Ok thanks for the valuble info.
Need help ASAP!!please
Jeremiah pushed Anthony with a net force of 12 N. Anthony accelerated across the hall at 0.2 m/s2. What was Anthony’s mass?
Answer:
6
Explanation:
Work Shown:
Force = Mass*Acceleration
F = ma
12 = m*0.2
12/0.2 = m
60 = m
m = 60 kilograms
Which air is driest? Air Temp 30F Dew-point 29F, Air Temp 77F Dew-point 19F, Air Temp 66F Dew-point 60F, or Air Temp 50F Dew-point 36F
Answer:
Air Temp 77F Dew-point 19F
Explanation:
Quiz
The dew point can be described as the temperature required by the air to be cooled. The driest air will have a higher dew point, therefore, at an air temperature of 66°F and a dew point of 60°F. Therefore, option (C) is correct.
What is dew point?The dew point can be defined as the temperature at which air should be cooled to become saturated with water vapor assuming constant air pressure and water content.
Moisture capacity will decrease below the dew point. Airborne water vapor will condense to form liquid water or dew. Dew develops on the surface and occurs through contact with a cooler surface.
The dew point is called the frost point when the temperature is below the freezing point because frost is produced by deposition rather than a condensation of water.
The humidity also impacts the dew point. The dew point increases when there is higher moisture in the atmosphere. Therefore, the higher dew point refers to less humid air or drier.
To learn more about dew point, here:
brainly.com/question/15313810
#SPJ2
If the atomic number of an element is 16, what is the element's identity?
What is its atomic mass
Answer: The element is sulfur and the atomic mass is 32.07
Explanation: wasn’t sure what you were asking so gave you both
please someone answer and help :)
All of the different organisms interacting in a pond make up
1.) a community
2.)the water cycle
3.) a population
4.) the habitat
Answer:
they would make up a population
Explanation:
all the inhabitants of a particular town, area, or country.
the population of frogs are very difficult to catch
A massless length of twine can withstand a maximum tension of 490 N. The twine is used to spin a 28-kg ball in horizontal circular motion of radius 1.8 m. The ball is spun faster and faster until the twine breaks. What was the maximum speed of the ball?
7.2 m/s
3.2 m/s
5.6 m/s
11 m/s
Answer:
5.6 m/s
Explanation:
An object has a mass of 441 g and a volume
of 10 cm3. What is the density of the object
in g/cm3?
The density is the ratio of the mass to the volume. The density of the object is 44.1 g/cm³.
What is density?Density (ρ) is the quantitative measurement of the substance having grams of mass that are dissolved per cubic meter of the solution. The density is calculated as:
ρ = M ÷ V
Given,
Mass of the object = 441 gm
The volume of the object = 10 cubic meter
Density is calculated as:
ρ = 441 ÷ 10
= 44.1 g/cm³
Therefore, 44.1 g/cm³ is the density of the object.
Learn more about density here:
https://brainly.com/question/952755
#SPJ1
An electric current is passed through a sample of water, causing the
sample to break down into oxygen and hydrogen. Given this information,
what is the correct classification of water?
Answer:
A compound
Explanation:
The water is best classified as a compound. When a substance is broken down into elemental composition or units, they are said to be a compound.
An element is a distinct substance that cannot be split up into simpler substances. Compound are substances composed of two or more kinds of atoms joined together in a definite grouping. The properties of compounds are distinct and different from those of the individual elements that are combined in its make - up. So, the water when broken down to elements is a compound.The three types of symbiosis are ___ and ___
Answer:
mutualism,commensalism and parasitism
Answer:
mutualism, commensalism, and parasitism
Match each term with the correct description below.
1. what is a charged atom that has gained one or more electrons?
