Balance this chemical equation

Ca(OH)2 + HCl ---> CaCl2 + H2O​

Answer:

0.10 % w/w

Explanation:

The percent by mass (%w/w) is defined as one hundred times the ratio between the mass of solute (In this case aspirin, 0.05g) and the mass of solution (Mass solute + mass of water = 0.05g + 50g = 50.05g). The percent by mass is:

0.05g Aspirin / 50.05g * 100 =

0.10 % w/w

Answer:

crust

Discuss with the whole class what the relative thicknesses of the layers are — that the inner core and outer core together form the thickest layer of the Earth and that the crust is by far the thinnest layer.

Explanation:

Discuss with the whole class what the relative thicknesses of the layers are — that the inner core and outer core together form the thickest layer of the Earth and that the crust is by far the thinnest layer.

Answer:

The muscoloskeletal system

Explanation:

The musculoskeletal system is made up of the body's bones (the skeleton), muscles, cartilage, tendons, ligaments, joints, and other connective tissue that supports and binds tissues and organs together. Its primary functions include supporting the body, allowing motion, and protecting vital organs.

Answer: potassium and rubidium

Explanation:

1) The group 1 of the periodic table contain six elements namely Lithium(Li), Sodium(Na),Potassium(K),Rubidium(Rb),Cesium(Cs) and Francium(Fr). These metals are called alkali metals because they form alkalies( i.e. strong bases capable of neutralizing acids) when they react with water.

2) The heavier alkali metals (K, Rb, and Cs) react so vigorously that they invariably explode.

3) This trend, which is not consistent with the relative magnitudes of the reduction potentials of the elements, serves as another example of the complex interplay of different forces and phenomena—in this case, kinetics and thermodynamics.

Answer:

Activator effects a mixture if you put to much of the activator your using into a product or thing you are using.

Explanation:

For ex.

If you poor to much activator into slime it will make the slime hard and very wet it will ruin your slime completely so you will have to do it just right but start off pouring it slowly and mix and then more if it needs more.

Answer:

Meristematic Tissues. Tissues where cells are constantly dividing are called meristems or meristematic tissues. These regions produce new cells.

Explanation:

thank me later

Answer:

Explanation:

THE BEST ANSWER IS CCC

Answer:

In a chemical reaction, reactants that are not used up when the reaction is finished are called excess reagents. The reagent that is completely used up or reacted is called the limiting reagent, because its quantity limits the amount of products formed.

Explanation:

Answer:

Increased the concentration

Explanation:

Complete Question

Open the simulation by pushing the play button.  Begin by dragging the concentration tester overto the liquid and add drink mix until the concentration reaches approximately 2.oo mol/L.  This means there are 2.00 moles of the drink mix in 1 Liter of the solution. Add more drink mix until you notice a color change. Have you increased or decreased the concentration? (Higher number means a higher concentration).

Solution

Drink mix is basically the solute which is added to solvent i.e water.

The higher is the amount of drink mix in the solvent, the higher is the concentration of the solute and hence darker is the color of the drink.

Hence, in the case the concentration of the drink has been increased.

Answer:

8.73 × 10²⁴ formula units

Explanation:

To calculate the number of formula units a substance contain, we multiply the number of moles by Avagadro number (6.02 × 10²³)

number of formula units = 14.50 moles × 6.02 × 10²³

= 87.29 × 10²³

= 8.73 × 10²⁴ formula units.

Answer:

4Cr + __302 -->_2Cr203.....

Answer:

71.92 kPa

Explanation:

Using the combined gas law equation;

P1V1/T1 = P2V2/T2

Where;

P1 = initial pressure (kPa)

P2 = final pressure (kPa)

V1 = initial volume (L)

V2 = final volume (L)

T1 = initial temperature (K)

T2 = final temperature (K)

According to the information provided in this question;

T1 = 50°C = 50 + 273 = 323K

V1 = 105L

T2 = -25°C = -25 + 273 = 248K

P2 = 105.4 kPa

P1 = ?

