Answer:
0°C
Explanation:
The melting point of water - the temperature at which solid water begins to melt - is 0°C at a pressure of 1 atm. In the heating curve of water, below 0°C we have solid water. Then, at 0°C the solid water starts to melt by forming liquid water. Above 0°C, when the total amount of water is in the liquid state, the liquid water begins to heat (it increases its temperature).
Answer:
the answer is 0 degrees C.
Explanation:
does anyone have the answer key to half life gizmos !!!!!!!!!!!
How has the way humans communicate changed over time?
Name the four different types of Spheres belonging to Earth and give examples of Renewable resource and the Biotic factors that exist in those spheres. There are three Abiotic (Non Living) spheres and the Biotic (Living)Biosphere exist within the three of the others
Write a short summary of the renewable resources in each sphere and explain how the biosphere interacts within the three of them
Answer:
Everything in Earth's system can be placed into one of four major subsystems: land, water, living things, or air. These four subsystems are called "spheres." Specifically, they are the "lithosphere" (land), "hydrosphere" (water), "biosphere" (living things), and "atmosphere" (air).
Explanation:
Explain the following terms Sublimation
Answer:
Sublimation is the transition of a substance directly from the solid to the gas state, without passing through the liquid state. ... The reverse process of sublimation is deposition or desublimation, in which a substance passes directly from a gas to a solid phase.
Please answer question #4
Answer:
F=500×3 = 1500 N
W = 1500×10 =15000 Nm
Which of the following options shows metallic bonding:
1.silver spoon
2.
bronze medal
3.
solid table salt
Answer:
bronze medal i guess
i hope its correct.
Explanation:
Answer:
silver spoon
Explanation:
i had this for castle learning and guessed this and it was right
How many molecules are in 2.0 moles of oxygen gas
Answer:
6.02 X 1023 molecules
Explanation:
A rectangular block of copper metal has a mass of 1896 grams. The volume of the block is 2cm^3. From this data, what is the density of the copper?(Please show how you got this answer)
What does it mean when there is a coefficient placed before a molecule?
Provide two examples to explain your understanding.
Answer:
Coefficients are used in all chemical equations to show the relative amounts of each substance present. This amount can represent either the relative number of molecules, or the relative number of moles (described below). If no coefficient is shown, a one (1) is assumed.
Explanation:
is the biosphere contains only non-living thing true or false
Answer:
False
Explanation:
It’s both living and non living
Answer:
False
Explanation:
In biospheres, there are both living and nonliving objects present! There are typically large abundances of living objects, such as animals, trees, grass, etc. There are also nonliving objects included in biospheres that are necessary for the prosperity of the living creatures! Examples of these nonliving objects include water for hydration, air for breathing, soil for growth, etc. A biosphere is where all living things are found on Earth, so the question is false since both types of things are found within them and not just nonliving things!
How does thermal energy affect chemical changes
Answer:
It makes chemicals hot or cold which makes chemicals react differently
Explanation:
mark me brainliest
5.Calculate the number of moles of 18.0 dm3 of carbon monoxide (CO) at rtp.
Answer:
0.81mole
Explanation:
Given:
Volume of carbon monoxide = 18dm³
Unknown
Number of moles of carbon monoxide = ?
Solution:
To solve this problem;
1 mole of any gas at rtp occupies a volume of 22.4dm³
So;
x mole of carbon monoxide will occupy a volume of 18dm³ at rtp
22.4x = 18
x = [tex]\frac{18}{22.4}[/tex] = 0.81mole
If the heat of combustion for a specific compound is −1160.0 kJ/mol and its molar mass is 86.47 g/mol, how many grams of this compound must you burn to release 541.20 kJ of heat?
Answer:
40.34 g
Explanation:
First, we divide the heat to release by the heat of combustion to obtain the required moles of compound:
541.20 kJ/(1160.00 kJ/mol) = 0.4665 mol
So, we have to burn approximately 0.47 mol of the compound. We convert the moles to mass in grams by using the molar mass:
mass = molar mass x moles = 86.47 g/mol x 0.4665 mol = 40.34 g
Therefore, you must burn 40.34 grams of the compound to release 541.20 kJ of heat.
A chemistry student is recording the electric charges of some atoms. Use the results in the chart to answer the following questions.
