2N2 + 502 --> 2N205
Based on the above reaction, if 7 moles of Ny react completely, how many moles of Oz must also react?
ASAP LOOK AT PICTURE

Answer:

Correct

Explanation:

According to the balanced chemical reaction, 2 mol FeBr3 are consumed for every 3 mol Na2S consumed.

A balanced equation obey the law of conservation of mass. The coefficients are the numbers which are added to balance the chemical equation. Here the given mole ratio is correct.

An equation in which the number of atoms of reactants and products on both sides of the equation are balanced is defined as the balanced chemical equation. The coefficients which are added in front of the formula of each component represents the number of the species.

A molar ratio denotes the ratio between the amounts in moles of any two compounds involved in a balanced chemical reaction. By comparing the coefficient of each component, the mole ratio can be determined.

Here for the given reaction, for every 3 moles of Na₂S consumption 2 moles of FeBr₃ is also consumed. So the molar ratio of Na₂S to FeBr₃ is 2/3. Molar ratios are used as the conversion factors between products and reactants in many chemistry problems.

To know more about mole ratio, visit;

https://brainly.com/question/29095152

#SPJ7

Answer: d

Explanation:

took the test

Answer:

I think it's 2

Explanation:

The magma gets so hot, it floats up before cooling and sinking again

Answer:

200 lb•ft/s

Explanation:

From the question given above, the following data were obtained:

Force (F) = 2 tons

Time (t) = 5 mins

Height (h) = 15 ft

Power (P) =?

Next, we shall convert 2 tons to pound. This can be obtained as follow:

1 ton = 2000 lb

Therefore,

2 tons = 2 × 2000

2 tons = 4000 lb

Next, we shall convert 5 mins to seconds. This can be obtained as follow:

1 min = 60 s

Therefore,

5 mins = 5 × 60

5 mins = 300 s

Finally, we shall determine the power of the pump. This can be obtained as follow:

Force (F) = 4000 lb

Time (t) = 300 s

Height (h) = 15 ft

Power (P) =?

P = F × h / t

P = 4000 × 15 / 300

P = 60000 / 300

P = 200 lb•ft/s

Thus, the power of the pump is 200 lb•ft/s

Answer:

It's 200 ft-lb/sec

Explanation:

I did it before!

Answer:

C. About 50 more grams ammonia would be able to dissolve as the solution has become unsaturated

Explanation:

From the question, we have;

The mass of ammonia dissolved in water = 60 grams

The mass of the water solvent which dissolves the ammonia = 100 g

The temperature to which the ammonia water solution is raised = 90°C

Therefore, given that the solubility of a solute in a solvent increases with temperature, when the temperature is raised, we have, that the solution will more unsaturated and will be able to dissolve more ammonia, therefore, option 'C' is the most correct option that corresponds with the relationship of temperature and solubility

Answer:

pH≈1.35

Explanation:

-log(0.045)≈1.35

Answer:

balanced equation of glucose

6CO2 + 6H2O----------C6H12O6 + 6O2

in the presence of sun light.

Answer:

Different properties

Explanation:

They are different.

answer:lettter B that is answer

Answer:

Average speed increases because average kinetic energy increases.

Explanation:

Temperature is the measure of the average kinetic energy of a system. As temperature increases, so will kinetic energy. As kinetic energy increases, speed increases.

Answer:

(14.5 mol) x (6.022 x 10^23 atoms/mol) = 8.73 × 10^24 atoms

Explanation:

pls mark brainliest

Answer:

None of these

Explanation:

The mass percent is 35.4% (3 s.f.)

14/4+35.5 = 14/39.5 x 100 = 35.4 (3 s.f.)

Answer:

pH is the number given to a substance of how powerful it is before 7 or beyond 7.

the solution is an acid.

Explanation:

Pls mark BRAINLIEST

Answer:

August 15, 1971

The nine sheikhdoms still had not agreed on terms of union by 1971, however, prompting Bahrain to declare itself fully independent on August 15, 197

1.A solution has a pH of 5, calculate the pOH, [H+], and [OH-]. Classify the solution as an acid, base, or neutral solution.

it's an acid

Explanation:

I hope that this helps

1,516.31168 grams of Magnesium Hydroxide

CH₄ + 2O₂ = CO₂ + 2H₂O

Answer:

it is a chemical change because it can't be change back to it normal position when it gets burnt

Answer:

Bottle Nose Dolphin ummmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmm

Explanation:

Answer:

I believe it's A. to reduce air bubbles. Tbh, it's been a while

Answer:

D. passing an electric current through water to form hydrogen and oxygen

Explanation:

only one that's not just a physical change.

False. To prepare 20.0 mL of 2.00 M solution of hydrochloric acid from 10.0 M stock solution, 4.0 mL of the stock solution and 16.0 mL of water would be needed.  

Recall the law of diffusion that:

C1V1 = C2V2, where C1 = initial concentration, V1 = initial volume, C2 = final concentration, and V2 = final volume.

In this case, if C1 =10.0 M, V1 = ?, C2 = 2.00 M and V2 = 20.0 mL

V1 = 2 x 20/10

         = 4.0 mL

Hence, 4.0 mL of the stock solution would be taken. Since the final volume is 20.0 mL, only 16.0 mL of water would need to be added and not 20.0 mL.

More on dilution can be found here: https://brainly.com/question/13844449

Answer:

B. Chemical changes produce new substances; physical changes do not.

Explanation:

Physical changes only alter appearances, while chemical changes are interactions that create new chemical formulas.