Help please for this problem.
15g of sugar and 10g of water are measured separately. The sugar is dissolved in the water. What will
the mass of the solution be?
Answer: a) No, both are different.
b) Ramesh- 9.9%
Sarika - 10%
Explanation:
According to the solution prepared by Ramesh,
Mass of sugar he took (Solute) = 10 g
Mass of water he took (Solvent) = 100 g
Thus Mass % of the solution =
According to the solution prepared by Sarika,
Mass of sugar she took (Solute) = 10 g
Mass of Solution she took = 100 g
Thus Mass % of the solution =
Explanation:
During the combustion of methane (CH4), one mole of methane gas combines with two moles of oxygen gas (O2) to produce one mole of carbon dioxide gas (CO2) and two moles of water vapor. Which of the following chemical equations correctly represents the combustion of methane described above
Answer:
CH4(g) +2O2____ CO2(g) +2H2O (l)
if water is added to a 0.70 molar solution of CuSO4 what will change
A. molarity will increase
B. Molarity will decrease
C. the amount of CuSO4 will decrease
D. No change in molarity or amount of salute
Answer:
B. Molarity will decrease
Explanation:
Molarity is one of the measures of the molar concentration of a solution. It is calculated by dividing the number of moles of the solute by the volume of the solvent. This means that the higher the amount of solute in relation to the volume of solvent, the higher the molarity of that solution.
In essence, adding water to a solution dilutes it i.e it increases the solvent's volume in relation to the solute, causing the molarity to decrease. In a nutshell, diluting a solution (by adding water or more solvent) causes the molarity of such solution to decrease. For example, if water is added to a 0.70 molar solution of CuSO4, the molarity of the solution will DECREASE.
A solution of 1.8274g of a polypeptide in 274mL of a aqueous solution has an osmotic pressure at 31.40 degrees C of 2.012 mmHg. The approximate molecular weight of this polymer is _____ g/mol.
Answer: Hence, the approximate molecular weight of the poymer is 64106 g/mol
Explanation:
[tex]\pi=CRT[/tex]
where,
[tex]\pi[/tex] = osmotic pressure of the solution = 2.012 mm Hg = 0.0026 atm
i = Van't hoff factor = 1 (for non-electrolytes)
Mass of solute (polypeptide) = 1.8274 g
Volume of solution = 274 mL
R = Gas constant = [tex]0.0821Latm/Kmol[/tex]
T = temperature of the solution = [tex]31.40^0C=(273+31.40)K=304.4K[/tex]
Putting values in above equation, we get:
[tex]0.0026=\frac{1.8274 g\times 1000}{M\times 274ml}\times 0.0821\times 304.4[/tex]
[tex]M=64106g/mol[/tex]
Hence, the approximate molecular weight of the poymer is 64106 g/mol
How many meters per second is 1.61kilometers per minute?
Answer:
26.83333
Explanation:
Which is most often used to destroy bacteria?
Why are most anions basic in H2O? Give formulas of four anions that are not basic.
Answer:
The anions that can act as bases (conjugate bases of weak acids) have the capability to hydrolyse water and produce OH− ions. Cl−, Br−NO−3, SO2−4 are all conjugate bases of strong acids that don't have the capability to hydrolyse water and so they aren't basic.
Explanation:
How many moles of water are there in 45 g of water?
a) 1.0 moles
b) 1.5 moles
c) 2.0 moles
d) 2.5 moles
Answer:
d
Explanation:
can you help me with my question In the extended simile of the underlined passage from Paragraph 15 of "A Wagner Matinee," the narrator makes an observation about the soul that aring rokol been A. it is like a strange moss on a dusty shelf that, with excruciating suffering, can wither and die y for I the be B though after excruciating suffering it may seem to wither, the soul never dies, C. excruciating, interminable suffering that goes on for half a century can kill the soul.
Which statements correctly describe the human skeletal system?
O A. The skeletal system produces red blood cells.
B. Once made, bones become solid structures.
OC. Adult bones are made of non-living materials only.
D. There are many kinds of joints.
OE. Joints are bones that can bend.
Answer:
A
Explanation:
Well, the human skeletal system produce red blood cells into and for the body.
If the knot (W) travels 2 meters in 1 second, we say it has a _____ of 2 m/s.
