Answer:Resistor Basics
Resistors are electronic components which have a specific, never-changing electrical resistance. The resistor's resistance limits the flow of electrons through a circuit.
They are passive components, meaning they only consume power (and can't generate it). Resistors are usually added to circuits where they complement active components like op-amps, microcontrollers, and other integrated circuits. Commonly resistors are used to limit current, divide voltages, and pull-up I/O lines.
Resistor units
The electrical resistance of a resistor is measured in ohms. The symbol for an ohm is the greek capital-omega: Ω. The (somewhat roundabout) definition of 1Ω is the resistance between two points where 1 volt (1V) of applied potential energy will push 1 ampere (1A) of current.
As SI units go, larger or smaller values of ohms can be matched with a prefix like kilo-, mega-, or giga-, to make large values easier to read. It's very common to see resistors in the kilohm (kΩ) and megaohm (MΩ) range (much less common to see miliohm (mΩ) resistors). For example, a 4,700Ω resistor is equivalent to a 4.7kΩ resistor, and a 5,600,000Ω resistor can be written as 5,600kΩ or (more commonly as) 5.6MΩ.
Schematic symbol
All resistors have two terminals, one connection on each end of the resistor. When modeled on a schematic, a resistor will show up as one of these two symbols:
Resistor schematic symbols
Two common resistor schematic symbols. R1 is an American-style 1kΩ resistor, and R2 is an international-style 47kΩ resistor.
The terminals of the resistor are each of the lines extending from the squiggle (or rectangle). Those are what connect to the rest of the circuit.
The resistor circuit symbols are usually enhanced with both a resistance value and a name. The value, displayed in ohms, is obviously critical for both evaluating and actually constructing the circuit. The name of the resistor is usually an R preceding a number. Each resistor in a circuit should have a unique name/number. For example, here's a few resistors in action on a 555 timer circuit:
Answer: resistor is
Explanation:
A resistor controls the flow of the electrical current within a circuit. Resistors are made from materials like copper or carbon, which make it difficult for the electrical charges to flow through a circuit. The most common type of resistor is a carbon resistor, which is a general purpose resistor, best suited for lower-powered circuits.
When the equation H2 + Fe3O4 = Fe + H2O is completely balanced using the smallest whole numbers, the coefficient oH2 would be A.) 1 B.)2 C.) 3 D.) 4
Answer:
H2 would have a coefficient of 2.
Explanation:
According to the balanced chemical equation, the coefficient of hydrogen is 4.
What is chemical equation?Chemical equation is a symbolic representation of a chemical reaction which is written in the form of symbols and chemical formulas.The reactants are present on the left hand side while the products are present on the right hand side.
A plus sign is present between reactants and products if they are more than one in any case and an arrow is present pointing towards the product side which indicates the direction of the reaction .There are coefficients present next to the chemical symbols and formulas .
The first chemical equation was put forth by Jean Beguin in 1615.By making use of chemical equations the direction of reaction ,state of reactants and products can be stated. In the chemical equations even the temperature to be maintained and catalyst can be mentioned.
Learn more about chemical equation,here:
https://brainly.com/question/28294176
#SPJ5
The job of the ______ is to hold all of the parts of a cell together
Answer:
cell membrane
Explanation:
it holds everything together
What element is in group 4 and period 3
Select odd one out.
I) O
II) Na
III) Cu
IV) Ag
Explanation:
0 is the odd one...............
and rest are metals and they lose electron and 0 gain electron and is non metal
The sound of a trumpet ECHOES off a nearby mountain. This is which type of wave interaction?
Answer:
reflection
Explanation:
wave reflection is when a sound bounces off something it cannot go through, like echoing
What is the lanthanide with least mass, periodic table?
Answer:
Europium/Eu ( not really sure )
The lanthanide element with the least mass is Lutetium (Lu)
Lutetium (Lu) is a member of the lanthanide series, which is a group of 15 elements located in the f-block of the periodic table. The lanthanide series starts with the element Lanthanum (La) and ends with Lutetium (Lu). Lutetium is the heaviest and most dense element in the lanthanide series. Lutetium has an atomic number of 71, indicating that it has 71 protons in its nucleus. It has a relatively high atomic mass of approximately 174.97 atomic mass units (u) according to the periodic table.
