A boy jumps into an indoor swimming pool. He notices that the water appears to get colder as he
goes deeper underwater. This is due to convection
Which statement is correct?
Cold water is more dense than warm water so it sinks to the bottom of the pool.
Warm water is more dense than cold water so it rises to the surface of the pool.
The molecules in cold water have more kinetic energy than the molecules
in warm water so
they move to the bottom of the pool faster.
The molecules in warm water are closer together than the molecules in cold water so they
rise to the surface of the pool.​

Answer:

Chupapi munyaño hoyaaaa

Answer:

the answer is B.

Explanation:

The ball that is thrown straight up has more kinetic energy and more speed than the ball that is thrown straight down. Both balls have the same kinetic energy and speed.

The kinetic energy of a body can be determined as the energy of a moving physical system because of its motion. Work has to be done on an object to change its kinetic energy.

The kinetic energy of the moving system can be expressed as K.E. = ½mv²  where ‘m’ is mass while ‘v’ is the velocity of the object.

The potential Energy of the physical system can be described as the energy stored due to its position. The mathematical formula for the calculation of the potential energy can be expressed in the form of P.E = m×g×h where ‘g’ is the gravitational acceleration, ‘m’ is the mass and ‘h’ is the height in meters

When two identical balls are thrown from a cliff, each with the same speed. One ball is thrown straight up, and the other ball is straight down. Both balls will have the same kinetic energy as well as speed.

Learn more about kinetic energy and potential energy, here:

brainly.com/question/15764612

#SPJ2

Answer:

The formula for calculating Density is:

= Mass / Volume

From this formula, we can say that the relationship between Mass and Density is a direct one. In other words, if mass is increasing - all else being equal - then density will increase as well.

If mass however was decreasing, density would have to decrease as well.

For example, assume 3 bricks have masses of 5kg, 10kg and 15kg. Also assume that the bricks all have the same volume of 5 m³.

Density of 5kg brick = 5 / 5 = 1 kg/m³

Density of 10kg brick = 10 / 5 = 2kg / m³

Density of 15kg brick = 15 / 5 = 3 kg /m³

Notice how density increases as mass increases and decreases when mass decreases.

Answer:

You first push in then when the syringe is full push the out

Explanation:

1. in

2. out

but u should watch a You-tube video just in case

I hoped this helped!

Answer:

Compression distance: [tex]d \approx 0.102\,m[/tex]

Explanation:

According to this statement, we know that system is non-conservative due to the rough patch. By Principle of Energy Conservation and Work-Energy Theorem, we have the following expression that represents the system having a translational kinetic energy ([tex]K[/tex]), in joules, at the expense of elastic potential energy ([tex]U[/tex]), in joules, and overcoming work losses due to friction ([tex]W_{l}[/tex]), in joules:

[tex]K + W_{l} = U[/tex] (1)

By definitions of translational kinetic and elastic potential energies and work losses due to friction, we expand the equation described above:

[tex]\frac{1}{2}\cdot m \cdot v^{2} +\mu\cdot m\cdot g \cdot s = \frac{1}{2} \cdot k \cdot d^{2}[/tex] (2)

Where:

[tex]m[/tex] - Mass of the block, in kilograms.

[tex]v[/tex] - Final velocity of the block, in meters per second.

[tex]\mu[/tex] - KInetic coefficient of friction, no unit.

[tex]g[/tex] - Gravitational acceleration, in meters per square second.

[tex]s[/tex] - Width of the rough patch, in meters.

[tex]k[/tex] - Spring constant, in newtons per meter.

[tex]d[/tex] - Compression distance, in meters.

If we know that [tex]m = 1.2\,kg[/tex], [tex]v = 2.3\,\frac{m}{s}[/tex], [tex]\mu = 0.44[/tex], [tex]g = 9.807\,\frac{m}{s^{2}}[/tex], [tex]s = 0.05\,m[/tex] and [tex]k = 730\,\frac{N}{m}[/tex], then the compression distance of the spring is:

[tex]\frac{1}{2}\cdot m \cdot v^{2} +\mu\cdot m\cdot g \cdot s = \frac{1}{2} \cdot k \cdot d^{2}[/tex]

[tex]m\cdot v^{2} + 2\cdot m\cdot g \cdot s = k\cdot d^{2}[/tex]

[tex]d = \sqrt{\frac{m\cdot (v^{2}+2\cdot g\cdot s)}{k} }[/tex]

[tex]d \approx 0.102\,m[/tex]

Answer:

Net force = the difference between the forces of two directions

Net force= 60N-(30N+20N)

=60-50

Therefore Net force = 10N

The girl's reference frame must be moving with the same speed as the plane.

