If the stack of bricks on the right has a mass of 240 kg, approximately what is the mass of the stack of bricks on the left?


A.
2400 kg
B.
720 kg
C.
320 kg
D.
480 kg

Answer:

liquid

Explanation:

correct answer hope it helps

Answer:

The flask has to be closed during the hydrochloric acid and sodium carbonate reaction as the resultant gas got trapped inside the closed flask.

Explanation:

The hydrochloric acid and sodium carbonate reaction was exothermic that caused the pressure to decrease. The flask has to be closed during the hydrochloric acid and sodium carbonate reaction as the resultant gas got trapped inside the closed flask.

In exothermic reactions, energy is produced in the form of heat or light.

Answer:

D. Supported by observations

Explanation:

Because theories change over time, they both need to be proven, they do not go off of consensus, but they do need to be supported by observations.

HOPE IT HELPS❣️

Answer:

68.48%

Explanation:

The percent mass of an element in a compound tells us about the amount of such element contributed to the total compound.

In this case, 7.28 g sample of chromium metal was heated to produce chromium oxide with weight of 10.63 g. The percent mass of chromium in chromium oxide can be calculated by using the formula:

%mass of Cr = mass of Cr/mass of Chromium oxide × 100%

%mass of Cr = 7.28/10.63 × 100

%mass of Cr = 0.6848 × 100

%mass of Cr = 68.48%

Answer:

Atomic size is the distance from the nucleus to the valence shell where the valence electrons are located. The separation that occurs because electrons have the same charge. The number of protons in the nucleus. The core electrons in an atom interfere with the attraction of the nucleus for the outermost electrons.

Explanation:

That would be B I believe, but please correct me if I'm wrong.

Answer:

20.180042 amu

Explanation:

From the question given above, the following data were obtained:

Isotope A (20Ne)

Mass of A = 19.9924356 amu

Abundance (A%) = 90.48%

Isotope B (21Ne):

Mass of B = 20.9938428 amu

Abundance (B%) = 0.27%

Isotope C (22Ne):

Mass of C = 21.9913831 amu

Abundance (C%) = 9.25%

Average atomic mass of Neon =.?

The average atomic mass of Neon can be obtained as follow:

Average atomic mass = [(mass of A × A%)/100] + [(mass of B × B%)/100] + [(mass of C × C%)/100]

= [(19.9924356 × 90.48)/100] + [(20.9938428 × 0.27) /100] + [(21.9913831 × 9.25) /100]

= 18.0891557 + 0.05668338 + 2.03420294

= 20.180042 amu

Therefore, the average atomic mass of Neon is 20.180042 amu

This follows a simple conversion technique. Basically what the question is trying to say here is to convert 29.1 inHg to mmHg. 1 inHg is equal to 25.4 mmHg so 29.1 inHg would be equal to [tex]25.4 * 29.1[/tex] which when evaluated turns out to be: [tex]739.14[/tex]. :D

The pressure will be 739.14 mm Hg.

The SI unit measuring pressure would be the pascal, which measures the force of each unit area of the surface.

Calculation of pressure

It is known that 1inHg = 25.4 mm Hg.

Hence, the pressure = 25.4 × 29.1 = 739.14 mm Hg

Therefore, the pressure will be 739.14 mm Hg.

To know more about pressure

https://brainly.com/question/15175692

#SPJ2

Answer: Spun yarn is made by twisting staple fibers together

To make a cohesive thread Or “single”. Twisting fibers, into yarn in the process called spinning can be dated back to the upper Paleolithic. Yarn spinning was one of the first processes to be industrialized.

Explanation:

Answer:

D.All three graph lines peak over the same few weeks of winter.

