[tex]\text{The unit of work is same as energy. Newton-meters(Nm) or Joules(J).}\\[/tex]
on which principle does a thermometer is based
Answer:
thermal expansion
hope it helps
A moving car hits the breaks and starts to slow down. The car was moving 35 m/s when hitting the breaks and slows at a rate of 7 m/s/s. What is the final velocity of the car after 4 seconds?
7 miles per second.
It would take 5 seconds to stop because 35 divided by 7 = 5.
It would slow 28 miles in 4 seconds because 7 x 4 = 28.
35 - 28 = 7.
What evidence is there that work is being done?
a) A lever is being used.
b) A simple machine makes a task easier.
c) The rock has a larger force than the boy.
d) The boy uses force to move the rock a distance.
Answer:
The boy uses force to move the rock a distance.
the graph is tied to the reading
here is the reading for the question
students in a physics class observing the race note that each runner maintains the same acceleration from the start ofthe 8.0 second interval until they each reach the finish line where each of the runners slows to a stop. Two students inthe class make the following claims about the runners’ accelerations from the start of the 8.0 second interval until bothrunners are at rest.
Student 1:“Runner A has a positive acceleration until reaching the finish line and then a negative acceleration aftercrossing the finish line in order to “undo” all of the positive velocity she gained. Since Runner B neverhad any positive acceleration, she doesn’t need any negative acceleration to slow to a stop; heracceleration will be zero the whole time.”
Student 2:“But negative values mean away south in this case – how could runner A be turning around? I think bothrunners must have positive accelerations the whole time since they are always moving north.”
For part (c), do not simple repeat the students’ arguments in your answers.
here are the questions:
i.Which aspects of student 1’s reasoning, if any, are correct? Explain your answer.
ii.Which aspects of student 1’s reasoning, if any, are incorrect? Explain your answer.
iii.Which aspects of student 2’s reasoning, if any, are correct? Explain your answer.
iv.Which aspects of student 2’s reasoning, if any, are incorrect? Explain your answer
THANK YOU THANK YOU THANK YOU
What determines the amount of gravitational force between
objects?
Answer:
The force of gravity depends directly upon the masses of the two objects, and inversely on the square of the distance between them. This means that the force of gravity increases with mass, but decreases with increasing distance between objects.
Please Mark as Brainliest
Texting: what are two needs or wants that this wave technology meets it:
Answer:
bugs/viruses all the time and more social platforms
Explanation:
In which scenario is work being done on an object?
a) A force is applied to an object to hold it at rest on an inclined plane.
b) Sitting on a box.
c) An upward force is applied to an object to move it upward at a constant speed.
d) An upward force is applied to an object to suspend it motionless in mid-air.
Answer:c
Explanation:
To solve this, we must know each and every concept related to work. Therefore, the correct option is option C that is "an upward force is applied to an object to move it upward at a constant speed."
What is work?Work in physics is the energy delivered to or out of an item by applying force across a displacement. It is frequently expressed in its most basic form as the combination of displacement and force.
When a force is applied, it is said to produce positive work if it has a portion in the directions of the movement of the site of application. Work is done on a body is equivalent to an increase in the body's energy, because work transmits energy to the body. If, on the other hand, the force acting is in the opposite direction as the item's motion, the work is regarded negative, suggesting that energy is withdrawn from the object.
Therefore, the correct option is option C that is "an upward force is applied to an object to move it upward at a constant speed."
To know more about work, here:
https://brainly.com/question/28727910
#SPJ2
A 1500 kg car travels 50 m north in 20 seconds. What is the magnitude of the average velocity of the car during the 20 second interval?
a. 2.5 m/s
b. 5.0 m/s
c. 6.5 m/s
d. 7.0 m/s
Answer:
a. 2.5 m/s
Explanation:
50 / 20 = 2.5 m/s
A battery is connected in series with an ammeter and a variable resistor R.
When R= 6.0 ohms, the current in the ammeter is 1.0 A. When R= 3.0 ohms, the current is 1.5 A.
Calculate the internal resistance of the battery.
A. 6.0 ohms
B. 1.5 ohms
C. 4.5 ohms
D. 3.0 ohms
what is 7 kg on the moon in newtons?
Answer:
11.37N
Explanation:
We can use the GUESS method to derive our solution.