2. What substance is held together by ionic bonds?
3. What metal and nonmetal transferrers electrons?
4. What particle has electrons that are shared unequally?
5. What forms when atoms share electrons by covalent bonds?
6. What two nonmetals share electrons?
7. What charge atom that has lost one or more electrons?
8. What two or metals "pooling" electrons?
a. metallic bond
b. covalent bond
c. anion
d. ionic bond
e. molecule
f. cation
g. compound
h. polar molecule
Answer:
1. anion
2. compund
3. ionic bond
4. polar molecule
5. molecule
6. covalent bond
7. cation
8. metallic bond
Explanation:
How many grams are in a 3.1E21 atom sample of vanadium
What is the concentration of a solution of 10. Moles of copper nitrate in 5.0 liters of solution
Answer:
10.5
Explanation:
well we added together so thats the result
What is a convection current (Be sure to include how temperature and density are involved.
Convection currents are flowing fluid that is moving because there is a temperature or density difference within the material. ... A temperature difference leads to an energy transfer from an area of higher energy to one of lower energy. Convection is a heat transfer process.
Which of the following happens to the particles when the temperature of liquid water drops?
kinetic energy decreases
kinetic energy increases and then decreases
kinetic energy increases
kinetic energy stays constant
Answer:
The Kinetic energy decreases
Explanation:
because the speed of the molecules slows down.
What is the correct name and HELPPP!!
What is the name and formula of an ionic compound containing the element with the
atomic number of 5 bonded to Carbonate? *
Boron Carbonide; B2(CO3)3
Boron Carbonate; B,CO,
Boron Carbide; B,CO,
Boron Carbonate; B2(CO3)3
Answer:
Boron Carbonate; B₂(CO₃)₃
Explanation:
For names, carbonide does not exist; that rules out the first option. Carbide refers to just a carbon atom, not carbon and oxygen as in the polyatomic ion carbonate. That rids us of the third option. We are left with boron carbonate with the formula BCO or boron carbonate with the formula B₂(CO₃)₃.
Recall the carbonate polyatomic ion's formula: CO₃²⁻
Thus BCO cannot be the formula.
Option 4 is your answer, Boron Carbonate; B₂(CO₃)₃.
To further check your answer, observe the oxidation states of boron and the polyatomic ion carbonate. Boron can exist in oxidation states of either 2+ or 3+, and carbonate is only 2-; in this formula, boron will exhibit a 3+ state to balance out with carbonate.
2x3+ = 6+; 3x2- = 6-
6+ + 6- = 0; balanced
You can see protons yes or no
No. Not with the naked eye
how many moles of Fe(OH)2 are required to produce 7.4 moles of Fe3(PO4)2
Answer:
22.2 mol
Explanation:
Considering the reaction stoichiometry, 22.2 moles of Fe(OH)₂ are required to produce 7.4 moles of Fe₃(PO₄)₂.
The balanced reaction is:
3 Fe(OH)₂ + 2 H₃PO₄ → Fe₃(PO₄)₂ + 6 H₂O
By reaction stoichiometry (that is, the relationship between the amount of reagents and products in a chemical reaction), the following amounts of moles of each compound participate in the reaction:
Fe(OH)₂: 3 moles H₃PO₄: 2 molesFe₃(PO₄)₂: 1 mole H₂O: 6 moles
Then you can apply the following rule of three: if by reaction stoichiometry 1 mole of Fe₃(PO₄)₂ requires 3 moles of Fe(OH)₂, 7.4 moles of Fe₃(PO₄)₂ require how many moles of Fe(OH)₂?
[tex]amount of moles of Fe(OH)_{2} =\frac{7.4 moles of Fe_{3} (PO_{4} )_{2} x3moles of Fe(OH)_{2} }{1mole of Fe_{3} (PO_{4} )_{2} }[/tex]
amount of moles of Fe(OH)₂= 22.2 moles
Finally, 22.2 moles of Fe(OH)₂ are required to produce 7.4 moles of Fe₃(PO₄)₂.
Learn more:
brainly.com/question/16487206?referrer=searchResults brainly.com/question/14446695?referrer=searchResults brainly.com/question/11564309?referrer=searchResults brainly.com/question/4025026?referrer=searchResults brainly.com/question/18650135?referrer=searchResultsWhich of the following elements is a metalloid? A. phosphorus B. cobalt C. silicon D. magnesium
Answer: silicon
Explanation:it just is
Respuesta
es la C. silicio
Explanation:
No existe una definición estandarizada de elemento metaloide ni un consenso completo sobre los elementos que son metaloides.
