Answer:
Theoretical value is the value a scientist expects from an equation, assuming perfect or near-perfect conditions. Experimental value, on the other hand, is what is actually measured from an experiment. Rarely (in fact never) are these numbers the same.
Take the area of a sheet of paper. I know that the area of a rectangle can be found by multiplying the lengths of both sides together. I can assume an 8.5x11 sheet, so I calculate exactly 93.5 square inches. This is my theoretical value. When I actually do the measurements on my paper, it turns out my paper has been slightly cut on one end, or I’m measuring with a shoddy ruler. Therefore, I might measure only 92.8 square inches. This is my experimental value. See thats it’s close, but not exact.
Expanding on this concept, quantum mechanics is so widely accepted in the scientific community because many theoretical values calculated by mathmaticians concurred with experimental values to many, many decimal places. These would be constants such as Plank’s Constant, energy levels of harmonic potentials, and energy levels of the hydrogen atom.
Explanation:
Theoretical result is based on information and mathematics. Trials or experiments are the foundation of experimental result. What ought to occur is theoretical probability. What actually occurs is experimental probability.
What is difference between theoretical and experimental result ?The definition of theoretical probability. It is not necessary to do the experiment and then analyze the findings for theoretical probability. The theoretical probability, however, represents what you anticipate will occur in an experimnet.
In experimental probability, information is gathered via repeated experimentation. In theoretical probability, data is gathered without doing the experiment by taking into account every possibility that has a chance of occurring.
Thus, difference between the theoretical and experimental heats of reaction the incomplete combustion may result in the formation of carbon and carbon monoxide instead of carbon dioxide and water.
To learn more about difference between theoretical and experimental result refer the link below;
https://brainly.com/question/535992
#SPJ2
what is the empirical formula of hydro carbon 7.7% by mass of hydrogen and 92.3% by mass of carbon
Answer: A hydrocarbon contains 92.3% by mass of carbon and 7.7% by mass of hydrogen. The empirical formula of the compound will be oose answer:
CH CH5 CH CH3.
Explanation: :)
Write the balanced equation!!
Acid-Base Reactions: HA + BOH → BA + H2O
Sulfuric Acid, H2SO4 (aq) + potassium hydroxide (aq) potassium sulfate (aq) + water (l)
Answer:
H2SO4 + 2KOH + K2SO4 + 2H2O
Explanation:
there are 2 potassium atoms on the left side so gotta balance that and 2 for the H in the KOH so we have to add a 2 for the hydrogen in H2O..I hope this is useful..
Which of the following is an organic compound?
sulfur oxide (SO)
sodium chloride (NaCl)
water (H 2O)
carbon monoxide (CO)
Answer:
Carbon monoxide (CO)
Explanation:
Organic compounds are generally any chemical compounds that contain "carbon-hydrogen bonds". Due to carbon's ability to catenate, millions of organic compounds are known. The study of the properties, reactions, and syntheses of organic compounds comprise the discipline known as organic chemistry.
1. A substance which takes the shape and volume of its container is a?
Solid
Liquid
Gas
Crystal
Answer:
Liquid
Explanation:
Liquid
Answer:
Gas
Explanation:
Gas takes the shape and volume of its container because it doesn't have a definite shape or volume.
Liquid is wrong because it takes the shape of its container, but has a definite volume.
Gas is wrong because it has a definite shape and volume.
Crystal is definitely wrong.
What is mechanical energy?
The energy that is associated with the motion or position of an object
The energy that travels in waves from the moon
Any energy that travels through a medium like water
The stored energy in a substance like oil or gasoline
Answer:
The energy that is associated with the motion or position of an object
or simply kinetic or potential Energy
Calculate the molar mass of carbon tetrachloride, CCl4.
how long does it take to cook a 12 pound turkey in the oven
14. Which of the following is true of the nucleus?
(a) The nucleus is considered the control center of the cell.
(b) The nucleus contains all the cell’s DNA.
(c) All cells have a nucleus.
