Answer:
do the wam wam
Explanation:
We have a parallel-plate capacitor with plates of metal each having a width W and a length L. The plates are separated by the distance d. Assume that L and W are both much larger than d. The maximum voltage that can be applied is limited to V max =K d, in which K is called the breakdown strength of the dielectric. Derive an expression for the maximum energy that can be stored in the capacitor in terms of K and the volume of the dielectric. If we want to store the maximum energy per unit volume, does it matter what values are chosen for L, W, and d? What parameters are important?
Answer:
max energy = [tex]W_{max} = \frac{1}{2}[/tex]*εo*εr*k^2
Explanation:
Given data:
weight of plates = W
length of plates = L
distance of separation = d
max voltage ( Vmax ) = Kd
Area ( A ) = WL
The values chosen for L, W, and d matters, although the maximum energy stored in the capacitor is independent of L, W, and d. but at a constant volume and a larger value for W and L which is > d, the value of the dielectric (εrK^2 ) should be a larger value '
The important parameters are : εrK^2 , k , d and Area
attached below is the remaining part of the solution
Question text
A man leaves home for a cycle ride and comes back home after a half-an-hour ride covering a distance of one km. What is the average velocity of the ride?
Answer: Hello, The average velocity of the ride is 0 km/h. Your Welcome! Mark me as Brainliest!
Explanation:
4.In a hydroelectric power plant, 100 m3/s of water flows from an elevation of 120 m to a turbine, where electric power is generated. The electric power you get out from the 80% efficiency turbine is known to be 50 MW, what is the rate of irreversible loss in the piping system (in MW unit)
Answer:
The rate of irreversible loss will be "55.22 MW".
Explanation:
The given values are:
Elevation,
h = 120 m
Flow of water,
Q = 100 m³/s
Efficiency,
= 80%
i.e,
= 0.8
Efficiency turbine,
= 50 MW
Now,
Without any loss,
The power generated by turbine will be:
⇒ [tex]P=\delta gQh[/tex]
On substituting the values, we get
⇒ [tex]=1000\times 9.8\times 100\times 120[/tex]
⇒ [tex]=117.72 \ MW[/tex]
Power generated in actual will be:
= [tex]\frac{50}{0.8}[/tex]
= [tex]62.5 \ MW[/tex]
Hence,
Throughout the piping system,
The rate of irreversible loss is:
= [tex]Power \ generated \ by \ turbine-Power \ generated \ in \ actual[/tex]
= [tex]117.72-62.5[/tex]
= [tex]55.22 \ MW[/tex]
g ) Water is the working fluid in an ideal regenerative Rankine cycle with one closed feedwater heater. Superheated vapor enters the turbine at 16 MPa, 560 oC, and the condenser pressure is 8 kPa. The cycle has a closed feedwater heater using extracted steam at 1 MPa. Condensate drains from the feedwater heater as saturated liquid at 1 MPa and is trapped into the condenser. The feedwater leaves the heater at 16 MPa and a temperature equal to the saturation temperature at 1 MPa. The mass flow rate of steam entering the first-stage turbine is 120 kg/s. Determine (a) the net power developed, in kW.
Answer:
146494 kw
Explanation:
Given data:
Turbine inlet pressure ( p1 ) = 16 MPa
Turbine inlet temperature ( T1 ) = 560°C
condenser pressure : P3 = 8Kpa
Extracted steam at pressure ( P2 ) = 1 MPa
mass flow rate of steam ( m ) = 120 kg/s
a) The net power developed
= 146494 kw
note: values of h1, h2, y, Wp are all calculated values not included in the solution to make the solution less cumbersome.
Consider a layer of insulation installed around a steam pipe. The radius of the pipe is R1 and the thickness of the insulation is R3-R1.The stream is maintained at a temperature TW and the air surrounding the insulation is at a temperature To and flows cross wise over the pipe. The air is flowed over the steam pipe at high enough velocity so a thermal boundary layer develops over the surface described by a heat transfer coefficient h.
Required:
Beginning with the heat equation, calculate the total quantity of heat being conducted per unit time (heat flow) through the insulation, Q (units: energy/time).
Answer:
hmmmmmmmmmmmmmmmmmmmmmmmmmmm
Explanation:
........
stole energy is also called
Answer:
Hey mate....
Explanation:
This is ur answer.....
Energy theft, also called energy diversion, occurs when individuals tamper with electric meters or electric power lines. Energy theft ranges from tapping into a neighbor's energy source to illegally adjusting a meter. Meter tampering occurs in homes, grocery stores, restaurants and other commercial establishments.
Hope it helps you,
mark me as the brainliest....
Follow me! :)
Tech A says that a mechanical pressure regulator exhausts excess fluid back to the transmission pan. Tech B says that if the transmission pan is removed, the magnet must be replaced. Who is correct?
Answer:
A
Explanation:
Please I need help with this
Photosynthesis energy is stored in the cells of green plants through
process called ______?
In order to cool a cylindrical steel rod of diameter D, length L and uniform temperature T1, it is placed in a well-mixed water bath at initial temperature T0 and volume V0. The heat transfer coefficient between the steel rod surface and the water is h1. Assume the specific heat, density and conductivity of the steel rod and water are known and constant. Write down heat transfer differential V1, P1, T1 equation and boundary and initial conditions for temperature distribution in both steel rod and water bath
Answer:
attached below
Explanation:
Cylindrical steel rod : diameter ( D ) , length L, uniform temperature T
Initial temp of water : To, heat transfer coefficient between steel rod surface and water : h1
The energy balance equation can be written as :
Rate of convectional heat loss = Rate of decrease in internal energy with respect to time
cp = heat capacity of body, v = volume , р = density of body
attached below is the heat transfer differential equation and boundary and initial conditions
2.3
What does NBT stand for?
Answer:
Named Binary Tag ( NBT)
Explanation:
The format is designed to store data in a tree structure made up of various tags
The meaning of the given word NBT is called; National Benchmark Test.
What is the meaning of NBT?The meaning of the given word NBT is called National Benchmark Test.
NBT ( national benchmark test ) is defined as a national test which must be written and passed by High school students that intend to go to the university ( i.e. passport to the university ).
Read more about NBT at; https://brainly.com/question/26887507
PLZ HELP I GIVE BRAINLIEST!!