The solution of copper sulfate was too cold
Explanation:
The lack of an observable reaction when adding a zinc strip to a copper sulfate solution could be due to the zinc not being reactive enough, the reaction occurring too slowly, or an experimental error.
What is the lack of an observable reaction?The lack of an observable reaction refers to a situation where no visible or measurable change occurs when two or more substances are mixed or brought into contact with each other, even though a reaction was expected based on the chemical properties of the substances involved.
Here in the Question,
The lack of an observable reaction when Alannah added a strip of zinc to a beaker containing a solution of copper sulfate could be due to the following reasons:
Zinc and copper sulfate do not react: It is possible that the zinc strip and copper sulfate solution do not react with each other, leading to no observable change. This could occur if the zinc strip is not reactive enough to displace the copper in the copper sulfate solution.
Reaction is slow: Another possibility is that the reaction between zinc and copper sulfate is occurring but is happening too slowly to be observed. In this case, the reaction rate may be too low to produce an observable amount of solid copper in the beaker in a short period of time.
Experimental error: It is also possible that an error was made during the experiment that prevented the expected reaction from occurring. For example, the concentration of the copper sulfate solution may have been too low, or the zinc strip may have been coated with a layer of oxide that prevented it from reacting with the solution.
Therefore, Zinc may not be sufficiently reactive, the reaction may proceed too slowly, or there may have been a mistake in the experiment if there was no detectable reaction when a zinc strip was added to a copper sulphate solution.
To learn more about redox reaction click:
brainly.com/question/2671074
#SPJ2
A toy car of mass 1kg moves at 2 m/s. If a 3N force is applied for 1.9 seconds. What is the cars final velocity? Answer to 1 decimal. Help fast please. I'll mark brainliest :)
Answer:
7.7 m/s
Explanation:
Initial speed=2 m/s
mv=Ft
1*v=3*1.9
v=5.7 m/s
5.7+2=7.7
PLZZZZZZZZZ HELPPPPP. BRAINLEST GIVEN What is a force of attraction between an object and the earth due to gravity?
Answer:
acceleration due to gravity: -9.8 m/s^2
Fg=mass of object*(-9.8)
Explanation:
This is a pretty vague question, but I'll answer as best I can.
All matter has gravity. YOU have gravity, although your gravitational pull is small. So, the force of attraction between the Earth and an object on Earth is modeled as
Force of gravity=(Gravitational constant*mass of object 1*mass of object 2)/distance between objects squared
Note that distance between an object on Earth and Earth is the radius of Earth (distance to Earth's core/center of mass)
Some people today claim the Earth is flat. Produce an argument to prove that the
Earth is not flat.
Answer:
i mean i think it is. we have no real pics of the earth they are all fake. And the moon landing was fake. the usa flag was blowing but there is no wind in space . its all fake
Explanation:
1. If you add air to a flat tire through a single small entry hole, why does the air spread out to fill the tire?
Answer:
The tire fills up just like anything else that holds air when u pump a ball or tire up it fills all the way up cause it is a small confined space and after filling it with air the atoms of the air fill the tire up
Explanation:
A player prefers to make high passes that lift the puck above the ice. Which stick should the
player choose?
Answer:
i dont know
Explanation:
hello
mass = 20Kg
velocity = 10m/s
what is the kinetic energy
Answer:
kinetic energy = 1 / 2 mv²
kinetic energy = 1 / 2 × 20 × 10 ²
kinetic energy = 1000 joules
.........
If I keep F constant in F=ma, what is the relationship between m and a?
Answer:
If F is a constant, we can take f = 1
f = m×a
ma = 1
therefore we can say that force is hence proportinal to the product of mass and acceleration.
a car travels at a constant speed of 30km/h for .80h what is the total distance
Answer:
2400 km
Explanation:
30km for 1hr
Need up to 80 hrs , multiply both 80 and 30
So its 2400km
The tuning fork has a frequency of 426.7 is found to cause resonance in a closed column of air measuring 0.186 (the diameter of the tube is 0.015m) find the velocity of the sound produced by the tuning fork.
