Answer:
The mass of aluminum hydroxide that will precipitate when 35.5 mL of 0.145 mol/L aqueous aluminum nitrate is mixed with 44.2 mL of 0.215 mol/L aqueous sodium hydroxide is approximately 0.247 grams
Explanation:
The given parameters are;
The volume of 0.145 mol/L aqueous aluminum nitrate in the reaction = 35.5 mL
The volume of 0.215 mol/L aqueous sodium hydroxide in the reaction = 44.2 mL
The balanced chemical equation for the reaction is given as follows;
Al(NO₃)₃ (aq) + 3NaOH (aq) → Al(OH)₃ (s) + 3NaNO₃ (aq)
Therefore;
1 mole of Al(NO₃)₃, reacts with 3 moles of NaOH to form 1 mole Al(OH)₃, and 3 moles of NaNO₃
The number of moles of aqueous aluminum nitrate in the reaction = 35.5/1000 L × 0.145 mol/L = 0.0051475 moles
The number of moles of aqueous sodium hydroxide in the reaction = 44.2/1000 L × 0.215 mol/L = 0.009503 moles
Therefore, 0.009503 moles NaOH will react with 0.009503/3 moles Al(NO₃)₃ to form 0.009503/3 moles of aluminum hydroxide precipitate
The molar mass of aluminum hydroxide = 78 g/mol
Therefore, 0.009503/3 moles of aluminum hydroxide weighs 78 × 0.009503/3 = 0.247078 grams
The mass of aluminum hydroxide that will precipitate out ≈ 0.247 grams.
A layer of sandstone is found on top of a layer of shale
Answer: Yes it is
Explanation:
7. Base your answer to the following question on the information below and on your knowledge of biology A student designed an experiment to investigate a claim that athletes would have lower heart rates than nonathletes during exercise. After the students classified themselves as an athlete or a nonathlete, their resting pulses were determined. Then all the students performed the same exercise for four minutes and their heart rates were determined by recording the pulse rate in beats per minute. The students continued to measure their pulse rates for an additional four minutes. The average heart rate per minute for each group was determined. The data were recorded, as shown on the table below Average Heart Rate Response to Exercise (beats per minute) Time (minutes) Athlete Students Nonathlete Students Resting Pulse 68 72 1 76 78 2 82 90 Exercising Period 3 115 95 110 4 130 5 100 125 6 95 120 After Exercise 7 85 100 8 68 95 2.4 To improve the validity of the conclusion reached in this experiment, the students should repeat the experiment A) disregarding any data that don't fit the hypothesis B) with a larger number of athletes and nonathletes C) comparing the heart rates and breathing rates of males and females D) with the athletes doing different exercises than the nonathletes
What is the difference between chlorine -35 and chlorine -37?
Answer:
Free chlorine involves the amount of chlorine that's able to sanitize contaminants, while combined chlorine refers to chlorine that has combined directly with the contaminants. Total chlorine is basically the sum of free chlorine and combined chlorine.
Explanation:
chlorine -35 being chlorine
chlorine -37 being free chlorine
PLZ HELP ASAP THIS IS DUE LIKE RIGHT NOW
Answer:it's either the first or second one
Explanation:
the layers of the earth
If the name of a compound ends in -ide, we know that the compound is made of __________ elements. What completes the sentence?
Answer:
Two
Explanation:
Typhoons are large storms that form over the Pacific Ocean Hurricanes are large storms that form over the Atlantic Ocean. Which of the following are essential components in the formation of a hurricane
or a lyphoon
A High pressure, high temperature, cyclonic winds, dry air
B. High pressure cool temperature, strong winds, humid air
cWarm front, clouds, low pressure, high slevation
D Low pressure, warm temperature, warm ocean waters, spiraling winds
What kind of bond would form between an iron and an oxygen atom: ionic, covalent, or metallic? What kind of bond would form between two silver atoms: ionic, covalent, or metallic? What happens to the valence electrons in this bond? How do ionization energy and electronegativity help explain why this occurs? 3) What kind of bond would form between two chlorine atoms: ionic, covalent, or metallic? What happens to the valence electrons in this bond? How do ionization energy and electronegativity help explain why this occurs?
Answer:
See explanation
Explanation:
Since iron is a metal and oxygen is a non metal, a bond is formed between the two when electrons are transferred from iron to oxygen. Hence the bond is ionic.
