Answer:
they would atrract because they are sticky but when you take it off it would ware off
Explanation: I have used tape before and when you stick something to it then take it off it wares off
Two pieces of sticky tape with the same charge are formed when the non-sticky sides of the tape remain facing each other, it is observed that there is an interaction between the two pieces of tape, but the attraction and repulsion depend upon their charges.
What is the significance of attraction and repulsion?If the two pieces of tape have the same charge, they will repel each other, and as a result, the pieces of tape will move away from each other and if the two pieces of tape have opposite charges, they will attract each other, and as a result, the pieces of tape will move towards each other. The electric fields that are created by each piece of tape attract each other if they have differing in charges.
Hence, interaction between the two pieces of nonstick tape is observed, and the attraction and repulsion depend upon their charges.
Learn more about attraction and repulsion here.
https://brainly.com/question/10895182
#SPJ2
1) If you release a rubber band that had 10 units of elastic energy, 12 units of movement energy cannot be produced. Why not?
2) For the rubber band in question 3, what would its percentage efficiency be if 7 units of movement energy were produced? Where have the remaining 3 units of energy gone?
3) What are the by-product energy transformations for a car?
Answer:
press dat crown for meh
Explanation:
A system's internal energy is given by the heat added to the system less the work done by the system
1) 12 units of movement energy cannot by produced from 10 units of elastic energy because the additional 2 units of energy cannot be created in the closed system of the rubber band
2) Part A; The percentage efficiency = 70%
Part B; The remaining 3 units is transformed into heat and sound energy
3) The by-products of the energy transformation for a car are;
Heat energySound energyChemical energyThe reason for the above outcomes is as follows:
1) The first law of thermodynamics known as the law of conservation of energy states that the sum of energy within an closed or isolated system is constant and it is conserved as time progresses
Mathematically, the law can be expressed as follows;
K₁ + U₁ = K₂ + U₂
Where;
K₁ and U₁ = Initial kinetic and potential energy respectively
K₂ and U₂ = Final kinetic and potential energy respectively
The energy stored in the rubber band is given as 10 units of elastic energy. If the rubber band is taken as being in a closed system, then no additional energy is added, and we have;
U₁ = 10 units and K₁ = 0, which gives;
K₁ + U₁ = 10 units
According to the law of conservation of energy, we get;
10 units = K₁ + U₁ = K₂ + U₂
Therefore, the sum of the final kinetic and potential energy is 10 units and the energy can only be transferred from kinetic to potential (internal) energy, such that the maximum kinetic, movement, energy obtainable is 10 units and 12 units of movement energy cannot be produced
2) The given parameter:
Initial amount of elastic energy = 10 units
The amount of movement energy produced = 7 units
[tex]Efficiency = \mathbf{\dfrac{Useful \ energy \ produced}{Total \ energy \ stored} \times 100}[/tex]
[tex]\mathbf{Efficiency \ of \ the \ rubber \ band, \, \eta }= \dfrac{Movement \ energy \ produced}{Elastic \ energy \ stored} \times 100[/tex]
Therefore;
[tex]\mathbf{\eta = \dfrac{7}{10} \times 100} = 70 \%[/tex]
The percentage efficiency of the rubber band, η = 70%
Part B
The remaining 3 units of energy is transformed into other energy forms including heat and sound energy
3) A by-product is a secondary product, produced in addition to a main or primary product.
In the energy transformations of a car, the main product of the energy transformation is the movement energy of the car
The by-product of the energy transformation in a car includes;
Heat energy; The temperature of the engine of the car rises
Sound energy; The engine sound
Chemical energy; The formation of new chemicals during the combustion process
Learn more about conservation of energy here:
https://brainly.com/question/11728993
How does the agricultural activity most likely affect the surface water of the area?
Answer:
Agriculture has been the cause of significant modification of landscapes throughout the world. Tillage of land changes the infiltration and runoff characteristics of the land surface, which affects recharge to ground water, delivery of water and sediment to surface-water bodies, and evapotranspiration.
Explanation:
urgenttt helpppp!!!!!!!!!!!!!!!!!!!!!!!!
a studentistrying to design an artificial eardrum for their science fair project. they made their eardrum hollow to cut down on cost and weight. when they tested how long it took to test the subject to hear deep, they found that their control ear drum made out of wood did better than their created one. the temperature that day wa 98 fahrenheit.
determine which statement supports the students findings.
a.the created eardrum performed worst because sound travels faster in solids due to large distance between the particals
b. the created eardrum performed worst because sound travels faster in solids due to the small distance between the particles.
c.the created eardrum performed worst because sound travels slower in air due to the small distance between the particles.
d.the created eardrum performed worst because sound travels slower through air in high temperatures due to the particles moving slower.