Answer:
we say it has a speed of 2m/s
Solid sodium reacts violently with water, producing heat, hydrogen gas, and sodium hydroxide. How many g of hydrogen gas are formed when 125.0 g of sodium are added to water?
2Na + 2H2O → 2NaOH + H2
Which statement are part of the safety protocol for this lab experiment?
Answer:
Always wear safety goggles when performing an experiment.
Use caution when constructing the track.
Ensure that the track is clear before releasing cars.
Report all accidents to the teacher.
Explanation:
Which best explains what happens to the carbon atoms in carbon dioxide during photosynthesis?
A They are incorporated into molecules of sugar.
B They are transformed into oxygen atoms.They are transformed into oxygen atoms.
C They are broken down into subatomic particles.They are broken down into subatomic particles.
D They are destroyed to release energy.They are destroyed to release energy.
c i think
Explanation:
if it's not look it up
Facts about flooding
Answer:
No region is safe from flooding. All 50 states are subject to flash floods.[1]
Flash floods can bring walls of water from 10 to 20 feet high.[2]
A car can be taken away in as little as 2 feet of water.[3]
To stay safe during a flood, go to the highest ground of floor possible. If your skin comes in contact with flood water, make sure to wash it with soap and disinfected water because the contents are unknown.[4]
Flooding is caused by spring thawing (snow and frozen grounds melting in the spring), heavy rains, snow melt runoffs, flash floods, and mudflows.[5]
Floods are the most widespread natural disaster aside from wildfires. 90% of all U.S. natural disasters declared by the President involve some sort of flooding.[6]
In preparation for a flood, it is important to stock up on first aid items, non-perishable foods, 3 gallons of water per person for 3 days, battery operated radio for weather reports, extra batteries, personal hygiene necessities.[7]
Based on Floodsmart, a 2,000 square foot home undergoing 12” of water damage could cost more than $50,000.[8]
Since flood damage is almost never covered by homeowners insurance, flood insurance is important for people living in high-risk flood zones.[9]
To stay safe during a flood, go to the highest ground of floor possible. If your skin comes in contact with flood water, make sure to wash it with soap and disinfected water because the contents are unknown.[10]
Communities particularly at risk are those located in low-lying areas, near water, or downstream from a dam.[11]
Characteristics of a substance that describe its' ability to change into a different substance are called?
Need help too please I would really appreciate it
Answer:
it's O2 since the oxygen has 6 valence electrons and it can make 2 covalent bonds
What is T in the equation G = H - TS?
A.
The temperature in kelvins at which the reaction is happening
B.
The temperature in degrees Celsius at which the reaction is run
C.
The temperature required to make the reaction spontaneous
D.
The temperature at which the Gibbs free energy is zero
The answer is A.
The T in the equation G = H - TS is the temperature in kelvins at which the reaction is happening. The correct option is A.
What is temperature?Temperature is the measurement of the coldness or hotness of a body. The SI unit of the temperature is kelvin and Celsius. The high-temperature regard hotness and the low temperature means a cold area.
G = H – TS is the equation to calculate Gibbs free energy.
Where G = Gibbs free energy
H = enthalpy
T = temperature
S = entropy
Gibbs free energy is the total amount of energy that is taken to do the work in a closed system. The entropy is the total amount of energy that is not useful for work. The temperature is the variable in this equation.
Thus, the correct option is A. The temperature in kelvins at which the reaction is happening.
To learn more about temperature, refer to the link:
https://brainly.com/question/4002787
#SPJ2
Determine the correct set-up below to determine what mass, in grams, of N2 is needed to completely react with 105 g F2 ?
Answer:
C: 1 mol F2/38 g F2
Explanation:
The reaction equation is;
N2 + 3F2 = 2NF3
Now, to know how many grams, of N2 is needed to completely react with 105 g F2 and since the molar mass of N2 is 28.02 g/mol, Molar mass of F2 is 38 g/mol, number of moles attached to N2 and F2 in the reaction are 1 and 3 moles respectively, then we will have;
105 g F2 × 1 mol F2/38 g F2 × 1 mol N2/3 mol F2 × 28.02 g N2/1 mol N2
Option C is Thus correct
The gravitational force between two masses is proportional to
A.
the difference between the masses.