Given:
We know our mass, and our acceleration. The acceleration on the moon is 1.625m/s^2.
[tex]m = 7kg \\ a = 1.625 \frac{m}{ {s}^{2} } [/tex]
Unknown:
We don't know, and are trying to find the force in Newtons.
[tex]F[/tex]
Equation:
We can use Newton's second law to find the solution.
[tex]F = ma[/tex]
Substitute:
Let's substitute our values into our equation.
[tex]F = 7 \times 1.625[/tex]
Solve:
We find our solution after solving for F.
[tex]7 \times 1.625 = F \\ 11.37 = F[/tex]
Our solution is 11.37N
Need
Help answering the questions
HELP ASAP WHOEVER ANSWERS FIRST WITH BE BRAINIEST PLEASE HELP!
The answer is : A₃ = A₁ - A₂ = 3.0 - 2.0 = 1.0A
Ok done. Thank to me :>
Jonathan is pushing a 25 kg box with a force of 135 N. The friction opposing the motion is unknown. The overall net force for the box is 70 N. Using this information calculate the magnitude of the frictional force of the box.
The magnitude of the frictional force of the box is 65 N
From the question given above, the following data were obtained:
Mass (m) = 25 KgForce applied (Fₐ) = 135 NNet force (Fₙ) = 70 NFrictional force (Fբ) =?The frictional force acting on the box can be obtained as follow:
Fₙ = Fₐ – Fբ
70 = 135 – Fբ
Collect like terms
70 – 135 = – Fբ
–65 = –Fբ
Multiply through by –1
Fբ = 65 NThus, the frictional force of the box is 65 N
Learn more on Frictional force: https://brainly.com/question/25767576
Explain the function and the difference between figure 1 and 2
Answer:
figure one (step up transformer) helps in increasing the output voltage
figure two (step down transformer) helps in decreasing the output voltage
Which shows the stars in the correct order, from smallest in size to largest?
white dwarf, Sun, red supergiant
Sun, red supergiant, white dwarf
white dwarf, red supergiant, Sun
Sun, white dwarf, red supergiant
Answer:
its A
Explanation:
White dwarf, Sun, red supergiant shows the stars in the correct order, from smallest in size to largest.
What is the size stars?More than 1.4 million kilometers span our Sun. However, not every star is the same size. They range in size from that of a metropolis to that of our solar system's half!
The mass of neutron stars is concentrated into a very compact area. Even though they are frequently only 20 to 40 km in diameter, they may hold the mass of one or two Suns. White dwarf stars are a little larger and frequently resemble the size of the Earth.
Compared to our Sun, the greatest supergiant stars can be more than 1500 times bigger. They are now more than 2,000 million kilometres across. Supergiants don't, however, have thousands of times the mass of the Sun. The reason for this is that as supergiants become older, their interiors become considerably more dispersed. Betelgeuse, a red giant in Orion's constellation, is nearly 1000 times broader than the Sun yet only has around 15 times as much mass.
Learn more about star here:
https://brainly.com/question/7379319
#SPJ2
Joey is performing an experiment in science class. He mixes two liquids in a test tube, and gas bubbles
appear at the surface of the test tube. Which of the following describes what is most likely taking place?
a.) A physical change is causing a change the phase from liquid to gas.
b. A chemical change has caused the liquids to undergo combustion and gas is escaping.
c. A physical change is causing the isolation to exhibit different properties than the original
substances.
d. A chemical change has resulted in the production of a new substance, which is being given off
as gas.
Answer:
The answer is D
Explanation:
Gas is made when chemical change happens. The chemical change has made a new substance gas. It cannot be combustion unless it is hot or was on fire.
A chemical change has resulted in the production of a new substance, which is being given off.
The correct option is D.
What is called chemical change?A chemical change is any process that converts one material into another, produces new compounds with unique features, or combines any of these processes. When two compounds combine to generate a new material, it takes place (synthesis or either decomposes to form more substances).
What takes place when chemicals change?Breaking covalent bond between reactant molecules (particles) and creating new bond between atoms in product particles are two aspects of chemical reactions (molecules). While there are the same number of atoms both before and after the biochemical transition, there will be a change in the number of molecules.