Can someone help me
Which of the following would a good frame of reference?
A) the moon
B) a tree
C) a rabbit
D) your sister while she rides her bike
PLZ ANSWER QUICKLY
Janice has just measured the density of an object. Which value is possible? (Density: D = )
A.–1 g/cm3
B.4 m/s
C.–3 m/s
D.6 g/cm3
Venn diagrams are used for comparing and contrasting different topics. The overlapping sections show characteristics that the topics have in common, and the sections that are unique to each topic show the characteristics apply to only that topic.
Overlapping circles are labeled solid on top, liquid at right, gas at left, with the intersection of all three labeled state of matter.
Which Venn diagram accurately describes what characteristics of solids, liquids, and gasses could be added to this diagram?
Overlapping circles are labeled definite shape most dense at top, mid-level density at right, definite volume least dense at left, with the intersection labeled state of matter.
Overlapping circles are labeled definite shape most dense at top, mid-level density at right, least dense at left, with the intersection of all three labeled state of matter. The intersection of the top and right circles is labeled definite volume.
Overlapping circles are labeled definite shape most dense at top, definite volume mid-level density at right, least dense at left, with the intersection of all three labeled state of matter. The intersection of the left and right circles is labeled definite shape.
Overlapping circles are labeled definite shape least dense at top, definite mid-level density at right, most dense at left, with the intersection of all three labeled state of matter. The intersection of the left and right circles is labeled definite shape.
Answer:
its the third image
Explanation:
Answer:
3
Explanation:
Two laws are described below:
Law A: It can be broken under certain conditions.
Law B: It does not focus on a natural phenomenon.
Based on these characteristics, what can you conclude about Law A and Law B?
Both Law A and Law B are societal laws.
Both Law A and Law B are scientific laws.
Law A is a scientific law and Law B is a societal law.
Law A is a societal law and Law B is a scientific law.
Answer:
B is the answer. Law A is a scientific law and Law B is a societal law
Answer: Both law A and B are scientific laws
The blue mass in the image is 10kg.
The red mass in the image is 10kg.
The blue mass is currently 4 meters away from the red mass.
If we change each mass to 20kg, what will happen to the gravitational force each mass puts on the other?? You have to pick a answer through A,B,C! The force of gravity will increase as the masses increase.
The force of gravity will not change as the masses increase.
The force of gravity will decrease as the masses increase.
PLEASE HELP! 20 POINTS!
Amy and Chris took different routes to travel from Point A to Point E. Amy took the route along A, B, C, D, and E and reached the destination in 2 hours. Chris took the route along A, G, F, and E and reached the destination in 3 hours. Their routes are shown.
Which conclusion is correct?
Amy's average speed is twice Chris's average speed.
Chris's average speed is twice Amy's average speed.
Amy's average speed is equal to Chris's average speed.
Chris's average speed is three times Amy's average speed.
Answer:
Amy's average speed is equal to Chris's average speed
Answer:
im pretty sure its 'a'
Explanation:
Amy took 1 more point than Chris and reached their destination in 2 Hrs. when Chris took less and reached the destination in 3 Hrs.
see picture for visual explanation:
( please just tell me the formula to use to solve it ) A hockey puck has a coefficient of kinetic friction of μk = .10. If the puck feels a normal force (FN) of 5 N, what is the frictional force that acts on the puck?
The frictional force that acts on the puck is 0.5 N.
The given parameters;
coefficient of kinetic friction, μk = 0.1normal force of the puck, Fₙ = 5 NThe frictional force that acts on the puck is determined by taking the product of the normal force and the coefficient of kinetic friction.
The frictional force that acts on the puck is calculated as follows;
[tex]F_k = \mu_k F_n[/tex]
Substitute the given parameters in the above equation and solve the frictional force.
[tex]F_k = 0.1 \times 5\\\\F_k = 0.5 \ N[/tex]
Thus, the frictional force that acts on the puck is 0.5 N.
Learn more here:https://brainly.com/question/14955072
What are some of the landforms rovers have found on Mars that show it was once an active place?
Answer:
The Curiosity rover found that ancient Mars had the right chemistry to support living microbes. Curiosity found sulfur, nitrogen, oxygen, phosphorus and carbon-- key ingredients necessary for life--in the powder sample drilled from the "Sheepbed" mudstone in Yellowknife Bay.
