what is the k expression for this reaction? plz help !

The mass of a substance is the product of its density and volume. Thus, the   mass of the dissolved solids with a density of 125 mg/dm³ with a volume of 250 cm³ is 31.25 mg.

Density of a substance is the measure of its mass per unit volume. Thus it describes how much denser the substance is in a given volume. Mathematically it is the ratio of mass to the volume.

Density of a substance depends on the mass, volume, bond type, temperature and pressure. The ratio of density of a substance with the density of water is called its specific gravity.

It is given that the density of the dissolved solids is 125 mg/dm³ and the volume is 250 cm³ or 0.25  dm³. Thus the mass can be calculated as follows:

density = mass/volume

 mass   = density × volume

             = 0.25  dm³  ×  125 mg/dm³

             = 31.25 mg

Hence, the mass of the dissolved solids in the river wayer is 31.25 M=mg.

To find more on density, refer here:

https://brainly.com/question/15164682

#SPJ2

Answer:

hey here is the answer to your question.

Explanation:

1) Write a balanced equation for the reaction occurring. (*Iron occurs in a few different oxidation states, but I will assume we're referring to Fe(II) or Fe2+)

Fe + CuSO4 -> Cu + FeSO4

2) Calculate the number of moles of each reactant.

Fe: 1.924 g * (1 mol / 55.85 g) = 0.03455 mol Fe

CuSO4: 0.1363 L * (0.0750 mol / 1 L) = 0.01022 mol CuSO4

3) Determine the limiting reactant. Because we have fewer moles of copper(II) sulfate and are reacting both reactants in a 1:1 ratio, we will run out of copper(II) sulfate first, making it the limiting reactant.

4) Convert moles of the limiting reactant to moles and grams of product of interest.

0.01022 CuSO4 (1 mol Cu / 1 mol CuSO4 ) (63.55 g Cu / 1 mol Cu) = 0.6495 g Cu

Answer:

Not really sure, buts its either B or C.

Answer:

The restoring force that prevents the furniture from tipping over when pushing the furniture towards the right, F= W × D

Where;

W = The weight of the furniture

D = The horizontal distance from the center of gravity of the furniture, CG and the to the lower right corner of the furniture

Given that A > D, for the furniture to tip over when pushing above the CG, we have;

F1 × A ≤ W × D

∴ F1 << W or for a force much smaller than W, the weight of the furniture applied above the center of gravity, the furniture will tip over

However when the force F2 is applied, where C < D, we have for no tipping over;

F2 × C ≤ W × D, therefore, given that C < D, when a force much higher than the weight, W, is applied at F2, the furniture will remain upright

Therefore, it is better push at a point lower than or equal to the center of gravity, whereby the point B is lower than the center of gravity, it is better to push at point B, Ravleen is correct and it is better to push at point B because the center of gravity is lower

If the furniture is pushed at the wrong spot it may tip over

Please see attached drawing

Explanation:

Answer:

[tex]at \: stp : \\ 22400 \: ml \: are \: occupied \: by \: 71 \: g \: of \: chlorine \\ 563 \: ml \: will \: be \: occupied \: by \: ( \frac{563}{22400} \times 71) \:g \\ = 1.78 \: g[/tex]

Explanation:

[tex]PV = nRT \\ (200000 \times 3.5 \times {10}^{ - 6} ) = n \times 8.314 \times 300 \\ n = \frac{0.07}{2494.2 } \\ n = 2.81 \times {10}^{ - 5} [/tex]

[tex] \small{ \star{ \underline{ \blue{ becker}}}}[/tex]

Answer:

HI

H₂O

H₃O⁺

I⁻

Explanation:

Bronsted-Lowry acids are chemicals that can donate protons, and Bronsted-Lowry bases are chemicals that can accept them. Conjugate bases and acids are the resulting effect of losing or gaining a proton in the form of H⁺.

From a chemicals standpoint, Student 2 contends that as global population grows, so does the need for water. This is the correct reasoning.

What is the purpose of chemistry?

Our basic needs of food, clothes, shelter, health, energy, and pure air, water, and soil are all met by chemistry. Chemical technologies improve our quality of life in many ways by offering fresh approaches to issues with health, resources, and energy use.

What subjects are studied in chemistry?

The study of matter, including its properties, behaviours, and structures, is known as chemistry. Chemists induce and monitor these reactions both in nature and artificially in a lab setting because they are interested in how materials behave and react in specific settings.

To know more about chemicals visit:

brainly.com/question/29240183

#SPJ1

Answer:

equal to [OH-]

Hydrogen ion concentration is more conveniently expressed as pH, which is the logarithm of the reciprocal of the hydrogen ion concentration in gram moles per liter. Thus, in a neutral solution the hydrogen ion (H+) and the hydroxyl ion (OH−)

Answer:

C5P4

Explanation:

the answer is C5P4 because penta is 5 and tetra is 4

Answer:

the addition to solute decreases the solvent's vapor pressure. a temperature must then be applied to overcome the change

Explanation:

Answer:

long story short: A

Explanation:

Answer:

c) NOx and VOC

oxides of nitrogen (NOx) and volatile organic compounds (VOC)

Explanation:

-

Answer:

See Explanation

Explanation:

In discussing the reason why Et₃SiCl is more easily hydrolysed than Et₃CCl, we must remember that the electronegativity difference between silicon and chlorine is much higher than the electronegativity difference between carbon and chlorine.

As a result of this, the Si-Cl bond in Et₃SiCl is more polar and hence susceptible to attack by water than the C-Cl bond in Et₃CCl.

Also, it is postulated that the presence of vacant d orbitals on silicon assists hydrolysis in Et₃SiCl. Such vacant orbitals are absent in carbon hence Et₃CCl does not undergo hydrolysis.

