"The" (and any subsequent words) was ignored because we limit queries to 32 words.
Which type of earthquake waves are responsible for most of the damage caused by an earthquake? Why?
please helppppp its due tomorrow
Answer:
Surface waves travel along the surface. There are two types of body waves: P-waves travel fastest and through solids, liquids, and gases; S-waves only travel through solids. Surface waves are the slowest, but they do the most damage in an earthquake.
Answer:
surface waves
Explanation:
they have the strongest vibration and can cause the most damage
A flight distance from philadelphia to cancun is 1469 miles.the estimated flight time is 3.25 hours.What is the avarage speeede of the plane in miles per hour(number and units)?
Answer:
1469 miles /3.25 hours = 452 miles per hours
Explanation:
divide distance by the time it takes to get there
14
A measure of the gravitational force exerted on an object?
A Weight
B) Force
C)Air resistance
Answer:
C
Explanation:
Answer:
A) weight
Explanation:
Hope it helps :))
A cinder block is sitting on a platform 10 m high. It has a mass of 25 Kg. What is the potential energy
Answer:
2450J
Explanation:
PE = mgh
PE = (25)(9.8)(10)
What is the geocentric angle of the earthquake focus?
Answer:
epicenter
Explanation:
the epicenter Is d point directly above it at the structure of the earth
Tom puts a metallic cover over his car's windshield after parking. How does this control
the sun's rays during a sunny day?
1. What is the difference between thermal energy and heat? Give an example.
Answer:
when you run u get tied
Explanation:
I do not now this one
If a ball is rolling down a hill, it has both kinetic and potential energy. The ball has
38 J of potential energy because of its height and 80J of kinetic energy because
of its motion. How much mechanical energy does the ball have
The answer is 118 J :)
Explanation:
38 +80 = 118.
motion is the act of ___
the options are movement, feeling, chemical engergy and sleep
Answer:
hi
Explanation:
F. A 50. A resistor (R2), and unknown resistor R2, a 120 Volt source, and an ammeter are connected in a
complete circuit. The ammeter reads 0.50 ampere (current).
R1
a. Determine the resistance of Rz.
R2
Complete question is;
A 50.-ohm resistor, an unknown resistor R, a 120-volt source, and an ammeter are connected in a complete circuit. The ammeter reads 0.50 ampere.
A) Calculate the equivalent resistance of the circuit shown.
B) Determine the resistance of resistor R shown in the diagram.
Answer:
A) R_eq = 240 Ω
B) R = 190 Ω
Explanation:
A) To get the equivalent resistance, we will use the formula;
R = V/I
Where;
V is Voltage
I is current
R is equivalent resistance
From the question, V = 120 V and I = 0.5A
Thus;
R_eq = 120/0.5
R_eq = 240 Ω
B) From the image, we see that the resistors are connected in series.
Formula for resistors in series is;
R = R1 + R2 +..... Rn
Thus;
240 = 50 + R
R = 240 - 50
R = 190 Ω
A) The equivalent resistance of the circuit shown will be 240 Ω.
B) The resistance of resistor R will be 190 Ω
What is resistance?Resistance is a type of opposition force due to which the flow of current is reduced in the material or wire. Resistance is the enemy of the flow of current.
The given data in the problem is;
R is the resistance = 50.-ohm
v is the voltage = 120-volt source
I is the value of the current =0.50 ampere.
A) The equivalent resistance of the circuit shown will be 240 Ω.
According to ohm's law
[tex]\rm R= \frac{V}{I} \\\\ \rm R= \frac{120}{0.5} \\\\ \rm R=240 \ ohm[/tex]
Hence the equivalent resistance of the circuit shown will be 240 Ω.
B) The resistance of resistor R will be 190 Ω
The given resistors are connected in the series;
R = R1 + R2 +..... Rn
240 = 50 + R
R = 240 - 50
R = 190 Ω
Hence the resistance of resistor R will be 190 Ω
To learn more about the resistance refer to the link;
https://brainly.com/question/20708652
Why is ultraviolet radiation considered more dangerous to humans than infrared radiation?