Atom Electric Charge
Carbon −4
Nitrogen +5
Oxygen −2
Part A:
Write an equation to find the difference in electric charge between the Nitrogen atom and the Oxygen atom.
Part B:
Using the equation you wrote in Part A, what is the difference in electric charge between the two atoms?
According to cell theory, where do plant cells come from?
A) organelles
B) other plant cells
C) protein synthesis
D) chemical reactions
Please help!
What function does this cytoplasm perform in a plant and animal cells
Answer:
It helps shape, while holding and keeping organelles in their place.
Explanation:
Answer:
it holds the cell organelles
Explanation:
You are welcome
How does science affect our lives on the example of the pandemic?
Science affected our lives at the beginning of this pandemic.
Explanation:
Although scientists did study the virus to see how deadly it is the pandemic kept spreading. The spreading of the virus was not the scientist's fault it was the citizens' fault. They now found a vaccine that took hard work and a short amount of time.
When Nitrogen gas gets cold enough it can form a liquid. This liquid nitrogen is an
example of what?
A. A chemical change because it took a significant temperature drop to convert
nitrogen from gas to liquid.
B. A chemical change because the nitrogen underwent a conversion from gas to a
liquids.
C. A physical change because it was only a state change from solid to liquid.
D. A physical change because the temperature drop causes the molecules to completely rearrange.
Answer:
C.
Explanation:
Phase change is physical.
When Nitrogen gas forms a liquid is a physical change because it was only a state change from solid to liquid. Therefore, option C is correct.
What is a physical change?A physical change takes place when some of the features of the matter change but the identity of the material does not. Physical changes can be categorized as reversible and irreversible. For example, the melting of water is reversible since the melted ice can be refrozen.
Physical change can be described as a kind of change where only physical properties of matter such as solubility, color, odor, etc. can change. During physical changes in matter, there will be no chemical bonds are broken or formed between atoms in the molecule.
The chemical composition as well as the chemical nature of the material will remain unchanged while a physical change. The molecules can rearrange without changing the internal chemical composition of matter.
Therefore, changing the state of nitrogen gas is a physical change.
Learn more about physical change, here:
brainly.com/question/17931044
#SPJ2
If one parent has sickle cell anemia and the other parent is a carrier, what is the possibility that their child will have sickle cell anemia
If an effusion experiment, it required 45 seconds for
a certain number of moles of an anknown gas to pass through
a small orifice into a vacuum. Under the same conditions, It required 18 seconds for the same number of moles of oxygen to effuse. Find the molecular mass of the unknown gas.
Answer: A vacuum. Under the same conditions 16 s were required for the same number of moles of O2 to effuse. ... The molar mass of the unknown gas is 200 g/mol. calculation ... QUESTION 1 If gas-burning appliances are vented into an unlined masonry chimney, deteriorate and crumble and may · PLS HELP
Explanation:
How many molecules OF2 would have a mass of .132 g
1.47 × 10²¹ molecules OF₂
General Formulas and Concepts:Math
Pre-Algebra
Order of Operations: BPEMDAS
Brackets Parenthesis Exponents Multiplication Division Addition Subtraction Left to RightChemistry
Atomic Structure
Reading a Periodic TableAvogadro's Number - 6.022 × 10²³ atoms, molecules, formula units, etc.Stoichiometry
Using Dimensional Analysis Explanation:Step 1: Define
0.132 g OF₂
Step 2: Identify Conversions
Avogadro's Number
Molar Mass of O - 16.00 g/mol
Molar Mass of F - 19.00 g/mol
Molar Mass of OF₂ - 16.00 + 2(19.00) = 54.00 g/mol
Step 3: Convert
Set up: [tex]\displaystyle 0.132 \ g \ OF_2(\frac{1 \ mol \ OF_2}{54.00 \ g \ OF_2})(\frac{6.022 \cdot 10^{23} \ molecules \ OF_2}{1 \ mol \ OF_2})[/tex]Divide/Multiply: [tex]\displaystyle 1.47204 \cdot 10^{21} \ molecules \ OF_2[/tex]Step 4: Check
Follow sig fig rules and round. We are given 3 sig figs.