B.
the first mass divided by the second mass.
C.
the product of the masses.
D.
the sum of the masses.
Answer:
D.
the sum of the masses.
Explanation:
What is this what is this
Answer:Attemted Failed
Maybe try to search
In a different way like:
what is the ingredient of cake
Instead of
how to make Cake
If 0.700 moles Ag is reacted with 10.0 g S, is sulfur or aluminum the limiting reactant?
Answer: [tex]S[/tex] is the limiting reagent
Explanation:
To calculate the moles :
[tex]\text{Moles of solute}=\frac{\text{given mass}}{\text{Molar Mass}}[/tex]
[tex]\text{Moles of} S=\frac{10.0g}{32g/mol}=0.3125moles[/tex]
[tex]\text{Moles of} Ag=0.700moles[/tex]
[tex]2Ag+S\rightarrow Ag_2S[/tex]
According to stoichiometry :
1 mole of [tex]S[/tex] require = 2 moles of [tex]Ag[/tex]
Thus 0.3125 moles of [tex]S[/tex] will require=[tex]\frac{2}{1}\times 0.3125=0.6250moles[/tex] of [tex]Ag[/tex]
Thus [tex]S[/tex] is the limiting reagent as it limits the formation of product and [tex]Ag[/tex] is the excess reagent.
An element ceases to be that element if the particle it loses or gains is a neutron.
True or false
Answer:
False
Explanation:
An element is named according to the number of protons in the nucleus. If it gains or loses a neutron, it becomes a different isotope of the same element.
The given statement is false.
Answer:
FALSEExplanation:
#CARRYONLEARNING
Which of the following best describes the difference between metals and nonmetals?
a
metals tend to have low melting points and nonmetals have high melting points
b
nonmetals are more reactive than metals
c
metals are brittle and dull
d
metals have high melting points and are malleable, whereas, nonmetals have lower melting points and tend to be brittle.
Answer:
the answer is d.
Explanation:
because metals are refers to natural elements that are hard, shiney, opaque, and dense. nonmetals implies thise chemical substances that are soft, non-shiney, transparent and brittle.
Question number 12 I need help
Answer: Its B.
Explanation:
i cant quite explain
I have 8 valence electrons, completely nonreactive, and my family contains Helium that is used to fill balloons! I must be a...
a
metal
b
nonmetal
c
metalloid
d
noble gas
Answer:
Noble gas
Explanation:
Noble gases are complete octets ( have 8 valence electrons) Helium is a member of this family.
SOMEONE HELP ME ASAP!!!
Answer:
A
Explanation:
Hey I'm Chloe can you Help me, Thank you :)
What pigment, only present in plants, makes photosynthesis possible?
Answer:
la photosintesis viene de la clorofila de la planta
Find the molarity of a solution made by dissolving 12.5 g sodium carbonate in 500.0 mL total solution
Answer:
The molarity of a solution is "25 M".
Explanation:
The given values are:
Moles of solute,
= 12.5 g
Volume of solution,
= 500 mL
i.e.,
= 0.5 L
Now,
The molarity will be:
= [tex]\frac{Number \ of \ moles \ of \ solute}{Volume \ of \ solution}[/tex]
On substituting the values, we get
= [tex]\frac{12.5}{0.5}[/tex]
= [tex]25 \ M[/tex]
how many grams of Al(no2)3 should be added to 1.3L of water to prepare a 2.0M solution
Answer: 429 grams of [tex]Al(NO_2)_3[/tex] should be added to 1.3 L of water to prepare 2.0 M solution
Explanation:
Molarity of a solution is defined as the number of moles of solute dissolved per Liter of the solution.
[tex]Molarity=\frac{n}{V_s}[/tex]
where,
n = moles of solute [tex]Al(NO_2)_3[/tex] = [tex]\frac{\text {given mass}}{\text {Molar mass}}=\frac{xg}{165g/mol}[/tex]
[tex]V_s[/tex] = volume of solution in Liters
Now put all the given values in the formula of molarity, we get
[tex]2.0M=\frac{xg}{165g/mol\times 1.3L}[/tex]
[tex]x=429g[/tex]
Therefore, 429 grams of [tex]Al(NO_2)_3[/tex] should be added to 1.3 L of water to prepare 2.0 M solution