Answer:
1. increase the temperature
2. increase the concentration of reactants
3. increase the surface area of the reactants
4. use a catalyst
5. remove the product as it's formed
Explanation:
for a chemical reaction to take place, the bonds between atoms in the reactants are broken, the atoms rearrange and new bonds between the atoms are formed to make the products.
Which of the following naming systems would you use to nameHClO2?
Question 6 options:
a)
HYDRO________IC ACID
b)
HYDROGEN _________IDE
c)
________________IC ACID
d)
________________OUS ACID
which of the following does NOT cause the
urban heat island effect
Answer:
what are the options?
Explanation:
In an ecosystem the urban heat island effect is caused by construction of tall buildings and concrete roads.
What is an ecosystem?Ecosystem is defined as a system which consists of all living organisms and the physical components with which the living beings interact. The abiotic and biotic components are linked to each other through nutrient cycles and flow of energy.
Energy enters the system through the process of photosynthesis .Animals play an important role in transfer of energy as they feed on each other.As a result of this transfer of matter and energy takes place through the system .Living organisms also influence the quantity of biomass present.By decomposition of dead plants and animals by microbes nutrients are released back in to the soil.
Learn more about ecosystem,here:
https://brainly.com/question/13979184
#SPJ6
the greenhouse effect
The greenhouse effect refers to global warming as a consequence of the accumulation of greenhouse gases.
What are greenhouse gases?Greenhouse gases are different types of gaseous elements that trap solar radiation on the Earth's surface.
The most important greenhouse gases include, among others, methane and carbon dioxide (CO2).
In conclusion, the greenhouse effect refers to global warming as a consequence of the accumulation of greenhouse gases.
Learn more about greenhouse gases here:
https://brainly.com/question/20349818
#SPJ1
The equivalence point for a strong acid – strong base titration will occur at:
pH < 7
pH = 7
pH > 7
pH = 14
I believe the ans is (2) pH = 7.
Explanation:
At the equivalence point, the salt of strong acid and strong base is completely hydrolyzed which gives a neutral solution with pH 7 as H+ ion concentration is equal to OH- ion concentration.
That big lorry hit the new car.change to passive voice
Need help on this question asap pleasee
What is the mass of 6.40 moles of copper(II)chloride (CuCl2)?
Answer:
860. g CuCl₂
General Formulas and Concepts:
Atomic Structure
Reading a Periodic TableCompoundsMolesStoichiometry
Using Dimensional AnalysisExplanation:
Step 1: Define
[Given] 6.40 mol CuCl₂
[Solve] g CuCl₂
Step 2: Identify Conversions
[PT] Molar Mass of Cu: 63.55 g/mol
[PT] Molar Mass of Cl: 35.45 g/mol
Molar Mass of CuCl₂: 63.55 + 2(35.45) = 134.45 g/mol
Step 3: Convert
[DA] Set up: [tex]\displaystyle 6.40 \ mol \ CuCl_2(\frac{134.45 \ g \ CuCl_2}{1 \ mol \ CuCl_2})[/tex][DA] Multiply [Cancel out units]: [tex]\displaystyle 860.48 \ g \ CuCl_2[/tex]Step 4: Check
Follow sig fig rules and round. We are given 3 sig figs.
860.48 g CuCl₂ ≈ 860. g CuCl₂
_____ Ca(NO3)2 + _____ Fe → _____ Fe(NO3)3 + _____ Ca I need this done quick and fast Balancing chemical equations
Answer:
3, 2, 2,3
..........................
Which part of the atom is most directly involved in chemical bonding?
Answer:
Electron
Explanation:
How many ml are in 3,764liters?
Hint: ‘mili’ means a thousandth (1/1,000)
Round your answer to the nearest whole number
Answer:
Your answer I think would be 3,764,000 .If Im wrong please correct me and comment below.
I got my answer by converting 3,764 liters to millileters using a converter calculator
then I rounded it to the nearest whole number using the rounding calculator from calculator soup. This has worked for me in the past.
Hope this helps, good luck!
