respectively.
Truth table
See the attachment for the truth table. The column in gray is the decimal representation of the sum of the inputs A, B, C.
Answer:
Function of circuit
The circuit is a "full adder". Its S output is the least significant bit of the binary sum of the inputs A, B, C. Its C output is the most-significant bit of that 2-bit binary sum. The "S" and "C" refer to "sum" and "carry", respectively.
The circuit is a "full adder". Its S output is the least significant bit of the binary sum of the inputs A, B, C. Its C output is the most-significant bit of that 2-bit binary sum. The "S" and "C" refer to "sum" and "carry", respectively.Truth table
The circuit is a "full adder". Its S output is the least significant bit of the binary sum of the inputs A, B, C. Its C output is the most-significant bit of that 2-bit binary sum. The "S" and "C" refer to "sum" and "carry", respectively.Truth tableSee the attachment for the truth table. The column in gray is the decimal representation of the sum of the inputs A, B, C.
Related Questions
State three means of operating a power tool
Answers
when you are performing an advanced filter, in which argument box do you enter the range for the dataset?
Answers
A fresh air louver mounted on an exterior wall and equipped with a damper to allow to allow the required fresh air into the boiler room
A should be closed
B remain open at all times
C should be open when the boiler off
D should open and close automatically
Answers
Answer:
DDDDDDDD
Explanation:
I THINK...............
On diesel engines, data from ________ sensors are commonly used to adjust exhaust gas recirculation (EGR) rates.
Answers
Answer:
Air mass sensors is the right answer i think
Explanation:
What is true about a point and shoot camera?
They always have lenses u can take on and off
They are often smaller than SLR cameras
They are used by professionals more often that SLR cameras
All of the above
Answers
Answer:
What is true about a point and shoot camera?
They are often smaller than SLR camerasAnswer:
They are often smaller than SLR cameras
Explanation:
If we have to become a pilot what class should we choose
.
Science,
economics,
or commerce
Answers
Answer:
Class Not Necessary For Army
Explanation:
Just a normal degree is enough
Answer:
Degree Is Enough
Explanation:
Bcz of There is Class
Technician A says that comparing the front vehicle height sensors to the rear sensors allows the ECM to determine body roll created by cornering force. Technician B says that vehicle height sensors are only located on the rear. Which technician is correct
Answers
Answer:
its b
Explanation:
How deep does electrical conduit need to be buried?
Answers
A person’s ability to use understand and relate to technology is known as :
A: Technology literacy
B: computer literacy
C: Technology knowledge
D: computer comprehension
Pick one out of those please
Answers
Answer:
A: Technology literacy
I took a computer class in the 8th grade.
Explanation:
hope this helps. . . <3
good luck! uωu
Cooling water available at 10°C is used to condense steam at 30°C in the condenser of a power plant at a rate of 0.60 kg/s by circulating the cooling water through a bank of 7-m-long 1.2-cm-internal-diameter thin copper tubes. Water enters the tubes at a mean velocity of 4 m/s and leaves at a temperature of 24°C. The tubes are nearly isothermal at 30°C. Determine the average heat transfer coefficient between the water, the tubes, and the number of tubes needed to achieve the indicated heat transfer rate in the condenser.
Answers
Answer:
Dang this looks hard
Explanation:
two solid yellow center lines on a two-lane highway indicate:
Answers
What was jimmy neutron's first invention?
Answers
Answer:
oh i like this film
Explanation:
ye ye
Explain the purpose of wrench plzzz
Answers
Answer:
Wrenches are made in various shapes and sizes and are used for gripping, fastening, turning, tightening and loosening things like pipes, pipe fittings, nuts and bolts. There are basically two major kinds of wrenches: Pipe wrenches used in plumbing for gripping round (cylindrical) things.
Plzz help me plzzzz plzz
Answers
Answer:
A. Air powered
Explanation:
Pneumatic tools are compressed air driven power tools powered by an air compressor.
FOR DARKEND1
÷
try copy and paste
Answers
Answer:
FOR DARKEND1
÷
try copy and paste
Explanation:
interesting , no idea who Darkend1. Divide copy by paste
is there water on mars
Answers
Answer:
nope, it is phsically impossible for water to be on mars
Explanation:
when the filament breaks in one lamp in a series circuit, other lamps in the circuit normally _________.
Answers
Answer:
when the filament breaks in one lamp in a series circuit, other lamps in the circuit normally stop working.
Explanation:
What is energy security, and why is it an important issue for many countries?
Answers
Answer:
What is energy security? Energy security is the association between national security and the availability or natural resources for energy consumption.
why is it an important issue for many countries? To ensure that their economics function without interruption and that their people have access to adequate, reliable and affordable supplies of modern and clean energy
an automobile radiator is filled to the brim with water when the engine is cool. what happens to the water when the engine is running and the water has been raised to a high temperature?
Answers
Answer:
(a) As the water rises in temperature, it expands or rises in pressure or both. The excess volume would spill out of the cooling system, or else the pressure would rise very high indeed.
(b) Modern cooling systems have an overflow reservoir to accept the excess volume when the coolant heats up and expands.
Explanation:
hope it helps!
