Answer:
The correct answer is -
Independent Variable: change of speed
Dependent Variable: time takes to stop
Controlled Variables: stop at a stop sign
Explanation:
To know the effect of the speed to take the time to stop at a stop sign Bobbye perform this exercise where he changes the speed at each time that he is driving to know the time it takes to stop at a stop sign. There is a change that takes place purposely is in the speed of driving so it is an independent variable as the independent variable is a variable that is manipulated in an experiment or investigation.
The time it takes to stop is the factor that depends on the speed so it is the dependent variable as the dependent variable is the variable that depends on the independent variable.
The control variable remains the same or constant in an investigation which is stoping at a stop time irrespective of speed.
If the atomic number increases then the atomic radius should decrease right? So what’s wrong with my data
Answer:
Atomic radius increases by increasing the atomic number.
Explanation:
Atomic radius :
Atomic radius is the distance between nucleus of an atom to its outer most electronic shell.
Trend along group:
As we move down the group atomic radii increased with increase of atomic number. The addition of electron in next level cause the atomic radii to increased. The hold of nucleus on valance shell become weaker because of shielding of electrons thus size of atom increased.
As the size of atom increases the ionization energy from top to bottom also decreases because it becomes easier to remove the electron because of less nuclear attraction and as more electrons are added the outer electrons becomes more shielded and away from nucleus.
The given data show that the atomic number in increased from 4 to 88 it means atomic radius also increased from 1.53Å to 2.83Å. It means the given data is the elements of periodic table present in group. It is the data of 2nd group of periodic table.
PLEASE HELP I'LL MARK BRAINLIEST
Describe, on the molecular level, why my glasses get fogged up when I wear my face mask (so dang annoying). Be sure to use these terms: -decreased kinetic energy -surface -attraction
Answer:
When you are in a cool place and exhale into your mask, the mask blocks and re-directs some of your breath up toward the top edge of the mask and under your glasses. ... When the warm breath hits the cool lens, the water in the breath condenses causing your lenses to fog up.
BRAINLEST WILL BE GIVEN TO A RIGHT ANSWER!!!!
Potassium (K) has a charge of +1, and sulfur has a charge of –2. Which best describes the compound they make?
A) The chemical formula is K2S, and the name is potassium sulfide.
B) The chemical formula is KS2, and the name is potassium sulfide.
C) The chemical formula is K2S, and the name is sulfur potassium.
D) The chemical formula is KS2, and the name is sulfur potassium.
Answer:
A) The chemical formula is K2S, and the name is potassium sulfide. Explanation:
edge
What is the number of protons for the following?
190
+2
Os
76
Answer:
190+2=192
Explanation:
192 add it 192 added
Answer: they are right
Explanation:
Also can someone help me with this one as well, thank you! :)
Answer:
a. The density of the aluminum will change if the sample gets too big.
Explanation:
Since increasing its size increases its volume hence it affects the value of its density by decreasing.
note: Density = mass/volume.
How would an invasive species affect an ecosystem?
Group of answer choices
The invasive species would integrate easily into the ecosystem.
The invasive species would take over in the area and throw off the balance of the ecosystem.
The invasive species would balance the ecosystem.
The invasive species would change the abiotic factors in the area.
Answer:
The invasive species would take over in the area and throw off the balance of the ecosystem.
Explanation:
Invasive species can harm both the natural resources in an ecosystem as well as threaten human use of these resources. An invasive species can be introduced to a new area via the ballast water of oceangoing ships, intentional and accidental releases of aquaculture species, aquarium specimens or bait, and other means.
Invasive species are capable of causing extinctions of native plants and animals, reducing biodiversity, competing with native organisms for limited resources, and altering habitats. This can result in huge economic impacts and fundamental disruptions of coastal and Great Lakes ecosystems.
Hope this helped!
Which type of bond will chromium atoms likely to form with other chromium atoms
A:ionic
B:covalent
C:metallic
Answer: B
Explanation: Covalent bonds where electrons are not shared equally between two atoms are called polar covalent bond. As shown above, the electrons in a covalent bond between two different atoms (H and Cl in this case) are not equally shared by the atoms. This is due to the electronegativity difference between the two atoms.
There are two types of chemical compound one is covalent compound and other is ionic compound in chemistry. The covalent bond will be formed between two chromium atoms. the correct option is option B.
What is chemical Compound?Chemical Compound is a combination of molecule, Molecule forms by combination of element and element forms by combination of atoms in fixed proportion.
Covalent bond formed by sharing of electron and ionic bond formed by complete transfer of electron.
Element with same electronegativity difference combine together by covalent bond whereas ionic bond is formed by elements whose electronegativity difference is high.
As two chromium is combining that is two two element with same electronegativity is combining therefore, formation of covalent bond is the only possibility.
Therefore covalent bond will be formed between two chromium atoms. the correct option is option B.
To learn more about chemical compound, here:
https://brainly.com/question/26487468
#SPJ2
What is the difference between carbon-12, carbon-13, and carbon-14?
Answer:
Number of neutrons in the nucleus.
Explanation:
Mass number is protons plus neutrons. Protons do not change from isotope to isotope
10 divided by 2 im confused
if your serious about this question then it is 5
Select the conditions that are required for the formation of hurricanes. (Choose 3)
A: cold,cyclonic wind
B: deep ocean water
C: cold ocean water
D: warm,humid wind
E: warm ocean water
F: a strong cold front
Answer:
A: cold, cyclonic wind
B: deep ocean water
C: cold ocean water
E: warm ocean water
F: a strong cold front
You only need A, B, C, E, F not D because that for tornadoes buddy.
Which of these properties can be used to separate mixtures? - characteristic properties *
1. state of matter
2. mass
3. volume
4. boiling/melting point
5. density
6. conductivity
7. solubility
Answer:
Boiling/melting point
Explanation:
Some elements can’t handle the heat nor the cold, so they separate like oil & water.