To know more about Chemical change visit:
https://brainly.com/question/2591189
#SPJ2
The function of the liver in the metabolism of amino acids is to
Answer:
Produce energy, or make carbohydrates or fats.
Explanation:
What is the control group
A control group in a scientific experiment is a group separated from the rest of the experiment, where the independent variable being tested cannot influence the results. This isolates the independent variable 's effects on the experiment and can help rule out alternative explanations of the experimental results.
Answer:
members of a control group receive a standard treatment, a placebo, or no treatment at all.
Explanation:
What is kinematics . Give two examples
Answer:
kinematics explains the terms like acceleration, velocity, and position of the objects while in motion.
Some important parameters in kinematics are displacement, velocity, and time.
Explanation:
your welcome,can you give me the brainliest? plssss
thank me if it was correct for you too.
Answer:
Definition of Kinematics :- Kinematics is the study of the motion of mechanical points, bodies and systems without consideration of their associated physical properties and the forces acting on them. ... An example model of bodies in a system is the gears in a vehicle's transmission.Example of kinematics :- The examples for kinematics are given below: -i) Moving train and bus. ii) Motion of a mass on inclined plane. iii) Running water in the river. iv) Falling water from a mountain peak.Explanation:
Hope this helps you dear ✌️Carry on learning !!How many protons are in C-14?
Answer:
56 proton sir
have a nice day
An object is struck by a 5N force for 8 seconds causing the object to experience a change in it's motion. What is the impulse acting on the object?
Hi there!
Recall the equation for impulse:
[tex]I = \Delta p = F * t[/tex]
Where:
I = Impulse (Ns)
F = Force (N)
t = Time (s)
Plug in the given values:
I = 5 · 8 = 40 Ns
Determine the kinetic energy of a 625-kg roller coaster car that is moving with a speed of 10 m/s.
Hi there!
Kinetic energy can be calculated using the following:
[tex]\large\boxed{KE = \frac{1}{2}mv^2}}[/tex]
Where:
KE = Kinetic energy (J)
m = mass (kg)
v = velocity (m/s)
Plug in the given values:
[tex]KE = \frac{1}{2}(625)(10^2) = \boxed{31250J}[/tex]
Got a question ~ can someone help me out ?
I want Explanation ~ [ cuz there's something I'm not clear about in this question ]
Thanks for Answering ~
Answer:
Hey Tyere!
Refer to the attachments....
I hope it is helpful to you...Cheers!____________When a projectile is launched horizontally, what is true of its acceleration as it travels through the air?
What is the average speed of the car ??
Answer:
90 km / hr
Explanation:
V = S / t = 60 * 3.6 km / 2.4 hr = 90 km / hr
Hope that helps <3
Which two changes would decrease the electric force between two charged
particles?
- A. Decrease the charge of one of the particles.
B. Increase the charge of both particles.
C. Increase the charge of one of the particles.
D. Decrease the distance between the particles.
E. Increase the distance between the particles.
PLEASE HELP I KEEP FAILING!!!!
Answer:
it is b and e
Explanation:
if u look at the words twice you will notice that b and e are both saying the same meanings just in diff rent words way u need to look close on things like that and u will get passing gradesTrue or false? Gas pressure is caused by molecules in a gas colliding with the walls of their container.
Answer:True
The number of molecules hitting the unit surface per unit time increasethe gas pressure increases.
A 1.5 kg ball has a velocity of 12 m/s just before it strikes the floor. Find the impulse on the ball if the ball bounces up with a velocity of 10 m/s.
Hi there!
Recall:
Impulse = Change in momentum
I = Δp = mΔv = m(vf - vi)
Let the direction TOWARDS the floor be POSITIVE, and AWAY be NEGATIVE.
Plug in the givan values:
Δp = 1.5(-10 - 12) = -33 Ns
**OR, the magnitude: |-33| = 33 Ns
Why are movie scenes in outer space often unrealistic?
Answer:
see explanation
Explanation:
by my calculations, i believe it may be because they have to pretend to be in space.
one of them is Space & Interstellar Travel
Which of the following elements is more reactive than the others
Answer:
Sulfur
Selenium
Nitrogen
Oxygen
Explanation:
Sulfur is the most reactive out of the four and Oxygen is the least reactive out of the four.