(d) all of the above
liquid bromine easily evaporates. explain what happens to the particles when a liquid evaporates
Answer:
they gain enough energy to break away from the bonds that keeps them a liquid
also the particles diffuse away
Explanation:
When liquid bromine evaporate,
Then space or distance between its particle increases.The bromine particles start moving freely when it evoporates .The inter-molecular force of attraction between particles is increases when liquid bromine evaporates.Why liquid bromine easily evaporates?The liquid bromine easily evaporates because of following reasons:
The liquid bromine is more denser then water.Its melting and boiling point is -7°C and 58.9°C.The liquid bromine present in the form liquid at room temperature that is why it is easy evaporates.To learn more about liquid bromine,
https://brainly.com/question/20462222
#SPJ2
how does the body and brain react when u are developing feelings for someobody?
What is the frequency of radiation whose wavelength is 2.40×10
Answer:
24
Explanation:
2.40*10=24.0
HELP ITS TIMED AND IM STUCK ONE THIS QUESTION
Answer:
It's gotta be the third answer
Explanation:
Hope this helpped!
The height that mercury reaches in the tube of a manometer ................on the diameter of the tube.
Answer:
does not depend
Explanation:
Answer:
DO NOT DEPENDEDExplanation:
I hope it's help u
Short definition of potential and kinetic energy in a roller coaster ride.
Potential energy is the energy an object has because of where it is in relation to other objects. Kinetic energy is what makes the object move. Many rides use the transfer of potential energy to kinetic energy to move along the track. Hope this helps!
What are their name?
Answer: Ch3 is Methlene Ch2 is Methyl Ch is Benzen
Explanation:
Hope this helps
difference between condensed milk and evaporated milk
The major difference that sets these two canned milk products apart is sugar content; sweetened condensed milk, as the name implies, is always sweetened, while evaporated milk is unsweetened
What do we call the things we see around us? *
15 points
a. ecosystem
b. environment
c. matter
d. density
:::: Answer ::::
C. matterThe reaction is at dynamic equilibrium.
N2 + 3H2 ⇌ 2NH3
Which statement is correct?
(1 point)
The solution has the same concentrations of nitrogen gas and ammonia.
The solution has the same concentrations of nitrogen gas and ammonia.
Nitrogen and hydrogen combine at the same rate that ammonia breaks down.
Nitrogen and hydrogen combine at the same rate that ammonia breaks down.
The solution has the same concentrations of nitrogen and hydrogen gases.
The solution has the same concentrations of nitrogen and hydrogen gases.
Both directions of the reaction have stopped.
Both directions of the reaction have stopped.
Considering the definition of dynamic equilibrium, the correct answer is second option: Nitrogen and hydrogen combine at the same rate that ammonia breaks down.
Chemical equilibrium is a state of a reaction in which no changes are observed as time passes, even though the reaction continues. That is, the chemical equilibrium is established when there are two opposite reactions that take place simultaneously at the same speed.
So, dynamic equilibrium is a chemical equilibrium, which occurs when two reversible processes happen at the same speed in both directions. In this way, the concentrations of the reactants and products remain constant over time.
In summary, the correct answer is second option: Nitrogen and hydrogen combine at the same rate that ammonia breaks down.
Learn more:
https://brainly.com/question/25505273?referrer=searchResultsQuestion 5 (5 points)
Use the picture below to determine if the following statements are observations or if the statements are inferences. Place a “O” in the blank for an observation and “I” for an inference.
BLANK 1: A person is in the water
BLANK 2: The weather is cold
BLANK 3: The tree branch is broken
BLANK 4: If the boy crawled out of the water the goat would push him back in
BLANK 5: The boy fell off the branch
[tex]▪▪▪▪▪▪▪▪▪▪▪▪▪ {\huge\mathfrak{Answer}}▪▪▪▪▪▪▪▪▪▪▪▪▪▪[/tex]
Blank # 1 - Observation
Blank # 2 - Observation
Blank # 3 - Observation
Blank # 4 - Inference
Blank # 5 - Observation
Answer:
Numbers 1,2,3, and 5 are all O
And Number 4 is aN I
are most of the elements on the periodic table classified as a metal or a non-metal?
Answer:
Metals
Explanation:
There are more metals next time trying checking the table they will be in colored squares to count to see which has more! HOPE THIS HELPED!