ANSWER:Ultraviolet radiation has a shorter wavelength than infrared radiation, and thus, the waves have higher energy. This allows them to penetrate the first layers of skin on humans and can mutate the DNA in the cells of the skin. This can result in cancer because of the mutations caused by the ultraviolet radiation.
The voltage across the terminals of a generator is 5.7 v when it supplies a current of 0.3 A. It becomes 5.1 V when I=0.9A. Find its emf and it's internal resistance
Answer:
The emf of the generator is 6VThe internal resistance of the generator is 1 ΩExplanation:
Given;
terminal voltage, V = 5.7 V, when the current, I = 0.3 A
terminal voltage, V = 5.1 V, when the current, I = 0.9 A
The emf of the generator is calculated as;
E = V + Ir
where;
E is the emf of the generator
r is the internal resistance
First case:
E = 5.7 + 0.3r -------- (1)
Second case:
E = 5.1 + 0.9r -------- (2)
Since the emf E, is constant in both equations, we will have the following;
5.1 + 0.9r = 5.7 + 0.3r
collect similar terms together;
0.9r - 0.3r = 5.7 - 5.1
0.6r = 0.6
r = 0.6/0.6
r = 1 Ω
Now, determine the emf of the generator;
E = V + Ir
E = 5.1 + 0.9x1
E = 5.1 + 0.9
E = 6 V
Which two statements describe what happens in both nuclear fusion and
nuclear fission reactions?
A. Each nucleus formed has fewer protons than the original nucleus
had.
B. Nuclei with small masses combine to form nuclei with larger
masses.
C. Radiation is released from the nuclei that undergo a reaction.
D. A small amount of the mass in each nucleus that undergoes a
reaction is converted to energy.
Answer:
C. Radiation is released from the nuclei that undergo a reaction.
D. A small amount of the mass in each nucleus that undergoes a
reaction is converted to energy.
Two statements, that describe what happens in both nuclear fusion and nuclear fission reactions, are:
Radiation is released from the nuclei that undergo a reaction.A small amount of the mass in each nucleus that undergoes a reaction is converted to energy.Hence, option (C) and (D) are correct.
What is nuclear reaction?A nuclear reaction is a process in nuclear physics and nuclear chemistry where two nuclei or a nucleus and an outside subatomic particle meet to create one or more new nuclides. Consequently, at least one nuclide must change throughout a nuclear reaction.
Instead of being referred to as a nuclear reaction, the process is simply referred to as a sort of nuclear scattering if a nucleus interacts with another nucleus or particle and they subsequently separate without altering the nature of any nuclide.
Learn more about nuclear reaction here:
https://brainly.com/question/16526663
#SPJ5
A sled starts off with an initial velocity of 8 m/s and slows down to 2 m/s after 3 seconds. What was its acceleration?
Answer:
-2m/s
Explanation:
A hair dryer is rated at 1.2kW. When it is plugged into a standard outlet and turned on, what is the current in the hair dryer?
Answer:
1200 watts at a standard 120v draws 10 amps
What is the most accurate way to check your heart rate (bpm)? Help me?
Answer:
Count your pulse for 60 seconds.
Explanation:
This isn't physics, this quesiton should be marked in health.
The current in the wires of a circuit is 180.0 milliAmps. If the
voltage impressed across the ends of the circuit was doubled
and the resistance was one-third the original value, then its
new current would be _____milliAmps.
Explanation:
ls xgfmc!hchlvb! jt?bjgchfb j
West
East
<
디
50 Newtons
40 Newtons
What is the net force on the box?
А
10 Newtons West
B
10 Newtons East
с
90 Newtons West
D
90 Newtons East
A . 10 Newton West
that's my Answer
Fossil fuels are burned, transferring their chemical potential energy to heat energy. How are nuclear power stations different?
Answer:
fossil fuels are natural and limited, nuclear is man made and more toxic
Explanation:
Jacob is building a soapbox derby car. He hopes to win an upcoming downhill race in his neighborhood.