Two silver atoms are held together by metallic bonds. Metallic bond are bond forces that exist between metal atoms in a crystal lattice. The valence electrons in this bond form a cloud. Metals have low ionization energy and low electronegativity hence they loose electrons easily. This accounts for the nature of the metallic bond.
The bond formed between two chlorine atoms is a covalent bond. The valence electrons in this bond are localized between the two chlorine atoms. Chlorine is a nonmetal hence it has a high ionization energy and high electronegativity. Hence it forms covalent bonds in which electrons are shared between bonding atoms.
The percentage by volume of oxygen in clean and dry air is approximately
Answer:
[tex]\huge\bf\underline{\underline{\pink{A}\orange{N}\red{S}\green{W}\purple{E}\blue{R}}}[/tex]
ONLY 20.95% IN THE AIR
:)
▃▃▃▃▃▃▃▃▃▃▃▃▃▃▃▃▃▃▃▃▃
what makes one of your cells you ?
uses of indicators in points?
Answer:
The common application of indicators is the detection of end points of titrations. The colour of an indicator alters when the acidity or the oxidizing strength of the solution, or the concentration of a certain chemical species, reaches a critical range of values.
Which has a higher frequency: microwaves or blue light? How do you know?
Answer:
Microwaves
Explanation:
Microwaves have more energy than blue light
Among microwaves or blue light, blue light has a higher frequency. This is because blue light belongs to the visible region has a short wavelength and produces a higher amount of energy.
What is the relationship between frequency and wavelength?The frequency of any wave is inversely related to the wavelength. This means that when the frequency of the wave increases, the wavelength decreases. While the relationship between frequency is directly related to the energy.
According to the context of this question, gamma rays have the highest frequency and shorter wavelength, while radiowaves have a shorter frequency and the highest wavelength.
Therefore, blue light has a higher frequency. This is because blue light belongs to the visible region has a short wavelength and produces a higher amount of energy.
To learn more about the Frequency of waves, refer to the link:
https://brainly.com/question/16610625
#SPJ2
About ______ impact the creators have been recognized on earth.
A) one thousand
B) 50
C)500
D)150
How would you define what the conductivity of a substance is?
Answer:
Conductivity of a substance is defined as 'the ability or power to conduct or transmit heat, electricity, or sound'.
Explanation:
hope it helps
plzz mark as brainliest....
How can we use properties to identify unknown minerals?
Answer:
BY NAMING THE MINERALS :>
Explanation:
Answer:
NAMING THE MINERALS
Explanation:
The transfer of energy in the form of invisible waves is
Answer:
Radiation
Explanation:
The central atom in PbSO4 is..............???????
Answer:
The central atom is S.
Explanation:
Look at the structure.
1. How many moles of Mg are there in 9.20 x 1024 atoms of Mg?
Answer:
15.28 molesExplanation:
To find the number of moles in a substance given it's number of entities we use the formula
[tex]n = \frac{N}{L} \\[/tex]
where n is the number of moles
N is the number of entities
L is the Avogadro's constant which is
6.02 × 10²³ entities
From the question we have
[tex]n = \frac{9.20 \times {10}^{24} }{6.02 \times {10}^{23} } \\ = 15.282392..[/tex]
We have the final answer as
15.28 molesHope this helps you
Help pls!
How can you use a chemical reaction to remove a contaminant from a solution?
Answer:
reverse osmosis
Explanation:
Water treatment is often complicated because it deals with the chemical makeup of the water, which varies widely. The first step is to determine what contaminants should be removed. Unfortunately, this is not always a straightforward process. Many contaminants make themselves known in obvious ways, such as iron or hydrogen sulfide, which can cause taste and odor issues. Other contaminants, such as arsenic or pesticides, are only uncovered through a sophisticated laboratory analysis.
It is important to test the water so that the right type of treatment system can be selected. Keep in mind, however, that more than one analysis may be necessary to get a baseline because water quality fluctuates. More information on possible contaminants in a specific area can be obtained by talking to residents, the local health department, the water department, or the state geological society. In addition, your laboratory should be able to recommend appropriate tests based on a customer’s concerns and the information provided about the water source. It is important not only to address customers’ concerns but also to educate them about potential contaminants they may not have considered.
Why is it important to pasteurize certain liquids?