Explanation:

took the test

Answer:

A) Carbon

Explanation:

the others are wrong its A

Answer:

A) carbon

Explanation:

carbon or simply c has an atomic number of 6 and it has an atomic mass of 12.01 amu. it belongs to group 4a

Answer: The percent yield of the reaction is 77.0 %

Explanation:

[tex]2Pb+O_2\rightarrow 2PbO[/tex]

[tex]\text{Number of moles}=\frac{\text{Given mass}}{\text{Molar mass}}[/tex]

[tex]\text{Number of moles of lead}=\frac{451.4g}{207.2g/mol}=2.18moles[/tex]

[tex]\text{Number of moles of lead oxide}=\frac{374.7g}{223.2g/mol}=1.68moles[/tex]

According to stoichiometry:

2 moles of [tex]Pb[/tex] produces = 2 moles of [tex]PbO_2[/tex]

2.18 moles of [tex]Pb[/tex] is produced by=[tex]\frac{2}{2}\times 2.18=2.18moles[/tex] of [tex]PbO_2[/tex]

Mass of [tex]PbO_2[/tex] =[tex]moles\times {\text {Molar mass}}=2.18\times 223.2g/mol=486.6[/tex]

percent yield =[tex]\frac{374.7g}{486.6g}\times 100=77.0\%[/tex]

Answer:

B) . six electrons in the triple bond of diatomic nitrogen

Explanation:

The three line in this Lewis dot structure represents the six electrons in the triple bond of diatomic nitrogen.

Nitrogen is made up of 7 electrons with 5 valence ones.

 A lewis structure is made up of the symbol of the element surrounded by dot to represent the valence electrons.

  In this nitrogen molecule, both species share  6 electrons. This makes each nitrogen atom isoelectronic with neon.

Answer:

opposite

Explanation:

Answer:

opposite

Explanation:

cu9c9ucoucucpucfpufupfpucupvpjvpucu

Answer:

it's answer is

element of an atom ✌️

Answer:

Purple light.

Yellow light.

Explanation:

Answer:

[tex]m_{CO2}=8.33gCO2[/tex]

Explanation:

Hello.

In this case, since the chemical reaction is:

[tex]C_7H_5N_3O_6(s)+\frac{21}{4} O2(g)\rightarrow 7CO_2(g)+\frac{3}{2} N_2(g)+\frac{5}{2} H_2O(l)[/tex]

Thus, since we have the initial moles of TNT:

[tex]n_{TNT}=25.7g*\frac{1mol}{227.13g} =0.113mol[/tex]

And the initial moles of oxygen given the ideal gas equation:

[tex]n_{O_2}=\frac{6.93atm*0.5L}{0.082\frac{atm*L}{mol*K}*298K}=0.142molO_2[/tex]

Given the 1:7 mole ratio between TNT and carbon dioxide and the 21/4:7 mole ratio between oxygen and carbon dioxide, we compute the yielded moles by each reactant:

[tex]n_{CO_2}^{by\ TNT}=0.113molTNT*\frac{7molCO_2}{1molTNT}=0.791molCO_2\\\\ n_{CO_2}^{by\ O_2}=0.142molO_2*\frac{7molCO_2}{21/4molO_2}=0.189molCO_2[/tex]

Thus, since oxygen yields less moles of carbon dioxide than TNT, we infer it is the limiting reactant, therefore, the produced mass of carbon dioxide is:

[tex]m_{CO2}=0.189molCO2*\frac{44.01gCO2}{1molCO2}\\\\m_{CO2}=8.33gCO2[/tex]

Best regards!

Answer:

We can see that the atomic radius decreases across every row.

Explanation:

I will comment more below.

The elements that represent the highest points on the graph are all elements of group 1 and occur at the head of the period to which they belong.

The periodic table is an arrangement of elements in groups and periods. The elements in the same group have the same number of valence electrons while the elements in the same period have the same number of shells.

Looking at the graph, we can see that the high points in the graph all correspond to the group 1 elements; sodium, potassium, rubidium and cesium.The have the highest atomic radii in the period. Atomic radii increases down the group but decreases across the period. Remember that these elements are at the head of the period to which they belong hence they have the highest atomic radii.