Answer:
The velocity of the tuning fork sound is 317.4648 m/s
Explanation:
The given parameters are;
The frequency of the fork, f = 426.7 Hz
The length of the closed air column, L = 0.186 m
The diameter of the tube, d = 0.15 m
At the fundamental frequency in a closed tube, we have;
λ = 4·L
Where;
λ = The wavelength of the wave
L = The length of the tube
From the equation for the velocity of a wave, we have;
v = f·λ
Where;
v = The velocity of the (sound) wave
f = The frequency of the wave = 426.7 Hz
λ = 4·L = 4 × 0.186 m = 0.744 m
∴ v = 426.7 Hz × 0.744 m = 317.4648 m/s
Therefore, the velocity of the sound produced by the tuning fork, v = 317.4648 m/s
What is the transfer of energy that occurs when a force causes an object to move?
O Energy
Force
Power
O Work
Answer:
huh? I think it's Power.....
a) A 12 kg object has a velocity of 37.5 m/s. What is its momentum?
b) How far does it get in 16 s?
Answer:
The answer would be 450 m kg/s
Explanation/ Explanation / Example:
Provided an object traveled 500 meters in 3 minutes , to calculate the average velocity you should take the following steps: Change minutes into seconds (so that the final result would be in meters per second). 3 minutes = 3 * 60 = 180 seconds , Divide the distance by time: velocity = 500 / 180 = 2.77 m/s .
If this doesn't help let me know!
Don't scroll down. Help pls 22 POINTS!!
Answer:
I don't know if these are all right but these are my best answers. good luck and I hope you do well.
1. true
2. true
3. false
4. true
5. true
6. true
7. true
8. true
9. false
10. false
13. it stimulates the heart through chest compressions
14. on bare skin upper right shoulder and lower left ribs
15. no CPR
Explanation:
10 pointss
For a two way mirror to work properly, light must be ___ on one side and ____ through the other side
a. reflected - transmitted
b. refracted - absorbed
c. absorbed- reflected
d. absorbed- transmitted
What volume of silver metal will have a mass of exactly 2.5 kg, given that the density of silver is 10.5 g/cm3? (Hint: Note the units of mass given and the units of density.)
Answer:
238.09 cm^3
Explanation:
V=mass/density
V=2500/10.5
V=238.09 cm^3
why the friction between an object and a surface is less than when the surface is titled than when the same surface is horizontal
Answer:
nvjch
ffufuxuhxjcjfbfdhdh
A 2kg rock is dropped from a height of 10m and hits the ground going 11m/s. How much work was done by air resistance as it fell?
Answer: 0.24 kg/m
Explanation: use k = ρ * A * C / 2 as the formulaA stone of mass 0.2kg is thrown vertically upwards from the ground with a velocity of 20m/s. Find the maximum height attained by the stone
Answer: 20.4 m
Explanation: speed v upward is v = vo -gt.
When maximum height v = 0, vo -gt = 0 and
T = vo / g = 20 m/s / 9.81 m/s² = 2.04 s
Now height y = vot -0.5 gt^2 = 20,4 m
This is possible to solve using
Conservation of energy Ek= Ep
0.5mv² = mgh. And h = v²/2g. Results same
in hydraulic pressure the area of the larger piston is half of the smaller piston.if the force of 4000N is applied on the smaller piston.what is the distance covered by the train ?
Answer:
The distance moved by the train is half the distance moved by the force
Explanation:
Given that the force applied to the smaller piston, F₂ = 4,000 N
The pressure in the area of the larger piston, A₁ = 2 × The pressure in the smaller piston, A₂
∴ A₁ = 2 × A₂
We have;
[tex]\dfrac{A_1}{A_2} = \dfrac{2\cdot A_2 }{A_2} =2 = \dfrac{F_1}{F_2}[/tex]
F₁ = 2·F₂ = 2 × 4,000 N = 8,000 N
F₁·d₁ = F₂·d₂
∴ 8,000 N ×d₁ = 4,000 N × d₂
d₁ = 1/2·d₂
∴ The distance moved by the train is half the distance moved by the force
If two monochromatic light waves undergo destructive interference, the amplitude of the resultant wave is
Answer: The amplitude is 0. (assuming that the amplitude ot both initial waves is the same)
Explanation:
When two monochromatic light waves of the same wavelength and same amplitude undergo destructive interference, means that the peak of one of the waves coincides with the trough of the other, so the waves "cancel" each other in that point in space.