Which of the following should he take into consideration if his only concern is winning the race?
A. the color of the goggles that he wears
B. the shape of the car he makes
C. the mass of the materials he uses
D. the strength of the materials he uses
What is the momentum of a 750 kg car traveling at a velocity of 25 m/s north?
Answer:
18750 kg-m/s
Explanation:
Momentum = mass x velocity
Answer:
18750 kg-m/s
Explanation: Momentum = mass x velocity 750x25 = 18750 kg-m/s
Can you brainlist
Determine the kinetic energy (in joules) of a 1000 kg roller coaster car that is moving with a speed of 25.0 m/s?
Each bat can produce different frequencies of ultrasound. Explain why this is useful if there are many bats hunting together.
Answer: Although low frequency sound travels further than high-frequency sound, calls at higher frequencies give the bats more detailed information--such as size, range, position, speed and direction of a prey's flight. Thus, these sounds are used more often.
Explanation:
The net force of two forces F1 and F2 acting in the same direction is 85N.And if is 15N when they are exerted in opposite directions. Find the magnitudes of F1 and F2
What happens to the force between charged and uncharged objects as the distance between them decreases?
Answer:Thus, if each of the charges were reduced by one-half, the repulsion would be reduced to one-quarter of its former value. Also In electrostatics, the electrical force between two charged objects is inversely related to the distance of separation between the two objects. ... And decreasing the separation distance between objects increases the force of attraction or repulsion between the objects.
Hope this helps have a awesome night/day❤️✨
Explanation:
Nothing, until those two objects physically touch each other; contact aligns polarity among the now single shared mass.
(Your question never states if both objects are unique or similar polar charges, so I just assumed they were both neutral objects existing within an electric field.)
So a better question would then be, what is gravity’s relationship with an electric field?
You could solve this with the following: confine the electric field’s volume to a set variable (never increasing nor decreasing in size or shape); density is variable and easily definable. This creates the limit to build upon. This density has to be fluid and has electron mass (full of electrons at rest mass, so with substance but no movement). Within, create a closed system (the hard part in this equation; outside interference like ambient light will eschew results) where each variable of kinetic energy then is accounted for or measurable (including heat and light, and the physical movement of the two objects)
Determine the mass for both objects, calculate gravity for both and each body’s inertia on the other as a sum over distance. record results. Polarity is shared across the masses until there is no longer inertia (one mass or contact).
Clothes in a dryer rub together and begin clinging to each other
A. Friction
B. Conduction
C. Induction
Answer:
Conduction
Explanation:
Because they touch lol
Answer:
Conduction
Explanation:
Because induction is the pass of electricity without contact and conduction is the complete opposite
An ohm is best described as a unit of measure for...
A. electrical resistance
B. electrical current
C. electrical potential difference
D. magnetic field strength
Mr. Cudd tries riding a bike to see if he still remembers how. As he gains some speed, he accidentally squeezes the front brakes. What happens immediately after is an example of which one of Newton’s laws?
Answer:
Newton's second Law of motion
Solids, liquids, and gases are very often depicted as groups of particles inside containers of fixed shape and dimension.
Using the simple model of solid, liquid, and gas, which of the following descriptions of physical properties is CORRECT?
A
The physical properties of this phase of matter are that the particles take the shape of the container, do not fill the entire volume, and are very strongly attracted to each other.
B
The physical properties of this phase of matter are that the particles take the shape of the container, do not fill the entire volume, and are strongly attracted to each other.
C
The physical properties of this phase of matter are that the particles take the shape of the container, they fill the entire volume of the container, and are strongly attracted to each other.
D
The physical properties of this phase of matter are that the particles do not take the shape of the container, they fill the entire volume, and are weakly attracted to each other.
Answer:
The answer would be B
Explanation:
Hope you have a good day
HELP ME PLEASE I need the answer now and I will give all my brain lists
Answer:
I'd say it's B
Sorry if I get you wrong-