(FOR SCIENCE)fill in the blank with the words ok the top!!!!!

Answer:

Im going to say voltage. It matches with my notes but it says voltage difference so i hope this helps!

Explanation:

Answer:

Since heat is carried by electromagnetic waves, it does not need a physical medium to transfer it. Instead it radiates through space - this is how the Earth is heated by the Sun despite space being a vacuum.

Explanation:

Answer:

it produces

Explanation:

a lot of waste

In an ecosystem,disadvantage of using wind as an energy source  is that it produces a lot of waste.

Ecosystem is defined as a system which consists of all living organisms and the physical components with which the living beings interact. The abiotic and biotic components are linked to each other through nutrient cycles and flow of energy.

Energy enters the system through the process of photosynthesis .Animals play an important role in transfer of energy as they feed on each other.As a result of this transfer of matter and energy takes place through the system .Living organisms also influence the quantity of biomass present.By decomposition of dead plants and animals by microbes nutrients are released back in to the soil.

Learn more about ecosystem,here:

https://brainly.com/question/13979184

#SPJ7

The solution of copper sulfate was too cold

Explanation:

The lack of an observable reaction when adding a zinc strip to a copper sulfate solution could be due to the zinc not being reactive enough, the reaction occurring too slowly, or an experimental error.

The lack of an observable reaction refers to a situation where no visible or measurable change occurs when two or more substances are mixed or brought into contact with each other, even though a reaction was expected based on the chemical properties of the substances involved.

Here in the Question,

The lack of an observable reaction when Alannah added a strip of zinc to a beaker containing a solution of copper sulfate could be due to the following reasons:

Zinc and copper sulfate do not react: It is possible that the zinc strip and copper sulfate solution do not react with each other, leading to no observable change. This could occur if the zinc strip is not reactive enough to displace the copper in the copper sulfate solution.

Reaction is slow: Another possibility is that the reaction between zinc and copper sulfate is occurring but is happening too slowly to be observed. In this case, the reaction rate may be too low to produce an observable amount of solid copper in the beaker in a short period of time.

Experimental error: It is also possible that an error was made during the experiment that prevented the expected reaction from occurring. For example, the concentration of the copper sulfate solution may have been too low, or the zinc strip may have been coated with a layer of oxide that prevented it from reacting with the solution.

Therefore, Zinc may not be sufficiently reactive, the reaction may proceed too slowly, or there may have been a mistake in the experiment if there was no detectable reaction when a zinc strip was added to a copper sulphate solution.

To learn more about redox reaction click:

brainly.com/question/2671074

#SPJ2

Explanation:

that the people closer too the head of the table will feel more vibrations than the people at the end of the table. since the vibrations will slow down as they travel farther down the table

Hope this helps!!

Answer:

1.42 seconds

Explanation:

T=2*pi*(sqrt length over gravity)

T=2*pi*(sqrt 0.5/9.8)

T=1.4189

Round to 3 significant digits

T=1.42 seconds

Answer:

density of the object

volume of the immersed part of the object

Answer:

v = 1  i ^ m / s,   v = 1 m / s

Explanation:

In this problem we show the difference between vectors and scalars.

The average speed is

          v = Δx / Δt

The bold are vectors            

          Δx = 20-10 = 10 i^  m

           v = 10/10

           v = 1  i ^ m / s

the unit vector indicates that the velocity is on the x-axis

The average speed is

           v =Δx / Δt

           v = 10/10

           v = 1 m / s

in this case we have a scalar

Answer:

The tissues in a multicellular organism requires a circulatory system in other to deliver oxygen and food to the tissues while also removing carbon dioxide and metabolic wastes due the complexity of these activities

Explanation:

Multicellular organisms are organisms that are made of more than one cell. the more cells an organism has the more complex certain activities might be for the organism hence the tissues in a multicellular organism requires a circulatory system in other to deliver oxygen and food to the tissues while also removing carbon dioxide and metabolic wastes

Answer:

2K + 2h2O =2KOH + H2

(Tell me if its incorrect)

Answer:

[tex] \boxed { \tt{gravitational \: pull(force)}}[/tex]

Answer:

No, he hasn't done any work.

Explanation:

In this scenario, the weightlifter hasn't done any work because even though he lifted the bell for a specific period of time, he didn't cover any distance.

