If you add the same amount of heat to two different substances, will they both change phase?

Answer:

Chlorine Iodine is a compound made out of one Chlorine molecule and one Iodine molecule

Explanation:

Answer:

The primary producer uses some of that energy. Because we lose energy each time we move up a trophic level, we have more producers than consumers, more herbivores than carnivores, more primary consumers than secondary consumers. See this Socratic answer for more detail.

Explanation:

Answer:

Producers produce food energy for themselves and all the other levels

Explanation:

Answer:

Give person above me brainliest

Explanation:

Answer:

Down arrow:

-a car comes to a stop when a traffic light turns red

Up arrow:

-race car accelerates when a race begins

Circle:

-car driving 45 mile per hour down straight road

Explanation:

and i think the car going around a bend would be an up arrow

Answer:

8.7 million species

Explanation:

Scientists have estimated that there are around 8.7 million species of plants and animals in existence.

Answer:

There are four elements that are found in all living animals, that are:

Oxygen (O)

Carbon (C)

Hydrogen (H)

Nitrogen (N).

Answer: B. strontium

Explanation: This is due to electrons being further away from the nucleus in strontium.

Answer:

.....................

30.973761

Answer:

Below

Explanation:

In a chemical reaction, per the law of conservation of mass, no atoms or subatomic particles will be created or destroyed; for example, H2O2 will decompose into H2 and O2, meaning no matter was created or destroyed.

Answer:

An unbalanced force causes the object to change position.

Explanation:

An unbalanced force causes the object on which it is acting to accelerate, changing its position, speed, or direction due to equal forces on opposite sides.

Answer:

Answer:

pairs of electrons

Explanation:

covalent bondin occurs when pairs of electrons are shared by atoms.... nonmetal will readily form covalent bonds with other nonmetal in order to obtain stability.

Answer:

Explanation:

poop

Answer:

Potassium is more reactive than aluminium, so no reaction takes place. But aluminium is more reactive than copper, so it replaces the copper in copper nitrate

More reactive metal compound + less reactive metal

-> no reaction

However

Less reactive metal compound + more reactive metal

-> more reactive metal compound + less reactive metal

This is called substitution reaction where the more reactive metal replaces the less reactive metal in the compound.

The elements in the lanthanide series are similar to gadolinium.

The periodic table is arranged in groups and periods. Elements in the same group have similar properties. At the bottom row of the periodic table lies a group of elements that have unique properties called the lanthanides. This is where Gadolinium belongs.

The elements in the lanthanide series such as europium and terbium are similar to gadolinium. The lanthanides are similar in chemical reactivity and appearance. However, the density of the metals differ because it increases with increase in atomic number.

Learn more: https://brainly.com/question/1415109

Answer:

It would be around 4.4 in PH

Explanation:

I hope this helped.

Answer:

In Homogenous mixtures, the whole mixture is in the same phase whereas in Heterogeneous mixture, substances can be of two phases and layers may separate. ... Homogeneous mixture could be exemplified as a sugar solution or salt solution whereas Mixture of salt and sand could be used as an example of Heterogeneous mixture.

Answer:

Explanation:

Consider the general chemical reaction

                                                       [tex]\mathrm{A} \ \overset{k}{\longrightarrow} \ \mathrm{product}[/tex]  .

If [A] is the concentration of A (reactant) at any time t and n is the reaction order for the whole equation, the rate is then related to the concentration of reactant A with the following differential form of equation

                                               [tex]Rate \ = \ -\displaystyle\frac{d[\mathrm{A}]}{dt} \ = \ k[\mathrm{A}]^{n}[/tex]  .

where k is the rate constant.

*Note that the differential term [tex]\displaystyle\frac{d[\mathrm{A}]}{dt}[/tex] has a negative sign to denote that the concentration of A is decreasing over time t.

Since the chemical reaction between tert-butyl bromide and water is given to be a first-order reaction, hence n = 1, and the resulting differential equation becomes

                                        [tex]Rate \ = \ -\displaystyle\frac{d[\mathrm{A}]}{dt} \ = \ k[\mathrm{A}]^{1} \ = \ k[\mathrm{A}][/tex]

To solve this first-order linear homogenous differential equation, the method of separation of variables can be used.

[tex]\-\hspace{1cm} \displaystyle\frac{d[\mathrm{A}]}{dt} \ = -\ k[\mathrm{A}] \\ \\ \-\hspace{0.5cm} \displaystyle\frac{1}{[\mathrm{A}]} \, d[\mathrm{A}] \ = -\ k \, dt \\ \\ \int\ {\displaystyle\frac{1}{[\mathrm{A}]} \, d[\mathrm{A}] \ = \ -\int {k} \, {dt}[/tex]

         [tex]\ln{[\mathrm{A}]} \ = \ -kt \ + \ C \\ \\ \-\hspace{0.45cm} $[A]$ \ = \ e^{-kt \ + \ C} \\ \\ \-\hspace{0.45cm} $[A]$ \ = \ e^{-kt}e^{C} \ \ \ \ \ \ \ \ \ (e^{a \ + \ b} \ = \ e^{a}e^{b} \ \ \ \mathrm{by \ the \ law \ of \ indices})[/tex]

Since the term [tex]e^{C}[/tex] is a constant, let [tex]\alpha \ = \ e^{C}[/tex], hence [tex][\mathrm{A}] \ = \ \alpha e^{-kt}[/tex] or [tex]C \ = \ \alpha e^{-kt}[/tex] according to the question. Given that the initial concentration (t = 0) of tert-butyl bromide is 0.2 mol/L and k = 0.0537[tex]\mathrm{h^{-1}}[/tex], so

[tex]0.2 \ = \ \alpha e^{-0.0537 \ \times \ 0} \\ \\ 0.2 \ = \ \alpha \ \ \ \ \ (e^{0} \ = \ 1)[/tex]

Therefore, the rate equation is [tex]C \ = \ 0.2e^{-0.0537t}[/tex].