<3 :D
What would be the bond angle if the molecular geometry were bent and had only one lone pair of electrons
120°
Bent molecular geometry
Examples H2O, SO2
Point group C2v
Coordination number 2
Bond angle(s) 90°<θ<120°
Write the balanced chemical equation for the following reaction. Also, classify the
reaction as sythesis, decomposition, single replacement, double replacement, or combustion.
aluminum sulfate + barium chloride —> aluminum chloride + barium sulfate
Answer:
Reaction: Al2(SO4)3 + 3BaCl2 --> 2AlCl3 + 3BaSO4
Type: Double Replacement
Explanation:
1.) First you need to understand what the different reactions are
a.) Synthesis: is a reaction where two or more substances will combine with each other to make one product.
Ex: A + B → AB
b.) Decomposition: when one compound breaks down into two or more substances. (Opposite of synthesis)
Ex: AB → A + B
c.) Single Replacement: when one element replaces another one in a reaction
Ex: A + BC → AC + B
d.) Double Replacement: when the positively charged cations and negatively charged anions of the reactants trade places. Normally this will be the two outer elements combining and the two inner ones combining.
Ex: AB + CD → AD + CB
e.) Combustion: when a substance reacts with oxygen gas and releases energy as light and heat.
Ex: CH4(g) + 2 O2(g) → CO2(g) + 2 H2O(g)
2.) From there you can write out the formula of the different reactants and products and balance the equation.
For a reversible system, the entropy change of the system is equal to entropy transferred with _____.
Answer:
Heat
Explanation:
Can someone help me with this chemistry question please?
C. Energy use
please mark me a brainlist
658 mL of 0.250 M HCl solution is mixed with 325 mL of 0.600 M HCl solution. What is the molarity of the resulting solution
The molarity of the resulting solution obtained by mixing 658 mL of 0.250 M HCl solution with 325 mL of 0.600 M HCl solution is 0.366 M
We'll begin by calculating the number of mole of HCl in each solution. This can be obtained as follow:
For solution 1:Volume = 658 mL = 658 / 1000 = 0.658 L
Molarity = 0.250 M
Mole of HCl =?Mole = Molarity x Volume
Mole of HCl = 0.250 × 0.658
Mole of HCl = 0.1645 moleFor solution 2:Volume = 325 mL = 325 / 1000 = 0.325 L
Molarity = 0.6 M
Mole of HCl =?Mole = Molarity x Volume
Mole of HCl = 0.6 × 0.325
Mole of HCl = 0.195 moleNext, we shall determine the total mole of HCl in the final solution. This can be obtained as follow:Mole of HCl in solution 1 = 0.1645 mole
Mole of HCl in solution 2 = 0.195 mole
Total mole = 0.1645 + 0.195
Total mole = 0.3595 moleNext, we shall determine the total volume of the final solution.Volume of solution 1 = 0.658 L
Volume of solution 2 = 0.325 L
Total Volume = 0.658 + 0.325
Total Volume = 0.983 LFinally, we shall determine the molarity of the resulting solution.Total mole = 0.3595 mole
Total Volume = 0.983 L
Molarity =?Molarity = mole / Volume
Molarity = 0.3595 / 0.983
Molarity = 0.366 MTherefore, the molarity of the resulting solution is 0.366 M
Learn more: https://brainly.com/question/25342554
what are colloids ?
A solution in which the size of solute particles is intermediate between those in true solution and suspension is called as Colloids.
Answer: A colloid is a mixture in which one substance consisting of microscopically dispersed insoluble particles is suspended throughout another substance.
Hope it helps , have a nice day :>
what is the hybridization at each carbon atom in the molecule?
The carbon atoms are sp3 hybridized.
Hope this helps!
can someone plaexplain to me what is 'first ionisation energy' in simple words coz my small brain can't understand it
[tex] \: \: \: \: \: \: [/tex]
the first ionization energy of an element is the energy needed to remove the outermost, or highest energy, electron from a neutral atom in the gas phase.hope it helps[tex] \: \: \: \: \: [/tex]
what happens to the particles of a solid as it becomes a liquid
Answer:
melting
Explanation:
Answer:
When a solid is heated the particles gain energy and start to vibrate faster and faster. ... Further heating provides more energy until the particles start to break free of the structure. Although the particles are still loosely connected they are able to move around. At this point the solid is melting to form a liquid.
Explanation:
Which of the following moves away from the central nervous system?
Afferent Neuron
Efferent Neuron
Proxima Neuron
Distal Neuron
Answer:
distal
Explanation:
you c a n remember that by the word distance