Mathematically, work done is given by the formula;

Work done = force * distance

[tex] W = F * d[/tex]

Where,

W is the work done

F represents the force acting on a body.

d represents the distance covered by the body.

Power can be defined as the energy required to do work per unit time.

Mathematically, it is given by the formula;

[tex] Power = \frac {Energy}{time} [/tex]

Ocean breezes are primarily due to convection, which is the transfer of heat through the movement of fluids or gases.  The correct option is B.

Convection is a method of heat transfer that occurs in fluids (liquids and gases) and involves the movement of material carrying thermal energy. In convection, heat is transferred by the movement of hot fluid from one place to another, which then causes the transfer of heat from the hot fluid to the cooler fluid or surface it comes into contact with.

Convection can occur in two ways:

Natural convection: It occurs due to the density differences caused by temperature variations within a fluid. When a fluid is heated, its density decreases, making it lighter and causing it to rise. As it rises, it cools, becomes denser and falls back down, creating a cycle that is known as a convection current.

Forced convection: In this type of convection, a fluid is forced to flow over a surface or through a channel, by an external agent like a fan or pump. The forced flow enhances the rate of heat transfer from the surface or through the channel, as compared to natural convection, where the fluid flow is driven only by buoyancy forces.

Convection is a very important process for heat transfer in many natural and industrial applications, including heating and cooling systems, meteorology, oceanography, and more.

Here in the Question,

Ocean breezes are primarily due to convection, which is the transfer of heat through the movement of fluids or gases. As the sun heats up the surface of the ocean, the air above it also heats up and rises. This creates a low pressure area that draws in cooler air from over the land, resulting in a breeze that blows from the ocean towards the shore. This is why sea breezes are generally felt during the day, when the land is warmer than the sea, and why they tend to die down at night, when the opposite occurs.

Therefore, The correct answer is B i.e convection.

To learn about the difference between conduction and convection click:

https://brainly.com/question/13104912

#SPJ7

Answer:

18.75 ohms.

Explanation:

From the question,

]When four resistors are connected in parallel in a circuit,

The equilvalent resistor is given as

1/R' = 1/R₁+1/R₂+1/R₃+1/R₄............................Equation 1

Where R' = Equivalent resistor.

Given: R₁ = R₂ = R₃ = R₄ = 75.0 ohms.

Substitute these values into equation 1

1/R' = (1/75)+(1/75)+(1/75)+(1/75)

1/R' = 4/75

R' = 75/4

R' = 18.75 ohms.

Hence the equivalent resistance = 18.75 ohms.

Answer:

18.8 ohms

Explanation:

apax

Answer:

a car

A sled sliding across snow or ice.

a ball down a hill

mercury

Explanation:

Answer:

1. Mechanical energy = 298.4 Joules.

2. Mechanical energy = 2140 Joules.

3. Mechanical energy = 0.2838 Joules.

Explanation:

Kinetic energy can be defined as an energy possessed by an object or body due to its motion.

Mathematically, kinetic energy is given by the formula;

[tex] K.E = \frac{1}{2}MV^{2}[/tex]

Where;

K.E represents kinetic energy measured in Joules.

M represents mass measured in kilograms.

V represents velocity measured in metres per seconds square.

Potential energy can be defined as an energy possessed by an object or body due to its position.

Mathematically, potential energy is given by the formula;

[tex] P.E = mgh[/tex]

Where,

P.E represents potential energy measured in Joules.

m represents the mass of an object.

g represents acceleration due to gravity measured in meters per seconds square.

h represents the height measured in meters.

Given the following data;

1. Kinetic energy = 182.2 J

Potential energy = 116.2 J

To find the mechanical energy;

Mechanical energy = kinetic energy + potential energy

Mechanical energy = 182.2 + 116.2

Mechanical energy = 298.4 Joules.

2. Mass = 40kg

Velocity = 3m/s

Height = 5m

We know that acceleration due to gravity is equal to 9.8m/s²

To find the mechanical energy;

We would determine the kinetic and potential energy respectively.

K.E = ½mv²

K.E = ½*40*3²

K.E = 20*9

K.E = 180 Joules.