The concentration of tert-butyl alcohol after 1 hour is

[tex]C \ = \ 0.2e^{-0.0537 \ \times \ 1} \\ \\ C \ = \ 0.2e^{-0.0537} \\ \\ C \ = \ 0.190 \ \mathrm{mol/L} \ \ \ (3 \ \ \mathrm{s.f.})[/tex]

Explanation:

=>7.7 x10¹⁴ to 4.2 x10¹⁴Hz

An experiment that would show that intramolecular forces are stronger than intermolecular forces will be heating a block of ice in a sealed container then allowing it to change to steam.

Intramolecular forces are the forces of attraction that hold atoms together within a molecule. Intramolecular forces require a high amount of energy to splits atoms or molecules in a chemical bonding.

Intermolecular forces are weaker forces of attraction that occur between molecules. They require lesser energy to splits molecules compared to intramolecular forces.

An experiment that would show that intramolecular forces are stronger than intermolecular forces will be heating a block of ice in a sealed container then allowing it to change to steam.

In the process, the energy required to change the state from ice to steam water is more than intermolecular forces.

Thus, we can conclude that this experiment shows that the intramolecular forces are stronger than the intermolecular forces.

Learn more about Intramolecular forces here:

https://brainly.com/question/13588164

Answer:

The basic unit of the nervous system is a nerve cell or neuron. The nervous system transmits signals between the brain and the rest of the body, this way, the nervous system's activity controls the ability to move, breathe, see, and think.

Explanation:

Have a great rest of your day
#TheWizzer

Answer:

the answer is B

Explanation:

this shows the next step and shows how magma turns into igneous rocks by heat and pressure

Answer:

What is nanofluids?

Nanofluids are engineered suspensions of nanometer-sized solid particles in a base fluid. Suspending small solid particles in the energy transmission fluids can improve their thermal conductivity and provides an effective and innovative way to enhance their heat transfer characteristics significantly.

How nanofluids work?

Nanofluid refers to the dispersion of metal or non-metal nano-powder into traditional heat exchange media such as water, alcohol, and oil to prepare a uniform, stable and high thermal conductivity. The traditional heat exchange medium has a low thermal conductivity and has been unable to meet the growing demand for industrial engineering heat exchange. The thermal conductivity of some metal or non-metal nanoparticles is often hundreds of times higher than that of heat-conducting media. For example, common silicon carbide nanoparticles have a thermal conductivity of 170-270 W/m•K. The researchers found that if the nanoparticles can be uniformly and stably dispersed in the heat transfer medium, the thermal conductivity of the nanoparticles will be greatly improved.

Answer:

la branche de la mécanique concernée par le mouvement des objets sans référence aux forces qui provoquent le mouvement

Answer:

the features or properties of motion in an object.

Answer:

True

Explanation:

True because of the law of conservation of mass, the same same amount of atoms will be on both sides of the reaction.

Explanation:

it is a parallel circuit.

hope this helps you.

This problem is asking for the equilibrium constant at two different temperatures by describing the chemical equilibrium between gaseous nitrogen, oxygen and nitrogen monoxide at 25 °C and 1496 °C as the room temperature and the typical temperature inside the cylinders of a car's engine respectively:

N₂(g) + O₂(g) ⇄ 2 NO(g)

Thus, the calculated equilibrium constants turned out to be 6.19x10⁻³¹ and 9.87x10⁻⁵ at the aforementioned temperatures, respectively, according to the following work:

There is a relationship between the Gibbs free energy, enthalpy and entropy of the reaction, which leads to the equilibrium constant as shown below:

[tex]\Delta _rG=\Delta _rH-T\Delta _rS\\\\\Delta _rG=-RT ln(K)[/tex]

Which means we can calculate the enthalpy and entropy of reaction and subsequently the Gibbs free energy and equilibrium constant. In such a way, we calculate these two as follows, according to the enthalpies of formation and standard entropies of N₂(g), O₂(g) and NO(g) since these are assumed constant along the temperature range:

[tex]\Delta _rH=2*90.25 kJ/mol - (0 kJ/mol+0 kJ/mol)=180.5kJ/mol\\\\\Delta _rS=2*(0.211 kJ/mol*K)-(0.192kJ/mol*K+0.205kJ/mol*K)=0.025kJ/mol*K[/tex]

Then, we calculate the Gibbs free energy of reaction at both 25 °C and 1496 °C:

[tex]\Delta _rG_{25\°C}=180.5-(25+298.15)*0.025=172.42kJ/mol\\\\\Delta _rG_{1496\°C}=180.5-(1496+298.15)*0.025=135.65kJ/mol[/tex]

And finally, the equilibrium constants derived from the general Gibbs equation and Gibbs free energies of reaction:

[tex]K=exp(-\frac{\Delta _rG}{RT} )\\\\K_{25\°C}=exp[-\frac{172420 J/mol}{(8.3145\frac{J}{mol*K})(298.15K)} ]=6.19x10^{-31}\\\\K_{1496\°C}=exp[-\frac{135650J/mol}{(8.3145\frac{J}{mol*K})(1769K)} ]=9.87x10^{-5}[/tex]

Learn more:

Answer:

C 7.5 Moles of MgSO4

Explanation: