I WILL GIVE U 100 POINTS IF U COMPLETE THIS AND GET RIGHT!!!!!!!!!!!!

Answer:

B. 1200

Explanation:

60 sec in one min in 2 min there will be 120 sec. 10x120=1200

Answer: Your using your skeletal muscle

Explanation:

Answer:

pressure is a horrible thing to go through, it can lead to many bad side effects, like burn out and it can also lead to high blood pressure, head aches, heart problems, depression, anxiety, and many more damaging effects. Pressure can destroy someones mental health if not dealed worth properly

I hope this is okay! I'm not sure what pressure you meant

Answer:

5.5 m/s

Explanation:

Right on Edge

The statement explains the importance of enzymes that check for and repair mistakes during DNA replication is the enzymes prevent many genetic mutations from being expressed. Thus, the option C is correct.

RNA polymerase is an enzyme that aids in the transcription of DNA into RNA during transcript in the nucleus. The enzymes prevent many genetic mutations from being expressed.

Primase is an enzyme that synthesizes short RNA sequences called primers. These primers serve as a starting point for DNA synthesis during replication as the DNA polymerases cannot begin the synthesis of the new strand, they only extend it after primase begins it and primase produces RNA molecules, the enzyme can be said to be a type of RNA polymerase.

Therefore, The statement explains the importance of enzymes that check for and repair mistakes during DNA replication is the enzymes prevent many genetic mutations from being expressed. Thus, the option C is correct.

Learn more about genetic mutations on:

brainly.com/question/1282397

#SPJ6

Answer:

either its 12 or 0.402

Explanation:

Answer:

The boat won't be able to move if the oars were out and there was no thruster. If there was a flow of the water then yes there would be a moving boat.

Answer:

1) Please find attached, created with Microsoft Visio

2) The acceleration of the masses connected by the light string is 0.00735 m/s²

3) The tension in the cord is 0.147 N

4) The time it would take the block to go 1.2 m to the edge of the table is approximately 18.07 s

5) The velocity of the cart as soon as it gets to the edge of the table is 0.042 m/s

Explanation:

1) Please find attached, the required free body diagram, showing the tension, weight and frictional (zero friction) forces acting on the cart and the mass created with Microsoft Visio

2) The acceleration of the masses connected by the light string is given as follows;

F = Mass, m × Acceleration, a

The mass of the truck, M = 20.0 kg

The mass attached to the string, hanging rom the pulley, m = 0.0150 kg

The force, F acting on the system = The pulling force on the cart = The tension on the cable = The weight of the hanging mass = 0.0150 × 9.8 = 0.147 N

The pulling force acting on the cart, F = M × a

∴ F = 0.147 N = 20.0 kg × a

a = 0.147 N/(20.0 kg) = 0.00735 m/s²

The acceleration of the truck = a = 0.00735 m/s²

3) The tension in the cord = F = 0.147 N

4) The time, t, it would take the block to go 1.2 m to the edge of the table is given by the kinematic equation, s = u·t + 1/2·a·t²

Where;

s = The distance to the edge of the table = 1.2 m

u = The initial velocity = 0 m/s (The cart is assumed to be initially at rest)

a = The acceleration of the cart = 0.00735 m/s²

t = The time taken

Substituting the known values, gives;

s = u·t + 1/2·a·t²

1.2 = 0 × t + 1/2 ×0.00735 × t²

1.2 = 1/2 ×0.00735 × t²

t² = 1.2/(1/2 ×0.00735) ≈ 326.5306

t = √(1.2/(1/2 ×0.00735)) ≈ 18.07

The time it would take the block to go 1.2 m to the edge of the table = t ≈ 18.07 s

5) The velocity, v, of the cart as soon as it gets to the edge of the table is given by the kinematic equation, v² = u² + 2·a·s as follows;

v² = u² + 2·a·s

u = 0 m/s

v² = 0² + 2 × 0.00735 × 1.2 = 0.001764

v = √(0.001764) = 0.042

The velocity of the cart as soon as it gets to the edge of the table = v = 0.042 m/s.

Answer:

There's no answer I'm just taking points like you did me,  so thank you for your points I'll put them to good use ;)

Answer:

C

Explanation:

???

i think

Answer:

Explanation:

Synthetic fabrics, such as nylon and polyester, are produced entirely from chemicals. Natural fabrics, such as cotton, silk, and wool are made of fibres from plants and animals. Synthetic fabrics are useful because they have very different or enhanced (improved) properties in comparison to natural materials.

Answer:

Because even though our eyes have a huge dynamic range (ability to pick out details in sharply lit and lesser lit areas simultaneously) than any camera, there's a limit.

When there's strong sunlight, your pupils contract and let less light in, which makes the shadows look darker.

When it's cloudy, your pupils widen and let more light in, which makes the shadows look less dark.

Do some experiments with a camera and you'll soon get the hang of it.

NOTE: Also test HDR (high dynamic range) photography, where the camera takes three or more pictures in quick succession, with different exposure settings, and combines them to get the most detail of both bright and dark areas. The result is more or less what we percieve.

Answer:

b. Oceans moderate temperatures and climate.