1.47204 × 10²¹ molecules OF₂ ≈ 1.47 × 10²¹ molecules OF₂
Which structures group together to form a system in the human body
Answer:
organs group together to form organ systems
Explanation:
What is the mass number of chlorine?
Answer:
Explanation:
35.453 u
What is the general form of a single replacement reaction
Answer: A. AB+C->CB+A
Explanation:
The chemical reaction includes the reactant and products. The single replacement reaction can be given as AB + C → CB + A. Thus option a is correct.
What is a single replacement reaction?A single replacement reaction is the exchange reaction that involves the substitution of a single element of the reactant with another element of the reactant species.
The reaction between zinc and copper chloride is a single replacement reaction as copper is replaced by zinc in the copper chloride compound to produce zinc chloride and copper.
Therefore, option A. AB + C → CB + A is the single replacement reaction.
Learn more about single replacement reaction here:
https://brainly.com/question/13903783
#SPJ2
how can an xray image show differences between bone and soft tissues, such as muscles and lungs? How might the atoms that make up bones be different from the atoms that make up soft tissues?
Answer with Explanation:
1. An "x-ray image" shows the difference between the bones and soft tissues because the bones appear white in color while the soft tissues appear gray in color.
2. The reason behind the difference in the appearance of bones and soft tissues on the x-ray film is their density. Bones are denser than soft tissues, which means that its atoms are closely-knitted when compared to the soft tissues that are far apart from each other. This allows the x-ray radiation to be absorbed by the bone while it passes through most of the soft tissues.
This is the reason why pregnant women are advised not to undergo an x-ray examination because the fetus is denser and it will surely absorb the x-ray radiation.
An X ray is a X wave radiation that can penetrate from a high EMR and has wavelengths that are shorter than the UV rays. The concept of X rays where discovered in 1895.
The X ray image shows the difference between bones and the soft tissues. As the bones appear to be white in color and soft tissues appear grey in color. As lungs also consists of bones they can vividly shown. Due to the bones being made of calcium they are different form the atoms that makes the soft tissues.Learn more about the x-ray image show differences between bone and soft.
brainly.in/question/32495134
Many disciplines are involved in environmental science, including chemistry and biology which ___ and economics and political science which __. Multiple choice question.
Answer:
Contribute evidence; help us understand how people use resources.
Explanation:
Environmental science can be defined as an interdisciplinary field of science that comprises of chemistry, economics, engineering, zoology, geography, geology, biology, ecology, physics, etc., used for the study and understanding of various environmental factors, issues in relation to human life.
Many disciplines are involved in environmental science, including chemistry and biology which contribute evidence and economics and political science which help us understand how people use resources in the production of goods and services to meet the need or requirements of consumer. These resources include land, labor, entrepreneurship and capital.
Which of the following is an example of potential energy?*
A firework exploding.
O A race car gaining speed towards the finish line.
O A phone sitting on the desk.
O Boiling water.
boiling waterAnswer:
Explanation:
its called thermal energy
What increases pressure?
a
more particles and higher temperatures
b
higher volume
c
number of particles
d
higher temperature
Answer:
A
Explanation:
more particles means things are heating up
Ex: Water. More bubbles form once water reaches it boiling point
HELP PLS 50 POINTSSSS
Listed in the Item Bank are some key terms and expressions associated with the categories seen in the Venn Diagram. To find out more
information about items, some have more details available when you click on them. Drag and drop each item onto the proper area of the
diagram. If an item describes more than one category, be sure to place it in the overlapping space.
ITEM BANK: Move to Bottom
Carbon dioxide is a product. Carbon dioxide is a reactant. Carried out in animals.
Carried out in plants
Chemical Reaction
Oxygen is a product
Oxygen is reactant Produces usable energy sourc
Cellular Respiration
Both
Photosynthesis
Answer:
Carbon dioxide is a product (cellular respiration)
Carbon dioxide is a reactant(photosynthesis)
Carried out in animals(cellular respiration)
Carried out in plants(both)
Chemical reaction(cellular respiration)
Oxygen is a product(photosynthesis)
Oxygen is a reactant(cellular respiration)
Produces usable energy source(photosynthesis)
Your welcome!!! Plz mark brainliest.
Answer:attached is the correct answer
Explanation:
Photosynthesis and Respiration
How would you solve this?