Water expands more when the temperature is elevated, increasing its volume. Consequently, the steel radiator will leak water. When the engine is running, the water is heated to higher temperatures, which causes it to expand and spill out.
What engine is running, the water raised to a temperature?Your engine should operate between 195 and 220 degrees, according to the majority of experts. Your needle should always remain centered in your gauge in ideal circumstances.
A thermostat, cylinder sleeve, cooling water pump, and heat exchanger are all components of an engine cooling water system. Water System for Engine Cooling. The cooling water must be circulated throughout the engine by a cooling water pump.
Therefore, This is due to the fact that radiator water will freeze when temperatures in colder countries fall below zero degrees, which is the freezing point of water.
Learn more about engine here:
https://brainly.com/question/2973143
#SPJ2
what factors need to be considered when building housing on a waterway
Answers
Answer:
Flooding
Explanation:
.
When building housing on a waterway one must always consider the factor of Flooding and its repercussions.
What is a Flood?A flood occurs when there is an excessive amount of water and it covers normally dry areas. The word can also refer to the tide's influx when used in the sense of "flowing water." Floods are a topic of research in the hydrology field and are very important to the fields of agriculture, civil engineering, and public health.
Floods have serious societal repercussions for both communities and people. As most people are well aware, flooding has a number of direct effects, including the loss of life, destruction of property, loss of crops and livestock, and worsening of health due to waterborne infections.
Stream gauges that are put in bodies of water close to inhabited areas are used to measure floods. The National Weather Service receives all data collected by them before it is sent to the United States Geological Survey (USGS), which erected and operates them (NWS)
To read more about Floods, refer to - https://brainly.com/question/28725721
#SPJ2
State three means of operating a power tool
Answers
Please help me please
Answers
Answer: C
Explanation:
soy nueva en esto me pudieran ayudar nadie me ayuda soy de peru y no endiendo nada de lo que me dicen alguie me puediera explicar como se utiliza esta fuente y si me pudiera guir y ser mi amigos o amiga para que me ayude , le agradecira un monton
Answers
Answer:
Explanation:
Tu pon lo que ocupes y espera
PDA is an abbreviation for professional diagnostic assistant
True or false
Answers
Answer:
False
Explanation:
It means Public Display of Affection
My cramps hurt sm and I’m so emotional
Answers
Answer:
Okay? I can try to help you.
Go to sleep.Cry in pain.I hope this helped at all.
Answer:
Man up you women. Eat some travis scuout burjer
Some benefits of science
Answers
Answer:
Scientific knowledge allows us to develop new technologies, solve practical problems, and make informed decisions — both individually and collectively. Because its products are so useful, the process of science is intertwined with those applications: New scientific knowledge may lead to new applications.
Explanation:
It helps us organize our daily activities.
This helps our work can be done faster.
It helps us to communicate more easily with others.
This helps us to better know and understand other cultures and societies.
Scientific knowledge also allows us to develop new technologies, solve practical problems, and make informed decisions — both individually and collectively. Because its products are so useful, the process of science is intertwined with those applications: New scientific knowledge may lead to new applications.
Which type of weld is made by welding around the perimeter of a
hole?
Answers
Joints between two overlapping components are made by depositing a fillet weld around the perimeter of a hole in one component so that it can be attached to the surface of another component exposed through the hole.
What emerging technologies will make electrical energy safer, more usable, more efficient, cleaner?
Answers
Answer:
Technion - photovoltaic cell efficiency
A team of researchers at Israel's Technion research university has created new photovoltaic technology to harness lost radiation and convert it into energy, boosting solar cell efficiency from 30 to 50 percent.
Explanation:
State three means of operating a power tool
Answers
Answer:
A power tool is a tool that is actuated by an additional power source and mechanism other than the solely manual labor used with hand tools. The most common types of power tools use electric motors. Internal combustion engines and compressed air are also commonly used. Other power sources include steam engines, direct burning of fuels and propellants, such as in powder-actuated tools, or even natural power sources such as wind or moving water. Tools directly driven by animal power are not generally considered power tools.
Power tools are used in industry, in construction, in the garden, for housework tasks such as cooking, cleaning, and around the house for purposes of driving (fasteners), drilling, cutting, shaping, sanding, grinding, routing, polishing, painting, heating and more.
Power tools are classified as either stationary or portable, where portable means hand-held. Portable power tools have obvious advantages in mobility. Stationary power tools, however, often have advantages in speed and precision. A typical table saw, for instance, not only cuts faster than a regular hand saw, but the cuts are smoother, straighter, and more square than what is normally achievable with a hand-held power saw. Some stationary power tools can produce objects that cannot be made in any other way. Lathes, for example, produce truly round objects.
Stationary power tools for metalworking are usually called machine tools. The term machine tool is not usually applied to stationary power tools for woodworking, although such usage is occasionally heard, and in some cases, such as drill presses and bench grinders, exactly the same tool is used for both woodworking and metalworking.
Explanation:
Multiple Choice
1.
is light-gauge metallic tube used to route wires.
A. Electrical metallic tubing (EMT)
B. Flexible metal conduit (FMC)
C. Rigid metal conduit (RMC)
D. Polyvinyl chloride (PVC) conduit
Answers
Answer:
I guess A number is right