P.E = mgh

P.E = 40*9.8*5

P.E = = 1960 Joules

Mechanical energy = K.E + P.E

Mechanical energy = 180 + 1960

Mechanical energy = 2140 Joules.

3. Mass = 0.002kg

Height = 3m

Velocity = 15m/s

To find the mechanical energy;

K.E = ½mv²

K.E = ½*0.002*15²

K.E = 0.001*225

K.E = 0.225 Joules.

P.E = mgh

P.E = 0.002*9.8*3

P.E = = 0.0588 Joules

Mechanical energy = K.E + P.E

Mechanical energy = 0.225 + 0.0588

Mechanical energy = 0.2838 Joules.

Answer:

Gravity acts to push the object sideways

Explanation:

projectile motion is a motion that moves along a curved path under the action of gravity only. Hope this helps!

Work = (force) x (distance)

Work = (20 N) x (10 m)

Work = 200 Joules

Answer:

I gotchu fam. 0.0435 kg

Explanation:

m1v1+m2v2=m1v1f+m2v2f

(0.5)(23)+(m2)(0)=(0.5)(17)+(m2)(69)

11.5=8.5+69m2

3=69m2

0.0435 kg

Answer:

v = (10 i ^ + 0j ^) m / s,    a = (0i ^ - 9.8 j ^) m / s²

Explanation:

This is a missile throwing exercise.

On the x axis there is no acceleration so the velocity on the x axis is constant

           v₀ₓ =  10 m / s

On the y-axis velocity is affected by the acceleration of gravity, let's use the equation

           v_y = [tex]v_{oy}[/tex] - g t

           [tex]v_{y}^2 = v_{oy}^2 - 2 g (y - y_o)[/tex]

at the highest point of the trajectory the vertical speed must be zero

           v_y = 0

therefore the velocity of the body is

          v = (10 i ^ + 0j ^) m / s

the acceleration is

          a = (0 i ^ - g j⁾

          a = (0i ^ - 9.8 j ^) m / s²

Answer:

too little body fat is a health risk

Explanation:

IF you do not have enough body fat you can have bad things happen to you

Answer:As a pendulum swings, its potential energy converts to kinetic and back to potential. ... A swinging pendulum.

Explanation:During the course of a swing from left to right, potential energy is converted into kinetic energy and back.

Answer:

3.375 m/s²

Explanation:

Using equation of motion:

v = u + at

Here, v = 27m/s & u = 0m/s & t = 8 sec

Let the acceleration be a.

=> 27 = 0 + 8(a)

=> 27/8 = a

=> 3.375 m/s²

Answer:

its A and B

Explanation:

Answer:

A or A and B

Explanation:

correct on edge 2021

Answer:

C

Explanation:

pls mark brainlest ty

have a good day

The gas has the same temperature throughout. (C)

Answer:

 μ = 0.179

Explanation:

For this exercise we use the rotational equilibrium condition, where we set a reference system at the top of the ladder where it is in contact with the parent, we will assume the counterclockwise rotations as positive

         ∑ τ = 0

         W_stairs x/2 + W_man x’+ fr y - N x = 0

          fr y = -W_stairs x/2 - W_man x’ + N x

let's use trigonometry for distances

* the man up the ladder 78%

            l ’= 0.78 L

            cos 59 = x ’/ l’

            x’= 0.78 L cos 59

* the horizontal distance

           cos 59 = x / L

            x = L cos 59

* vertical distance

            sin 59 = Y / L

            y = L sin 59

we substitute

           fr L sin 59 = -W_stairs Lcos59 / 2 - W_man 0.78 L cos59 + N L cos59

           fr sin 59 = - ½ W_stairs cos 59 - 0.78 W_man cos 59 + N cos 59

           fr = ctan 59  (N - ½ W_stairs - 0.78 W_man)     (1)

Let's write the translational equilibrium equations

Y axis  

           N -W_stairs - W_man = 0

           N = W_stairs + W_man

           N = 85 + 21.5 9.8

           N = 295.7 N

we substitute in 1

           fr = ctg 59 (295.7 - ½ 85 - 0.78 21.5 9.8)

           fr = 0.6 (295.7 - 42.5 - 164.346)

           fr = 52.89 N

the expression for the friction force is

            fr = μ N

            μ = fr / N

             μ = 52.89 / 295.7  

             μ = 0.179