Why are some isotopes radioactive and some are not?
Answer: there are atoms that either have too many or too few neutrons or protons in their nuclei. This results in an imbalance between the jedi forces holding them together, which leads to an excess of internal energy. Such atoms are said to be unstable or radioactive.
Explanation:
What is the answer 24.3m
A car drives with constant speed of 112km/h. How long will it take to travel to distance of 56 kilometers?
112 km is travelled by car in 60 minutes
1 km is travelled by car in 60/112 minutes
56 km is travelled by car in 60/112*56 = 30 minutes = 0.5 hours
Explanation:
find the volume. mass is 9.75 g and the density is 15.6 g/cm3
Answer:
1.6cm3
Explanation:
density = mass/volume
15.6g/cm3= 9.75 g/volume
15.6/9.75 = volume
1.6cm3 = volume
Suppose you set a glass of water in direct sunlight for 2 hours and measure its temperature every 10 min . What type of graph would you use to display your data .
HELP ASAP PLS
Answer:
line graph
Explanation:
The type of graph would be used to display the data is line graph.
What is graph?Graph is defined as a visual representation, such as a picture or diagram, that shows information or values in a structured way. The graph's goal is to visually represent numerical data so that it can be quickly, simply, and clearly understood. As a result, graphs are visual displays of data.
Although a graphical display is easier to understand, data can also be presented as a table. For this kind of data, a line graph will be used. This will show more clearly how the temperature of the water fluctuates over the course of two hours. Time is an independent variable, whereas temperature is a dependent variable.
Thus, the type of graph would be used to display the data is line graph.
To learn more about graph, refer to the link below:
https://brainly.com/question/17267403
#SPJ5
what is your definition of science?
**ANSWER AND ILL GIVE YOU BRAINLIEST ANSWER**
It has been proposed that mitochondria and chloroplasts are modern descendants of early prokaryotic cells that began to reside and gradually evolve within primitive cells.
Answer:
mitochondria and chloroplasts both have prokaryotic ribososmes
Explanation:
Mitochondria and chloroplasts are the modern descendants of early prokaryotic cells. These lived in primitive cells and later developed into part of them. This hypothesis is supported because both mitochondria and chloroplasts have their own primitive ribosomes. These two organs contain 70s ribosomes.2) A wooden block has a volume of 176 cm3 and a density of 18.2 g/ cm3. What is the mass?
Answer:
3,203.2 g
Explanation:
density multiplied by volume gives you the mass, and both cm3 cancel eachother out so you are left with just g.
As a star uses up its hydrogen supply, it changes from a main sequence star to a -
A.) dwarf
B.) supernova
C.) black hole
D.) giant
As a star uses up its hydrogen supply, it changes from the main sequence star to a Giant. Thus, the correct option for this question is D.
What is a Star?A star may be defined as a type of huge celestial body that is generally constructed of hydrogen and helium that produce light and heat from the churning nuclear forges inside their cores. They are the luminous bodies that are visible in the sky at night.
A giant is a type of star that has utilized its hydrogen supply in its cores and transformed itself into the thermonuclear fusion of hydrogen in the shell that envelops its surroundings.
This creates an outwards force and stimulates fusion that initiates to increase and hence the star can not able to maintain its equilibrium longer.
Therefore, as a star uses up its hydrogen supply, it changes from the main sequence star to a Giant. Thus, the correct option for this question is D.
To learn more about Red giant, refer to the link:
https://brainly.com/question/27111741
#SPJ6
Shreya spent $16 on a magazine and some
erasers. If the magazine cost $7 and each
eraser cost $3, then how many erasers did
she buy?
Answer:
she bought 3 erasers an got two dollars back
Explanation:
What are the units for Rf values? Please help!
Answer:
Microwatts.
Explanation:
RF + EMF Unit Conversion Charts: Interpreting exposure levels. When measuring Radio Frequencies, the most common units of measurement are microwatts per square meter (µW/m2), microwatts per square centimeter (µW/cm2) and volts per meter (V/m).
Answer:
No units
Explanation:
In Thin Layer Chromatography (TLC), retention factor (Rf value) is found by taking the distance travelled by the spot divided by the distance of the solvent front. Rf value is a ratio of distances hence they have no units.
Mathematical derivation
The distance travelled by the spot is in cm, and that of the solvent front is also in cm. Thus, dividing the two units would give us no units for the Rf value.
What is TLC?
TLC is a technique used for separation and identification. The stationary phase is polar while the solvent is relatively nonpolar. Thus, the less polar substance is more attracted to the solvent (according to the principle of 'like attracts like') and travels further and thus have a higher Rf value.
To learn more about Rf values, check out: https://brainly.com/question/14393140
A regulation that should be followed to prevent accidents is called safety blank
Answer:
Safety Regulations
Explanation:
hope this helps:)
Which molecule is sometime referred to as “the recipe book for how to make a protein"?
Answer:
RNA molecules
Explanation:
RNA molecules carry the instructions that are necessary to create proteins
Answer:
RNA molecules
Explanation:
RNA molecules carry the instructions that are necessary to create proteins
Will give Brainlest for correct answers
How is kinetic energy affected by temperature
Answer:
Temperature affects the kinetic energy in a gas the most, followed by a comparable liquid, and then a comparable solid. The higher the temperature, the higher the average kinetic energy, but the magnitude of this difference depends on the amount of motion intrinsically present within these phases
Explanation:
I just know lol
The sum of the number of protons and neutrons in an atom is called the ________ of the element. 1. Molar Mass 2. Atomic number 3. Average atomic mass 4. Mass number
o2 o4 o3 o1
Answer:
The sum of the number of protons and neutrons in an atom is called the Mass number.