Hence, lutetium is the lanthanide element with the least mass.
Learn more about lanthanide elements here:
https://brainly.com/question/28305751
#SPJ 6
Pls help fast, I will give brainliest!
Answer:
c
Explanation:
At which position on the diagram would an apple have the greatest potential energy?
Answer:
Position 1 because it is the highest from the ground.
Hope this helps!
What kind of reaction is 2H202 → 2H20 + O2?
O A. Decomposition
O B. Single-replacement
C. Double-replacement
O D. Synthesis
Answer:
this reaction is so the answer should be A
Please help ASAP!! I’m stuck!!
Which statement is true based on the formula?
6CO2 + 6H2O —> C6H12O6
+ 6O2
1. The mass of carbon dioxide plus water is equal to the mass of sugar plus oxygen
2. The mass of carbon dioxide plus water is less than the mass of sugar plus oxygen
3. The mass of carbon dioxide plus water is greater than the mass of sugar plus oxygen
Answer:
The answer of this question is 3
Which of the following is a product in the reaction described by the word equation below?
iron + copper(II) sulfate ----------> iron(II) sulfate +copper
Answer:
Please answer my question
If a piece of paper with a mass of 1.3 grams is shredded into pieces and then it's weighed again so what would be the mass of the paper shreds?
Option 1: More than 1.3 grams
Option 2: stays the same (1.3 grams)
or
Option 3: Less than 1.3 grams
Answer:
option 2
Explanation:
What is the difference between a pure solvent and a solution? Do they have the same physical properties?
Answer:
The physical properties of a solution are different from those of the pure solvent. ... Colligative properties are those physical properties of solutions of nonvolatile solutes that depend only on the number of particles present in a given amount of solution, not on the nature of those particles.
Learn more:
brainly.com/question/12225553
An organism from the past that is related to all the organisms in the group is called?
Answer:
phylogenic trees/phylogeny
Explanation:
the evolutionary history and relationship of an organism or group of organisms is called its phylogeny
Gas in a balloon occupies 3.3 liters. What volume will it occupy if the pressure is changed from 100 kPa to 90.0 kPa, if the temperature is held constant?
Answer:
3.7 L
Explanation:
Initial volume (V₁) = 3.3 L
Initial pressure (P₁) = 100 KPa
Final pressure (P₂) = 90 KPa
Final volume (V₂) =?
The final volume of the gas can be obtained by using the Boyle's law equation as follow:
P₁V₁ = P₂V₂
100 × 3.3 = 90 × V₂
330 = 90 × V₂
Divide both side by 90
V₂ = 330 / 90
V₂ = 3.7 L
Thus, the final volume of the gas is 3.7 L
what is the molecular shape of N2O2?
Answer:
If you're just looking at the Lewis Structure from the perspective of the octet rule, it does appear that the structure is correct. Dinitrogen always has a lone pair of electrons which could conceivably be used for dative bonding as you suggest. So from that perspective there appears to be nothing wrong at all - other than that it doesn't exist in nature in this way.
Explanation:
28g of aluminum reacts with 45g oxygen
1) complete balanced equation?
2) what is the limiting reactant?
3) how many grams of product could be formed?
4) how many grams of excess would you predict?
5) if you actually measured 50g of product, what is the percent yield?
Answer:
answer below:
Explanation:
1) 4 Al + 3 O2 --> 2Al2O3.
2) Al mol= 28/27 = 1.037mol
O mol= 45/16 = 2.812mol
Al : O
4 : 2
x : 2.812
cross multiply
4 x 2.812/2 = 5.624 mol of Al
Al is limiting reactant
3) 28/5.246 = 5.34product can be formed (not that much sure)
4) 45/ 0.5185 = 86.79
86.79 - 5.34 = 81.45g
5) 50 / 81.45 x 100 = 61.39% ( i guess)
i hope this hleps you
how does pentene become pentane?
How does propene become propane?