Then if two light waves undergo destructive interference, the amplitude of the resultant wave in that particular point is 0.
Answer:
No, the resulting wave in the diagram does not demonstrate destructive interference. The resulting wave in the diagram shows a bigger wave than Wave 1 or Wave 2. If it demonstrated destructive interference, it would be a smaller wave or a horizontal line. With destructive interference, waves break down to form a smaller wave, or cancel each other out, resulting in no wave formation.
Explanation:
edge
Please list them from top to bottom, for exp like in your response, a,g,q,d. Giving quite some points for it.
If a motor is rated at 5.6KW, work done in 20minutes is equal to:
Answer:
given Power= 5.6×1000=5600watt
t=20min=20×60=1200sec. work done=?
P=w/t
w=pt=5600×1200=672×10^4Joule
The amount of work done by the motor is equal to 6.72 Megajoules.
Given the following data:
Time = 20 minutesPower = 5.6 Kilowatt = 5600 Watts.Conversion:
1 minute = 60 seconds20 minutes = [tex]20 \times 60 = 1200[/tex] seconds.To determine the amount of work done by the motor:
Mathematically, the work done by an object with respect to power and time is given by the formula:
[tex]Work\;done = power \times time[/tex]
Substituting the given parameters into the formula, we have;
[tex]Work\;done = 5600 \times 1200[/tex]
Work done = 6,720,000 Joules
Note: 1,000,000 Joules = 1 Megajoules.
Work done = 6.72 Megajoules.
Read more on work done here: https://brainly.com/question/13818347
the movement of a body between any two points in any direction is called
Answer:
I think is called Motion
but am not sure
Answer:
Maybe its displacement, I'm not sure?
Explanation:
would this be Newtons 1st, 2nd, or 3rd law
Answer:
Newton's First Law of Motion.
Explanation:
Newton's First Law of Motion states that a body continues its state of motion untill and unless an external force acts on it. Here, the truck moves forward even after the breaks are applied in order to maintain its State of motion.
What is the unit of energy called? (Give name and symbol)
work and power!!
____is the measure of how much work, energy, or power is used or converted properly. Efficiency C Power b Newton d. Horsepower
Answer:
Efficiency
Explanation:
If the mass of each ball is 12 kg and they experience a gravitational force of magnitude 2.00
x 10-7 N between them, what is the distance between the balls ?
Answer:
[tex] {2 \times 10} - 7 = 12 {}^{2} \div x \\ x = 2 \times 10 - 7 \div 12 {}^{2} [/tex]
I'm just in jss2 but I read physics. this is what I think
A particle was moving in a straight line at 172.8 km/hr. If it decelerated over 120 meters to come to rest, find the time taken to cover this distance.
Answer:
v=s/t
s=vt
t=s/v
t=(120×10‐³)/172.8
(the distance meters has been changed to kilometres)
t=1/1440 hrs
Given ,
Helppppp meeeeee pleaseeeeeeeee
Rose and Joel's children recently moved out to live independently. The couple has been missing their kids and is experiencing the empty-nest syndrome. Which TWO strategies will help them deal with their loneliness? -pursuing a hobby -joining an activity club with like-minded people -calling their children regularly -visiting their children frequently -convincing their children to move in back home with them
Answer:
Joining a club and getting a hobby
Explanation:
Join a club if you want to meet people, and when they choose a hobby it should be more than just gardening, because gardening sucks in the long term and it doesn't fill that gap. I know because my grandma did it and she is still sad.
which line represnts object moving fastest
**WILL MARK BRAINLEST ANSWER, IF RIGHT**
Line - A: (15/10) = 1.5 inch/second
Line - B: (0/10) = 0
Line - C: (10/10) = 1.0 inch/second
Line - D: (-25/20) = -1.25 inch/second
Line-A represents the greatest speed.