Please help and thank you
Answer:
C
Explanation:
This is a chemical reaction, because only the electrons were rearranged
what are some non living factors that you need in a habitat?
Answer:
You depend on each other and need the nonliving things in your home, like food, water, air, and furniture. Living things need nonliving things to survive. Without food, water, and air, living things die. Sunlight, shelter, and soil are also important for living things.
Explanation: i dunno if this is right or not ;-; but i tried UnU
An unknown compound has the following chemical formula:
P4Sx
where x stands for a whole number.
Measurements also show that a certain sample of the unknown compound contains 2.9 mol of sulfur and 1.94 mol of phosphorus. Write the complete chemical formula for the unknown compound.
will give brainliest :]
Answer:
where the main questions of these assmesnt
Explanation:
If you start with 30.0 grams of sodium fluoride, how many grams of magnesium fluoride will be produced?
Answer:
22.2 g of MgF₂
Explanation:
We star from the reaction:
NaF → sodium fluoride
Mg → Magnesium
2NaF + Mg → MgF₂ + 2Na
2 moles of sodium fluoride react to 1 mol of Mg in order to produce 1 mol of magnesium fluoride and 2 moles of sodium.
We convert mass of the reactant to moles:
30 g . 1mol / 41.98 g = 0.715 mol
We assume that Mg is in excess
As ratio is 2:1, if we have 0.715 moles of NaF we may produce the half of moles, of MgF₂
0.715 mol /2 = 0.357 moles of MgF₂
We convert moles to mass: 0.357 mol . 62.30g /mol = 22.2 g
What’s the empirical formula of a molecule containing 65.5% carbon, 5.5% hydrogen, and 29.0% oxygen?
Which is an example of a nonaqueous solution?
gasoline
fog
mayonnaise
fruit juice
Answer: Gasoline
Explanation: Siri said so
The non-aqueous means it does not contain water. Among the given options gasoline is an example of a non-aqueous solution. The correct option is A.
What is a non-aqueous solution?The solution which is obtained by dissolving solute in any liquid other than water is defined as the non-aqueous solution. If solute is dissolved in solvent like benzene, alcohol, ether, carbon disulphide, acetone etc. forms a non aqueous solution.
The major difference between the aqueous and non-aqueous solution is that the solvent of an aqueous solution is water whereas in non-aqueous solutions, the solvent is any substance other than water.
The solvent of non-aqueous solution can be polar or nonpolar and depending on the polarity the solutes dissolve in the solvent. Here gasoline is an example of the non-aqueous solution. The gasoline is a crude oil which does not include water as an ingredient.
Thus the correct option is A.
To know more about non-aqueous solution, visit;
https://brainly.com/question/4992250
#SPJ7
if 67.8 moles of gas was measured out into a helium balloon how many molecules would be present within the balloon
Answer:
[tex]4.08x10^{25} molecules[/tex]
Explanation:
Hello there!
In this case, since the understanding of the mole-molecules relationships is analyzed via the Avogadro's number:
[tex]1mol=6.022x10^{23}molecules[/tex]
Next, we can solve the following setup by starting with the 67.8 moles of helium and obtaining the required molecules as follows:
[tex]67.8mol*\frac{6.022x10^{23}molecules}{1mol}\\\\=4.08x10^{25} molecules[/tex]
Best regards!
a. 35
b.65
c.81
d.180
I think it's 80 . 12
pls tell me if correct
So I have an F in science, and everything is due today. Am I going to fail 9th grade because I didn't pass that class?
Answer:
i dk how ur school works, but you'll most likely have to take that science again to get the credits u need to graduate
Explanation:
i need help on this question
NO LINKS!
Answer:
2 experimental
Explanation:
How many total atoms are in 1 mole of H2O?
Answer:
1.806 x 10^24 atoms total
Explanation:
SEP Analyze Data Look at the phase diagram. What is the state of matter for methanol at a temperature of −0.1°C and a pressure of 2.5 atm?