V2 = 55.0 L

Using P1V1/T1 = P2V2/T2

P1 × 105/323 = 105.4 × 55/248

105P1/323 = 5797/248

0.325P1 = 23.375

P1 = 23.375 ÷ 0.325

P1 = 71.92 kPa

Answer:

Yes

Explanation:

Due to pollution, greenhouse gasses, etc

Humans are increasingly influencing the climate and the earth's temperature by burning fossil fuels, cutting down forests and farming livestock. This adds enormous amounts of greenhouse gases to those naturally occurring in the atmosphere, increasing the greenhouse effect and global warming.

Answer:

0.97

Explanation:

Let R₁ represent the rate of diffusion of NO.

Let R₂ represent the rate of diffusion of CO.

Molar mass of NO (M₁) = 14 + 16 = 30 g/mol

Molar mass of CO (M₂) = 12 + 16 = 28 g/mol

Thus, the rate of NO to CO can be obtained as follow:

R₁ /R₂ = √(M₂/M₁)

R₁ /R₂ = √(28/30)

R₁ /R₂ = √(28/30)

R₁ /R₂ = 0.97

R₁ : R₂ = 0.97

NO : CO = 0.97

Therefore, the rate of diffusion of NO to CO is 0.97

Answer:

najah zggs haihß hajoa ha8 a an àjàhajß

Answer:

[tex]\boxed {\boxed {\sf 2. \ 157 \ kPa}}[/tex]

Explanation:

Since temperature remains constant, the only variables that change are volume and pressure. Therefore, we are using Boyle's Law. This states that the pressure is inversely proportional to the volume. The formula is:

[tex]P_1V_1=P_2V_2[/tex]

We know the gas starts with a volume of 20.0 liters at a pressure of 275 kPa. We can substitute these values into the left side of the formula.

[tex]275 \ kPa *20.0 \ L=P_2V_2[/tex]

We know the gas expands to a volume of 35.0 Liters, but we do not know the pressure.

[tex]275 \ kPa *20.0 \ L=P_2* 35.0 \ L[/tex]

Since we are solving for the new pressure, we must isolate the variable P₂. It is being multiplied by 35.0 Liters and the inverse of multiplication is division. Divide both sides by 35.0 L.

[tex]\frac {275 \ kPa * 20.0 \ L}{ 35.0 \ L}= \frac{P_2*35.0 \ L}{35.0 \ L}[/tex]

[tex]\frac {275 \ kPa * 20.0 \ L}{ 35.0 \ L}=P_2[/tex]

The units of liters cancel.

[tex]\frac {275 \ kPa * 20.0 }{ 35.0 }=P_2[/tex]

[tex]\frac {5500}{35.0} \ kPa= P_2[/tex]

[tex]157.142857 \ kPa=P_2[/tex]

The original measurements of pressure and volume have 3 significant figures, so our answer must have the same. For the number we calculated, that is the ones place.

The 1 in the tenths place (157.142857) tells us to leave the 7 in the ones place.

[tex]157 \ kPa= P_2[/tex]

If the gas expanded to a volume of 35.0 liters while the temperature remained constant, the pressure in container was approximately 157 kilopascals.

Answer:

[tex]\boxed {\boxed {\sf 19 \ M}}[/tex]

Explanation:

Molarity is a measure of concentration in moles per liter, so the formula is:

[tex]molarity= \frac{moles \ of \ solute}{liters \ of \ solution}}[/tex]

This solution has 9.0 moles of solute and 462 milliliters of solution. We must convert milliliters to liters. Remember that 1 liter contains 1000 milliliters.

Create a ratio.

Multiply by the value we are converting: 462 milliliters

[tex]0.462 \ L[/tex]

Now we know both values and we can solve for the molarity.