Learn more: https://brainly.com/question/9352088

If we add water to a concentrated acid, then the solution may boil very violently, splashing concentrated acid. If add acid to water, the solution that forms is very dilute and a small amount of heat is released.

When a strong acid is poured into water, it flows down the flask and mixes much better, so no boiling takes place. The addition of water to acid forms an extremely concentrated solution of acid initially. A large amount of heat is released and the solution may boil very violently, splashing concentrated acid out of the beaker and all this because the reaction is exothermic in nature.

The reason this takes place is due to a large amount of energy liberated in the hydration reaction of concentrated ions. Therefore, we add acid to water dropwise for the dilution with constant stirring and not water to acid directly.

If we add water to acid, then an exothermic reaction occurs and the solution may boil very violently. To form the dilute solution of any strong acid, you should add acid to water and the small amount of heat released is not sufficient to vaporize and spatter it.

Learn more about dilution of acid, here:

https://brainly.com/question/

#SPJ2

Answer:

option is (b)

Explanation:

please mark me as brilliant

Answer:

The answer is true

Explanation: Because The law of multiple proportions states that when two elements react to form more than one compound, a fixed mass of one element will react with masses of the other element in a ratio of small, whole numbers.

Answer:

m*s⁻¹.

Explanation:

Hello!

In this case, since the frequency measures how repetitive an event is per unit of time, for instance the laps a car drives every 5 minutes or something similar, we can infer it has units of event/time; in such a way, the unit m*s⁻¹ is not a proper unit of frequency because it is a proper unit of velocity which is the distance traveled per unit of time.

In such a way, Hz (hertz), s⁻¹ and 1/s are possible ways frequency can be represented.

Best regards!

Answer:

It's B

Explanation:

I got it right on edjenuity

The most likely outcome of the retrofitting of a nuclear power plant is that it will be able to reprocess its used uranium fuel. Therefore, option C is correct.

A nuclear power plant is a facility that generates electricity by harnessing the heat produced by nuclear reactions. At the heart of a nuclear power plant is the reactor, where a controlled chain reaction of nuclear fission occurs.

Reprocessing is a process by which the used nuclear fuel is chemically treated to separate out and recover the unused uranium and plutonium, which can then be reused as fuel. This reduces the amount of radioactive waste produced by the plant and also extends the life of the uranium fuel.

The fission reactions to fusion reactions is not currently a viable option for power generation, and the idea that a retrofitting would eliminate radioactive wastes is unlikely, as nuclear power plants will always produce some amount of radioactive waste.

Thus, option C is correct.

To learn more about the nuclear power plant, follow the link:

https://brainly.com/question/4246037

#SPJ3

Answer:

349.22°C

Explanation:

Let the final temperature of the two pieces of metal be x.

Now, the warmer metal which is C u reduces from 475°C to x. Thus Δt for C u is; Δt1 = 475 - x.

The cooler metal Cr increases in temperature from 265°C to x. Thus, it's change in temperature is Δt for Cr is; Δt2 = x - 265.

Now from conservation of energy, the amount of energy leaving the C u metal is equal to the amount of energy entering the Cr metal.

Thus;

q_lost = q_gain

Where;

q_lost = m1•c1•Δt1

q_gained = m2•c2•Δt2

Now, c1 & c2 are the specific heat capacity of C u and Cr respectively.

From online tables, c1 = 0.385 J/g°C and c2 = 0.46 J/g°C

We are given;

m1 = 12g and m2 = 15g

Thus;

12 × 0.385 × (475 - x) = 15 × 0.46 × (x - 265)

2194.5 - 4.62x = 6.9x - 1828.5

6.9x + 4.62x = 2194.5 + 1828.5

11.52x = 4023

x = 4023/11.52

x = 349.22°C

Answer:

False

Explanation:

They’re used cause they’re generally harder than pure metals

Alloys are used much more than pure metals because they are generally stronger and less likely to react with air or water...

So I would say false