free!!!!!!!!!!!!!!!!!!!​

Answer:

B The forces acting on the book are in equilibrium

Explanation:

The book that lies on the table and does not move according to Newton's First Law of motion, because there are no net forces acting on it, therefore the net force (the sum of forces acting on the book) is zero

Therefore, the magnitude of the forces acting on the book and the direction in which the forces acts on the balance each other such that the book is in an equilibrium state because the forces acting on the book (which can cause the book to move) are in equilibrium

Therefore, the book is not moving because the forces on the book are in equilibrium.

Answer:

Explanation:

The equation for Kinetic Energy is

[tex]KE=\frac{1}{2}mv^2[/tex] and we know everything but the mass of this ball. Filling in:

[tex]3.00=\frac{1}{2}m(5.00)^2[/tex]. Get everything isolated from the :

[tex]m=\frac{2(3.00)}{(5.00)^2}[/tex] which tells us that we need 3 significant digits in our answer.

m = .240 kg since mass is always in kg i the velocity is in meters/sec

Answer:

200 N

Explanation:

Since Young's modulus for the metal, E = σ/ε where σ = stress = F/A where F = force on metal and A = cross-sectional area, and ε = strain = e/L where e = extension of metal = change in length and L = length of metal wire.

So,  E = σ/ε = FL/eA

Now, since at break extension = e.

So making e subject of the formula, we have

e = FL/EA = FL/Eπr² where r = radius of metal wire

Now, when the radius and length are doubled, we have our extension as e' = F'L'/Eπr'² where F' = new force on metal wire, L' = new length = 2L and r' = new radius = 2r

So, e' = F'(2L)/Eπ(2r)²

e' = 2F'L/4Eπr²

e' = F'L/2Eπr²

Since at breakage, both extensions are the same, e = e'

So,  FL/Eπr² = F'L/2Eπr²

F = F'/2

F' = 2F

Since F = 100 N,

F' = 2 × 100 N = 200 N

So, If the radius and length of the wire were both doubled then it would break when the tension reached 200 Newtons.

Answer:

Energy

Explanation:

Explanation:

everything can be found in the picture

Answer:

halved.

Explanation:

Given the following data;

Potential difference = constant

Resistance = 2 * resistance = 2R

To find the current I;

Ohm's law states that at constant temperature, the current flowing in an electrical circuit is directly proportional to the voltage applied across the two points and inversely proportional to the resistance in the electrical circuit.

Mathematically, Ohm's law is given by the formula;

[tex] V = IR[/tex]

Where;

V represents voltage measured in voltage.

I represents current measured in amperes.

R represents resistance measured in ohms.

Making current (I) the subject of formula, we have;

[tex] I = \frac {V}{R} [/tex]

Substituting into the formula, we have;

[tex] I = \frac {V}{2R} [/tex]

[tex] I = \frac {1}{2} * \frac {V}{R} [/tex]

[tex] I = \frac {1}{2} * I [/tex]

Therefore, if the resistance of the resistor is doubled, the current through the resistor is halved.

Answer:

60

Explanation:

90+30=120:2=60km/h

Answer:

mark as the brainly olss

Answer:

2.90 meters

Explanation:

Distance of speaker 2 =?

Distance of speaker 1 = 1.47m

Velocity = 343

f = 240Hz

For constructive interference to occur:

Difference in distance or path = wavelength

For minimum distance, n = 1

Distance 2 - distance 1 = nλ

Recall λ = v/f

V = Velocity ; f = frequency

Distance 2 - distance 1 = v/f

Distance 2 - 1.47 = (343/240)

Distance 2 = 1.429 + 1.47

Distance 2 = 2.899 meters

Minimum Distance of speaker 2 for their to be constructive interference = 2.90meters

Answer: 0.280

Explanation: trust.

Answer:

B) uniform

Explanation:

We can solve this problem by using Boyle's law, which states that:

For a constant mass of an ideal gas kept at constant temperature, the pressure of the gas is inversely proportional to its volume.

Mathematically:

where

p is the pressure of the gas

V is its volume

If we apply the equation to the bottle in the problem, we see that:

- when the volume of the bottle (and therefore, of the gas inside) decreases, than the pressure will increase

- viceversa, when the volume of the bottle increases, the pressure will decrease

The amount by which the pressure increases is inversely proportional to the decrease in volume, so the answer depends on how the volume of the bottle decreases: however, if the volume of the bottle decreases uniformly, then we can say that the pressure inside the bottle will also increases uniformly.

MARK THIS ANSWER AS THE BRAINLIEST PLEASE ❤️

An increase in pressure of a plastic bottle  uniformly decreases by a factor of ten when the volume decreases.

Pressure is defined as the force applied on an object perpendicular to it's surface per unit area over which it is distributed.Gauge pressure is a pressure which is related with the ambient pressure.

There are various units by which pressure is expressed most of which are derived units which are obtained from unit of force divided by unit of area . The SI unit of pressure is pascal .

It is a scalar quantity which is related to the vector area element with a normal force acting on it.It is distributed over solid boundaries and across arbitary sections of fluid normal to the boundaries at every point.Pressure and volume of gas are inversely proportional.