If an observer is stationary and he watches a car moving he can observe that the car has a momentum and is moving with certain speed. But if the observer is in the car or moving with same speed, the car does not appear to move away form the observer. Likewise, two observers moving with different speed will have different observation about the same car.

Similarly, if the girl describes the plane is not moving that means either she is in the plane or moving with the same speed along with the plane.

Learn more about frame of reference:

https://brainly.com/question/20897534

Answer:

Explanation:

The amount of force needed needs to be greater than all the forces acting in the opposite direction that the bowling ball was thrown. This includes air resistance, floor friction, gravity, and any other force involved. As long as the force acting on the bowling ball that is causing it to go in the direction of the pins is slightly greater than the opposite acting forces then it will continue in that direction. Since no values are provided we cannot calculate the actual precise value of force needed.

If the needle in the galvanometer is going up, the conclusion about the motion of the magnet is it must be moving right.

The galvanometer is the device used to detect the small current when moving coil is deflected.

When the magnet is moved towards or into the coil of wire, the magnetic field will change and voltage will be generated into the coil. The coil  must be moving to the right when galvanometer going up.

Thus, the conclusion about the motion of the magnet is, it must be moving to the right.

Learn more about galvanometer.

https://brainly.com/question/17247518

#SPJ2

Answer:

18,000 j

Explanation:

the lightbulb dissipates 5W of power

P = ΔE / Δt

rearrange to solve for energy

ΔE = PΔt

P = 5W

t =  1 hour = 60 minutes = 3600 seconds

ΔE = 5 * 3600

ΔE = 18000 J

Answer:

The four forms of energy are:

1. Kinetic Energy

2. Radiation Energy

3. Potential Energy

4. Chemical Energy

Explanation:

Above are listed the four main types of energy. Hope this helps! :)

Answer:

v = 135.13 mph

Explanation:

Given that,

The race car was moving for 3.7 hours and during that time it traveled a distance of 500 miles south.

We need to find the speed of the car.

We know that,

Speed = distance/time

So,

[tex]v=\dfrac{500\ miles}{3.7\ h}\\\\v=135.13\ mph[/tex]

So, the speed of the car is equal to 135.13 mph.

Answer:4.39

Explanation:For acellus students the answer is 4.39

Answer:

E = 0.4 kWh

Explanation:

Given that,

The power of a bulb, P = 40 W

Time, t = 10 hours

We need to find the energy used by the bulb. Let it is equal to E. So,

[tex]E=P\times t\\\\E=40\times 10\\\\E=400\ W-h\\\\or\\\\E=0.4\ kWh[/tex]

So, 0.4 kWh of energy would be needed.

Answer: 146,000 Wh or 146 kWh

Explanation:

65 days × 10 hours × 40 W = 146,000 Wh or 146 kWh

Answer:

t.f. are you sure that's english? it looks like not a real thing

Explanation:

Answer:

B. It's nucleus releases energy

Explanation:

Answer:

please give me brainlist and follow

Explanation:

As the projectile moves upward, its vertical component of velocity decreases due to gravity. While the horizontal component remains the same as there is no acceleration in the horizontal direction. At maximum height vertical component of velocity is zero.

Ignoring air resistance, an object thrown in any direction moves in a parabolic path from the time it leaves the thrower's hand until the time it hits the ground or a physical obstruction.

Answer:

G. it enables people to use pots and pans made of metal to cook food

Explanation:

Metals are known to be substances with a relative high melting point, which means that it takes a very high temperature to melt them. As used in this question, copper (Cu) and iron (Fe) at metallic elements that have high melting points.

One advantage of this property based on the options provided is that "it enables people to use pots and pans made of metal to cook food". This is because cooking food requires subjecting them to a constant temperature from a heat source e.g cooker or stove.

The material used to hold the food being cooked must possess a very high melting point to withstand the heat, hence, the importance of these metallic substances. Most pots and pans are made of steel, an alloy of iron, hence, they have high melting point.

Answer:

The SI unit for electric current is Ampere (A)

Answer:https://www.ux1.eiu.edu/~cfadd/1150-05/Hmwk/Ch09/Ch09.html

i has the answer that you need i think i could not take a screen shot of it sorry

Explanation:

Answer:

There is less gravity on the moon

hope this helps

have a good day :)

Explanation:

Answer:

When you burned the skewer tip coated with sodium chloride, you should have seen that the flame was pure yellow-orange (without any blue). This is because when the metal sodium is burned, it makes intense yellow-orange light. ... This is because when the metal copper is burned, it makes bluish-green light.

hope this helps

Answer:

Explanation:you knoe i know

Answer: B - 234/90 TH

Explanation: A P 3 X

Answer: B - 234/90 TH

Explanation:

Answer:

0.5*0.8*45^2. =810J

Explanation:

KE=1/2 mv^2