The reaction scheme is shown in the image attached to this answer.

Answer:

1. Allele for shortness (t)

2. Allele for tallness (T)

Explanation:

Gregor Mendel performed numerous experiments using pea plants (Pisium sativum). He tested the height traits of pea plants by crossing tall pea plants (TT) and short pea plants (tt) to obtain offsprings that were all tall (Tt) in the first filial generation (F1).

This is possible because the allele for tallness is DOMINANT while the allele for shortness is RECESSIVE. This means that tallness allele (T) will mask the phenotypic expression of shortness allele (t) when in an heterozygous state (Tt) as in the F1 generation.

Answer:

Carbon and oxygen combine to form two oxides, carbon monoxide and carbon dioxide in which the ratio of the weights of carbon and oxygen is respectively 12:16 and 12:32.

Answer:

9.0 moles of CaO

Explanation:

We have the reaction equation as follows;

Fe2O3 + Ca3(PO4)2 -------> 2FePO4 + 3CaO

Now we know from the equation that;

1 mole of iron III oxide yields 3 moles of CaO

Therefore;

3 moles of iron III oxide yields 3 * 3/1

= 9.0 moles of CaO

V2 = 21.4 ml

Explanation:

Note: When dealing with gases, make sure that you change the units from °C to K.

T1 = 15°C + 273 = 288K

T2 = 35°C + 273 = 308K

V1 = 20 ml

V2 = ?

We use Charles's law to solve V2:

V1/T1 = V2/T2

or

V2 = (T2/T1)V1

= (308K/288K)(20 ml)

= 21.4 ml

Answer:

C: checking your email

Explanation:

I believe that C would be impossible, as you cannot use wireless networks without radio waves

Answer:

correct answer is d)

Explanation:

This answer demonstrates law of conservation of mass because the mass of the products is equal to the mass of reactants with the help of the coefficients which is the process known as balancing. This answer also includes the correct formulas, as Br is a gas so it MUST be written as Br2. hope this helps:)

2Al(s) + 3Br2(1) - 2AlBr3(s) is the  correct formulas and demonstrates conservation of mass.

Every action has an equal and opposite response, states Newton's Third Law. This indicates that any force applied to an item will have an equal and opposite-directed response force of the same magnitude. A force pair is the collective name for these connected forces.

Each individual object will have a different force pair with each other object in systems of numerous objects where all things interact. In the case of charged particles, the charge of each object will dictate the direction of each force in the force pair.

Similar charges will cause particles to repel one another by directing their forces away from one another. With their forces pointing in the same direction, particles with opposing charges attract one another.

Therefore, 2Al(s) + 3Br2(1) - 2AlBr3(s) is the  correct formulas and demonstrates conservation of mass.

To learn more about mass, refer to the link:

https://brainly.com/question/19694949

#SPJ2

Answer:

Explanation:

The properties that are observed or measured without changing the composition of matter are called physical properties.

color, Temperature, Texture are the physical properties as the composition of matter remains the same.

On the other hand, Radioactivity, Flammability and Reactivity comes under chemical property as during the chemical reactions there might be some changes in the properties.

Answer:

d

Explanation:

Coal is extracted by mining.

Once coal has been extracted, it can be used directly  for heating and industrial processes or to fuel power plants for electricity.

Benefits are:

Coal energy is an affordable energy source because of the coal's stable price compared to other fuel sources.

Coal is easy to burn.

Coal produces high energy upon combustion.

Coal energy is inexpensive.

Answer:

pH = 5.37

Explanation:

We'll begin by obtaining the concentration of the hydrogen ion in the solution. This can be obtained as follow:

HNO₃ (aq) —> H⁺ (aq) + NO₃¯ (aq)

From the balanced equation above,

1 mole of HNO₃ produced 1 mole of H⁺.

Therefore, 4.3×10¯⁶ M HNO₃ will also produce 4.3×10¯⁶ M H⁺.

Finally, we shall determine the pH of the solution. This can be obtained as follow:

Concentration of Hydrogen ion [H⁺] = 4.3×10¯⁶ M

pH =?

pH = –Log [H⁺]

pH = –Log 4.3×10¯⁶

pH = 5.37

Therefore, the pH of the solution is 5.37

Answer: A planet from a rain forest would not survive in a desert home, for the fact they depend on water and as these live from water, without it, this leads to dehydration and with loss of water with plants, nothing is able to survive when it comes to a rain forest plant being in a desert home. Another reason is the high trees and leaves that are providing the plants enough sunlight or shade to grow, it guarantees to help keep the temperature normal. Being in a deserted area would mean that there would be a temperature change, something the plant is not used to. Without that needed shade and avoiding the scorching sun, they will die out from how different the temperature is, and how hot it is.

Explanation: I hope this helped you.

okay, the answer should be simple and easy, plants from a rainforest would not survive in a desert because the plants in the rainforest do get water, sunlight and air whereas the plants in the desert have Sunlight which is very hot. so if a plant in the rainforest was transferred to the desert it will hard to survive and it will eventually die because they will not get water that will be needed and the plant can get sunburns with the too hot temperature.

Answer:

34.92 grams NaCl (in 1 L of solution)

Explanation:

The chemical formula of sodium chloride is NaCl. From the formula, we can calculate the molar mass of NaCl:

MM(NaCl)= MM(Na) + MM(Cl) = 23 g/mol + 35.4 g/mol = 58.4 g/mol

A solution of NaCl with a molarity of 0.598 M has 0.598 moles of NaCl per liter of solution. So, we multiply the moles by the molar mass of NaCl to calculate the mass we need:

mass of NaCl = 0.598 mol x 58.4 g/mol = 34.92 g NaCl

Therefore, we need 34.92 grams of NaCl to prepare 1 liter of a solution with a molarity of 0.598 M.