[tex]molarity= \frac{9.0 \ mol}{ 0.462 \ L}[/tex]

Divide.

[tex]molarity= 19.4805195 \ mol/L[/tex]

The original measurements of moles and milliliters have 2 and 3 significant figures respectively. We have to round our answer to the least number of sig figs, which is 2 in this case.

For the number we found, that is the ones place. The 4 in the tenths place (19.4805195) tells us to leave the 9 in the ones place.

[tex]molarity= 19 \ mol/L[/tex]

1 mole per liter is equal to 1 molar or M, so our answer is equal to 19 M.

[tex]molarity \approx 19 \ M[/tex]

The molarity of the solution is approximately 19 M.

Answer:

Cr is oxidised

and

Zn is reduced

[ Reduced reactant ] :

Cr^( + 3 ) + 3 e^( - 1 ) ===》 Cr^( 0 )

_____________________________

[ Oxidicided reactant ] :

Zn^(0) ===》Zn^( + 2 ) + 2 e^( - 1 )

Explanation:

Hope it's helpful for Yuh bro!!

Answer:

Friendship is, in many respects, a "comfortable" love relationship. Friendships involve as little or as much intimacy as the partners are inclined to express at any given time. Friends are not normally obligated to exchange benefits, but do so in ways that are often so natural as to be unwitting. The ties that bind them are by unfettered mutual consent. In spite of its being so comfortable, in fact because of it, friendship contributes in unique ways .

Answer: No it does not

Explanation:

The law of conservation of mass states that mass is neither created nor destroyed and in this equation you start with 1 molecule of Cl and 1 of H, but on the reactants side you end up with 2 of each. To make it follow the law of conservation of mass you would have to balance the equation

Answer:reflection

Explanation:

Answer:

Br

Explanation:

Answer:

If a one kilogram block of lead absorbs 2,000 J of energy then the temperature rise will be larger. If 1,000 J of heat is absorbed by a 2 kg block of lead then the temperature of the block doesn't rise as much since the energy is shared between more particles.

Explanation:

Answer:

d

Explanation:

from you know the atomic number it should be easy to find

To determine the molar mass of an element, one must know the element's atomic number​. Therefore, option D is correct.

An element's atomic number (Z) is the number of protons in the nucleus of each atom of that element. This means that the number of protons is the feature that distinguishes each element from all others. Elements differ based on their atomic number.

Because the combined masses of protons and neutrons account for nearly all the mass of a given atom, the atomic mass of a single atom can be calculated by adding the total number of protons and neutrons of that particular isotope.

The atomic mass of any element on the periodic table can be used to calculate its molar mass.

Thus, option D is correct.

To learn more about an atomic number, follow the link;

https://brainly.com/question/16858932

#SPJ6

Answer:

1.5 moles of KMnO4 will be produced from 1.5 moles of MnO2

Explanation:

The balanced equation of this chemical reaction is

2 MnO2 + 4 KOH + O2 → 2 KMnO4 + 2 KOH + H2

2 moles of MnO2 produces 2 moles of   KMnO4

That means 1 moles of KMnO4 will be produced from 1 moles of MnO2

Hence, 1.5 moles of KMnO4 will be produced from 1.5 moles of MnO2

The moles of manganese oxide were used in the reaction is 1.5 moles.

Stoichiometry of any reaction tells about the relative amount of species present before and after the chemical reaction.

Given chemical reaction is:

2MnO₂ + 4KOH + O₂ → 2KMnO₄ + 2KOH + H₂

From the stoichiometry of the reaction, it is clear that same moles of manganese oxide and potassium permanganate is involved in the reaction.

2 moles of KMnO₄ = produce by 2 moles of MnO₂

1.5 moles of KMnO₄ = produce by 2/2×1.5=1.5 moles of MnO₂

Hence, required moles are 1.5 moles.

To know more about moles, visit the below link:

https://brainly.com/question/24631381

here's your answer..