1. What did you notice about the distance between the atoms as the number of bonds increased? (Compare bond of H2S and H2O)
2. What is the relationship between atomic size and bond length for H2O / H2S and CO2 / CS2?
Answer:
Inverse relationship between number of covalent bonds and bond length.
Explanation:
There is inverse relationship between number of covalent bonds and bond length which means that if one increases the decreases or the one decreases the increases. When the number of covalent bonds between two atoms increases, the bond length decreases because there are more number of electrons present between the two nuclei, the two nuclei can get closer to each other until both nuclei experience their repulsive force of attraction. In bond of H2S has lower electronegativity value as compared to H2O so the bond length decreases due to attraction of shared pair of electrons by both nuclei.
How many moles of hydrogen gas (H2) are required to react completely with 0.75 moles of nitrogen
gas (N2)?
Answer:
2.25 moles H2
Explanation:
The equation N2+ 3H2 > 2NH3
1 mol of N2 gives 3 mol of H2
Then
. 75 mole N2 give 3*.75 = 2.25 moles of H2
The limiting reactant is...
A). The reactant that produces the least amount of product
or B). The reactant that produces the most amount of product
I give Brainliest ! plz no links!
Answer:
A.) produces the least amount of product.
What would make oppositely charged objects attract each other more?
increasing the positive charge of the positively charged object and increasing the negative charge of the negatively
charged object
decreasing the positive charge of the positively charged object and decreasing the negative charge of the negatively
charged object
increasing the distance between the positively charged object and the negatively charged object
maintaining the distance between the positively charged object and the negatively charged object
Answer: increasing the positive charge of the positively charged object and increasing the negative charge of the negatively charged object.
Explanation:
edge
Answer:
Your answer is A.
Explanation:
Select all that apply.
When the products of a reaction have less energy than the reactants:
The reaction is exothermic.
The reaction is endothermic.
The reactants lost internal energy.
The change in enthalpy is positive.
Answer:
The reaction is endothermic
Explanation:
we know that the reactants had to get energy from its surroundings which means that the reaction is endothermic
-- A scientist combines 14 grams of potassium nitrate with an unknown amount of
potasslum chloride. If the total mass of the products is 27.6 grams, what was the
mass of the potassium chloride?
Cada
Answer:
The unknown amount of potassium chloride is 13.6 grams.
Explanation:
The reaction of 14 grams of KNO₃ with KCl produces a total mass of 27.6 grams of the products.
The law of conservation of mass tells us that the total mass of the reactants must be the same that the total mass of the products. So, we can find the mass of KCl as follows:
[tex] m_{r} = m_{p} [/tex]
Where r is for reactants and p is for products
[tex] m_{KNO_{3}} + m_{KCl} = m_{p} [/tex]
[tex] 14 g + m_{KCl} = 27.6 g [/tex]
[tex] m_{KCl} = 27.6 g - 14 g = 13.6 g [/tex]
Therefore, the unknown amount of potassium chloride is 13.6 grams.
I hope it helps you!
How many grams are there in 7.40 moles of AgNO3?
Answer:
1257.03 grams
Explanation:
mass=mole*molar mass
mass=7.4*169.87= 1257.03
why there might be something else in the water besides the reddish-brown substance?
Answer:
Tbe reddish brown substance might be the rust that formed overtime in a iron tap and over the course of time mixed with other dust and particles it might have formed another substance .
The reddish brown substance is iron oxide which is formed by the reaction of iron materials with water and air. This oxide layer above the surface of metallic parts is called rust.
What is iron oxide ?The Fe is a reddish metal more reactive towards the air and water as well. Fe is a very common in the manufacturing of many household materials. However, by the action of air and water these metallic parts undergo corrosion.
Corrosion is a chemical change involving the formation of oxide layer over the metallic surface which eventually corrode the substance and make it unusable.
Fe reacts with oxygen of water or air forming the reddish brown iron oxide Fe₂O₃ that is what called the rust. Rust can be seen in needles, vehicle parts made of iron etc.
Find more on corrosion:
https://brainly.com/question/28302789
#SPJ2