A balloon filled with helium occupies 21.0ft³ at 55.0°F. Find the temperature of the helium if the volume of the balloon decreases to 11.0ft³. (Assume that the pressure is held constant.)
Answer:
Assuming pressure is held constant,the question reduces to a ratio and proportion type of question where;
At constant pressure,
21.0ft³-55.0°F
11.0fy³=11.0ft³/21.0ft³×55°F
The temperature is 28.809°F≈29°F
29°F is the temperature of the helium if the volume of the balloon decreases to 11.0ft³.
What is temperature?Temperature expresses hotness and coldness or a measure of the average kinetic energy of the atoms or molecules in the system.
Assuming pressure is held constant, the question reduces to a ratio and proportion type of question where;
At constant pressure,
21.0ft³- 55.0°F
11.0fy³ = 11.0ft³ ÷ 21.0ft³ × 55°F
The temperature is 28.809°F ≈ 29°F
Hence, 29°F is the temperature of the helium if the volume of the balloon decreases to 11.0ft³.
Learn more about temperature here:
brainly.com/question/28004147
#SPJ2
yo, i need help. 25 points and brainliest. :|
Answer:
here's your answer...
Explanation:
Full moon, also hey lol.
have a germ-free day.
At 303 K, the volume of a gas is 30.0 ml. At constant pressure, what is the new
volume of the gas if the temperature is decreased to 283K?
Answer:
V₂ = 28 mL
Explanation:
Given data:
Initial temperature = 303 K
Initial volume = 30.0 mL
Final temperature = 283 K
Final volume = ?
Solution:
The given problem will be solve through the Charles Law.
According to this law, The volume of given amount of a gas is directly proportional to its temperature at constant number of moles and pressure.
Mathematical expression:
V₁/T₁ = V₂/T₂
V₁ = Initial volume
T₁ = Initial temperature
V₂ = Final volume
T₂ = Final temperature
Now we will put the values in formula.
V₁/T₁ = V₂/T₂
V₂ = V₁T₂/T₁
V₂ = 30.0 mL × 283 K /303 K
V₂ = 8490 mL.K / 303 K
V₂ = 28 mL
What Happens When extra Solute is added to unsaturated ,saturated and supersaturated solution
of water is 36.0 g. If any more NaCl is added past that point, it will not dissolve because the solution is saturated. If more solute is added and it does not dissolve, then the original solution was saturated. If the added solute dissolves, then the original solution was unsaturated.
why carbon is a basic thing to classify as organic and inorganic compounds?
Answer:
To answer, all living organisms contain carbon-based compounds, which classifies them organic.
Simply, carbon dioxide, is an example of an inorganic compound since it does not contain both carbon and hydrogen. Alternatively, one molecule of carbon dioxide contains one atom of carbon and two atoms of oxygen.
A control is....
A: What we measure
B: What we change
C: What we measure that does not have the variable we are testing.
D: What we conclude
What data do scientists use to determine when a volcano might erupt?
Whoever gives me the right answer will get brainliest.
Answer:
seismographs
Explanation:
Scientists use seismographs that record the length and strength of each earthquake to try to determine if an eruption is imminent. Magma and gas can push the volcano's slope upward.
What are the first two levels of cellular organization?
Answer:
Cells and tissue
Explanation:
Cells are the smallest functional units of all living things
Tissue is organic material from which organs and their bodily structures appear
What is the mass 5.00 x 1022 molecules of PbCI2
Answer:
ion know this one
Explanation:
Can someone help me click the picture
Answer:
A product
B coefficient
C script
D rectant
Which of the following is a true difference between protons and neutrons?
a
the have different masses
b
they are in different locations in the atom
c
the proton identifies the atom and the neutrons does not
d
all of the choices are true
Answer:
D
Explanation:
Which describes a covalent bond?
a. Formed by the sharing of electrons between atoms
b. Formed by the giving and taking of electrons between atoms.
c. Formed by the forces of gravity between atoms.
d. Formed by sharing protons and neutrons between atoms
Answer:
a
Explanation:
covalent bonds are bonds between two nonmetals where they share an electron :)
A metal atom and a non-metal atom bond together. What type of bond do they form?
Question 8 options:
Ionic
Round
Covalent
Glue
Answer: Iconic
Explanation:Ionic bonds are formed through the exchange of valence electrons between atoms, typically a metal and a nonmetal.
What separation method collects vapor
Answer:
evaporation and distilation
Explanation:
In 25 words or fewer, what do you think a scientist would want to explain about this soda?
Answer:
This soda is brown, sweet, has high carbonation, and is about 200 calories when consumed.
Explanation:
:)
can you guys help me
Answer:
B) 6 Newtons
Explanation:
Applied Force = 10 N
Resistive Frictional Force = 4 N
As we know that frictional forces always act in the opposite of the relative motion [force], and that opposite forces always subtract.
Hence,
The Net Force acting on the block = 10 N -4 N = 6 Newtons
Answer: The Answer is B
The production of 2-methyl-2-phenyl propane. This would be a two-step synthesis.
Can someone explain what is this reaction ?
Why are liquid and gas molecules different
The force of attraction between one polar molecule and another polar molecule is
Answer:
Dipole-dipole forces
Explanation:
A polar compound is that compound which contains atoms that have a difference in charges i.e electrostatic attraction occurs between its constituent atoms. Polar molecules are attracted to other polar molecules with opposite charges and her held together with the aid of certain forces
The attractive force between the negative part of a polar molecule (-) and the positive part of another polar molecule (+) is called DIPOLE-DIPOLE FORCES. This dipole-dipole force gets stronger with an increasing polarity of the molecules involved.