Learn more about pressure,here:

https://brainly.com/question/14760196

#SPJ6

Answer:

si?

Explanation:

definition La myopie. L'oeil myope est trop long ou le cristallin trop convergent. L'image d'un objet à l'infini se forme en avant de la rétine. Le punctum remotum est ... i dont know sorry

Answer:

planisphere

Explanation:

Answer:

Based on what we have learned so far, in what ways have the experiences of Asian-Canadians stayed the same over time? Why do you think these similarities exist? Please give specific examples to support your ideas.

Explanation:

Action-reaction forces are equal and opposite forces that act on different objects, so they don't cancel out. In fact, they often result in motion. Think about Jerod again. He applies force with his foot to the ground, whereas the ground applies force to Jerod and the skateboard, causing them to move forward.

Hope this helps =)

Answer:

R + 6 ohms

Explanation:

The current is the same in all three resistors

i = 2 amps

The problem is that the total voltage is unknown.

R = r

R1 =3 ohms

R2 = 3 ohms

The voltage drop is E = I*R

I = 2 amps

R1 = 3 ohms

R1 = 3 ohms

E = 3*2 = 6 volts

The second 3 ohm resistor also has 6 volts across it.

The total is 12 volts so far. But we know nothing more on how to solve for R.

All you can say is that the total resistance = R + 6 ohms

Answer:

ΔL = 1.2 10⁻³ m

Explanation:

The expression for thermal expansion is

        ΔL = α L₀ ΔT

in this case it indicates that the length is L₀ = 5 m for T₀ = 20C the final temperature is T_f = 40 C

the table shows the value of thermal expansion for steel α = 12 10⁻⁶ C⁻¹

let's calculate

        ΔL = 12 10⁻⁶  5 (40 -20)

        ΔL = 1.2 10⁻³ m

Answer:

A lightning flash is at least 270,000 mph (434,523 kph)!

Explanation:

Have a great summer :)

Answer:

670,000,000 mph

Explanation:

The speed of lightning. While the flashes we see as a result of a lightning strike travel at the speed of light (670,000,000 mph) an actual lightning strike travels at a comparatively gentle 270,000 mph

Explanation:

using Ohm's law which is defined as V=IR

where V is the voltage, I is the current and R the resistance

Answer:

because it will help it go and funcion more

Explanation:

Answer:

It uses graivity and momentum because since we all know, gravity pulls things down, they have a chaint hat lifts the carts up, and then when it gets to a top, it releases it. When it goes down very high, it will go faster. Then it uses momentum when it goes up, then down again, or a loop to regain speed. IT doesn't need a engine or a motor to speed it up or slow it down because gravity and momentum is already doing the job a engine could. Like I said, when it is high in the sky and released, it goes down in incredible speed. And when it needs more speed to keep the ride going, it can add a loop or tight turns to increase it more.

Answer:

10 cm

Explanation:

Được

Tần số = 50 hertz

Khoảng cách đã đi = 25 m

Thời gian đi quãng đường 25 m = 5 giây

Tốc độ của sóng = 25/5 = 5 mét trên giây

Như chúng ta biết

Bước sóng = Vận tốc / tần số

Bước sóng = 5 mét trên giây / 50 trên giây

Bước sóng = 0,1 m = 10 cm

Answer:

Virtual and erect.

Answer:

Hitting the brakes

I guess....

Answer:

if he hits the brakes before it hits the wall then the safest outcome will be that he and his car will be safe.

Answer:

soccer, football, volleyball, baseball, locress

Explanation:

hope it helps

Answer:

Power = 20 Watts

Explanation:

Given the following data;

Voltage = 100 V

Resistance = 500 Ohms

To find the power that is required to light a lightbulb;

Mathematically, power can be calculated using the formula;

[tex] Power = \frac {Voltage^{2}}{resistance} [/tex]

Substituting into the formula, we have;

[tex] Power = \frac {100^{2}}{500} [/tex]

[tex] Power = \frac {10000}{500} [/tex]

Power = 20 Watts

i believe the awnser is Amplitude

Answer:

Current = 2 Amperes

Explanation:

Given the following data;

Resistance = 8 Ohms

Power = 32 W

To find the amount of current going through the speaker;

Mathematically, power can be calculated using the formula;

Power = current² * resistance

Substituting into the formula, we have;

32 = current² * 8

Current² = 32/8

Current² = 4

Taking the square root of both sides, we have;

Current = √4

Current = 2 Amperes

Explanation:

first find the volume of room --->

[tex]v \: = 10 \times 12 \times (400 \times {10}^{ - 2} ) \times = 480 \: {m}^{3} [/tex]

then find the mass

[tex]mass \: = \: density \: \times \: volume \: = 480 \times 1.26 = 604.8 \: kg[/tex]

Answer:

Kevin must have used simple random sampling.

Explanation:

We can say that Kevin used simple random sampling. This is because this type of sampling allows elements to be taken from a population in a completely random way, to form a sample. In this case, each element, or individual, as shown in the question above, has the same probability of being selected to compose the sample, since this selection is completely random.