How many kinds of atoms are there
Answer:
there are more than 109 different types of atom - one for each element.
Why will a toy train remain still if you push on the engine with
A force of 3 N and your friend push on the caboose with a
Force of 3 N?
Explanation:
Because when two equal forces are applied from opposite directions, they "eliminate" each other.
The train would go right if a 3N force was only applied in the right direction, and it would go left if the same force was only applied to the left.
If a 3N force was applied to the right and a 2N force to the left, it would equal a 1N force to the right (3-2=1).
But there it's 3-3=0, so in practice the force is 0N. Therefore the train won't move.
The reaction between a strong acid and a weak base produces a salt, but water is not usually formed because:
the reaction is too hot and water evaporates
there is no hydrogen present to form water
the acid is not strong enough to form water
weak bases tend not to be hydroxides
Answer:
3
Explanation:
standard units of measure for density
Answer:
g/cm³ for solids,
g/ml for liquids
g/L for gases.
Explanation:
Though SI unit of density is kg/m³, for convenience we use g/cm³ for solids, g/ml for liquids and g/L for gases. Mathematically, density is defined as mass divided by volume: ρ=m/V
2000 km/sec. Convert that to
m/sec.
Answer:
2000 km/sec
1km=1000m
2000×1000
2000,000 m/sec
When salt is placed on ice the ice melts. explain why?
Explanation:
When salt is added to ice, salt first dissolves in the film of liquid water that is always present on the surface, thereby lowering the ice's freezing point
please mark as brainliest ,I really need it
49. Carry out the indicated temperature conversions.
40 °C to Fahrenheit degrees
b. -40 °F to Celsius degrees
c. 232 K to Celsius degrees
d. 232 K to Fahrenheit degrees
Answer:
sorry but dorks dont learn maths
Explanation:
just kidding no offense but i think umm 1st one will stay same
i searched google
The power to conduct elections is what type of power
Answer:
Unlike delegated powers, they are not listed specifically, but are guaranteed by the Tenth Amendment: "The powers not delegated to the United States by the Constitution, not prohibited by it to the States, are reserved to the States respectively, or to the people." Some traditional reserved powers include regulating ...
Explanation:
how many significant figures in 12.030?
Answer:
5
Explanation:
because the 0 is Sig because there is a point and other numbers
how many grams in 5mg
Answer:
0.005
Explanation:
I looked it up
Explanation: It's important to understand that "mg" is the abbreviation
for milligrams and "g" is the abbreviation for grams.
To convert 5 milligrams into grams, we first find the conversion factor
for milligrams and grams, which is 1,000 milligrams = 1 gram.
Next, notice that we're going from a smaller unit,
milligrams, to a larger unit, grams, so we divide.
Whenever we go from a smaller unit to a larger unit,
we will divide by the conversion factor.
So we have 5 mg ÷ 1,000.
When dividing by a power of 10, we can count the number of zeroes
in the power of 10 and move the decimal point that many places to the left.
So our answer is 0.005 grams.
Betty drew the life cycle of a butterfly for a science exhibition. The life cycle showed the various stages of growth before the egg turns into a butterfly. What type of model did Betty use?
Answer:
Conceptual
Explanation:
A conceptual models are graphical representation of the biological or physical system or another natural phenomenon. It is helping people to understand, imitate and make connections with natural phenomena. The given situation is an example of a conceptual model because it is represented in a graphical way and represents the basic biological events of the actual transformation of a butterfly (transforming a young adult insect into a young adult worm).Answer:
Conceptual
letter B
Describe how the charges of the subatomic particles interact with one another.
Answer:
Electrons, Protons, and Neutrons. ... Protons are another type of subatomic particle found in atoms. They have a positive charge so they are attracted to negative objects and repelled from positive objects. Again, this means that protons repel each other
which best represents a particle containing 28 protons, 26 electrons,and 34 neutrons?
Answer:
This question lacks options, but the question can be answered based on knowledge of proton, electron and neutron number. The answer is:
62 Ni2+ particle
Explanation:
Nickel is a chemical element with atomic number 28. This means it has 28 electrons and 28 protons in its neutral atom. However, the isotope of nickel being described in the question has a mass number of 62. The mass number is calculated by adding the proton number with the neutron number. That is;
Mass number = number of protons + number of neutrons
Mass number = 28 + 34
Mass no. = 62
An element with mass number 62, which has lost two electrons to become positively charged (two positive charges) is described in the question. Hence, the particle that best fits this description is positively charged Nickel particle (Ni2+).
Ni2+ has 28 protons, 26 electrons (reduced by 2) and 34 electrons.
Note that, the 2+ charge is as a result of the loss of two electrons, hence, reducing the electron number by 2.
A researcher is measuring changes in the density of the upper atmosphere over time. Which units should be used for the density measurements?
Answer:
lbm/ft³ or psi/ft
Explanation:
The description in the question shows the density to measured is that of gases (upper atmosphere). The density of a gas can be described as the mass of the gas divided by the volume of the gas at a certain temperature and pressure. It's unit can be represented as lbm/ft³ or psi/ft.
NOTE:
"lbm" means "lean body mass" which is a unit for mass or weight and can be described as the pound mass
"psi" means "pound per square inch"; is also a unit for mass or weight
4) If a snail averages about 0.0045 miles per hour (mi/hr), what is his average speed in meters per
second (m/s) (1 mile = 1.6 km)?
Answer:
the answer is 0.00201168 meters per second