Explanation:

i had this on my quiz and it was right =]

Answer: Number 6 is Periods

Explanation:

Answer:7800

work=force x distance

Force in Newtons

Distance in Meters

Work in Joules

Answer:

A subduction zone is also generated when two oceanic plates collide — the older plate is forced under the younger one — and it leads to the formation of chains of volcanic islands known as island arcs.

Explanation:

Answer:

Under normal conditions, a magnetic material like iron doesn't behave like a magnet because the domains don't have a preferred direction of alignment. On the other hand, the domains of a magnet (or a magnetized iron) are all aligned in s specific direction.

Answer:

c i kn now it is

Explanation:

Answer: 4

Explanation:

The dependent variable is the temperature of the water.

Answer:

a) La piedra es lanzada desde una altura de 0,785 metros.

b) La piedra es lanzada con una velocidad inicial de 6,25 metros por segundo.

Explanation:

a) Dado que la piedra es lanzada horizontalmente, tenemos que la piedra experimenta un movimiento horizontal a velocidad constante y uno vertical uniformemente acelerado debido a la gravedad. La altura de la que fue lanzada la piedra se puede determinar mediante la siguiente ecuación cinemática:

[tex]y = y_{o}+v_{o,y}\cdot t +\frac{1}{2}\cdot g\cdot t^{2}[/tex] (1)

Donde:

[tex]y[/tex] - Altura final, medida en metros.

[tex]y_{o}[/tex] - Altura inicial, medida en metros.

[tex]v_{o,y}[/tex] - Componente vertical de la velocidad inicial, medida en metros por segundo.

[tex]t[/tex] - Tiempo, medido en segundos.

[tex]g[/tex] - Aceleración gravitacional, medida en metros por segundo cuadrado.

Si sabemos que [tex]y = 0\,m[/tex], [tex]v_{o,y} = 0\,\frac{m}{s}[/tex], [tex]t = 0,4\,s[/tex] y [tex]g = -9,807\,\frac{m}{s^{2}}[/tex], entonces la altura inicial de la piedra es:

[tex]y_{o} = y-v_{o,y}\cdot t -\frac{1}{2}\cdot g\cdot t^{2}[/tex]

[tex]y_{o} = 0\,m-\left(0\,\frac{m}{s} \right)\cdot (0,4\,s)-\frac{1}{2}\cdot \left(-9,807\,\frac{m}{s^{2}} \right) \cdot (0,4\,s)^{2}[/tex]

[tex]y_{o} = 0,785\,m[/tex]

La piedra es lanzada desde una altura de 0,785 metros.

b) Ahora, obtenemos el componente horizontal de la velocidad inicial a partir de la siguiente ecuación cinemática:

[tex]v_{o,x} = \frac{x-x_{o}}{t}[/tex] (2)

Donde:

[tex]x_{o}[/tex], [tex]x[/tex] - Posiciones horizontales iniciales y finales, medidas en metros.

[tex]t[/tex] - Tiempo, medido en segundos.

Si tenemos que [tex]x_{o} = 0\,m[/tex], [tex]x = 2,5\,m[/tex] y [tex]t = 0,4\,s[/tex], entonces el componente horizontal de la velocidad inicial es:

[tex]v_{o,x} = \frac{2,5\,m-0\,m}{0,4\,s}[/tex]

[tex]v_{o,x} = 6,25\,\frac{m}{s}[/tex]

La piedra es lanzada con una velocidad inicial de 6,25 metros por segundo.

Answer: true

Explanation:

Answer:

Explanation:

The momentum of an object can be found by using the formula

momentum = mass × velocity

From the question we have

momentum = 0.15 × 35

We have the final answer as

Hope this helps you

Answer:

Him

Explanation:

He will push less but more and he will use more energy

Explanation:

We need to draw position-time graph when the speed is increasing.

The slope of position-time graph gives the speed of an object.

Position means distance covered.

When the speed of an object is increasing with time. It means it is moving with increasing speed.

The attached figure shows the position -time graph when speed is increasing​.

Answer:

1.1 lbs

Explanation:

To convert kg to lbs you multiply kilograms by 2.2. So 0.5kg × 2.2 equals to 1.1 lbs

The energy type at the initial time is potential energy and the energy at the final time or position is kinetic energy.

The law of conservation of energy states that energy can neither be created nor destroyed but can be transformed from one form to another.

Based on the law of conservation of mechanical energy, the formula for the change in the kinetic energy and the potential energy of the bicyclist is given as;

K.Ei + P.Ei = K.Ef + P.Ef

where;

The kinetic energy of the bicyclist increases with increase in the velocity of the bicyclist while the potential energy increases with increase in the height of the bicyclist.

At the initial position when the bicyclist is at rest, the kinetic energy is zero, so the only energy at the initial position is potential energy because the height is maximum.

In addition, at the final position, the velocity of the bicyclist is maximum and the height is zero, so the only energy at the final position is kinetic energy.

Learn more about conservation of energy here: https://brainly.com/question/166559

#SPJ1

Answer:

Heat is a source of energy

Explanation:

Just took the test