Answer:
Turning the lights off when they're not needed.
10. Air is a homogenous mixture of gases. Oxygen is 20% by volume of air typically. What
amount of moles of oxygen is present in 20 L of air at STP?
Answer:
893 moles
Explanation:
An ideal gas at STP occupies 22.4 liters. Calculating Oxygen as if it were an ideal gas there are . 893 moles of Oxygen in 20.0 liters.
Five liters of air at -35°C is warmed to 89°C. What is the new volume if the pressure remains constant
Answer:
7.61 liters
Explanation:
From the question,
Applying Charles law formula,
V₁/T₁ = V₂/T₂...................... Equation 1
Where P₁ = initial volume of of air, V₂ = Final volume of air, T₁ = Initial Temperature of air, T₂ = Final Temperature of air.
make V₂ the subject of the equation
V₂ = (V₁×T₂)/T₁............... Equation 2
Given: V₁ = 5 liters, T₁ -35 °C = (-35+273) K = 238 K, T₂ = 89°C = (89+273) K = 362 K
Substitute these values into equation 2
V₂ = (5×362)238
V₂ = 1810/238
V₂ = 7.61 liters
please help me do it dont worry the answers are their just put them in theright place
A 4.00g sample of gas is found to exert a pressure of 1.71 atm when confined in 3.60L container at a temperature of 24
Answer:
There are 0.311 moles of gas in the tank
Explanation:
Complete question
A 4.00g sample of gas is found to exert a pressure of 1.71 atm when confined in 3.60L container at a temperature of 241 K. Find the number of moles of the gas
Solution
As we know
[tex]PV = nRT[/tex]
where P is the pressure of the gas in atm
V is the volume in liters
n is the number of moles
R is the gas constant = 0.08206 L·atm/K·mol
and T is the temperature in Kelvin
Substituting the given values in above equation, we get -
[tex]1.71 * 3.60 = n * 0.08206 * 241\\n = 0.311[/tex]
There are 0.311 moles of gas in the tank
Rubidium Rb
when was the element discovered and by whom ??? ASAP MAKE IT AT LEAST A PARAGRAPH!!!
Answer:
Rubidium Rb was discovered in 1861It was discovered by the German chemist Robert Wilhelm Bunsen and the German physicist Gustav-Robert KirchoffExplanation:
Rubidium was discovered by the German chemists Robert Bunsen and Gustav Kirchhoff in 1861 while analyzing samples of the mineral lepidolite with a device called a spectroscope. The sample produced a set of deep red spectral lines they had never seen before. Bunsen was eventually able to isolate samples of rubidium metal. Today, most rubidium is obtained as a byproduct of refining lithium.
In any engineering design problem, the first step is to understand the problem and identify one or more possible solutions. In this task, you’ll analyze the problems you face as the chemical engineer challenged with setting up the ammonia-making process. Recall the chemical equation for producing ammonia:
N2 + 3H2 ⇌ 2NH3 + energy
2.How can you change the chemical equilibrium to benefit the company? What benefits will be realized?
Answer:
Explanation:
2NH3(g)(→ N2(g)(+(3H2(g)
Eventually, these two reactions occur at the same rate. When this happens,
the concentrations of nitrogen, hydrogen, and ammonia become constant, and the
system is said to be “at equilibrium”. Typically,
we represent chemical equilibrium
using a double-headed reaction arrow:
PLEASE HELP QUICKLY!! How many moles of NH4OH are in 0.125L of a 1.4 M solution of NH4OH?
Answer:
0.175mol
Explanation:
Molarity of a solution can be calculated thus:
Molarity (M) = number of moles (n) / volume (V)
According to the information provided in this question, volume of NH4OH = 0.125L, molarity = 1.4M
Using; Molarity = n/V
1.4 = n/0.125
n = 0.175mol
what is modal class?
தமிழ் வாழ்க
Answer:
Modal means the one that occurs most often (averages: mode). In maths, the mode is one of the most common ways to describe a set of data. ... The modal class is, therefore, the group with the highest frequency.
Answer:
Modal means the one that occurs most often (averages: mode). In maths, the mode is one of the most common ways to describe a set of data. ... The modal class is, therefore, the group with the highest frequency. For example: if you counted the number of pencils in different pencil cases and you decided to group them.
Explanation:
தமிழன் ❤
someone pls answer i will in fact give u brainliest
Answer:
d. Solid
Explanation:
It is frozen to be a glacier
Hope this helps :)
Deforestation affects which of the following?
O none of the cycles
Owater cycle and carbon cycle
O carbon cycle only
O water cycle only
Answer:
water cycle and carbon cycle
An aerosol can contains gases under a pressure
of 4.4 atm at 26 ◦C. If the can is left on a
hot sandy beach, the pressure of the gases
increases to 4.68 atm. What is the Celsius
temperature on the beach?
Answer in units of ◦C.
Answer:
e
Explanation:
and e
Explain why a change to the green-leaf population caused the wee-bug population to change in size?
Answer:
If there are fewer births than deaths, then the size of the population will decrease. Organisms in consumer populations get energy storage molecules from eating organisms in resource populations. The more energy storage molecules available to a population, the more the organisms in that population can reproduce.
A change to the green-leaf population caused the wee-bug population to change in size because wee-bug depends upon green leaves for their food.
What is the population?It is a group of organism of the same species living in a particular area.
The increase or decrease in the population of organisms depends upon factors such as available resources and predator population.
The green leaf is the food resource for wee bugs hence if the green leaf population increase then the wee bug's population will also be increased.
Therefore, a change to the green-leaf population caused the wee-bug population to change in size because wee-bug depends upon green leaves for their food.