En la clasificación de metaloides se suelen incluir a:
Boro (B)
Silicio (Si)
Germanio (Ge)
Arsénico (As)
Antimonio (Sb)
Telurio (Te)
Colour in acid of red litmus paper
Red
Litmus paper turn red when it comes in contact with acid. It turn blue if it come in contact with a base. Neutral litmus paper is purple
Transfer of heat through conduction can occur in which of the following?
A. Solids
B. Liquids
C. Gases
D. All of the above
What is one example of pre-exising marine life?
dinosaur egg
shrimp burrow
leaf imprint
bird bone
Answer:
Shrimp burrow
Explanation:
Shrimp are types of sea life, whales eat them
Why do electrons falling into different orbits give off characteristics wavelengths?
Explanation:
Because the difference in energy between orbits is different in different types of atoms, moving electrons between different orbits requires photons carrying different amounts of energy (different wavelengths).
A student analyzed an unknown sample that contained a single anion. The sample gave a white precipitate upon addition of a solution of AgNO3 which dissolved in ammonia. Which anion is present in the unknown solution? Write the corresponding net ionic equation.
Answer:
Chloride ion
Explanation:
The anion present in the unknown solution would be chloride ions.
A white precipitate of silver chloride is usually formed when drops of silver nitrate are added to a solution containing chloride ions. The ionic equation is as below:
[tex]Cl^- (aq) + Ag^+ (aq) --> AgCl (s)[/tex]
Beaux has purchased a synthetic material for a product he is launching. What is most likely a benefit of this material?
It is biodegradable.
It can be recycled cheaply.
It is heavy.
It can be mass produced.
Answer:
The answer is D. it can be mass produced
Explanation:
Answer:
The answer is D It can be mass produced.
Explanation:
I just took the test
2. Platinum metal has a density of 21.4 g/mL. If the block measures 3 cm, by 0.03 m, by 40 mm
how much does it weigh in milligrams?
Answer:
80mg
Explanation:
Given parameters:
Density of Platinum metal = 21.4g/mL
Dimension of the metal = 3cm by 0.03m by 40mm
Unknown:
Weight of the metal in milligrams?
Solution:
Density is the mass per unit volume of a substance.
Mathematically;
Density = [tex]\frac{mass}{volume}[/tex]
Volume of the platinum metal = l x w x h
Let us convert the dimension of the metal to the same unit;
3cm x 0.03m x 40mm
convert to cm;
100m = 1cm
0.03m = [tex]\frac{0.03}{100}[/tex] = 0.0003cm
-- 40mm;
1mm = 0.1cm
40mm = 40 x 0.1 = 4cm
Volume of the metal = 3 x 0.0003 x 4 = 0.0036cm³
1mL = 1cm³; so volume = 0.0036mL
Mass of the metal = 21.4 x 0.0036 = 0.08g
1g = 1000mg
0.08g = 0.08 x 1000 = 80mg
Water is the only substance that can dissolve polar solutes. True or False?
Answer:
false!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Explanation:
If the temperature of a substance increases will the particles of that substance be moving faster or slower or at the same speed as they were before the temperature changed
Answer:
If the temperature increases, temperature reflects the speed of the molecules, so if the molecules are at a higher temperature, they are faster and they start to break bonds and new things react.
Explanation:
This is methane, Methane is gas that is found in small quantities in Earth's atmosphere. Methane is the simplest hydrocarbon,
consisting of one carbon atom and a powerful greenhouse gas. What is the chemical formula for methane?
A)
4CH
B)
C4H
C)
C4H4
D)
CH4
Answer:
CH4
Explanation:
I looked it up and took the test
Answer:
You go to K12?
Explanation:
Help please! I’ll mark brainliest to who ever answers this first!!
Answer:
paleontologists is the answer to scientist who studies fossil