Answer:
Pasteurization involves heating liquids at high temperatures for short amounts of time, it can make it better if you wanted hot cocoa but bad for milk
Explanation:
Answer:
Pasteurization kills harmful microbes in milk without affecting the taste or nutritional value
Explanation:
When force are ____ the object does not move
when forces are balanced the object does not move.
Explanation:
if you and your friend push both sides of the chair at the same time with the same amount of strength the chair wouldn't move.
ill attach a picture
Answer:
35.50
Explanation:
There are two stable isotopes, 35Cl (75.77%) and 37Cl (24.23%), giving chlorine a standard atomic weight of 35.45
what hypothesis is best for chemical reaction?
will give Brainliest
Answer:
If the reactants in the chemical reactions are known, then the products can be predicted because the pattern of the chemical reactions is being followed. The pattern for a single replacement is A + BC --> AC + B. This is like the Hear It Pop Chemical Reaction which is also an example of the single replacement.
Explanation:
HELPP ASAP
What do the colors on the periodic table show?
A. which element it is
B. the metallic properties of the element
C. the types of compounds the element can make
D. whether the element is a solid, a liquid, or a gas at room temperature
Answer:
Periodic tables can use color to identify other element characteristics. For example, an electronegativity periodic table color codes the elements based on how electronegative they are. The valence periodic table uses color to identify the most common valence state for each element.Oct 2, 2019
pls like and rate us .
The color given to a the elements in periodic table is to characteristics of the elements mainly to identify whether they are solid, gas or liquid. Thus option D is correct.
What is periodic table?A periodic table contains all the discovered elements which are classified into different groups and periods. Groups are vertical columns of elements with similar properties and same number of valence electrons.
Periods are horizontal rows from left to right with an increase in atomic number. There are 18 groups and 7 periods in periodic table. Each group has given each color and some elements showing exceptional characteristics such as hydrogen and helium have separate colors.
All the first group elements called alkali metals have one color and the second groups elements with another color, All the d-block elements are given the same colour and metals in p-block elements have the same color.
Similarly, all the metalloids have one color and all other gases have the same colour in which inert gas group and halogen group have seperate colours.
Hence, the color in periodic table helps to identify the element's nature like its state also. Thus option D is correct.
To find more about periodic table, refer the link below:
https://brainly.com/question/11155928
#SPJ2
What conclusion can she make from her experiment?
Heather is testing a substance as to whether it is
organic or inorganic. She works with the solid
substance and discovers it can conduct electricity
without burning. She also knows the carbon to oxygen
ratio is 1 to 2
O The substance is organic because it is solid at room
temperature.
O The substance is organic because it cannot burn
readily
O The substance is inorganic because it has carbon.
The substance is inorganic because it conducts
electricity
Answer:
Im pretty sure the answer is D
Explanation
Answer:
Answer D
Explanation:
How long does it take for 87.5 % of each isotope(Krypton-73, Krypton-74, Krypton-76, and Krypton-81) to decay?
How many moles in 435 liters of Krypton gas at STP?
19.4 mol Kr
General Formulas and Concepts:Chemistry
Stoichiometry
Using Dimensional AnalysisGas Laws
STP (Standard Conditions for Temperature and Pressure) = 22.4 L per mole at 1 atm, 273 KMath
Pre-Algebra
Order of Operations: BPEMDAS
Brackets Parenthesis Exponents Multiplication Division Addition Subtraction Left to Right Explanation:Step 1: Define
435 L Kr at STP
Step 2: Identify Conversions
[STP] 22.4 L = 1 mol
Step 3: Convert
[tex]435 \ L \ Kr(\frac{1 \ mol \ Kr}{22.4 \ L \ Kr} )[/tex] = 19.4196 mol Kr
Step 4: Check
We are given 3 sig figs. Follow sig fig rules and round.
19.4196 mol Kr ≈ 19.4 mol Kr
Formula for the compound that contains Mg2+ and O2-
Answer:
MgO.
Explanation:
charges of both satisfy one another (balanced) -- producing a compound MgO.
In the Bronsted-Lowry model of acids and bases, an _____ is a hydrogen donor and a _____ is a hydrogen acceptor.
Answer:
According to Bronsted-lowry concept an acid is a hydrogen donnor and a base is a hydrogen acceptor.
Explanation:
Please help me !!!!!
Answer correctly please !!!!!!!!!!!!!!! Will mark brainliest !!!!!!!!!!!!!!!!!