Learn more about the population?
https://brainly.com/question/7979871
Heat from the sun is absorbed by the _____?
Answer:
earth
Explanation:
What fossil helped support Wegener's hypothesis of continental drift?
A. Gondwanaland
B. Kannemeyerid
C. Mesosaurus
D. Glossopteris
Answer:
Glossopteris
Explanation:
Glossopteris is a fossil fern that helped support Wegener's hypothesis.
Hope this helps! Have a great day!
How can the strength of an acid be determined using titration? (100 POINTS!)
Answer:
Explanation:
A titration in general is used to determine the concentration of something with a solution of known solution. For acid, a base solution of known concentration is added slowly. The end-point is determined by using a pH indicator. When the acid is neutralized at the end, note the amount of base solution used and the strength of acid can be calculated.
Note that the quantity of base solution utilised and the acid strength can be estimated after the acid has been neutralised.
What is titration?Titration is a method of chemical analysis where the quantity of a sample's constituents is established by adding a precisely measured amount of something else with which the component that is wanted will react in a specific, known proportion.
A burette, which is essentially a long, graded measurement tube with a stopper and a tube for injection at its bottom end, is used to gradually administer a standard solution of titrating reagent, and titrant, to a specified concentration. When the point of equal value is achieved, the addition is terminated. Note that the quantity of base solution utilised and the acid strength can be estimated after the acid has been neutralised.
Therefore, note that the quantity of base solution utilised and the acid strength can be estimated after the acid has been neutralised.
To know more about titration, here:
https://brainly.com/question/24704707
#SPJ2
When the equation H202 + H2O + O2 is completely balanced, the SUM of all the coefficients will be
A.5
B. 8
C.3
D.4
When balancing chemical equations, it is okay to adjust
(3 points)
A.
coefficients.
B.
superscripts.
C.
subscripts.
D.
any of these.
Answer:
A
Explanation:
Thats the correct anwers
8.2 moles of ethanol is boiled, how much energy was required to do so?
AH fus=4.60 kJ/mol
AHvap=43.5 kJ/mol
Answer:
Explanation:
Understand that a substance's specific heat (C) is a property that can be used to ... Calculate the heat required to melt 25.7 g of solid methanol at its melting point. ... How many moles of NH4NO3 must be dissolved in water so that 88.0 kJ of heat ... to vaporize 54.0 g of ethanol (C2H5OH) if AHvap for ethanol = 43.5. kJ/mol?
_____________ is the force or pressure of electricity and is compared to the amount of water pressure in a hose.
Answer:
Voltage.
Explanation:
Voltage is the force or pressure of electricity and is compared to the amount of water pressure in a hose.
Answer:
Voltage is the force or pressure of electricity and is compared to the amount of water pressure in a hose.
Please help. I need help with all 4
the process shown was used by Mendel during his experiments. What is the process called?
Answer: cross-pollination
Explanation:
We can predict that summer will follow spring. T or F
Answer:
T
Explanation:
The velocity of an object consists of its speed and..
A. Average speed
B. Distance
C. Displacement
D. Direction
Answer:
direction
Explanation:
How do plants and animals rely on each other?
Answer:
b
Explanation:
help asap show work | a gas with a volume of 13L at a pressure of 197 kPA is allowed to expand to a volume of 23L. what is the pressure of the container if the temperature remains constant
Answer:
111 kPaExplanation:
The new pressure can be found by using the formula for Boyle's law which is
[tex]P_1V_1 = P_2V_2[/tex]
where
P1 is the initial pressure
P2 is the final pressure
V1 is the initial volume
V2 is the final volume
Since we're finding the new pressure
[tex]P_2 = \frac{P_1V_1}{V_2} \\[/tex]
We have
[tex]P_2 = \frac{13 \times 197000}{23} = \frac{2561000}{23} \\ = 111347.826...[/tex]
We have the final answer as
111 kPaHope this helps you
A3.00 mol sample of CO2 (g) is in a rigid 6.00 L container at 400.°C.
Which of the following is the pressure of the gas?
16.4 atm
27.6 atm
200. atm
995 atm
Answer:
i'm thinking 27.6 not sure
Explanation:
PLEASE HELP AND FAST!! How many grams of NH4OH are in 0.125L of a 1.4 M solution of NH4OH?
Answer:
6.132
Explanation:
In general, what happens when a subscript is found
outside of parentheses?
Answer:
you multiply it by the other subscripts in the parenthesis.
Explanation:
The pressure in a car tire is 178 kPa at 37°C. After a long drive, the pressure is 275 kPa. What is
the new temp of the air in the tire, assuming the volume is constant?
Answer:
T₂ = 478.93 K
Explanation:
Given that,
Initial pressure, P₁ = 178 kPa
Initial temperature, T₁ = 37°C = 310 K
Final pressure, P₂ = 275 kPa
We need to find the new temp of the air in the tire, assuming the volume is constant. We know that,
[tex]\dfrac{P_1}{T_1}=\dfrac{P_2}{T_2}\\\\T_2=\dfrac{P_2T_1}{P_1}\\\\T_2=\dfrac{275\times 310}{178}\\\\T_2=478.93 K[/tex]
So, the new temperature is equal to 478.93 K.
How do properties of water break down rocks?
Answer:
Explanation:
Freezing water can break rock without any change in the minerals that form the rock (physical weathering). This usually produces small particles and sand. Water with dissolved gases and other chemicals causes the minerals in rocks to be changed, leading to the deterioration of the rock (chemical weathering).
chemical weathering
Explanation:
freezing water when mix with it cause detorilation of rocks