One of the most dangerous side effects of an erupting volcano is a
Answer:
One of the most deadly effects of a volcano is the ash coming from the eruption, which carries poisonous gases that are harmful to humans, plants, and animals alike.
Explanation:
:))))))))
What will be the change of velocity of a 50kg object if a force of 2,000N
is applied to it for 0.010 seconds?
Answer:
0.4m/s
Explanation:
[tex]F = ma[/tex] where F= force, m= mass, and a=acceleration
we also know that,
a = Δv / t where Δv = change in velocity and t = time
thus F = m ( Δv / t)
[tex]2000=50(\frac{v}{0.01})[/tex]
[tex]\frac{2000}{5000} = v[/tex]
0.4m/s = Δv
how dose storing waste underground can be effected by ground water in aquifers
Answer:
it can contaminate the water
Explanation:
I hope this helps ;)
Which of the following methods transmits a drug directly into the bloodstream?
Answer:
I think Intravenous transmits a drug directly into the bloodstream.
Hope this help! :)
I REALLY NEED HELP!!
The velocity of a car increases from +4.0 m/s to +16.0 m/s
in a time period of 4.0 s. What was the average
acceleration?
Answer:
Explanation:
Although we do have an equation for this in terms of one-dimensional motion, it's easy enough just to use the mathematical definition of acceleration:
[tex]a=\frac{v_f-v_0}{t}[/tex] which says, in words, the acceleration of an object is equal to the objects final velocity minus its initial velocity, divided by the change in time. Since everything is given in m and s, our answer will be in m/s/s:
[tex]a=\frac{16.0-4.0}{4.0}[/tex] and
[tex]a=\frac{12.0}{4.0}[/tex] so
a = 3.0 m/s/s
Determine whether the interference is constructive or destructive at each location indicated.
A.constructive or destructive
B. constructive or destructive
C. constructive or destructive
D. constructive or destructive
Answer:
A. Constructive
B. Destructive
C. Destructive
D. Constructive
Explanation:
Constructive interference takes place at locations along the path of two superposed waves where the waves are in phase such that a high or low point of one of the waves corresponds with a high or low point of the other wave which gives a resulting wave amplitude which is the sum of the amplitudes of the individual waves
Destructive interference takes place at locations along the path of two superposed waves where one wave is out of phase with the other wave such that a high or low point of one of the waves coincides with a low or high point of the other wave respectively thereby cancelling the effect of the other wave and giving a resulting wave that has an amplitude which is the difference in the amplitudes of the individual waves
Therefore;
At point A, the peak of each wave partially coincides resulting in constructive interference
At point B, the peak of the blue wave and the trough of the red wave partially coincides resulting in destructive interference
At point C, the through of the blue wave and the peak of the back wave partially coincides resulting in destructive interference
At point D, the trough of each wave partially coincides resulting in constructive interference.
The mineral quartz has a chemical formula of SiO2. What is the formal name
for this compound?
Answer:
Silicon Dioxide
Answer:
Silicon dioxide
Explanation:
2. Why is alcohol thermometer not suitable to measure high temperature?
Answer:
Alcohol thermometers are used rather than mercury thermometers in very cold regions because alcohol has a lower freezing point than mercury. Pure ethanol freezes at -115 degrees C, while mercury freezes at -38 degrees C.
Explanation:
It is less durable because alcohol evaporates faster than mercury. It cannot measure high temperature because of a low boiling point. It wets the walls of the thermometer, which can adversely impact the accuracy of readings
imagine no girls awnser this question ://
Answer:
im confused
Explanation:
Your spaceship has run out of fuel and comes to a halt halfway between the earth and the moon. Will you and your spaceship (a combined mass of 5000 kg) fall towards the moon or towards the earth? Show calculations to support your answer.
Answer:
moon
Explanation:
cause yes
A hot-air balloon with a mass of 400 kilograms moves across the sky with 3,200 joules of kinetic energy. The velocity of the balloon is meters/second.
Answer:
4 m/s
Explanation:
KE =
Velocity of balloon will be 4 m/s.
!! Hope It Helps !!
A SOUND WAVE WITH ITS CHARACTERISTIC PATTERN OF COMPRESSIONS AND
RAREFACTIONS IS SHOWN BELOW. A CENTIMETER RULER IS INCLUDED BELOW THE
PATTERN THE WAVELENGTH OF THIS SOUND WAVE IS HOW MANY cm?
A 2 cm
B 3 cm
C 35 cm
D. 85 cm
וייייייייייייייייי
U
0
1
2
3
4
5
6
7
8
9
10
Answer:
The wavelength is 1.7cm
Explanation:
Given
See attachment for wave pattern
Required
What is the wavelength
To do this, we simply calculate the distance between successive waves (see attachment 2 for point A and B)
Using the ruler, points A and B are at:
[tex]A = 0.6cm[/tex]
[tex]B = 2.3cm[/tex]
So, the wavelength is:
[tex]\lambda = B - A[/tex]
[tex]\lambda = 2.3cm - 0.6cm[/tex]
[tex]\lambda = 1.7cm[/tex]
If approximated, the wavelength is:
[tex]\lambda \approx 2cm[/tex]
The Sun creates energy through a series of steps known as:
The Sun creates energy through a series of steps known as nuclear fusion.
What is nuclear fusion?Nuclear fusion is the process by which atomic nuclei combine to form heavier nuclei, releasing a tremendous amount of energy in the process. In the Sun, this process occurs in the core, where the temperature and pressure are high enough to overcome the electrostatic repulsion between positively charged atomic nuclei. Hydrogen atoms are fused together to form helium atoms, releasing energy in the form of light and heat.
The process of nuclear fusion in the Sun can be broken down into several steps.
The first step involves the collision of two hydrogen atoms to form a deuterium atom, releasing a positron and a neutrino in the process. The deuterium atom can then combine with another hydrogen atom to form helium-3, releasing a gamma ray. Finally, two helium-3 atoms can combine to form helium-4, releasing two protons and releasing even more energy in the process.
Therefore, the process of nuclear fusion in the Sun is a complex series of steps that releases a tremendous amount of energy and is responsible for the light and heat that we receive on Earth.
To learn about Kinetic energy click:
brainly.com/question/26472013
#SPJ2
Ten examples of luminous objects
Answer:
Sun, fireflies, glow worms ,Stars ,a lighter torch ,a kerosene Oil Lamp, burning candle, vapor light, a bulb
Answer:
Sun
Flame in an oil lamp
tube light
bulb
fireflies
lighted candle
LEDs
laser
jellyfish
Fire
Explanation:
luminous objects are objects that produce light and are responsible for vision.