Explanation:
Hope it helped
Answer:
,
Explanation:
Where in the eye are rods and cones located?
cornea
retina
lens
iris
WILL GIVE BRAINLIEST!
Answer:
By the Retina
Explanation:
I like your profile pic
Answer: retina
Explanation: They are located in the retina (a layer at the back of the eye).
Use the chemical reaction to answer the question.
Answer:
60 grams
Explanation:
Rahul sees a flock of birds. He watches as the flying birds land in neat little rows on several power lines. Which change of state does the motion of the birds most closely model?
melting
vaporization
deposition
sublimation
Answer:
C.) Deposition.
Explanation:
I just took the unit test
The change of state that Rahul sees and models the motion (movement) of the birds is called deposition.
What is deposition?In physics, deposition can be defined as a transition phase from a gaseous state to a solid without the need to pass to a liquid state.
The physical phenomena of deposition are relatively common in nature and they include many natural processes.In conclusion, the change of state that Rahul sees and models the motion (movement) of the birds is called deposition.
Learn more about deposition here:
https://brainly.com/question/1128134
#SPJ5
IF YOU PASS SCIENCE TEST HELP ME PLEASE!!!
refer to the data table below. According to the data, what conclusion can be drawn from the data table below?
A. sound doesn't travel through human beings at all
B. sound travels through human beings faster than through cork.
C. sound travels through human beings slower than through a cork
D. sound travels through human being
Answer:
uhmmm wait I'm still doing my module
True or False this is a black hole 75 points + Brainliests
Answer:
true
Explanation:
lol idek tbh
Answer: true?
thx for the points anyway
Explanation:
Which contributions did Johannes Kepler make? Check all that apply.
Which contributions did Johannes Kepler make? Check all that apply.
He revived Aristotle’s model of the solar system.
He solved Ptolemy’s model by proving elliptical orbits.
He proved Galileo’s calculations were incorrect.
He determined that planets move faster when closer to the Sun.
He discovered laws of planetary motion.
Answer:
he solved ptolemy's model of the solar system
he determined that planets move faster when closer to the sun
he discovered laws of planetary motion
Explanation:
•✧•
John Kepler made significant contributions to optics and geometries. Options 2,4 and 5 are the statement that shows the contribution of Johannes Kepler.
What are the contributions of Johannes Kepler?Johannes Kepler was indeed an astronomer and mathematician who finds the planet's elliptical orbits around the sun.
He identifies three basic rules of planetary motion. He also made significant contributions to optics and geometries.
Following are the contributions of Johannes Kepler;
2. He solved Ptolemy’s model by proving elliptical orbits.
4. He determined that planets move faster when closer to the Sun.
5. He discovered the laws of planetary motion.
Hence options 2,4 and 5 are the statement that shows the contribution of Johannes Kepler.
To learn more about the Johannes Kepler refer to the link;
https://brainly.com/question/247659
Use the chemical reaction to answer the question.
Answer:
I believe this answer is -They maintain their properties-
Explanation:
Let's see what others say. :)
A lever has an input arm 50 centimeters long and an output arm 40 centimeters long. What is the mechanical advantage of the lever? (MA=Input distance / Output distance) a 2.0 b 1.25 c 1 d 0.8
Answer:
45
Explanation:
well 45
Mechanical advantage will be option b)1.25
What is Mechanical advantage ?
Mechanical advantage equal to the ratio of length of the input arm and output arm
Given
Input arm = 50 cm
output arm = 40 cm
Mechanical advantage = Input distance / Output distance
= 50 / 40
= 1.25
Mechanical advantage will be option b)1.25
learn more about Mechanical advantage :
https://brainly.com/question/16617083?referrer=searchResults
#SPJ2
A group of students is investigating whether the smoothness of a surface affects the force of friction. Each student pushes a book on two different surfaces. One surface is ice and the other is concrete. The distance traveled by the book on each surface is shown.
Experimental Observations
Student 1 Student 2 Student 3 Student 4
Distance traveled by book on ice 23 cm 21 cm 24 cm 22 cm
Distance traveled by book on concrete 15 cm 18 cm 16 cm 17 cm
Based on the table, which conclusion is correct about the average distance traveled?
A. It is less on concrete.
B.It is greater on concrete.
C.It is less when the book is pushed harder.
D. It is independent of the type of surface.
Answer:
The answer is D
Explanation:
I took the quiz:)